25 resultados para Stokesian Dynamics Method
em Scielo Saúde Pública - SP
Resumo:
Distribution, abundance, feeding behaviour, host preference, parity status and human-biting and infection rates are among the medical entomological parameters evaluated when determining the vector capacity of mosquito species. To evaluate these parameters, mosquitoes must be collected using an appropriate method. Malaria is primarily transmitted by anthropophilic and synanthropic anophelines. Thus, collection methods must result in the identification of the anthropophilic species and efficiently evaluate the parameters involved in malaria transmission dynamics. Consequently, human landing catches would be the most appropriate method if not for their inherent risk. The choice of alternative anopheline collection methods, such as traps, must consider their effectiveness in reproducing the efficiency of human attraction. Collection methods lure mosquitoes by using a mixture of olfactory, visual and thermal cues. Here, we reviewed, classified and compared the efficiency of anopheline collection methods, with an emphasis on Neotropical anthropophilic species, especially Anopheles darlingi, in distinct malaria epidemiological conditions in Brazil.
Resumo:
We apply the Bogoliubov Averaging Method to the study of the vibrations of an elastic foundation, forced by a Non-ideal energy source. The considered model consists of a portal plane frame with quadratic nonlinearities, with internal resonance 1:2, supporting a direct current motor with limited power. The non-ideal excitation is in primary resonance in the order of one-half with the second mode frequency. The results of the averaging method, plotted in time evolution curve and phase diagrams are compared to those obtained by numerically integrating of the original differential equations. The presence of the saturation phenomenon is verified by analytical procedures.
Resumo:
OBJECTIVE: To estimate the basic reproduction number (R0) of dengue fever including both imported and autochthonous cases. METHODS: The study was conducted based on epidemiological data of the 2003 dengue epidemic in Brasília, Brazil. The basic reproduction number is estimated from the epidemic curve, fitting linearly the increase of initial cases. Aiming at simulating an epidemic with both autochthonous and imported cases, a "susceptible-infectious-resistant" compartmental model was designed, in which the imported cases were considered as an external forcing. The ratio between R0 of imported versus autochthonous cases was used as an estimator of real R0. RESULTS: The comparison of both reproduction numbers (only autochthonous versus all cases) showed that considering all cases as autochthonous yielded a R0 above one, although the real R0 was below one. The same results were seen when the method was applied on simulated epidemics with fixed R0. This method was also compared to some previous proposed methods by other authors and showed that the latter underestimated R0 values. CONCLUSIONS: It was shown that the inclusion of both imported and autochthonous cases is crucial for the modeling of the epidemic dynamics, and thus provides critical information for decision makers in charge of prevention and control of this disease.
Resumo:
Introduction: This study aimed to identify airborne fungi in São Luis, Maranhão, Brazil, to determine the prevalent genera and to correlate these genera with the area and season. Methods: In total, 1,510 colony-forming units (CFUs) of airborne fungi were isolated from the north, south, east and west sides and from the center of the city from January to December 2007. The samples were collected on Petri dishes that were exposed to the fungi by the gravitational method. Results: Twenty genera of fungi were isolated; the most common were Aspergillus (33.5%), Penicillium (18.8%), Cladosporium (14.2%), Curvularia (10.6%) and Fusarium (7.6%). The CFUs of the fungi were statistically significant (p < 0.0001). Fungal biological diversity was present all year, without any large seasonal variations but with slight increases in May, August and September. Conclusions: The fungal genera identified in this study were correlated with natural systems and could be useful when evaluating the impact of environmental changes on the region.
Resumo:
An attempt was made to determine more accurately the density of molluskan populations in the Pampulha reservoir, using the quadrate method, intending to detect the fluctuation of the populations density, the habitat conditions and the possible competitive interactions among Biomphalaria tenagophila, Melanoides tuberculata, Pomacea haustrum and Biomphalaria glabrata, through the analysis of populational parameters. Among the most significative facts observed in the reservoir it has to be mentioned: the almost disappearance of B. glabrata; the invasion, colonization, fixation and fast growing of M. tuberculata population until reaching about 11,000 individuals/[square metre]; the density fluctuations of B. tenagophila, P. haustrum and M. tuberculata alives and deads; differences on the habitat preference of these three molluskan species at the edge (at the limit earth-water, at 0.70m and 1.40m from the shore line); monthly mortality rates and reproduction seasons of the species.
