Políticas productivas y competitividad industrial: El caso de Argentina y Brasil

This article aims, on the one hand, to analyze the increase of productive asymmetries between Argentina and Brazil that have been evidencing during the last two decades, and are currently reveled in the structural trade deficit of industrial products that affects Argentina in the bilateral relationship. On the other hand, it intends to contribute to understanding the roots of these asymmetries based on the differences in the public policies implemented by both countries during the period extending from the implementation of the Mercosur, in the early 1990s, until 2008. The focus is set on the technological pattern of industrial production and trade structures, considering a non neutral impact over the long term development.

LOW COST ANALYZER FOR THE DETERMINATION OF PHOSPHORUS BASED ON OPEN-SOURCE HARDWARE AND PULSED FLOWS

The need for automated analyzers for industrial and environmental samples has triggered the research for new and cost-effective strategies of automation and control of analytical systems. The widespread availability of open-source hardware together with novel analytical methods based on pulsed flows have opened the possibility of implementing standalone automated analytical systems at low cost. Among the areas that can benefit from this approach are the analysis of industrial products and effluents and environmental analysis. In this work, a multi-pumping flow system is proposed for the determination of phosphorus in effluents and polluted water samples. The system employs photometric detection based on the formation of molybdovanadophosphoric acid, and the fluidic circuit is built using three solenoid micropumps. The detection is implemented with a low cost LED-photodiode photometric detection system and the whole system is controlled by an open-source Arduino Uno microcontroller board. The optimization of the timing to ensure the color development and the pumping cycle is discussed for the proposed implementation. Experimental results to evaluate the system behavior are presented verifying a linear relationship between the relative absorbance and the phosphorus concentrations for levels as high as 50 mg L-1.

Chemical characterization of the flour of peel and seed from two papaya cultivars

Papaya is among the currently most important tropical fruits grown in Brazil and in the world. The fruit is mainly consumed fresh although it offers many industrial products. The processing of this fruit, as well as its fresh consumption, results in large amounts of waste, such as peels and seeds. Papaya consumption is one of the causes of significant loss of food value; therefore, new aspects on the use of its waste as by-products, or in the production of food additives, or even the incorporation of its flour in food have aroused great interest because these are products of high nutritional value, and their use may be economically viable. The objective of this study was to produce and characterize peel and seed flours from two papaya cultivars (Havai and Calimosa) for their chemical constituents focusing on possible use in foods. The proximate and mineral composition, titratable acidity, soluble solids, pH, contents of vitamin C, and phenolic compounds were determined. According to the results obtained, the papaya peel and seed flours had high contents of protein and fiber and therefore can be used as alternative sources of nutrients and can also be added in foods avoiding waste and adding value to the fruit.

A industrialização da pauta de exportação brasileira entre 1964 e 1974: novos dados e índices para o comércio exterior brasileiro do período

This paper analyses the effects on Brazil's trade indices of the rising share of industrial products in Brazil's exports in the period from 1964 to 1974. New price and quantity indices of Fisher for Brazil's exports and imports of industrial and non-industrial goods have been especially constructed for this period, in order to obtain methodologically consistent series of indexes from 1964 to 2005. The market-share-constant model was applied to analyze the effects of different groups of products on Brazil's export revenues between 1964 and 1974.

Estudo da complementaridade do comércio entre o Brasil e o Japão com vistas a um acordo de livre comércio

Complementarity of trade between Brazil and Japan with a view to a free trade agreement. Japan has signed free trade agreements as trade policy since 2002 and three countries have already signed in Latin American. Considering the intention to carry out an agreement with Mercosur, this article aims to analyze the complementarities between Brazil and Japan trade structure by revealed comparative advantages indexes, with World Bank data for the period between 2006 and 2008. The results show a comparative advantage in primary commodities to Brazil and in industrial products to Japan, as well as indicating sectors that may oppose to trade liberalization.

Extractants to assess zinc phytoavailability in mineral fertilizer and industrial by-products

