Avaliação do efeito da concentração de carbonato na eletrodeposição de cobre sobre discos de aço-carbono

Mild steel blankets were covered with electrolytic copper thin layer, from cyanide bath, being evaluated the influence of the carbonate concentration in the physiochemical properties of those deposits. The cell voltage decreased as the current intensity decreased, but the adherence of the deposit was not enhanced, showing that the increment of carbonate concentration causes substantial problems. Chemical solubilization reactions of air-bearing carbon dioxide and oxidation of free cyanide ions through dissolved oxygen evolved in the anodic processes contribute to the copper plating to occur in an inefficient way. The best optimal conditions require a carbonate concentration below 50 g L-1.

O comportamento do elétron: uma análise do efeito compton e da relação de Broglie

The De Broglie's relation was a fundamental step in the development of a wave nature for matter. Therefore, we have examined it from the perspective of the new atomic theory. This relation makes successful predictions of the stable energy levels for electrons orbiting a nucleus. The formulation of the de Broglie's relation is a fundamental application of the theory of wave-particle duality for a material particle. In this work, the direct demonstration employing the equations E = mc² and E = hcλ, was avoided. We provide a complete analysis of this relation considering features of the special theory of relativity.

Efeito do intemperismo artificial em quatro madeiras tropicais monitorado por espectroscopia de infravermelho (DRIFT)

Four tropical woods, were investigated to compare their performance and natural resistances to artificial weathering using the diffuse reflectance infrared Fourier transform spectroscopy (DRIFT). The species were garapeira (Apuleia leiocarpa), itaúba (Mezilaurus itauba) and tauari (Couratari sp.), woods traditionally indicated for exterior uses, and marupá (Simarouba amara), that served as reference. The samples were submitted to cycles of UV radiation (350 nm) and water until 2,000 h. The photodegradation processes of woods surfaces were accomplished monitoring the changes in the intensities associated to lignin (1508 cm-1) and carbonyl group (1736 cm-1) absorptions. The results have shown that lignin was the first component to be photodegradated, resulting in surfaces mainly composed by cellulose, after 2,000 h of UV irradiation. The processes of formation and lixiviation of carbonyl compounds were different for each species. The experimental conditions used in this work were too severe to evaluate the wood density and extractives content influences during the treatment.

Efeito da composição das correntes do conversor das unidades de FCC no desempenho catalítico de aditivos DESOx

Hydrotalcite-like compounds having Mg partially replaced by Cu or Mn were prepared and used as precursors for two mixed oxides (Cu-OM50 and Mn-OM50) that were evaluated for SOx removal in the presence of O2, NO and CO. Under SO2/O2 reaction system, SOx removal was slightly higher over Cu-OM50. The addition of CO and NO to the feed markedly hindered the SO2 oxidation over Cu-OM50 while no significant effect was observed for Mn-OM50. For the regeneration step, the use of propane instead of H2 reduces regeneration capacity, mainly for Cu-OM50. Mn-OM50 was less affected by the feed composition, suggesting that it was a promising additive for SOx removal.

Efeito do tratamento térmico na microestrutura, turbostraticidade e superfície de carbono vítreo reticulado analisado por XPS, espalhamento Raman e voltametria cíclica

The structural and surface properties of reticulated vitreous carbon (RVC) were discussed as a function of its heat treatment temperature (HTT), for samples produced in the range from 700 to 2000 ºC, using the furfuryl precursor resin. The samples were analyzed by x-ray photoelectron spectroscopy, first and second order Raman scattering as well as electrochemical response. Exploring the material turbostraticity concept, the interdependence between the RVC chemical surface variation and its defects were demonstrated. The influence of heteroatom presence was discussed in the material ordering for HTT lower than 1300 ºC while the graphitization process evolution was also pointed out for HTT higher than 1500 ºC.

Estudo da degradação fotocatalítica de dimetil dissulfeto: avaliação estatistica do efeito do pH da temperatura e concentração do contaminante orgânico

This work aimed to assess the photocatalytic degradation of a model odor compound (dimethyl disulfide, DMDS), found in liquid and gaseous wastes of plants for processing poultry byproducts. The effect of pH and temperature on adsorption and photocatalytic degradation was evaluated through factorial experimental designs. The results suggest the presence of an optimum region for adsorption, at 45.0 ºC and pH 4.0. In the photocatalytic runs an optimum for temperature and pH was also observed. At 45 ºC and pH 4.0 the removal of DMDS was 99% after 60 min of irradiation.