Evaluation of oxacillin and cefoxitin disks for detection of resistance in coagulase negative staphylococci

Coagulase-negative Staphylococcus spp. was considered nonpathogenic until the emergence of multiresistance and the demonstration of their participation as infectious agents. In Brazil, oxacillin resistance may be present in over 80% of isolates, and the Clinical and Laboratory Standards Institute standardized a disk-diffusion method to predict this resistance in Staphylococcus. The aim of this study was to evaluate the variability among commercial disks of oxacillin (1 µg) and cefoxitin (30 µg) widely used in clinical laboratories of microbiology, compared with mecA gene and minimum inhibitory concentration (MIC) of oxacillin. The use of oxacillin and cefoxitin disks simultaneously allowed the detection of important differences, particularly, in less frequent species such as S. cohnii, S. haemolyticus, S. saprophyticus, and S. sciuri. Disks of cefoxitin of the brand 2 displayed good correlation with the mecA gene (98.7%) and oxacillin MIC (97.8%), while major discrepancies were observed using disks of brand 1. One of the critical points in the diffusion disk test is the quality of the disks: the use of better quality disks associated with molecular methods lead to better results to define the best antibiotic therapy.

Ultra-trace monitoring of copper in environmental and biological samples by inductively coupled plasma atomic emission spectrometry after separation and preconcentration by using octadecyl silica membrane disks modified by a new schiff's base

Ultra-trace amounts of Cu(II) were separated and preconcentrated by solid phase extraction on octadecyl-bonded silica membrane disks modified with a new Schiff,s base (Bis- (2-Hydroxyacetophenone) -2,2-dimethyl-1,3-propanediimine) (SBTD) followed by elution and inductively coupled plasma atomic emission spectrometric detection. The method was applied as a separation and detection method for copper(II) in environmental and biological samples. Extraction efficiency and the influence of sample matrix, flow rate, pH, and type and minimum amount of stripping acid were investigated. The concentration factor and detection limit of the proposed method are 500 and 12.5 pg mL-1, respectively.

Solid phase extraction of zinc with octadecyl silica membrane disks modified by N,N'-disalicylidene-1,2-phenylendiamine and determination by flame atomic absorption spectrometry

A procedure for separation and preconcentration of trace amounts of Zn(II) from aqueous media is proposed. The procedure is based on the adsorption of Zn2+ on octadecyl bonded silica membrane disk modified with N,N'-disalicylidene-1,2-phenylendiamine at pH 7. The retained zinc ions were then stripped from the disk with a minimal amount of 1.5 mol L-1 hydrochloric acid solution as eluent, and determined by flame atomic absorption spectrometry. Maximum capacity of the membrane disk modified with 5 mg of the ligand was found to be 226 µg Zn2+. The relative standard deviation of zinc for ten replicate extraction of 10 µg zinc from 1000 mL samples was 1.2%. The limit of detection of the proposed method was 14 ng of Zn2+ per 1000 mL. The method was successfully applied to the determination of zinc in natural water samples and accuracy was examined by recovery experiments and independent analysis by graphite furnace atomic absorption spectrometry (GFAAS).

A rapid and simple method to detect ESBL in Enterobacter cloacae based on MIC of cefepime

INTRODUCTION: The aim of this study was to identify a rapid and simple phenotypic method for extended-spectrum β-lactamase (ESBL) detection in Enterobacter cloacae. METHODS: A total of 79 consecutive, non-repeated samples of E. cloacae were evaluated. Four phenotypic methods were applied for ESBL detection, results were compared to multiplex polymerase chain reaction (PCR) as the gold standard reference method: 1) ceftazidime and cefotaxime disks with and without clavulanate, both with boronic acid added; 2) disk approximation using cefepime and amoxicillin/clavulanate; 3) ESBL screening by minimum inhibitory concentration (MIC) ≥ 16µg/mL and 4) by MIC ≥ 2µg/mL for cefepime. RESULTS: Method 4 showed the best combination of sensitivity (100%) and specificity (94%). CONCLUSIONS: MIC ≥ 2µg/mL for cefepime would be very useful for the phenotypic detection of ESBL in samples of E. cloacae.

O tamanho dos vasos e fibras do xilema-secundário nos anéis de crescimento da Tecoma chrysothrica, Mart.

This paper deals with the macroscopic and microscopic observation of the growth ringe in two disks from the crossing section of wood stem of Tecoma chrysothrica and also deals with statistical analysis of the size of fiber and vessel member in different grow rings of secondary xilem. By statistical analyses of variance the authors verified the following: first, the fiber reaches its utmost length at the 11 th and 12 th grow rings; second, the vessel member reaches its utmost width in the same region as the fiber length. This point out there is certain correlation between the width of vesses member with the fiber length at the same growth rings. There was no statistical signification in the variation of the vessel length and the fiber width.