Efficient analytical methods for the quantification of plant-available Zn contained in mineral fertilizers and industrial by-products are fundamental for the control and marketing of these inputs. In this sense, there are some doubts on the part of the scientific community as well as of the fertilizer production sector, whether the extractor requested by the government (Normative Instruction No. 28, called 2nd extractor), which is citric acid 2 % (2 % CA) (Brasil, 2007b), is effective in predicting the plant availability of Zn via mineral fertilizers and about the agronomic significance of the required minimal solubility of 60 % compared to the total content (HCl) (Brasil, 2007a). The purpose of this study was to evaluate the alternative extractors DTPA, EDTA, neutral ammonium citrate (NAC), buffer solution pH 6.0, 10 % HCl, 10 % sulfuric acid, 1 % acetic acid, water, and hot water to quantify the contents of Zn available for maize and compare them with indices of agronomic efficiency of fertilizers and industrial by-products when applied to dystrophic Clayey Red Latosol and Dystrophic Alic Red Yellow Latosol with medium texture. The rate of Zn applied to the soil was 5 mg kg-1, using the sources zinc sulfate, commercial granular zinc, ash and galvanic sludge, ash and two brass slags. Most Zn was extracted from the sources by DTPA, 10 % HCl, NAC, 1% acetic acid, and 10 % sulfuric acid. Recovery by the extractors 2 % CA, EDTA, water, and hot water was low. The agronomic efficiency index was found to be high when using galvanic sludge (238 %) and commercial granular zinc (142 %) and lower with brass slag I and II (67 and 27 %, respectively). The sources galvanizing ash and brass ash showed solubility lower than 60 % in 2 % CA, despite agronomic efficiency indices of 78 and 125 %, respectively. The low agronomic efficiency index of industrial by-products such as brass slag I and galvanizing ash can be compensated by higher doses, provided there is no restriction, as well as for all other sources, in terms of contaminant levels of arsenic, cadmium, chromium, lead, and mercury as required by law (Normative Instruction No 27/2006). The implementation of 2nd extractor 2 % CA and the requirement of minimum solubility for industrial by-products could restrict the use of alternative sources as potential Zn sources for plants.

PHYTOAVAILABILITY OF COPPER IN INDUSTRIAL BY-PRODUCTS AND MINERAL FERTILIZERS

Alternative copper (Cu) sources could be used in fertilizer production, although the bioavailability of copper in these materials is unknown. The objective of this study was to evaluate the extractants neutral ammonium citrate (NAC), 2 % citric acid, 1 % acetic acid, 10 % HCl, 10 % H2SO4, buffer solution pH 6.0, DTPA, EDTA, water, and hot water in the quantification of available Cu content in several sources, relating them to the relative agronomic efficiency (RAE) of wheat grown in a clayey Latossolo Vermelho eutrófico (Oxisol) and Neossolo Quartzarênico (Typic Quartzipsamment). Copper was applied at the rate of 1.5 mg kg-1 as scrap slag, brass slag, Cu ore, granulated copper, and copper sulfate. The extractants 10 % HCl, 10 % H2SO4, and NAC extracted higher Cu concentrations. The RAE values of brass slag and Cu ore were similar to or higher than those of Cu sulfate and granulated Cu. Solubility in the 2nd NAC extractant, officially required for mineral fertilizers with Cu, was lower than 60 % for the scrap slag, Cu ore, and granulated copper sources. This fact indicates that adoption of the NAC extractant may be ineffective for industrial by-products, although no extractant was more efficient in predicting Cu availability for wheat fertilized with the Cu sources tested.

Óleo da castanha de caju: oportunidades e desafios no contexto do desenvolvimento e sustentabilidade industrial

The new millennium is marked by a growing search for renewable fuels and alternative raw materials from biomass in the petrochemicals industry. However, there are many challenges to overcome regarding technological and human resources aspects. In this scenario, cashew nut oil, which is rich in natural phenols, is considered to be very promising for the development of synthetic and functional products and as a feedstock for production of fine chemicals and a wide variety of new materials.

Do engenho à biorrefinaria: a usina de açúcar como empreendimento industrial para a geração de produtos bioquímicos e biocombustíveis

A sugar cane mill is at the present moment a modest biorefinery producing few products such as sugar, ethanol and polyhydroxybutyrate (PHB). In the near future, this mill can expand its production using several renewable feedstock's to produce biofuels and high value biobased chemicals. However, the choice of appropriate products for addition to the portfolio is challenged by a lack of broad-based conversion technology coupled with a plethora of potential targets. The intent of this revision was to catalyze research efforts to expand the list of products and to present an updated evaluation of potential target structures for chemical production.

Isolation and characterization of bacterial strains with a hydrolytic profile with potential use in bioconversion of agroindustial by-products and waste

There is a trend towards the use of novel technologies nowadays, mainly focused on biological processes, for recycling and the efficient utilization of organic residues that can be metabolized by different microorganisms as a source of energy. In the present study the isolation of bacterial strains from six different agro-industrial by-products and waste was performed with the objective of evaluating their hydrolytic capacities and suitability for use in bioconversion of specific substrates. The 34 isolated strains were screened in specific culture media for the production of various hydrolytic enzymes (lipase, protease, cellulase, and amylase). It was found that 28 strains exhibited proteolytic activity, 18 had lipolytic activity, 13 had caseinolytic activity, 15 had amylolytic activity, and 11 strains exhibited cellulolytic activity. The strains that showed the highest hydrolytic capacities with biotechnological potential were selected, characterized genotipically, and identified as Bacillus, Serratia, Enterococcus, Klebsiella, Stenotrophomonas, Lactococcus, and Escherichia genera. It was concluded that the strain isolates have a high potential for use in the bioconversion of agro-industrial waste, both as a pure culture and as a microbial consortium.

