Planosols Developed in Different Geoenvironmental Conditions in Northeastern Brazil

ABSTRACT The semiarid region of northeastern Brazil has a large area occupied by Planosols, where in the State of Pernambuco these soils are mainly used for livestock farming and subsistence crops. The knowledge on these soils is limited, which compromises the understanding on their behavior, potentialities and limitations.This study aimed to analyze morphological, chemical, physical and mineralogical attributes of Planosols developed under different geoenvironmental conditions. Morphological descriptions and chemical, physical and mineralogical analyses were performed in four profiles of Planosols along a rainfall gradient. An increase in rainfall allowed for an increase in the clay content in the Bt horizon and a reduction in ESP, EC, Na+, CEC, S, pH (water and KCl) and soil density. Horizons A and E were thicker in Planosols in more humid environments. The increase in ESP associated with the presence of expansive minerals (smectite and vermiculite) allowed the development of a prismatic structure in Haplic Planosols and a columnar structure in Natric Planosols. The mineralogical assembly is indicative of poorly weathered soils. The mineralogical assemblies of the silt and clay fractions were similar in the different geoenvironments, while higher contents of easily alterable minerals were observed in the composition of the sand fraction in environments with a drier climate.

Comparison of microscopic method and computational program for pesticide deposition evaluation of spraying

The main objective of this work was to compare two methods to estimate the deposition of pesticide applied by aerial spraying. Hundred and fifty pieces of water sensitive paper were distributed over an area of 50 m length by 75 m width for sampling droplets sprayed by an aircraft calibrated to apply a spray volume of 32 L/ha. The samples were analysed by visual microscopic method using NG 2 Porton graticule and by an image analyser computer program. The results reached by visual microscopic method were the following: volume median diameter, 398±62 mum; number median diameter, 159±22 mum; droplet density, 22.5±7.0 droplets/cm² and estimated deposited volume, 22.2±9.4 L/ha. The respective ones reached with the computer program were: 402±58 mum, 161±32 mum, 21.9±7.5 droplets/cm² and 21.9±9.2 L/ha. Graphs of the spatial distribution of droplet density and deposited spray volume on the area were produced by the computer program.

Drying rates of Rubi grapes submitted to chemical pretreatments for raisin production

The objective of this work was to determine the most appropriated chemical treatment to be used to dry grapes cv. Rubi for raisin production. Drying curves for convective drying with air at 50ºC, in a tray drier, were obtained for grapes submitted to chemical pretreatments with different concentrations of potassium carbonate and olive oil, and different dipping times, according to factorial designs. Convective drying curves were also obtained for grapes pretreated in aqueous suspensions of soybean lecithin, at varied lecithin concentrations and dipping times. Page model was adjusted to the experimental drying curves, and the calculated drying times showed that the best pretreatment consisted in dipping grapes for 2 minutes in a 5% olive oil and 6% K2CO3 emulsion, at 50ºC, which resulted in a drying time close to that of the pretreatment with 2.5% of olive oil, but with a lower consumption of this substance. In addition, the immersion of grapes in an aqueous suspension of 2% soy lecithin, at 50ºC, for 5 minutes, resulted in a total drying time slightly higher than the most effective pretreatment.

Apparent digestibility of ingredients in diets for Salminus brasiliensis

The objective of this work was to determine the nutritional value of different protein sources for "dourado" (Salminus brasiliensis). Thirty juveniles per group (33.51±1.4 g) were hand fed on a reference diet (70%) added of tested ingredients (30%) and chromium oxide III (0.1%). Apparent digestibility coefficients of the gross energy (ADC GE), crude protein (ADC CP) and amino acids of the tested ingredients were evaluated. Corn gluten meal yielded the best results for ADC GE and ADC CP (95.7 and 96.9%, respectively) amongst plant ingredients. Spray-dried blood meal yielded the best values of ADC GE and ADC CP amongst animal ingredients (94.1 and 96.3%, respectively). Wheat bran yielded poorest ADCs coefficients (77 for ADC GE and 88.2% for ADC CP).

