EFFECTS OF SINGLE, BINARY AND TERTIARY COMBINATIONS WITH Jatropha gossypifolia AND OTHER PLANT-DERIVED MOLLUSCICIDES ON REPRODUCTION AND SURVIVAL OF THE SNAIL Lymnaea acuminata

The effect of sub-lethal doses (40% and 80% of LC50/24h) of plant derived molluscicides of singly, binary (1:1) and tertiary (1:1:1) combinations of the Rutin, Ellagic acid, Betulin and taraxerol with J. gossypifolia latex, leaf and stem bark powder extracts and their active component on the reproduction of freshwater snail Lymnaea acuminata have been studied. It was observed that the J. gossypifolia latex, stem bark, individual leaf and their combinations with other plant derived active molluscicidal components caused a significant reduction in fecundity, hatchability and survival of young snails. It is believed that sub-lethal exposure of these molluscicides on snail reproduction is a complex process involving more than one factor in reducing the reproductive capacity.

Block of the Mitral-pulmonary Isthmus During Ablation of a Single Left-sided Accessory Pathway Causing Different Patterns of Retrograde Atrial Activation

The case of a 16-year-old patient with atrioventricular tachycardia caused by a single left anterolateral accessory pathway is reported. When the patient underwent radiofrequency ablation, a lesion on the mitral annulus lateral wall produced changes in the retrograde atrial activation pattern determined by that pathway; changes ranged from a delay in depolarization of the annulus posterior portions to full left atrium counterclockwise activation. Such phenomena were probably caused by a block in the isthmus between the annulus and the lower left pulmonary vein ostium. This case illustrates the importance of the mitral-pulmonary isthmus in the process of left atrium activation, an alert to changes induced by its unintentional block during accessory pathway ablation.

Participation of interleukin-5, interleukin-8 and leukotriene B4 in eosinophil accumulation in two different experimental models

There are several experimental models describing in vivo eosinophil (EO) migration, including ip injection of a large volume of saline (SAL) or Sephadex beads (SEP). The aim of this study was to investigate the mechanisms involved in the EO migration in these two models. Two consecutive injections of SAL given 48 hr apart, induced a selective recruitment of EO into peritoneal cavity of rats, which peaked 48 hr after the last injection. SEP, when injected ip, promoted EO accumulation in rats. The phenomenom was dose-related and peaked 48 hr after SEP injection. To investigate the mediators involved in this process we showed that BW A4C, MK 886 and dexamethasone (DXA) inhibited the EO migration induced by SAL and SEP. To investigate the source of the EO chemotactic factor we showed that mast cells, macrophages (MO), but not lymphocytes, incubated in vitro in presence of SAL released a factor which induced EO migration. With SEP, only mast cells release a factor that induced EO migration, which was inhibited by BW A4C, MK 886 and DXA. Furthermore, the chemotactic activity of SAL-stimulated mast cells was inhibited by antisera against IL-5 and IL-8 (interleukin). SAL-stimulated MO were only inhibited by anti-IL-8 antibodies as well SEP-stimulated mast cells. These results suggest that the EO migration induced by SAL may be dependent on resident mast cells and MO and mediated by LTB4, IL-5 and IL-8. SEP-induced EO migration was dependent on mast cells and may be mediated by LTB4 and IL-8. Furthermore, IL-5 and IL-8 induced EO migration, which was also dependent on resident cells and mediated by LTB4 . In conclusion, EO migration induced by SAL is dependent on mast cells and MO, whereas that induced by SEP is dependent on mast cells alone. Stimulated mast cells release LTB4, IL-5 and IL-8 while MO release LTB4 and IL-8. The IL-5 and IL-8 release by the SAL or SEP-stimulated resident cells may act in an autocrine fashion, thus potentiating LTB4 release.

Reaching for the Holy Grail: insights from infection/cure models on the prospects for vaccines for Trypanosoma cruziinfection

Prevention of Trypanosoma cruzi infection in mammals likely depends on either prevention of the invading trypomastigotes from infecting host cells or the rapid recognition and killing of the newly infected cells byT. cruzi-specific T cells. We show here that multiple rounds of infection and cure (by drug therapy) fails to protect mice from reinfection, despite the generation of potent T cell responses. This disappointing result is similar to that obtained with many other vaccine protocols used in attempts to protect animals from T. cruziinfection. We have previously shown that immune recognition ofT. cruziinfection is significantly delayed both at the systemic level and at the level of the infected host cell. The systemic delay appears to be the result of a stealth infection process that fails to trigger substantial innate recognition mechanisms while the delay at the cellular level is related to the immunodominance of highly variable gene family proteins, in particular those of the trans-sialidase family. Here we discuss how these previous studies and the new findings herein impact our thoughts on the potential of prophylactic vaccination to serve a productive role in the prevention of T. cruziinfection and Chagas disease.