Characterization of blueberry fruits (Vaccinium spp.) and derived products

The objectives of this study were to physicochemically characterize and determine the antioxidant activities and anthocyanin contents of organic Rabbiteye blueberries grown in Southern Brazil and its derived products, in order to investigate the utility of food processing wastes as raw materials for developing products with beneficial health properties. The antioxidant capacity of the blueberries was superior to that of other fruits and juices. The pomace exhibited high activity, albeit lower than that of the fruit, while the flour and the dried blueberries lost 66% and 46% of the original antioxidant activity, respectively. The average anthocyanin contents of the fruits were moderate compared to other sources and species of blueberries. The pomace contains a large amount of anthocyanins while the flour and dried blueberries exhibited a 32% and 42% loss in anthocyanin content, respectively. The use of agro-industrial residues, in addition to adding value and minimizing the impact caused by the accumulation in the environment, can be directed toward the development of new products with bioactive properties.

Biomassa seca acumulada, partições e rendimento industrial da cana-de-açúcar irrigada no Semiárido brasileiro

Objetivou-se, com este trabalho, determinar parâmetros de crescimento e de rendimento da cana-de-açúcar cv. RB92579, sob regime de irrigação, no Semiárido brasileiro, visando a avaliar o desempenho desta cultura nas condições edafoclimáticas locais. Foram avaliados o acúmulo de biomassa seca e as suas respectivas partições, durante dois ciclos consecutivos de cana-de-açúcar (soca e ressoca), além dos indicadores de rendimento e de qualidade da cultura ao final do período experimental. Em ambos os ciclos, foram realizadas dez coletas de amostras para se determinar a biomassa seca de seis componentes estruturais dos perfilhos (folhas verdes, bainhas, parte emergente, pseudocolmos, folhas e bainhas mortas e colmo). A cana-de-açúcar apresentou elevado acúmulo de biomassa seca da parte aérea da planta, com valor médio de 6.493 g m-2 para os dois ciclos de cultivo. No início do seu crescimento, os fotoassimilados foram destinados prioritariamente às folhas verdes, bainhas, parte emergente e pseudocolmos. Em fase posterior de crescimento, os fotoassimilados passaram a ser utilizados na formação dos colmos. Os resultados obtidos foram muito semelhantes para os ciclos de soca e ressoca. Os modelos ajustados para descrever a evolução da biomassa seca e de suas respectivas partições apresentaram ajustes satisfatórios, em função dos dias após o corte. O elevado rendimento industrial (133,88 ± 40,84 t ha-1) e a alta concentração de sacarose por biomassa seca (0,34 ± 0,10 g g-1) proporcionaram valores elevados de produção de açúcar (17,75 ± 4,44 t ha-1) e de álcool (12,73 ± 3,23 t ha-1), indicando alto desempenho produtivo da RB92579 para a região.

Desempenho de clones elite de batata para caracteres agronômicos e de qualidade industrial

O objetivo deste trabalho foi verificar o desempenho de clones elite de batata, em relação a caracteres agronômicos e de qualidade industrial. Os experimentos foram realizados em Pelotas, RS, Canoinhas, SC, e Londrina, PR. Foi avaliado um conjunto de clones elite, pertencentes ao Programa de Melhoramento Genético de Batata, da Embrapa. O delineamento experimental foi o de blocos casualizados, com três repetições para Pelotas e Londrina e quatro para Canoinhas. Foram avaliados os caracteres massa total de tubérculos, massa comercial de tubérculos, número de tubérculos comerciais, percentagem de massa de tubérculos comerciais, massa média de tubérculos comerciais, peso específico, cor de fritura e ciclo vegetativo. A partir dos dados obtidos foram realizadas as análises de variância para cada local e teste de agrupamento de médias para cada caráter. Para identificação de clones apropriados ao mercado 'in natura', em que é fundamental o elevado potencial produtivo e precocidade, os clones mais promissores foram F80-03-06 e CL02-05, quando comparados à cultivar testemunha Ágata. Para o processamento industrial, em que o peso específico, a cor de fritura e o rendimento de tubérculo são caracteres importantes, destacou-se o clone F81-01-06, que apesar de não apresentar os maiores rendimentos totais, apresentou tubérculos grandes, ciclo vegetativo intermediário e boa aptidão para fritura, quando comparando-se ao cultivar testemunha Asterix.