Enraizamento de microestacas de mirtileiro provenientes de microjardim clonal semi-hidropônico

O uso de microjardins clonais hidropônicos tem sido relatado com sucesso para espécies florestais e pode vir a se tornar uma excelente alternativa para espécies frutíferas de difícil propagação, como é o caso do mirtilo. O objetivo deste estudo foi avaliar o enraizamento de microestacas de mirtileiro provenientes de dois sistemas de cultivo (convencional e semi-hidropônico), submetidas a diferentes concentrações de AIB (ácido indolbutírico). As microestacas de mirtileiro das cultivares Bluebelle e Woodard foram submetidas a diferentes concentrações de AIB (0; 500; 1.000; 1.500 e 2.000 mg.L-1), acondicionadas em caixas plásticas contendo vermiculita e, aos 90 dias de cultivo, avaliou-se o seu rendimento. O delineamento experimental foi o inteiramente casualizado, com vinte tratamentos, contendo quatro repetições, compostas por dez microestacas cada. Foram avaliados as porcentagem de sobrevivência e de enraizamento, o comprimento da maior raiz, o número de brotações, o comprimento médio das brotações, o número de folhas e as massas fresca e seca radiculares. O sistema semi-hidropônico proporcionou um rendimento de microestacas significativamente superior ao convencional; entretanto, este material apresentou menores porcentagens de sobrevivência e enraizamento. Todos os tratamentos, inclusive aquele sem a presença de AIB, apresentaram porcentagens de enraizamento superiores a 50%.

Growth and production of irrigated vitória pineapple grown in semi-arid conditions

This study aimed to evaluate the growth characteristics of irrigated Vitória pineapple plants grown in semi-arid conditions and determine its developmental stages based on those characteristics. It was used a randomized block design with four replicates. The experimental treatments were: plant harvest at 270, 330, 390, 450, 510, 570, 690, 750, and 810 days after planting (DAP). The following variables were determined: plant height, stem diameter, D-leaf length, D-leaf fresh and dry mass, biomass production of plants and plant parts (organs), and vegetative biomass. Five phenological stages are proposed based on vegetative biomass production: < 20% biomass production (V1); 21-40% (V2); 41-60% (V3); 61-80% (V4); and > 80% (V5). The maximum growth rate for plant height, D-leaf length, and stem diameter was observed at the end of the phenological stage V1 (390-411 DAP), and at the end of stage V5 these plant traits had average values of 106, 82, and 7 cm, respectively. The maximum biomass accumulation rates were observed at stages V4 and V5, resulting in a final fruit yield and total fresh biomass of 72 t ha-1 and 326 t ha-1, respectively. Finally, we estimated that 80% of the accumulated biomass may remain in the field after fruit and slip harvest, and could be incorporated as plant residue into the soil.

COMPARISON OF RNA EXTRACTION METHODS FOR Passiflora edulis SIMS LEAVES

ABSTRACT Functional genomic analyses require intact RNA; however, Passiflora edulis leaves are rich in secondary metabolites that interfere with RNA extraction primarily by promoting oxidative processes and by precipitating with nucleic acids. This study aimed to analyse three RNA extraction methods, Concert™ Plant RNA Reagent (Invitrogen, Carlsbad, CA, USA), TRIzol® Reagent (Invitrogen) and TRIzol® Reagent (Invitrogen)/ice -commercial products specifically designed to extract RNA, and to determine which method is the most effective for extracting RNA from the leaves of passion fruit plants. In contrast to the RNA extracted using the other 2 methods, the RNA extracted using TRIzol® Reagent (Invitrogen) did not have acceptable A260/A280 and A260/A230 ratios and did not have ideal concentrations. Agarose gel electrophoresis showed a strong DNA band for all of the Concert™ method extractions but not for the TRIzol® and TRIzol®/ice methods. The TRIzol® method resulted in smears during electrophoresis. Due to its low levels of DNA contamination, ideal A260/A280 and A260/A230 ratios and superior sample integrity, RNA from the TRIzol®/ice method was used for reverse transcription-polymerase chain reaction (RT-PCR), and the resulting amplicons were highly similar. We conclude that TRIzol®/ice is the preferred method for RNA extraction for P. edulis leaves.

