Métodos sintéticos para preparação de 2,2'-bipiridinas substituídas

The 2,2'-bipyridine has been entitled as the most widely used ligand. Nowadays there is a large variety of known molecules comprising at least two 2,2'-bipyridine units and the number of applications in many areas such as catalysis, new materials, optoeletronics and electrochemistry have increased very much in the past decades. Nevertheless, there is no article that gives an overview of the main synthetic methods for obtaining the substituted 2,2'-bipyridines, generally non available. This article presents a synthetic discussion about the three different methods (coupling reaction, ciclo-functionalization and functionalization of the heteroaromatic rings of 2,2'-bipyridine) for preparing these heterocyclic compounds and also provides a practical and fundamental guide, for obtaining more than eighty different symmetric and unsymmetrical substituted 2,2'-bipyridines, shown in a table with the corresponding references.

Determinação espectrofotométrica simultânea de cobre e ferro em álcool etílico combustível com reagentes derivados da ferroína

In the present work three ferroin reagents were studied for the simultaneous spectrophotometric determination of iron and copper: 1,10-phenanthroline, 2,2'-bipyridine and 2,4,6-tri(2-pyridyl)-1,3,5-triazine. Effect of pH, conditions, order reagent addition, interferences, amount of reagents, lineal range, sensitivity and stability of each system were compared. The 2,4,6-tri(2-pyridyl)-1,3,5-triazine can be used for determination of iron in the presence of copper with a detection limit of 5 µg L-1 and coefficient of variation of 2.0%; However it was not possible to determine directly copper in the presence of iron with this reagent. 1,10-phenanthroline can be used for simultaneous determination of the metallic ions with detection limits of 7 and 8 mg L-1 and coefficients of variation of 1.8 and 2.3% in the determination of iron and copper, respectively. The results showed also that 2,2'-bipyridine can be used for simultaneous determination of the metallic ions with detection limits of 11 and 32 µg L-1 and coefficients of variation of 1.9 and 2.5% in the determination of iron and copper, respectively. The reagents were used for spectrophotometric determination of iron and copper in ethanol fuel.

Synthesis, characterization, DFT and Td-dfT study of the [Fe(mnt)(L)(t-BuNC) 2] octahedral complex (L = phen, bipy)

FeBr2 has reacted with an equivalent of mnt2- (mnt = cis-1,2-dicyanoethylene-1,2-dithiolate) and the α-diimine L (L = 1,10'-phenantroline, 2,2'-bipyridine) in THF solution, and followed by adding of t-butyl-isocyanide to give [Fe(mnt)(L)(t-BuNC)2] neutral compound. The products were characterized by infrared, UV-visible and Mössbauer spectroscopy, besides thermogravimetric and conductivity data. The geometry in the equilibrium was calculated by the density functional theory and the electronic spectrum by the time-dependent. The experimental and theoretical results in good agreement have defined an octahedral geometry with two isocyanide neighbours. The π→π* intraligand electronic transition was not observed for cis-isomers in the near-IR spectral region.

Iron and zinc availability in maize lines

The aim of this study was to characterize the Zn and Fe availability by phytic acid/Zn and phytic acid/Fe molar ratios, in 22 tropical maize inbred lines with different genetic backgrounds. The Zn and Fe levels were determined by atomic absorption spectrophotometry and the P through colorimetry method. Three screening methods for phytic acid (Phy) analysis were tested and one, based on the 2,2'-bipyridine reaction, was select. There was significant variability in the contents of zinc (17.5 to 42 mg.kg-1), iron (12.2 to 36.7 mg.kg-1), phosphorus (230 to 400 mg.100 g-1), phytic acid (484 to 1056 mg.100 g-1), phytic acid P (140 to 293 mg.100 g-1) and available-P (43.5 to 199.5 mg.100 g-1), and in the available-P/total-P ratio (0.14 to 0.50), Phy/Zn (18.0 to 43.5) and Phy/Fe (16.3 to 45.5) molar ratios. Lines 560977, 560978 and 560982 had greater availability of Zn and lines 560975, 560977, 561010 and 5610111 showed better Fe availability. Lines 560975, 560977 and 560978 also showed better available-P/total-P ratio. Thus, the lines 560975, 560977 and 560978 were considered to have the potential for the development of cultivars of maize with high availability of Fe and/or Zn.