Physical characteristics of oily spraying liquids and droplets formed on coffee leaves and glass surfaces

The physical characteristics of a spray liquid are important in getting a good droplet formation and control efficiency over a particular target. As a function of these characteristics, it is possible to decipher which is the best adjuvant based on the respective concentration used during the spray. Therefore, ten spraying liquids were prepared, which varied in concentrations of pesticide lufenuron + profenofos, mineral oil, water and manganese sulfate. Pendant droplets formed from these mixtures were measured to examine their impact on surface tension. Droplets were applied to the surface of coffee leaves and the surface tension, contact angle formed and the leaf area wetted by the droplet, were measured. A smooth glass surface was taken as a comparative to the coffee leaves. The highest concentrations of oil resulted in lower surface tension, smaller contact angles of droplets on leaf surfaces and larger areas wetted by the droplets. Both surfaces showed hydrophilic behavior.

Quality of peanut mechanical sowing in function of seeding density and size of the seeds

ABSTRACTPeanut crop (Arachis hypogaeaL.) mechanization has been improved over the years; however there are drawbacks that affect the quality of operations. Thus, this article’s objectives were to evaluate the operational performance of the mechanized sowing of peanut crop according to seeding densities (10, 14, and 18 seeds m-1) and seed sizes (21 and 23 mm). It was observed that the seeds of 23 mm had shorter average number of days to emergence and a higher percentage of emergences, occurring the opposite to the seeding density of 18 seeds m-1. The higher the seeding density, the largest was the plant stand, whereas the 23 mm seed obtained the best results and the same with the seeding density of 14 seeds m-1 that had a higher percentage of normal spacing. The densities of 14 and 18 seeds m-1 reflected in higher yields, being always superior to the 23 mm seeds.

Atenolol prevents the formation of expansive hematoma after rhytidoplasty

Objective: To evaluate the perioperative use of atenolol in reducing the incidence of hematoma after rhytidoplasty.Methods: Between January 2007 and February 2013, 80 patients were randomized into two groups: Group A (n = 26) received perioperative atenolol in order to maintain heart rate (PR) around 60 per minute; Group B (n = 54) did not receive atenolol. Both groups underwent the same anesthetic and surgical technique. We monitored blood pressure (BP), HR, hematoma formation and the need for drainage. Patients were followed-up until the 90th postoperative day. The variables were compared between the groups using the ANOVA test. Continuous variables were presented as mean ± standard deviation and the differences were compared with the Student's t test. Values of p d" 0.05 were considered significant.Results: In group A the mean BP (110-70mmHg ± 7.07) and HR (64 / min ± 5) were lower (p d" 0.05) than in group B (135-90mmHg ± 10.6) and (76 / min ± 7.5), respectively. There were four cases of expansive hematoma in group B, all requiring reoperation for drainage, and none in group A (p d" 0,001).Conclusion: The perioperative use of atenolol caused a decrease in blood pressure and heart rate and decreased the incidence of expanding hematoma after rhytidectomy.