Ecological niche models and patterns of richness and endemism of the southern Andean genus Eurymetopum (Coleoptera, Cleridae)

Eurymetopum is an Andean clerid genus with 22 species. We modeled the ecological niches of 19 species with Maxent and used them as potential distributional maps to identify patterns of richness and endemicity. All modeled species maps were overlapped in a single map in order to determine richness. We performed an optimality analysis with NDM/VNDM in a grid of 1º latitude-longitude in order to identify endemism. We found a highly rich area, located between 32º and 41º south latitude, where the richest pixels have 16 species. One area of endemism was identified, located in the Maule and Valdivian Forest biogeographic provinces, which extends also to the Santiago province of the Central Chilean subregion, and contains four endemic species (E. parallelum, E. prasinum, E. proteus, and E. viride), as well as 16 non-endemic species. The sympatry of these phylogenetically unrelated species might indicate ancient vicariance processes, followed by episodes of dispersal. Based on our results, we suggest a close relationship between these provinces, with the Maule representing a complex area.

A bench arc-furnace facility for fullerene and single-wall nanotubes synthesis

A metallic-sample arc-furnace was modified to synthesize fullerenes and nanotubes. The (reversible) changes and the process for producing single-wall nanotubes (SWNTs) are described.

Models for the estimation of thermodynamic properties of layered double hydroxides: application to the study of their anion exchange characteristics

Several models for the estimation of thermodynamic properties of layered double hydroxides (LDHs) are presented. The predicted thermodynamic quantities calculated by the proposed models agree with experimental thermodynamic data. A thermodynamic study of the anion exchange process on LDHs is also made using the described models. Tables for the prediction of monovalent anion exchange selectivities on LDHs are provided. Reasonable agreement is found between the predicted and the experimental monovalent anion exchange selectivities.

Structural and reactivity analyses of 2-benzylamino-1,4-naphthoquinone by X-ray characterization, electrochemical measurements, and dft single-molecule calculations

This study represents an integrated approach towards understanding the electronic and structural aspects of 2-benzylamino-1,4-naphthalenedione, a representative 2-amino-napfthoquinone. To this end, theoretical calculations performed at the B3PW91/6-31+G(d) level of density functional theory, electrochemical and X-ray structural investigation were employed. Two intramolecular H-bonds and other two intermolecular H-bonds were observed, including non-classical interactions. Cyclic voltammogram (CV) and differential pulse voltammetry (DPV) show two pairs of peaks, being each one a monoelectronic process.

ALLOMETRIC MODELS FOR ESTIMATING ABOVEGROUND BIOMASS AND BIOMASS ALLOCATION OF CAPIXINGUI TREES (Croton floribundus Spreng.) IN AN AGRISILVICULTURAL SYSTEM

ABSTRACT The objective of this study was to select allometric models to estimate total and pooled aboveground biomass of 4.5-year-old capixingui trees established in an agrisilvicultural system. Aboveground biomass distribution of capixingui was also evaluated. Single- (diameter at breast height [DBH] or crown diameter or stem diameter as the independent variable) and double-entry (DBH or crown diameter or stem diameter and total height as independent variables) models were studied. The estimated total biomass was 17.3 t.ha-1, corresponding to 86.6 kg per tree. All models showed a good fit to the data (R2ad > 0.85) for bole, branches, and total biomass. DBH-based models presented the best residual distribution. Model lnW = b0 + b1* lnDBH can be recommended for aboveground biomass estimation. Lower coefficients were obtained for leaves (R2ad > 82%). Biomass distribution followed the order: bole>branches>leaves. Bole biomass percentage decreased with increasing DBH of the trees, whereas branch biomass increased.

Mathematical models to describe the volumetric shrinkage rate of red beans during drying

The present study aimed to determine the volumetric shrinkage rate of bean (Phaseolus vulgaris L.) seeds during air-drying under different conditions of air, temperature and relative humidity, and to adjust several mathematical models to the empiric values observed, and select the one that best represents the phenomenon. Six mathematical models were adjusted to the experimental values to represent the phenomenon. It was determined the degree of adjustment of each model from the value of the coefficient of determination, the behavior of the distribution of the residuals, and the magnitude of the average relative and estimated errors. The rate of volumetric shrinkage that occurred in bean seeds during drying is between 25 and 37%. It basically depends on the final moisture content, regardless of the air conditions during drying. The Modified Bala & Woods' model best represented the process.