New or rare frogs from the Coastal Ranges of Brazil: eleutherodactylus venancioi n.sp., E. hoehnei n.sp. Holoaden bradei n.sp. e H. lüderwaldti Mir. Rib., 1920

Field-work in the sierras near the sea-board of south-eastern Brazil continues to yield new or rare frogs. Four more of these forms are presented here. Two of them, both new, are put into the genus Eleutherodactylus, to which they belong by their general habitat, morphology, and also by the osteological characters. They differs from the known regional species of this genus only by the wider and shorter disks of some of the digits and the more lanceolate build. The other two species belong to the very little known genus Holoaden, established by MIRANDA RIBEIRO in 1920. One of them is his type-species, H. lüderwaldti, which continues to be very rare. The other, H. bradei, is new. It seems endemic to the Upper Itatiaia and is very plentiful there.

Plants of an Eucalyptus clone damaged by Scolytidae and Platypodidae (Coleoptera)

Species of Scolytidae and Platypodidae were evaluated in a plantation using a clone of Eucalyptus grandis x Eucalyptus urophylla in the State of Minas Gerais, Brazil. Wood disks with galleries were taken from 15 eucalyptus trees between 0.5 and 1.5 m height. After collection, all trees attacked were burned. Woodborers obtained from these disks were identified as Premnobius cavipennis, Premnobius ambitiosus, Dryocoetoides cristatus (Coleoptera: Scolytidae) and Euplatypus parallelus (Coleoptera: Platypodidae). This is the first report of D. cristatus, a Brazilian native species, damaging eucalyptus, which shows its adaptation to this plant.

Análise de praguicidas organofosforados em água por extração em fase sólida (SPE) utilizando discos C18 e cromatografia em fase gasosa: avaliação da contaminação do reservatório de Furnas (MG-Brasil)

Solid phase extraction (SPE) in C18 disks has been optimized and validated for extraction of 5 organophosphorus (OP) pesticides in water. Extraction has been followed by separation and detection by gas chromatography/flame photometry. Excellent linearity was obtained for all compounds (r greater than 0.99), with CVs between 1.0-6.9%, recoveries between 73-95% and quantification limits between 2.5-5.0 µg L-1. Samples from Furnas dam were analyzed monthly during one year and 10% showed OP pesticide residues.

Preconcentration, determination and speciation of iron by solid-phase extraction using dimethyl (E)-2-[(Z)-1-acetyl)-2-hydroxy-1-propenyl]-2-butenedioate

A new sensitive and selective procedure for speciation of trace dissolved Fe(III) and Fe(II), using modified octadecyl silica membrane disks and determination by flame atomic absorption spectrometry was developed. A ML3 complex is formed between the ligand and Fe(III) responsible for extraction of metal ion on the disk. Various factors influencing the separation of iron were investigated and the optimized operation conditions were established. Under optimum conditions, an enrichment factor of 166 was obtained for Fe3+ ions. The calibration graph using the preconcentration system for Fe3+ was linear between 40.0 and 1000.0 μg L-1.

A novel postharvest rot of okra pods caused by Rhizoctonia solani in Brazil

Okra pods with unusual brown lesions and rot were collected in a local supermarket in Brasília DF. The objective of this paper was to characterize the causal agent, to fulfill Koch's postulates and to determine some conditions conducive to disease. The pathogen was identified as Rhizoctonia solani based on morphological characteristics which fitted the fungus description, such as pale to brown hyphae, with nearly right-angled side branches constricted at the base, hyphal cells 6-10 µm wide with a septum near the base. Five isolates were obtained from infected pods and identified as AG 1-IB anastomosis group. Wounded or unwounded okra pods cv. Santa Cruz 47 were inoculated with mycelium disks of R. solani and kept in humid chambers at 12 ºC or 25 ºC. After seven days at 25 ºC, both wounded and unwounded pods were completely rotted and brown, while those kept at 12 ºC showed small lesions ranging from 0.6 to 1.0 mm only in wounded pods. The pathogen was able to grow in different materials used for assembling crates and packs of horticultural products, such as pinewood, corrugated carton, plastic, Styrofoam and newspaper sheets when kept in humid chambers (24 ºC, 96 % RH). The disease occurrence can be related to careless handling practices and to the transmission of R. solani propagules by infected plant debris or soil particles. This is the first report of Rhizoctonia solani causing postharvest rot in okra pods in Brazil.

