Modelling head loss along emitting pipes using dimensional analysis

Local head losses must be considered in estimating properly the maximum length of drip irrigation laterals. The aim of this work was to develop a model based on dimensional analysis for calculating head loss along laterals accounting for in-line drippers. Several measurements were performed with 12 models of emitters to obtain the experimental data required for developing and assessing the model. Based on the Camargo & Sentelhas coefficient, the model presented an excellent result in terms of precision and accuracy on estimating head loss. The deviation between estimated and observed values of head loss increased according to the head loss and the maximum deviation reached 0.17 m. The maximum relative error was 33.75% and only 15% of the data set presented relative errors higher than 20%. Neglecting local head losses incurred a higher than estimated maximum lateral length of 19.48% for pressure-compensating drippers and 16.48% for non pressure-compensating drippers.

Two-Phase (Solid-Liquid) Flow in Inclined Pipes

This paper presents an experimental research about the behavior of two-phase flows in inclined pipes. The inclination angle varied from 5° to 45° and the slurry solid concentration varied up to 15%. It was concluded that the head losses of the downward sloping pipe flow are always lower than the head losses of the horizontal flow and these are always lower than the head losses of the upward sloping pipe flow, regardless the concentration and inclination angle. It was possible to develop empirical equations to calculate the head losses of the horizontal flow and the upward and downward sloping pipe flows.

Aspectos ultraestruturais de hemócitos de Biomphalaria glabrata Say (1818) (Gastropoda: Planorbidae) analisados sob microscopia eletrônica de transmissão

Os hemócitos do caramujo Biomphalaria glabrata, um importante transmissor do trematódeo Schistosoma mansoni no Brasil, foram coletados de especimens na região Bragantina, localizada a oeste do estado do Pará. Os hemócitos foram examinados por meio de microscopia eletrônica de transmissão. As células foram fixadas pelo método de rotina com o uso do tampão PHEM (PIPES, HEPES, EGTA e Magnésio). Foram descritos os aspectos ultra-estruturais celulares como inclusões citoplasmáticas limitadas por membranas, mitocôndrias, retículos endoplasmáticos e outros. As observações mostram que esse tampão possui a propriedade de preservação do citoesqueleto celular, apresentando bons resultados na preservação das estruturas dos hemócitos e suas organelas.

Optimization and inhibition of the adherent ability of Plasmodium falciparum-infected erythrocytes

The vast majority of the 1-2 million malaria associated deaths that occur each year are due to anemia and cerebral malaria (the attachment of erythrocytes containing mature forms of Plasmodium falciparum to the endothelial cells that line the vascular beds of the brain). A "model" system"for the study of cerebral malaria employs amelanotic melanoma cells as the "target"cells in an vitro cytoadherence assay. Using this model system we determined that the optimum pH for adherence is 6.6 to 6.8, that high concentrations of Ca²* (50mM) result in increased levels of binding, and that the type of buffer used influences adherence (Bis Tris > MOPS > HEPES > PIPES). We also observed that the ability of infected erythrocytes to cytoadhere varied from (erythrocyte) donor to donor. We have produced murine monoclonal antibodies against P. falciparum-infected red cells which recognized modified forms of human band 3; these inhibit the adherence of infected erythrocytes to melanoma cells in a doso responsive fashion. Antimalarials (chloroquine, quinacrine, mefloquine, artemisinin), on the other hand, affected adherence in an indirect fashion i.e. since cytoadherence is due, in part to the presence of knobs on the surface of the infected erythrocyte, and knob formation is dependent on intracellular parasite growth, when plasmodial development is inhibited so is knob production, and consequently adherence is ablated.

Teores de nitrato (NO3-) e amônio (NH4+) nas águas do aqüífero Barreiras nos bairros do Reduto, Nazaré e Umarizal - Belém/PA

This paper evaluates the occurrence of nitrate and ammonium in the Barreiras aquifer in the metropolitan area of Belém, Pará State, Brazil. The results show that some wells display ammonium and nitrate concentrations above or close to the limits of water potability regulations. The main cause of the pollution of these waters is related the local disposal of domestic effluents and/or leakage from pipes of old sewage systems.

Fatores químicos e físicos que afetam a contaminação por chumbo e cobre em água potável: uma abordagem para o estudo de caso em química analítica

Lead and copper concentrations in drinking water increase considerably on going from municipality reservoirs to the households sampled in Ribeirão Preto (SP-Brazil). Flushing of only 3 liters of water reduced metal concentrations by more than 50%. Relatively small changes in water pH rapidly affected corrosion processes in lead pipes, while water hardness appeared to have a long-term effect. This approach aims to encourage University teachers to use its content as a case study in disciplines of Instrumental Analytical Chemistry and consequently increase knowledge about drinking water contamination in locations where no public monitoring of trace metals is in place.