Application of simulated annealing in simulation and optimization of drying process of Zea mays malt

Kinetic simulation and drying process optimization of corn malt by Simulated Annealing (SA) for estimation of temperature and time parameters in order to preserve maximum amylase activity in the obtained product are presented here. Germinated corn seeds were dried at 54-76 °C in a convective dryer, with occasional measurement of moisture content and enzymatic activity. The experimental data obtained were submitted to modeling. Simulation and optimization of the drying process were made by using the SA method, a randomized improvement algorithm, analogous to the simulated annealing process. Results showed that seeds were best dried between 3h and 5h. Among the models used in this work, the kinetic model of water diffusion into corn seeds showed the best fitting. Drying temperature and time showed a square influence on the enzymatic activity. Optimization through SA showed the best condition at 54 ºC and between 5.6h and 6.4h of drying. Values of specific activity in the corn malt were found between 5.26±0.06 SKB/mg and 15.69±0,10% of remaining moisture.

Comparison of diffusion models for description of osmotic dehydration of radish slices dipped in brine

ABSTRACT This paper aims at describing the osmotic dehydration of radish cut into cylindrical pieces, using one- and two-dimensional analytical solutions of diffusion equation with boundary conditions of the first and third kind. These solutions were coupled with an optimizer to determine the process parameters, using experimental data. Three models were proposed to describe the osmotic dehydration of radish slices in brine at low temperature. The two-dimensional model with boundary condition of the third kind well described the kinetics of mass transfers, and it enabled prediction of moisture and solid distributions at any given time.

AGRICULTURAL MACHINERY AND IMPLEMENTS DESIGN PROCESS: GUIDELINES FOR SMALL AND MID-SIZED BUSINESSES

ABSTRACT This study aims at presenting the process of machine design and agricultural implements by means of a reference model, formulated with the purpose of explaining the development activities of new products, serving as a guideline to coach human resources and to assist in formalizing the process in small and medium-sized businesses (SMB), i.e. up to 500 employees. The methodology used included the process modeling, carried out from case studies in the SMB, and the study of reference models in literature. The modeling formalism used was based on the IDEF0 standard, which identifies the dimensions required for the model detailing: input information; activities; tasks; knowledge domains; mechanisms; controls and information produced. These dimensions were organized in spreadsheets and graphs. As a result, a reference model with 27 activities and 71 tasks was obtained, distributed over four phases of the design process. The evaluation of the model was carried out by the companies participating in the case studies and by experts, who concluded that the model explains the actions needed to develop new products in SMB.

On the Efficiency of Alternatives in Process Plans

Process planning is a very important industrial activity, since it determines how a part or a product is manufactured. Process planning decisions include machine selection, tool selection, and cutting conditions determination, and thus it is a complex activity. In the presence of unstable demand, flexibility has become a very important characteristic of today's successful industries, for which Flexible Manufacturing Systems (FMSs) have been proposed as a solution. However, we believe that FMS control software is not flexible enough to adapt to different manufacturing system conditions aiming at increasing the system's efficiency. One means to overcome this limitation is to include pre-planned alternatives in the process plan; then planning decisions are made by the control system in real time to select the most appropriate alternative according to the conditions of the shop floor. Some of the advantages of this approach reported in the literature are the reduction of the number of tool setups, and the selection of a replacement machine for executing an operation. To verify whether the presence of alternatives in process plans actually increases the efficiency of the manufacturing system, an investigation was carried out using simulation and design of experiments techniques for alternative plans on a single machine. The proposed methodology and the results are discussed within this paper.

P-selectin, carcinoma metastasis and heparin: novel mechanistic connections with therapeutic implications

Metastasis is a multistep cascade initiated when malignant cells penetrate the tissue surrounding the primary tumor and enter the bloodstream. Classic studies indicated that blood platelets form complexes around tumor cells in the circulation and facilitate metastases. In other work, the anticoagulant drug heparin diminished metastasis in murine models, as well is in preliminary human studies. However, attempts to follow up the latter observation using vitamin K antagonists failed, indicating that the primary mechanism of heparin action was unrelated to its anticoagulant properties. Other studies showed that the overexpression of sialylated fucosylated glycans in human carcinomas is associated with a poor prognosis. We have now brought all these observations together into one mechanistic explanation, which has therapeutic implications. Carcinoma cells expressing sialylated fucosylated mucins can interact with platelets, leukocytes and endothelium via the selectin family of cell adhesion molecules. The initial organ colonization of intravenously injected carcinoma cells is attenuated in P-selectin-deficient mice, in mice receiving tumor cells pretreated with O-sialoglycoprotease (to selectively remove mucins from cell surfaces), or in mice receiving a single dose of heparin prior to tumor cell injection. In each case, we found that formation of a platelet coating on cancer cells was impeded, allowing increased access of leukocytes to the tumor cells. Several weeks later, all animals showed a decrease in the extent of established metastasis, indicating a long-lasting effect of the short-term intervention. The absence of obvious synergism amongst the three treatments suggests that they all act via a common pathway. Thus, a major mechanism of heparin action in cancer may be inhibition of P-selectin-mediated platelet coating of tumor cells during the initial phase of the metastatic process. We therefore suggest that heparin use in cancer be re-explored, specifically during the time interval between initial visualization of a primary tumor until just after definitive surgical removal.