Comportamento da dose glandular versus contraste do objeto em mamografia: determinação de formalismo semi-empírico para diferentes combinações alvo-filtro

OBJETIVO: Verificar o efeito da mudança no contraste do objeto, tempo de exposição e dose de radiação quando diferentes espessuras de filtração de molibdênio (Mo) e ródio (Rh) são empregadas em mamógrafos. MATERIAIS E MÉTODOS: Realizaram-se medidas da exposição na entrada da pele com uma câmara de ionização para diferentes espessuras para os filtros de Mo e Rh. Para determinar a dose glandular média foi utilizado simulador de BR12 (50% tecido adiposo e 50% tecido glandular) de diferentes espessuras (4 cm e 8 cm). Energias na faixa de 24 kVp a 34 kVp foram empregadas e filmes Kodak MinR 2000 foram utilizados. RESULTADOS: Os resultados evidenciaram dados de contraste do objeto, dose glandular e tempo de exposição para diferentes espessuras de filtros adicionais e diferentes tensões. Esses dados indicaram aumento nos valores de contraste do objeto e tempo de exposição, com o aumento da espessura dos filtros. A dose glandular apresentou comportamento com diferentes tendências para cada caso analisado. Equações foram definidas para possibilitar a estimativa do contraste do objeto, dose glandular e tempo de exposição para os casos estudados. CONCLUSÃO: Os resultados possibilitaram a estimativa de equações que auxiliam na verificação do comportamento do contraste do objeto e da dose glandular para simuladores com espessura de 4 cm e 8 cm e para os filtros de Rh e Mo. Dessa forma, torna-se possível estimar a figura de mérito (razão entre o contraste do objeto e a dose glandular), podendo auxiliar na análise da relação risco-benefício dos casos estudados.

Influência da metodologia de avaliação da camada semi-redutora em radiologia diagnóstica

OBJETIVO: A análise crítica da metodologia de medida da camada semi-redutora em feixes de raios X teve como base o regulamento técnico para proteção radiológica e controle de qualidade em radiodiagnóstico médico e odontológico. MATERIAIS E MÉTODOS: Na medida da camada semi-redutora, a técnica radiográfica, o arranjo experimental, os meios espalhadores, a instrumentação, o tamanho de campo de radiação e a metodologia de análise dos dados foram considerados. RESULTADOS: A camada semi-redutora obtida em condições de boa geometria, para a técnica escolhida, foi de 2,44 ± 0,02 mmAl. Em relação a este valor, observaram-se desvios máximos na camada semi-redutora de 4,1% na variação da geometria, de 98,8% na variação da câmara de ionização e do meio espalhador, e de até 29,5% com outro tipo de detector. CONCLUSÃO: Os resultados mostraram que não ocorre variação significante na camada semi-redutora para diferentes tamanhos de campo de radiação, mas foram evidentes a influência do espalhamento na superestimação da camada semi-redutora e a redução desta na presença de blocos de chumbo como meio espalhador. O procedimento prático adotado mostrou-se bastante confiável e evidenciou a grande discrepância decorrente da adoção de metodologias impróprias, enfatizando a necessidade de estabelecer um procedimento padrão para a medida da camada semi-redutora.

Aplicação de SPME (Solid Phase Micro-Extraction) na análise de águas potáveis de três localidades do estado de São Paulo

The technique of solid phase microextraction (SPME) was used for the extraction of halogenated contaminants of water samples from three cities of the State of São Paulo and the extracts were submitted to gas chromatographic analysis with electron capture detection (GC-ECD). In the samples of water collected at the city of São Paulo the detected level of trihalomethanes (THM) expressed as the sum of chloroform, dibromochloromethane and dichlorobromomethane, were higher than the permissible limit established by the Brazilian regulation. In the samples collected at the two other cities the level of any of the three THM remained below the sensitivity of the ECD.

Estudo químico-computacional da reatividade de aziridinona e diaziridinona através de cálculos semi-empíricos

The results of semiempirical molecular orbital calculations performed on aziridinone and diaziridinone employing the MNDO, AM1, and PM3 molecular models are presented. The AM1 method, which best reproduces ground-state molecular properties, is used to calculate electronic parameters and the use of these parameters for the evaluation of reactivity is discussed.

Nitração do fenol, um método em escala semi-micro para disciplina prática de 4 horas

A procedure for the nitration of phenol in a semi-micro scale, followed by separation of the formed orto- and para-nitrophenol isomers by column chromatography, is described. All the experiment, including determination of the melting point of the isolated products, require a period of 4 hours, and it is suitable for organic chemistry laboratory undergraduate courses.

Avaliação da salinização de açudes no semi-árido brasileiro por ICP-AES

The salt accumulation process in some reservoirs of regular and irregular use (from 10 to 50 years of constrution), located in the Southeast of Bahia State was evaluated. Inductively coupled plasma atomic emission spectrometry was used to evaluate the concentrations of Na, K, Ca and Mg in water samples from inside and upstream of the reservoirs. The results showed that for reservoirs of irregular use, the salt accumulation, indicated by the tracer Na, increases with the age of the reservoirs, however for the reservoirs of regular use the hydraulic retention time is the main parameter.