Sooty blotch and flyspeck control with fungicide applications based on calendar, local IPM, and warning system

The objective of this work was to compare fungicide application timing for the control of sooty blotch and flyspeck (SBFS) of 'Fuji' apples in Rio Grande do Sul state, Brazil. The following treatments were evaluated in two growing seasons: two warning system-based (modified version of the Brown-Sutton-Hartmann system) spray of captan plus thiophanate methyl, with or without summer pruning; two calendar/rain-based spray of captan or a mixture of captan plus thiophanate methyl; fungicide spray timing based on a local integrated pest management (IPM) for the control of summer diseases; and a check without spraying. Sooty blotch and flyspeck incidence over time and their severity at harvest were evaluated. The highest number of spray was required by calendar/rain-based treatments (eight and seven sprays in the sequential years). The warning system recommended five and three sprays, in the sequential years, which led to the highest SBFS control efficacy expressed by the reduced initial inoculum and disease progress rate. Summer pruning enhanced SBFS control efficacy, especially by suppressing SBFS signs which tended to be restrained to the peduncle region of the fruit. Sooty blotch and flyspeck can be managed both with calendar and the grower-based IPM practices in Brazil, but a reduced number of sprays is required when the warning system is used.

GROWTH, YIELD AND POSTHARVEST QUALITY OF WAX APPLE AS AFFECTED BY NAPHTHALENE ACETIC ACID APPLICATION

Results of this study represent the first report of the effect of Naphthalene Acetic Acid (NAA) on the pre and post harvest quality of wax apple fruit. The wax apple trees were spray treated with 0, 5, 10 and 20 mg L-1 NAA under field conditions during 2008 to 2011. The experiments were carried out in Completely Randomized Design (CRD) with six replications. Leaf chlorophyll content, chlorophyll fluorescence, photosynthetic yield, net photosynthetic rate, drymatter content of leaves and total soluble solids and K+content of wax apple fruits were significantly increased after treatments with 10 mg L-1. Polygalacturonase activity significantly decreased with NAA treatments. The application of 5 mg L-1 NAA increased 27% more bud and reduced 42% less fruit drop compared to the control. In addition, higher protein and phosphate synthase activity of leaves, fruit set, fruit growth, larger fruit size and yield were recorded in NAA treated plants. In storage, treated fruits exhibited higher TSS and firmness and less weight loss, browning, titratable acidity, respiration and ethylene production than the control. It is concluded that spraying with 5 and 10 mg L-1 NAA once a week under field conditions produced better fruit growth and yield of the wax apple and maintained better fruit quality in postharvest storage.

Análise de extratos de plantas por CCD: uma metodologia aplicada à disciplina "química orgânica"

extracts of the regional plants Annona squamosa and Annona muricata were analysed by silica gel thin-layer chromatography using adequate systems of solvents and spray reagents. Carbohydrates, amino acids, alkaloids, flavonoids and terpenoids were detected in both species. These data agree with those on the literature about phytochemistry of the Annonaceae.

Emprego de nebulizador pneumático de ICP-MS como câmara de diluição em sistemas de injeção em fluxo para determinações multielementares

An automatic dispenser based on a flow-injection system used to introduce sample and analytical solution into an inductively coupled plasma mass spectrometer through a spray chamber is proposed. Analytical curves were constructed after the injection of 20 to 750 µL aliquots of a multielement standard solution (20.0 µg L-1 in Li, Be, Al, V, Cr, Mn, Ni, Co, Cu, Zn, As, Se, Sr, Ag, Cd, Ba, Tl, Pb) and the acquisition of the integrated transient signals. The linear concentration range could be extended to ca. five decades. The performance of the system was checked by analyzing a NIST 1643d reference material. Accuracy could be improved by the proper selection of the injected volume. Besides good precision (r.s.d. < 2%), the results obtained with the proposed procedure were closer to the certified values of the reference material than those obtained by direct aspiration or by injecting 125 µL of several analytical solutions and samples.

