Construção e estudos de perfomance de um reator fotoquímico tipo CPC ("Compound Parabolic Concentrator")

A CPC (Compound Parabolic Concentrator) reactor was projected and constructed aiming to promote the degradation of the organic matter present in considerable volumes of aqueous effluents, under the action of solar radiation. The essays were done using a model effluent which consists of a mixture of fragments of a sodium salt of lignosulphonic acid possessing a mean molecular weigth of 52,000 Daltons, and a real effluent, from a chip board industry. The volume of effluent in each test was about 50 L. The tests involved heterogeneous (TiO2 P25 Degussa and formulations made from the association of TiO2 with a photosensitiser), and homogeneous (thermal and photochemical Fenton reactions) catalysis of the effluents. The results demonstrate the viability of application of this kind of reactor even when the load of organic pollutants is high.

Um reator fotoquímico barato e eficiente para experimentos de química

In this work, we present an efficient and inexpensive device for undergraduate chemistry classes aimed at teaching and learning the photolytic synthesis concepts. A photochemical reactor was tested for the synthesis of the organometallic compound enneacarbonyldiiron from iron pentacarbonyl in acetic acid, and its formation evidenced by FTIR analysis. Although similar devices have been described in other studies, none of these offered the simplicity, low cost, class-compatible reaction times and good yields afforded by the procedure reported herein.

Aplicação da radiação ultravioleta como forma de contribuição para a química verde e construção de um reator fotoquímico alternativo e de baixo custo, para pré-tratamento de amostras

Ultraviolet radiation corresponds to a fraction of electromagnetic radiation, covering wavelengths between 1 and 400 nm. Methods based on UV irradiation have become popular because it is possible to treat samples simply by applying energy, avoiding procedures that require the use of toxic substances, thus contributing to the development of Green Chemistry. This study aimed to assess the main applications of UV radiation reported in the literature and thoroughly described the construction of an alternative and low-cost photochemical reactor to be used for the pretreatment of samples in the laboratory. The use of this new photochemical reactor in the clean-up of milk samples for spectrofluorimetric measurements was also reported.

Tensão térmica e taxa de reação em um reator para gaseificação de biomassa do tipo concorrente

A conversão da energia química da biomassa em outras formas de energia pode ser processada de diversas maneiras. Dentre essas, encontra-se a gaseificação, que utiliza reatores para conversão da biomassa em gás combustível. Para o dimensionamento de um gaseificador e seus constituintes, vários fatores devem ser levados em consideração, desde as características do combustível até as reais necessidades de energia térmica liberada. Especificamente no dimensionamento da grelha, alguns índices servem de referência, como a tensão térmica e a taxa de reação. Este trabalho teve como objetivos determinar a taxa de reação e a tensão térmica de uma grelha plana utilizada em um gaseificador bem como comparar os valores obtidos com aqueles recomendados para o dimensionamento de grelhas em fornalhas. Foi utilizado um gaseificador de biomassa de fluxo concorrente de pequena escala, ao qual foi acoplada uma câmara para combustão do gás produzido. O combustível utilizado foi toretes de eucalipto, em pedaços com diâmetro de 4 a 8 cm e comprimento de 10 a 20 cm. Conclui-se que os índices de taxa de reação e tensão térmica encontrados podem ser utilizados como parâmetros para o dimensionamento de grelhas de gaseificadores de leito fixo.

Remoção de compostos nitrogenados e fosfatados de efluentes por meio de reator anaeróbico com fluxo ascendente

O objetivo deste trabalho foi avaliar a remoção de compostos nitrogenados e fosfatados e da carga orgânica poluidora oriunda de cultivo heterotrófico de camarão marinho, por meio de reator anaeróbico. Foi construído um reator com fluxo ascendente, em que os efluentes de entrada e saída foram avaliados continuamente durante 120 horas, com três repetições. Os parâmetros físicos e químicos avaliados foram: temperatura, pH, condutividade, ortofosfato, nitrito, nitrato, amônia, demanda química de oxigênio e sólidos totais. O reator permaneceu estável, com boas condições de retenção de sólidos. O reator anaeróbico removeu 96,7% do nitrogênio amoniacal e 91% de ortofosfatos dos efluentes de cultivo de camarão marinho, o que mostra que os efluentes tratados estão dentro dos limites estabelecidos pela legislação.

O comportamento Fotoquímico dos Complexos Pentaaminas de Rutênio(II) com Ligantes π Insaturados

A general overview on the photochemical behaviour of [Ru(NH3)5L]2+ complexes (where L is a p ligand) is presented. The proposed mechanisms and techniques employed for the study of these reactions are discussed. Emphasis is made on the mechanisms that allow the identification of the reactive excited state of the [Ru(NH3)5py]2+ complex.

Otimização de um mecanismo fotoquímico para a simulação da atmosfera urbana brasileira

A photochemical reaction mechanism for the description of air quality in Brazilian urban regions is described and evaluated by comparison with chamber experiments. The mechanism was developed for use in ozone modeling and application of control strategies. The oxidation of ethanol and methyl-ter-butyl-ether is also considered. Using this chemical model, a trajectory simulation of Brazil Avenue, Rio de Janeiro, was performed. The model predicts that ozone should reach a maximum of 22.4 ppb at 14:57 h. This value is in good agreement with the experimental measurements of 22.5 ppb for 14:00 h and 22.3 ppb for 15:00 h.