Estudo semi-empírico de ácidos hidroxâmicos: ácido formoidroxâmico e derivados do aleloquímico dimboa

Open chain hydroxamic acid (Hx) can exist as Z and E diastereomers of two tautomers, hydroxamic acid and hydroximic acid. The conformational stability of the formohydroxamic acid isomers evaluated by PM3 compared better to ab initio results from the literature than AM1 results. Structural data of the cyclic Hx 2,4-dihydroxy-7-metoxy-2H-1,4-benzoxazin-3(4 H)-one (DIMBOA) obtained by both semiempirical methods compared well to ab initio results. pKa data from the literature for derivatives of the aldolic isomer of DIMBOA were compared to the stability of the anions resulting from the loss of protons of their phenol and hydroxamic acid groups, determined as the difference in heat of formation between anionic and neutral forms, calculated by AM1 and PM3 methods. Good correlations between theoretical and experimental data were obtained for both semiempirical methods.

Síntese de sulfadiazina e sulfadiazina de prata em escala semi-micro: prática experimental em síntese de fármacos

The total synthesis of sulfadiazine and silver sulfadiazine from readily available starting materials was adapted to semi-micro laboratory scale and is proposed as an experiment in drug synthesis for undergraduate courses.

Solid phase extraction of iron and lead in environmental matrices on amberlite xad-1180/pv

A solid phase extraction procedure using Amberlite XAD-1180/Pyrocatechol violet (PV) chelating resin for the determination of iron and lead ions in various environmental samples was established. The procedure is based on the sorption of lead(II) and iron(III) ions onto the resin at pH 9, followed by elution with 1 mol/L HNO3 and determination by flame atomic absorption spectrometry. The influence of alkaline, earth alkaline and some transition metals, as interferents, are discussed. The recoveries for the spiked analytes were greater than 95%. The detection limits for lead and iron by FAAS were 0.37 µg/L and 0.20 µg/L, respectively. Validation of the method described here was performed by using three certified reference materials (SRM 1515 Apple Leaves, SRM 2711 Montana Soil and NRCC-SLRS-4 Riverine Water). The procedure was successfully applied to natural waters and human hair.

Determinação de hidrocarbonetos voláteis e semi-voláteis na atmosfera

This paper focuses: (i) the development of a measurement technique for the determination of atmospheric C2-C6 hydrocarbons with sampling in canisters and analysis by gas chromatography/flame ionisation detector (GC/FID), (ii) the improvement of an existent adsorption-sampling technique with Tenax TA tubes for the determination of C6-C11 hydrocarbons and analysis by GC/FID after thermal desorption and cryogenic concentration, (iii) the identification of compounds present in ambient air by gas chromatography/mass spectrometry (GC/MS) for both canister and Tenax samples, (iv) a program of interlaboratorial comparison for quality control of C2-C11 analyses, and (v) the seasonal characterisation of ambient air C2-C11 hydrocarbons.

Extraction, purification and biochemical characterization of a peroxidase from Copaifera langsdorffii leaves

The aim of this work is to obtain, purify and characterize biochemically a peroxidase from Copaifera langsdorffii leaves (COP). COP was obtained by acetone precipitation followed by ion-exchange chromatography. Purification yielded 3.5% of peroxidase with the purification factor of 46.86. The COP optimum pH is 6.0 and the temperature is 35 ºC. COP was stable in the pH range of 4.5 to 9.3 and at temperatures below 50.0 ºC. The apparent Michaelis-Menten constants (Km) for guaiacol and H2O2 were 0.04 mM and 0.39 mM respectively. Enzyme turnover was 0.075 s-1 for guaiacol and 0.28 s-1 for hydrogen peroxide. Copaifera langsdorffii leaves showed to be a rich source of active peroxidase (COP) during the whole year. COP could replace HRP, the most used peroxidase, in analytical determinations and treatment of industrial effluents at low cost.

Resistência mecânica de hidrogéis termo-sensíveis constituídos de Alginato-Ca2+ / PNIPAAm, tipo Semi-IPN

Thermosensitive hydrogels were synthesized using alginate-Ca2+ in association with a thermosensitive polymer, such as PNIPAAm. The mechanical properties of the hydrogels were determined measuring the maximum tension of deformation. With the increase of the temperature by 25 to 40 ºC above the LCST the chains of PNIPAAm collapsed, dragging the alginate net and diminishing the size of the pores. The decrease in the size of the pores of the hydrogel was followed by an increase in the mechanicals resistance of the material.