Net melon resistance to Didymella bryoniae according to grafting and potassium levels

Chemical control of the fungus Didymella bryoniae, the causal agent of the disease gummy stem blight in melon, is frequently inefficient; thus, alternatives such as grafting and nutrition must be studied. Rootstocks and potassium levels were tested aimed at controlling this disease in net melon under protected environment. The melon hybrid 'Bônus II', ungrafted and grafted onto 'Dinero' melon and 'Strong Tosa' pumpkin rootstocks, was cultivated and inoculated by using the toothpick insertion method with 7-mm mycelial disks from the isolate D. bryoniae Dbr 37; for control, only toothpick insertion was used. The plants were subjected to the following potassium levels: 0, 62.5, 125, 187.5, 250 mg L-1. Grafted 'Bônus II' melon plants were resistant to the fungus, whereas ungrafted ones were susceptible. The adopted potassium levels did not influence the stem lesion size or the survival of plants.

Oxisol resistence to penetration in no-till system after sowing

If inappropriately conducted, management and sowing practices may compromise the environment and the profitability of the agricultural activity. The aim of this study was to analyze the furrow opener mechanisms action and the level of load applied to soil firming mechanism in no-till, on the Oxisol resistance to penetration during soybean sowing, under three soil moistures. The experiment was arranged in split-split plot design, in which the plots were composed by three soil moistures (23.8; 25.5 and 27.5% b.s.), two furrow opener mechanisms sub-plots (double disks and furrow plough) and the split-split plot of three levels of load applied to soil firming mechanism (12.2; 18.5 and 24.1 kPa), according to randomized blocks design, with three replications. The soil moisture provided different resistance behavior to penetration with the depth, on the seedbed, independently of the furrow opener and the level of load applied to soil firming mechanism. The furrow plough use provided less soil resistance to penetration when compared to the double disk furrow opener, on the seedbed, independently of the soil moisture and the level of load applied to soil firming mechanism. The pressure applied by soil firming mechanism of 18.5 kPa provided the lower resistance to penetration, when the furrow plough was used. The soil resistance to penetration was less on the sowing line than on between rows, with 20 cm deep.

Evaluation of cotton stalks destroyers

The destruction of the cotton crop residues (cotton stalks) is a mandatory procedure in Brazil for prophylactic issues, but is a subject unexplored by the research and there are few studies that deal with this issue. However, this is not encouraged in recent decades, studies aimed at developing and evaluating equipment for this purpose. The present study had the objective to evaluate six methods for mechanical destruction of cotton crop residues. Each method was defined based on the principle of operation of the active parts of the equipment, which were tested in medium texture soil and in a clayey one. The variables used to evaluate the efficiency of the equipment were the regrowth rate, the theoretical field capacity and energy demand. The equipment with convergent concave disks (DCC) and flat cutters discs from manufacturer A (CPS-a) showed the best results in cotton stalks destruction in both soil types. The harrow disc (GPD) was efficient only in clay soil. It was concluded that the equipment with convergent concave disks, among those tested, was the most efficient to destroy cotton stalks, regardless of soil type, and that the harrow disc was not included among the best performers.

Soil chiseling and fertilizer location in sugarcane ratoon cultivation

While the pre-harvest sugarcane burning is a disused practice, green harvest requires changes concerning ratoon cultivation due to the presence of a thick layer of straw. The experiment, conducted in a mechanical green harvesting area cultivated with sugarcane, consisted of two stages: in the first stage, the mechanical straw cutting performance of flat disks with different geometry edges was evaluated, considering two types of disks and 10 replications in a completely randomized design; in the second stage, the effect of soil chiseling on both sides of planting lines, using shanks with straw cutting flat disks, was assessed, as well as fertilizer deposition form. The experimental design in the second stage was completely randomized, with seven treatments and five replications. Treatments consisted of a combination of two straw cutting disks (smooth or toothed edge), chiseling presence or absence, and fertilizer deposition forms (broadcast, on the planting line, and incorporated into chiseling furrows). The toothed disk differed from the smooth one, presenting lower values of horizontal and vertical forces, and torque. The agroindustrial variables pol (%), brix (%), fiber (%), and ATR (kg Mg-1) were not influenced by the fertilizer deposition form and soil chiseling. However, the localized fertilizer deposition increased crop yield when compared with broadcast fertilization.

Development of nano-meter motion control in Japan

Production machines for next generation LSIs such as 4G-DRAMs and for large liquid crystal displays such as 0.5mx0.5m size, and information equipment such as magnetic hard disks and DVDs must have the positioning accuracy of a nano-meter order. To realize such a high degree of the positioning accuracy, not only precision machine elements and mechanisms but also high precision sensors, actuators and controller design techniques becomes crucial. This paper introduces recent topics of precision positioning and motion control technology in Japan.