Determinação espectrofotométrica de aspartame em adoçantes por injeção em fluxo usando um reator em fase sólida contendo fosfato de zinco imobilizado

A flow injection spectrophotometric method was developed for determining aspartame in sweeteners. Sample was dissolved in water and 250 µL of the solution was injected into a carrier stream of 5.0 x 10-5 mol L-1 sodium borate solution. The sample flowed through a column (14 cm x 2.0 mm) packed with Zn3(PO4)2 immobilized in a polymeric matrix of polyester resin and Zn(II) ions were released from the solid-phase reactor by formation of the Zn(II)-aspartame complex. The mixture merged with a stream of borate buffer solution (pH 9.0) containing 0.030 % (m/v) alizarin red S and the Zn(II)-alizarin red complex formed was measured spectrophotometrically at 540 nm. The calibration graph for aspartame was linear in the concentration range from 10 to 80 µg mL-1 with a detection limit of 4 µg mL-1 of aspartame. The RSD was 0.3 % for a solution containing 40 µg mL-1 aspartame (n = 10) and seventy results were obtained per hour. The proposed method was applied for determining aspartame in commercial sweeteners.

Construção e otimização de um reator de baixo custo para a fotodegradação da matéria orgânica em águas naturais e sua aplicação no estudo da especiação do cobre por voltametria

This work describes the construction of a home-made low-cost reactor, using easily available materials, capable of destroying efficiently dissolved organic matter. Just 30 minutes of irradiation were sufficient to destroy more than 99% of the humic acids present in a solution of 4 mg C L-1. Copper speciation was evaluated in natural waters of different salinities to test the reactor's efficiency in destroying organically complexed metal species. The effect of the organic matter concentration, salinity, dissolved oxygen and temperature in the photo-oxidation process is discussed.

Influência do meio reacional no comportamento fotoquímico do inseticida paration etílico

The photodegradation of parathion in natural and dezionised waters was studied under irradiation at two different wavelengths: 280 nm and 313 nm. The influence of humic acids was evaluated. The results demonstrated that the degradation occurred only due to photochemical processes. The chemical hydrolysis and biological processes can be neglected in this case. The addition of humic acids did not increase the photodegradation rate in either water samples (natural or dezionised). In alkaline solutions the photodegradation rate was higher in dezionised water when compared to natural waters. The kinetic degradation in all experiments obeyed a first order reaction pattern.

Proposição de um reator fotocatalítico para destruição de microrganismos em ambientes interiores

The TiO2/UV photocatalytic reactor was investigated as an alternative system to inactivate airborne microorganisms. The experiments performed in the absence of the catalyst showed that direct photolysis was not efficient to destruct microorganisms, with only 30% of inactivation. Similar inactivation percentage was obtained using TiO2 in absence of UV radiation. The destruction of microorganisms present in a contaminated indoor atmosphere, using the combination of TiO2/UV was very efficient, reaching more than 98% of destruction.

Determinação turbidimétrica de dipirona em fluxo utilizando um reator contendo cloreto de prata imobilizado em resina poliéster

A simple flow injection procedure was developed for determining dipyrone (1-phenyl-2,3-dimethyl-4-methylaminomethano-5-pyrazolone sodium, metamizol, analgin) in pharmaceutical formulations. The determination is based on the reduction of Ag+ ions to Ag0 by dipyrone. A colloidal suspension of Ag0 produced was transported by carrier solution (0.01 mol L-1 NaOH) and turbidimetrically detected at 425 nm. The analytical curve for dipyrone was linear in the range from 5.0 x 10-4 to 2.5 x 10-3 mol L-1 with a correlation coefficient of 0.9990. The detection limit was 1.3 x 10-4 mol L-1 (3sigmaB/slope). The relative standard deviation for ten successive measurements was 1.8% and an analytical frequency of 45 h-1 was obtained. The recovery values from three samples ranged from 96.0 to 102%.

Reator de membrana enzimático e fluidos supercríticos: associação de processos

The aim of this work is to present the new applications of membrane technology in fat and oil processing, with emphasis on development and applications of the enzymatic membrane reactor and its association with extraction and purification technology by supercritical fluids (SCF). Combining the extraction by SCFs and the separation by membranes allows the integration of extractions reactions with selective separation by membranes through filtration of the supercritical mixture (SCF + extracted solutes). This association provides important energy savings regarding the SCF recompression costs.

Degradação de corantes ácidos por processos oxidativos avançados usando um reator com disco rotatório de baixa velocidade

Three technologies were tested (TiO2/UV, H2O2/UV, and TiO2/H2O2/UV) for the degradation and color removal of a 25 mg L-1 mixture of three acid dyes: Blue 9, Red 18, and Yellow 23. A low speed rotating disc reactor (20 rpm) and a H2O2 concentration of 2.5 mmol L-1 were used. The dyes did not significantly undergo photolysis, although they were all degraded by the studied advanced oxidation processes. With the TiO2/H2O2/UV process, a strong synergism was observed (color removal reached 100%). Pseudo first order kinetic constants were estimated for all processes, as well as the respective apparent photonic efficiencies.

Estudo da degradação de ranitidina via H2O2 eletrogerado/Fenton em um reator eletroquímico com eletrodos de difusão gasosa

The study of the electrochemical degradation of the ranitidine was developed using an electrochemical reactor with a gas diffusion electrode (GDE) as cathode. The electrolysis experiments was performed at constant current (1 < A < 10) and flow rate of 200 L h-1. The process of drug degradation, chemical/electrochemical and electro-Fenton ways, using electrochemical reactor showed best efficiency at current values of > 4 A. The process reached a production of 630 mg L-1 of the H2O2 at 7 A. The ranitidine concentrations was reduced in 99.9% (HPLC) and chemical oxygen demand (COD) was reduced in 86.7% by electro-Fenton.