Resumo:
Brazilian scientists have been contributing to the protozoology field for more than 100 years with important discoveries of new species such asTrypanosoma cruzi and Leishmania spp. In this work, we used a Brazilian thesis database (Coordination for the Improvement of Higher Education Personnel) covering the period from 1987-2011 to identify researchers who contributed substantially to protozoology. We selected 248 advisors by filtering to obtain researchers who supervised at least 10 theses. Based on a computational analysis of the thesis databases, we found students who were supervised by these scientists. A computational procedure was developed to determine the advisors’ scientific ancestors using the Lattes Platform. These analyses provided a list of 1,997 researchers who were inspected through Lattes CV examination and allowed the identification of the pioneers of Brazilian protozoology. Moreover, we investigated the areas in which researchers who earned PhDs in protozoology are now working. We found that 68.4% of them are still in protozoology, while 16.7% have migrated to other fields. We observed that support for protozoology by national or international agencies is clearly correlated with the increase of scientists in the field. Finally, we described the academic genealogy of Brazilian protozoology by formalising the “forest” of Brazilian scientists involved in the study of protozoa and their vectors over the past century.
Resumo:
Abstract OBJECTIVE To understand the family dynamics when there is a member in the residence with Alzheimer's disease. METHOD A study of qualitative approach, using the creative sensitive method (CSM), and with participation of two families who had a member with Alzheimer's disease at home. RESULTS Three categories emerged: Effects of Alzheimer's disease and the family dynamics; Development process of Alzheimer's disease and Coping strategies in face of the disease. CONCLUSION It was possible to know the manifestations and consequences of Alzheimer's disease in the family, such as mutual help, the mobilization of resources to activate memories of the past, spirituality and faith. There was also understanding of the structure of family dynamics.
Resumo:
Soil water properties are related to crop growth and environmental aspects and are influenced by the degree of soil compaction. The objective of this study was to determine the water infiltration and hydraulic conductivity of saturated soil under field conditions in terms of the compaction degree of two Oxisols under a no-tillage (NT). Two commercial fields were studied in the state of Rio Grande do Sul, Brazil: one a Haplortox after 14 years under NT; the other a Hapludox after seven years under NT. Maps (50 x 30 m) of the levels of mechanical penetration resistance (PR) were drawn based on the kriging method, differentiating three compaction degrees (CD): high, intermediate and low. In each CD area, the infiltration rate (initial and steady-state) and cumulative water infiltration were measured using concentric rings, with six replications, and the saturated hydraulic conductivity (K(θs)) was determined using the Guelph permeameter. Statistical evaluation was performed based on a randomized design, using the least significant difference (LSD) test and regression analysis. The steady-state infiltration rate was not influenced by the compaction degree, with mean values of 3 and 0.39 cm h-1 in the Haplortox and the Hapludox, respectively. In the Haplortox, saturated soil hydraulic conductivity was 26.76 cm h-1 at a low CD and 9.18 cm h-1 at a high CD, whereas in the Hapludox, this value was 5.16 cm h-1 and 1.19 cm h-1 for the low and high CD, respectively. The compaction degree did not affect the initial and steady-state water infiltration rate, nor the cumulative water infiltration for either soil type, although the values were higher for the Haplortox than the Hapludox.
Resumo:
Abstract: The objective of this work was to evaluate soil water dynamics in areas cultivated with forage cactus clones and to determine how environmental conditions and crop growth affect evapotranspiration. The study was conducted in the municipality of Serra Talhada, in the state of Pernambuco, Brazil. Crop growth was monitored through changes in the cladode area index (CAI) and through the soil cover fraction, calculated at the end of the cycle. Real evapotranspiration (ET) of the three evaluated clones was obtained as the residual term in the soil water balance method. No difference was observed between soil water balance components, even though the evaluated clones were of different genus and had different CAI increments. Accumulated ET was of 1,173 mm during the 499 days of the experiment, resulting in daily average of 2.35 mm. The CAI increases the water consumption of the Orelha de Elefante Mexicana clone. In dry conditions, the water consumption of the Miúda clone responds more slowly to variation in soil water availability. The lower evolution of the CAI of the IPA Sertânia clone, during the rainy season, leads to a higher contribution of the evaporation component in ET. The atmospheric demand controls the ET of clones only when there is higher soil water availability; in this condition, the water consumption of the Miúda clone decreases more rapidly with the increase of atmospheric demand.
