61 resultados para FUEL ETHANOL
em Scielo Saúde Pública - SP
Resumo:
A method was developed for quantification of Cd and Pb in ethanol fuel by filter furnace atomic absorption spectrometry. Filter furnace was used to eliminate the need for chemical modification, to stabilize volatile analytes and to allow the application of short pyrolysis step. The determinations in samples were carried out against calibration solutions prepared in ethanol. Recovery tests were made in seven commercial ethanol fuel samples with values between 90 and 120%. Limits of detection were 0.1 µg L-1 for Cd and 0.3 µg L-1 for Pb. Certified water samples (APS 1071, APS 1033, NIST 1643d, NIST 1640) were also used to evaluate accuracy and recoveries from 86.8% to115% were obtained.
Resumo:
A square wave voltammetric method is described for the determination of acetaldehyde using the derivatization reaction with hydrazine sulphate, based on the reduction of hydrazone generated as a product that exhibits a single well-defined peak at -1.19V in acetate buffer at pH 5. Calibration graphs were obtained from 1.0 x 10-6 mol L-1 to 10 x 10-6 mol L-1 of acetaldehyde, using a reaction time of 8 min and a hidrazine concentration of 0.02 mol L-1. The detection limit was 2.38 x 10-7 mol L-1. The method was applied satisfactorily to the determination of total aldehyde in fuel ethanol samples without any pre-treatment.
Resumo:
OH LIF-thermometry was applied to premixed ethanol flames at atmospheric pressure in a burner for three flame conditions. Flame temperatures were simulated from energy equation with PREMIX code of CHEMKIN software package for comparison. A kinetic modeling based on a model validated through chemiluminescence measurements and on a set of reactions for nitrogen chemistry was evaluated. Marinov's mechanism was also tested. Sensitivity analysis was performed for fuel-rich flame condition with Φ = 1.34. Simulated temperatures from both reaction mechanisms evaluated were higher than experimental values. However, the proposed kinetic modeling resulted in temperature profiles qualitatively very close to the experimental.
Resumo:
We present in this work an experimental investigation of the effect of temperature (from 25 to 180 ºC) in the electro-oxidation of ethanol on platinum in two different phosphoric acid concentrations. We observed that the onset potential for ethanol electro-oxidation shifts to lower values and the reaction rates increase as temperature is increased for both electrolytes. The results were rationalized in terms of the effect of temperature on the adsorption of reaction intermediates, poisons, and anions. The formation of oxygenated species at high potentials, mainly in the more diluted electrolyte, also contributes to increase the electro-oxidation reaction rate.
Resumo:
OBJECTIVE: To assess the health risk of exposure to benzene for a community affected by a fuel leak. METHODS: Data regarding the fuel leak accident with, which occurred in the Brasilia, Federal District, were obtained from the Fuel Distributor reports provided to the environmental authority. Information about the affected population (22 individuals) was obtained from focal groups of eight individuals. Length of exposure and water benzene concentration were estimated through a groundwater flow model associated with a benzene propagation model. The risk assessment was conducted according to the Agency for Toxic Substances and Disease Registry methodology. RESULTS: A high risk perception related to the health consequences of the accident was evident in the affected community (22 individuals), probably due to the lack of assistance and a poor risk communication from government authorities and the polluting agent. The community had been exposed to unsafe levels of benzene (> 5 µg/L) since December 2001, five months before they reported the leak. The mean benzene level in drinking water (72.2 µg/L) was higher than that obtained by the Fuel Distributer using the Risk Based Corrective Action methodology (17.2 µg/L).The estimated benzene intake from the consumption of water and food reached a maximum of 0.0091 µg/kg bw/day (5 x 10-7 cancer risk per 106 individuals). The level of benzene in water vapor while showering reached 7.5 µg/m3 for children (1 per 104 cancer risk). Total cancer risk ranged from 110 to 200 per 106 individuals. CONCLUSIONS: The population affected by the fuel leak was exposed to benzene levels that might have represented a health risk. Local government authorities need to develop better strategies to respond rapidly to these types of accidents to protect the health of the affected population and the environment.
Resumo:
We studied the role of ethanol on the modulation of liver granulomata around Schistosoma mansoni eggs in mice. Albino mice, receiving 7% ethanol as the sole drinking liquid, at 60 and 90 days post-infection, presented smaller granulomata than controls did, when sacrificed at 120 days post-infection. No differences in diameters could be observed, when ethanol was given 4 months before up to 120 days after infection. The results suggested that modulation of schistosome granulomata by ethanol ingestion varies with time and duration of drug consumption.
Resumo:
Cryptococcosis is a worldwide disease caused by the etiological agent Cryptococcus neoformans. It affects mainly immunocompromised humans. It is relatively rare in animals only affecting those that have received prolonged antibiotic therapy. The propolis is a resin that can present several biological properties, including antibacterial, antifungal and antiviral activities. The standard strain C. neoformans ATTC 90112 was used to the antifungal evaluation. The tests were realized with propolis ethanol extract (PEE) G12 in concentrations from 0.1 to 1.6 mg mL-1. The evaluation of MIC and MFC were done according to DUARTE (2002)5. The inhibitory effect of PEE G12 on the fungal growing was seen at the concentration of 0.2 mg mL-1 and 1.6 mg mL-1 was considered a fungicidal one.
Resumo:
Fractionation of Piper nigrum ethanol extract, biomonitored by assays on pyrethroid-resistant Aedes aegypti larvae yielded isolation of the larvicidal amides piperolein-A and piperine. Comparing LC50 values, the ethanol extract (0. 98 ppm) was the most toxic, followed by piperolein-A (1. 46ppm) and piperine (1. 53ppm).
