Rapid detection by transmission electron microscopy of mycoplasma contamination in sera and cell cultures

Transmission electon microscopy has been employed for the rapid detection of mycoplasma in sera and cell cultures. High speed centrifugation of sera or low speed centrifugation of cell debris, followed by negative staining of the resuspended pellet, detected mycoplasma contamination more frequently than a culture method followed by direct fluorescence (DAPI), which was used as a control procedure. The appearance of the mycoplasma cell border and content gives some information about particle viability.

Toxoplasma gondii: a rapid method for the isolation of pure tachyzoites: preliminary characterization of its genome

A rapid and simple technique for the purification of Toxoplasma gondii tachyzoites was developed. Highly purified parasites were obtained from the peritoneal exudates of infected mice by means of two consecutive discontinous sucrose gradients run at low speed (10,000xg, 30 min). Parasites obtained by this method conserved its biological activity. Hybridizations tudies with DNA from healthy mice and from purified tachyzoites preparations demonstrated that Toxoplasma gondii tachyzoites DNA could be obtained with better than 90 per cents purity. Preliminary studies with DNA endonucleases showed the presence in the tachyzoites genome of highly repetitives sequences.

Performance of a reciprocal shaker in mechanical dispersion of soil samples for particle-size analysis

The dispersion of the samples in soil particle-size analysis is a fundamental step, which is commonly achieved with a combination of chemical agents and mechanical agitation. The purpose of this study was to evaluate the efficiency of a low-speed reciprocal shaker for the mechanical dispersion of soil samples of different textural classes. The particle size of 61 soil samples was analyzed in four replications, using the pipette method to determine the clay fraction and sieving to determine coarse, fine and total sand fractions. The silt content was obtained by difference. To evaluate the performance, the results of the reciprocal shaker (RSh) were compared with data of the same soil samples available in reports of the Proficiency testing for Soil Analysis Laboratories of the Agronomic Institute of Campinas (Prolab/IAC). The accuracy was analyzed based on the maximum and minimum values defining the confidence intervals for the particle-size fractions of each soil sample. Graphical indicators were also used for data comparison, based on dispersion and linear adjustment. The descriptive statistics indicated predominantly low variability in more than 90 % of the results for sand, medium-textured and clay samples, and for 68 % of the results for heavy clay samples, indicating satisfactory repeatability of measurements with the RSh. Medium variability was frequently associated with silt, followed by the fine sand fraction. The sensitivity analyses indicated an accuracy of 100 % for the three main separates (total sand, silt and clay), in all 52 samples of the textural classes heavy clay, clay and medium. For the nine sand soil samples, the average accuracy was 85.2 %; highest deviations were observed for the silt fraction. In relation to the linear adjustments, the correlation coefficients of 0.93 (silt) or > 0.93 (total sand and clay), as well as the differences between the angular coefficients and the unit < 0.16, indicated a high correlation between the reference data (Prolab/IAC) and results obtained with the RSh. In conclusion, the mechanical dispersion by the reciprocal shaker of soil samples of different textural classes was satisfactory. The results allowed recommending the use of the equipment at low agitation for particle size- analysis. The advantages of this Brazilian apparatus are its low cost, the possibility to simultaneously analyze a great number of samples using ordinary, easily replaceable glass or plastic bottles.

Degradação de corantes ácidos por processos oxidativos avançados usando um reator com disco rotatório de baixa velocidade

Three technologies were tested (TiO2/UV, H2O2/UV, and TiO2/H2O2/UV) for the degradation and color removal of a 25 mg L-1 mixture of three acid dyes: Blue 9, Red 18, and Yellow 23. A low speed rotating disc reactor (20 rpm) and a H2O2 concentration of 2.5 mmol L-1 were used. The dyes did not significantly undergo photolysis, although they were all degraded by the studied advanced oxidation processes. With the TiO2/H2O2/UV process, a strong synergism was observed (color removal reached 100%). Pseudo first order kinetic constants were estimated for all processes, as well as the respective apparent photonic efficiencies.

Time motion analysis of football (soccer) referees during official matches in relation to the type of fluid consumed

The aim of the present study was to determine the effect of volume and composition of fluid replacement on the physical performance of male football referees. Ten referees were evaluated during three official matches. In one match the participants were asked to consume mineral water ad libitum, and in the others they consumed a pre-determined volume of mineral water or a carbohydrate electrolyte solution (6.4% carbohydrate and 22 mM Na+) equivalent to 1% of their baseline body mass (half before the match and half during the interval). Total water loss, sweat rate and match physiological performance were measured. When rehydrated ad libitum (pre-match and at half time) participants lost 1.97 ± 0.18% of their pre-match body mass (2.14 ± 0.19 L). This parameter was significantly reduced when they consumed a pre-determined volume of fluid. Sweat rate was significantly reduced when the referees ingested a pre-determined volume of a carbohydrate electrolyte solution, 0.72 ± 0.12 vs 1.16 ± 0.11 L/h ad libitum. The high percentage (74.1%) of movements at low speed (walking, jogging) observed when they ingested fluid ad libitum was significantly reduced to 71% with mineral water and to 69.9% with carbohydrate solution. An increase in percent movement expended in backward running was observed when they consumed a pre-determined volume of carbohydrate solution, 7.7 ± 0.5 vs 5.5 ± 0.5% ad libitum. The improved hydration status achieved with the carbohydrate electrolyte solution reduced the length of time spent in activities at low-speed movements and increased the time spent in activities demanding high-energy expenditure.