Economic optimization method to design telescope irrigation of multiples outlets

In this study is presented an economic optimization method to design telescope irrigation laterals (multidiameter) with regular spaced outlets. The proposed analytical hydraulic solution was validated by means of a pipeline composed of three different diameters. The minimum acquisition cost of the telescope pipeline was determined by an ideal arrangement of lengths and respective diameters for each one of the three segments. The mathematical optimization method based on the Lagrange multipliers provides a strategy for finding the maximum or minimum of a function subject to certain constraints. In this case, the objective function describes the acquisition cost of pipes, and the constraints are determined from hydraulic parameters as length of irrigation laterals and total head loss permitted. The developed analytical solution provides the ideal combination of each pipe segment length and respective diameter, resulting in a decreased of the acquisition cost.

Solar energy use for water pre-heating in boilers of agro-industries

Energy consumption in the world has been growing every year. The industrial sector represents 27.32% of the world energy demand. Heating systems that use solar energy may contribute with a percentage of the total energy required by industries. This work aimed to study the use of vacuum solar collectors for water pre-heating in boilers. We used four collectors installed according to NBR 15,569; water flow through the tubes was 0.058 L/s, and temperature in the inlet and outlet pipes was measured. Results showed that instantaneous radiation, and inlet fluid and room temperatures are variables that influence the process, reaching water maximum temperature in the solar collector outlet of 97.9 °C, and efficiency of approximately 65% for most experiments. For the financial viability evaluation, the payback study was applied, which resulted in 4; 7 and 5 years, for the respective sources: firewood, LPG (liquefied petroleum gas), and electricity. Regarding the calculation of the annual contribution to the reduction of greenhouse gases, it was, respectively, 2.162 and 356 kg of CO2 per m² of collector tubes, in comparison with firewood and LPG.

Poultry carcass decomposition and physicochemical analysis of compounds in different Composter types

This study aimed to assess five composter types in poultry carcasses decomposition and to perform a physicochemical analysis of the compounds obtained. Composter types used were six-hole brick, wood, screen, windrow with three PVC pipes with six holes and windrow with three PVC pipes with 10 holes. Composting was followed by four periods using wood shaving like substrate with one bird carcass placed in each composter. Pile turning was performed every 10 days and temperature in each layer was measured on 1st, 7th, 14th, 19th and 29th day, at 3 p.m., as well as room temperature. Temperature during pile turning was also measured at five points per layer and carcass weighing performed to calculate decomposition percentage. Physicochemical parameters evaluated in substrates were moisture, ash, phosphorus, potassium, nitrogen, pH, organic carbon and C/N ratio, up to 30 days. Data were analyzed by repeated measures model, using MIXED method of SAS software. All values of final physicochemical composition of substrates were found according to values of IN-25, except nitrogen. The composter types were efficient in decomposition of poultry carcasses.

Buckling analysis of PVC sheets with RIB

This study has a technical and applied character. A PVC structured wall pipe can be produced by spirally winding a ribbed sheet having a male-female lock, chemically welded by an adhesive. These pipes are "flexible" and are used mainly in underground installations, to convey fluids in free duct regime. Initial studies have indicated that the buckling resistance of the ribs from the sheet coiling to the tube manufacturing is the critical design parameter. This study presents the theoretical analytical development in order to obtain the critical buckling moment of these sheets. This analysis uses concepts initially developed to calculate buckling resistance in monosymmetrical profiles that are very used in the metallic structure industry. Since the material used was PVC, that has different mechanical properties than steel and aluminum, it was necessary to consider the differences in the analytical treatment. It is important to emphasize that the results obtained are product of the co-operative work of engineers from industry and university.

Effects of nutrient impoverishment on phytoplankton biomass: a mesocosms experimental approach in a shallow eutrophic reservoir (Garças Pond), São Paulo, southeast Brazil

Nutrient impoverishment in mesocosms was carried out in a shallow eutrophic reservoir aiming to evaluate the nutrient removal technique as a method for eutrophication reduction. Garças Pond is located in the Parque Estadual das Fontes do Ipiranga Biological Reserve situated in the southeast region of the municipality of São Paulo. Three different treatments were designed, each consisting of two enclosures containing 360 liters of water each. Mesocosms were made of polyethylene bags and PVC pipes, and were attached to the lake bottom. Treatment dilutions followed Carlson's trophic state index modified by Toledo and collaborators, constituting the oligotrophic, mesotrophic, and eutrophic treatments. Ten abiotic and 9 biological samplings were carried out simultaneously. Trophic states previously calculated for the treatments were kept unaltered during the entire experiment period, except for the mesotrophic mesocosms in which TP reached oligotrophic concentrations on the 31st day of the experiment. In all three treatments a reduction of DO was observed during the study period. At the same time, NH4+ and free CO2 rose, indicating decomposition within the enclosures. Nutrient impoverishment caused P limitation in all three treatments during most of the experiment period. Reduction of algal density, chlorophyll a, and phaeophytin was observed in all treatments. Competition for nutrients led to changes in phytoplankton composition. Once isolated and diluted, the mesocosms' trophic state did not change. This led to the conclusion that isolation of the allochthonous sources of nutrients is the first step for the recovery of the Garças Pond.