Resumo:
We evaluated the dynamics of ear infestations caused by Rhabditis spp. and Raillietia spp., which were correlated with animal age, intensity of clinical signs and climate factors. Sixty-four Gir cattle were distributed into three groups: GA - 23 calves with 4 to 6 months of age; GB - 18 calves with 7 to 12 months of age; and GC - 23 heifers with 13 to 33 months of age. Five samplings, defined as S1, S2, S3, S4 and S5 were performed every three months from August 2008 to August 2009. The ear secretion was collected using the auricular washing method for the right ear and a swab for the left ear. A clinical assessment of the animals was performed, and they were classified according to the presence and severity of otitis. The highest relative frequency of rhabditosis was 52.2% in GC at the last sampling. In the first sampling, 42.2% of the animals were infested by Raillietia spp. The older cattle were more susceptible to infestations by both parasites. No correlation of Rhabditis spp. and Raillietia spp. parasitism with climate factors was found. The results showed that both parasites could infest Gir cattle, and in most cases, there was no co-infestation. Only older animals parasitized by the nematode showed clinical signs of the disease.
Resumo:
The increasing complexity of controller systems, applied in modern passenger cars, requires adequate simulation tools. The toolset FASIM_C++, described in the following, uses complex vehicle models in three-dimensional vehicle dynamics simulation. The structure of the implemented dynamic models and the generation of the equations of motion applying the method of kinematic differentials is explained briefly. After a short introduction in methods of event handling, several vehicle models and applications like controller development, roll-over simulation and real-time-simulation are explained. Finally some simulation results are presented.
Resumo:
In-package pasteurization is the most used method for beer microbiological stabilization. The search for safer and better quality food has created a need to better understand the processes involved in producing it. However, little is known about the temperature and velocity profiles during the thermal processes of liquid foods in commercial packaging, which results in over-dimensioned processes to guarantee safety, decreasing the sensorial and nutritional characteristics of the product and increasing process costs. Simulations using Computational Fluid-Dynamics (CFD) have been used by various authors to evaluate those processes. The objective of the present paper was to evaluate the effect of packaging orientation in the pasteurization of beer in a commercial aluminum can using CFD. A heating process was simulated at 60 ºC up to 15 PUs (a conventional beer process, in which 1 Pasteurization Unit (PU) is equivalent to 1minute at 60 ºC). The temperature profile and convection current velocity along the process and the variation of the PUs were evaluated in relation to time considering the cans in the conventional, inverted, and horizontal positions. The temperature and velocity profiles were similar to those presented in the literature. The package position did not result in process improvement.
Resumo:
The expectation that technological returns from defense expenditure through acquisition, international cooperation and domestic research would further national development underappreciates the different technological dynamic of the armed services. This paper outlines the technological dynamic the stems from fighting in the air, at sea and on land, exemplifying consequences for the case of acquisition.
Resumo:
This study aimed to evaluate the efficiency of multiple centroids to study the adaptability of alfalfa genotypes (Medicago sativa L.). In this method, the genotypes are compared with ideotypes defined by the bissegmented regression model, according to the researcher's interest. Thus, genotype classification is carried out as determined by the objective of the researcher and the proposed recommendation strategy. Despite the great potential of the method, it needs to be evaluated under the biological context (with real data). In this context, we used data on the evaluation of dry matter production of 92 alfalfa cultivars, with 20 cuttings, from an experiment in randomized blocks with two repetitions carried out from November 2004 to June 2006. The multiple centroid method proved efficient for classifying alfalfa genotypes. Moreover, it showed no unambiguous indications and provided that ideotypes were defined according to the researcher's interest, facilitating data interpretation.