Low efficacy of azithromycin to treat cutaneous leishmaniasis in Manaus, AM, Brazil

An open trial to evaluate the azithromycin efficacy in cutaneous leishmaniasis patients was carried out in Manaus (AM), where Leishmania (Viannia) guyanensis is the main etiologic agent. Forty-one patients with skin lesions of less than 12 weeks duration, without specific treatment for the last three months and a positive imprint to Leishmania sp. were included. From these, 31 (75.6%) were male with median age of 30.2. All of them received a daily-single oral dose of 500 mg of azithromycin for ten days. At 25th day, 16 (39%) presented therapeutic failure and received intramuscular pentavalent antimonial, four were considered lost, 21, that had improved or were inaltered received another ten-day series of azithromycin and were monthly followed, but nine (21.9%) of them presented a poor clinical response and switched to intramuscular pentavalent antimonial on day 55. Of the 12 remaining cases evaluated on day 55, despite of clinical improvement, three asked for antimony therapy and 9 (21.9%) continued the follow-up but, only three were cured on 55th, 85th and 115th days, and six did not come back for final evaluation. The intention-treatment overall response rate was 22% and whole cure was seen in three (7.3%) of cases. Thus, azithromycin showed a low efficacy to treat cutaneous leishmaniasis in Manaus.

Seeder-fertilizer machine: energetic demand as a function of vegetal covering handling and manure deposition shank depth in no-tillage system

The purpose of this work was evaluating the energetic demand of a seeder-fertilizer machine as a function of the type and handling of vegetal covering culture and of the fertilizer deposition shank depth. A Valtra BM100 tractor was used implemented to pull a high precision seeder-fertilizer machine with four ranks of seeding, spaced 0.9 m for maize culture. Experiment was conducted with design in randomized blocks in factorial plots, in the Laboratory of Machines and Agricultural Mechanization experimental area (LAMMA) of UNESP-Jaboticabal, using two covering cultures (black-mucuna and crotalaria), three handlings of this covering, two mechanical (straw crusher and roller knife) and one chemical (pulverization of herbicide), performed 120 days after seeding of covering cultures and three depths of fertilizer deposition shank, completing 18 treatments, with four repetitions, totaling 72 observations. Parameters of displacement speed, gliding, force on traction bar, peak force, power on pulling bar and fuel consumption were evaluated. It was possible to conclude that force on traction bar was less for depths of 0.11 and 0.14 m of fertilizer plough shank, the same occurring for peak force, power on traction bar and volumetric consumption. The specific consumption was lower at a depth of 0.17 m of fertilizer plough shank. Covering cultures and their handlings did not interfere in the performance of machines under inquiry.

A modified contour error controller for a high speed XY table

This article deals with a contour error controller (CEC) applied in a high speed biaxial table. It works simultaneously with the table axes controllers, helping them. In the early stages of the investigation, it was observed that its main problem is imprecision when tracking non-linear contours at high speeds. The objectives of this work are to show that this problem is caused by the lack of exactness of the contour error mathematical model and to propose modifications in it. An additional term is included, resulting in a more accurate value of the contour error, enabling the use of this type of motion controller at higher feedrate. The response results from simulated and experimental tests are compared with those of common PID and non-corrected CEC in order to analyse the effectiveness of this controller over the system. The main conclusions are that the proposed contour error mathematical model is simple, accurate, almost insensible to the feedrate and that a 20:1 reduction of the integral absolute contour error is possible.

Prevalence of low trauma fractures in long-term kidney transplant patients with preserved renal function

We evaluated the prevalence of low bone mineral density (BMD) and osteoporotic fractures in kidney transplantation (KT) patients and determined risk factors associated with osteoporotic fractures. The study was conducted on 191 patients (94 men and 97 women) with first KT for 3 years or more presenting stable and preserved renal function (serum creatinine levels lower than 2.5 mg/dl). KT patients were on immunosuppressive therapy and the cumulative doses of these drugs were also evaluated. BMD was determined by dual-energy X-ray absorptiometry at multiple sites (spine, femur and total body). Quantitative ultrasound of the calcaneus (broadband ultrasound attenuation, speed of sound, and stiffness index, SI) was also performed. Twenty-four percent (46) of all patients had either vertebral (29/46) or appendicular (17/46) fractures. We found osteoporosis and osteopenia in 8.5-13.4 and 30.9-35.1% of KT patients, respectively. Women had more fractures than men. In women, prevalent fractures were associated with diabetes mellitus [OR = 11.5, 95% CI (2.4-55.7)], time since menopause [OR = 3.7, 95% CI (1.2-11.9)], femoral neck BMD [OR = 1.99, 95% CI (1.4-2.8)], cumulative dose of steroids [OR = 1.1, 95% CI (1.02-1.12)] and low SI [OR = 1.1, 95% CI (1.0-1.2)]. In men, fractures were associated with lower lumbar spine BMD [OR = 1.75, 95% CI (1.1-2.7)], lower SI [OR = 1.1, 95% CI (1.03-1.13)], duration of dialysis [OR = 1.3, 95% CI (1.13-2.7)], and lower body mass index [OR = 1.24, 95% CI (1.1-1.4). Our results demonstrate high prevalence of low BMD and osteoporotic fractures in patients receiving a successful kidney transplant and indicate the need for specific intervention to prevent osteoporosis in this population.