Resumo:
In this work, the analgesic and anti-inflammatory activities of Zeyheria montana Mart. ethanol leaf extract were investigated at doses of 75, 150 and 300 mg/kg body weight. In the analgesic assay, against a chemical stimulus in mice, acetic acid-induced writhes were significantly inhibited by the extract at doses of 75 mg/kg (67.27%), 150 mg/kg (49.38%) and 300 mg/kg (82.87%). Also, a vigorous decrease in hyperalgesia was observed when measured after 2 h and 6 h of lipopolysaccharide stimulation of rats for all doses of extract tested. Z. montana extract, at doses of 75 and 300 mg/kg, caused very slight central analgesia in rats submitted to thermal stimulus, particularly noticeable at 30 min following treatment. The anti-inflammatory activity of Z. montana extract on carrageenan-induced oedema in rats was evaluated. The oedema development, measured at 180 min following carrageenan intraplantar injection, was significantly reduced by all tested doses: 75 mg/kg (33.30%), 150 mg/kg (45.80%) and 300 mg/kg (75.00%). The LD50 value was greater than 2000 mg/kg. These results demonstrated that the ethanol extract from Z. montana leaf possesses anti-nociceptive and anti-inflammatory activities, which could be of relevance for the pharmacological control of pain and inflammatory processes.
Resumo:
The objective of this work was to assess the effects of Aspidosperma pyrifolium ethanol extracts on cabbage moth (Plutella xylostella) larvae. The ethanol extracts of the stem bark, fruits and roots of A. pyrifolium were obtained by classical phytochemical methods, and the resulting subfractions were tested on P. xylostella, using 4 and 5 mg L-1. The crude ethanol extract of the stem bark was more lethal. The alkaloid-rich aqueous subfraction derived from the stem bark extract caused 100% larval mortality at 4 mg L-1. Insecticidal activity was associated with the presence of the monoterpenoid indole alkaloids aspidofractinine, 15-demethoxypyrifoline, and N-formylaspidofractinine. These alkaloids presented excellent insecticidal properties against P. xylostella.
Resumo:
The objective of this work was to evaluate the impacts of spittlebug (Mahanarva fimbriolata) attack on sugarcane quality and ethanol production. Technological and microbiological parameters of juice and fermentation process were evaluated in ten fermentation cycles and two harvest seasons. Treatments consisted of different spittlebug stalk damage levels: control, with 100% of apparently healthy stalks; medium, with 15% of damaged or dry stalks (DDS); high, with 30% of DDS; and very high, with 60% of DDS. Spittlebug attack caused significant losses in cane quality, reducing total soluble solids, sucrose content, total reducing sugars, and pH, and increasing total phenolic compounds, and total and volatile juice acidity. The fermentation process was also significantly affected, resulting in lower ethanol content in wine. There was an increase in acetaldehyde concentration in the distillate. The spittlebug attack caused negative impacts on sugarcane quality and fermentation process, and these impacts are stronger in late season harvests.
Resumo:
Mauritia vinifera (buriti) is a palm tree that grows wild in different areas of Brazil, particularly in the Amazonian region. The buriti oil is rich in carotenoids, especially in β-carotene. The growing interest in other natural sources of β-carotene has stimulated the industrial use of buriti as a raw material for pulp oil extraction. Most processes are based on the conventional technologies, involving drying and pressing the pulp for oil recovery and further separation of carotenoids in a liquid phase using organics solvents. In the present work, the ethanol-based process was evaluated for simultaneous carotenoids recovering and fractionating from buriti pulp. The raw material and ethanol, 1:4 ratio, were placed in an erlenmeyer flask and maintained at 30rpm for 1 hour in a temperature-controlled bath at 65ºC. The mixture was filtered under vacuum and cooling at 10ºC to allow for the separation of the solvent in two phases. Carotenoids composition, determined by HPLC, has indicated a β-carotene concentration about 12 times greater in the lower phase than in the upper phase. The profile of the carotenoids in the denser phase is quite similar to that of raw buriti oil, and the concentration of total carotenoids is 40% higher than that of the original raw oil, making the ethanol-based process particularly attractive for industrial applications.
Resumo:
AbstractObjective:The present article is aimed at reporting the author’s experience with transcatheter arterial embolization using a lipiodol-ethanol mixture in three cases of unresectable symptomatic giant hepatic hemangiomas.Materials and Methods:The cases of three patients with giant unresectable symptomatic hepatic hemangiomas embolized in the period 2009–2010 were retrospectively reviewed. In all the cases, transarterial embolization was performed with an ethanol-lipiodol mixture.Results:Symptoms regression and quality of life improvement were observed in all the cases. No complications were observed and all the patients were discharged within 12 hours after the procedure.Conclusion:Transcatheter arterial embolization using ethanol mixed with lipiodol was a safe and effective treatment for symptomatic giant hepatic hemangiomas in this small series of patients.
Resumo:
Numerical modeling studies of urban atmospheres were performed with a photochemical box submodel which incorporates primary emission rates, temperature and solar irradiance rate coefficients. Actinic flux calculations were made for an appropriate latitude for Rio de Janeiro and initial concentrations and emission rates were taken from experimental data. The relative importance of individual reactions is discussed as well as the effect of enhanced aldehyde emissions from vehicles using ethanol and ethanol-containing fuel.
Resumo:
A method is presented for the choice of spectral regions when absorption measurements are coupled to chemometric tools to perform quantitative analyses. The method is based on the spectral distribution of the relative standard deviation of concentration (s c/c). It has been applied to the development of PLS-FTNIR calibration models for the determination of density and MON of gasoline, and ethanol content and density of ethanol fuel. The new method was also compared with the correlation (R²) method and has proved to generate PLS calibration models that present better accuracy and precision than those based on R².