Degradação e estabilização do diclofenaco em nanocápsulas poliméricas

The parameters which affect the degradation and stabilization of diclofenac in suspensions of nanocapsules and of the corresponding spray-dried powders were investigated. Formulations were subjected to 14 months of storage at room temperature. In addition, a study of the degradation of diclofenac was carried out by exposing the formulations or mixtures (drug and adjuvants) to UVC wavelengths. The presence of Epikuron 170® in a concentration higher than 3.06 mg/mL stabilizes the drug, avoiding its reduction or degradation. The degradation products were isolated, analyzed by gas chromatography-mass spectrometry, and identified as 2-(2',6'-dichlorophenyl)aminobenzyl alcohol and N-(2',6'-dichlorophenyl)anthranilylaldehyde.

Nanoparticle-coated organic-inorganic microparticles: experimental design and gastrointestinal tolerance evaluation

The influences of the spray-drying parameters and the type of nanoparticles (nanocapsules or nanospheres) on the characteristics of nanoparticle-coated diclofenac-loaded microparticles were investigated by using a factorial design 3². Gastrointestinal tolerance following oral administration in rats was evaluated. Formulations were selected considering the best yields, the best encapsulation efficiencies and the lowest water contents, presenting surfaces completely coated by nanostructures and a decrease in the surface areas in relation to the uncoated core. In vitro drug release demonstrated the influence of the nanoparticle-coating on the dissolution profiles of diclofenac. Nanocapsule-coated microparticles presented a protective effect on the gastrointestinal mucosa.

Micropartículas nanorrevestidas contendo um fármaco modelo hidrofóbico: preparação em etapa única e caracterização biofarmacêutica

The aim of this work was to prepare and characterize spray-dried nanocapsule-coated microparticles obtained in one step, using indomethacin as a hydrophobic drug model and poly(e-caprolactone) or Eudragit® RS100, as polymers. Nanocapsule-coated microparticles showed micrometric mean sizes (10 - 15 µm) and a reduced surface area (75 - 85 m²g-1) compared to the raw material (214 m²g-1). Microparticles coated with Eudragit® RS100-nanocapsules showed a better control of the drug release. The release profiles fit to the monoexponetial model and to the Power Law. The mechanism of the indomethacin release from the microparticles is non-Fickian and depends on the particles desagglomeration.

High encapsulation efficiency of sodium alendronate in eudragit S100/HPMC blend microparticles

The hydrophilic drug sodium alendronate was encapsulated in blended microparticles of Eudragit® S100 and Methocel® F4M or Methocel® K100LV. Both formulations prepared by spray-drying showed spherical collapsed shape and smooth surface, encapsulation efficiencies of 85 and 82% and mean diameters of 11.7 and 8.4 µm, respectively. At pH 1.2, in vitro dissolution studies showed good gastro-resistance for both formulations. At pH 6.8, the sodium alendronate release from the microparticles was delayed and was controlled by Fickian diffusion. In conclusion, the prepared microparticles showed high encapsulation efficiency of sodium alendronate presenting gastro-resistance and sustained release suitable for its oral administration.

Avaliação da porosidade de microcápsulas contendo proteína bioativa por porosimetria de mercúrio e adsorção de nitrogênio

Microcapsules containing lactoferrin were produced by spray drying using dextrin:octenylsuccinate starch, as wall materials. Porosity characteristics of spray-dried microcapsules were investigated by mercury intrusion porosimetry and nitrogen adsorption. The outer and inner structures of microcapsules were studied by Scanning Electron Microscopy and sizes were determined by Laser Diffraction. Results indicate that all microcapsules presents adsorption isotherm of type II and that micropores on the microcapsules surface will be very few or none. Our results show that microstructure, surface area and size of microcapsules are affected by dextrin: octenylsuccinate starch proportion. Pore characteristics for various microcapsules are found to be different.

Química forense: perspectivas sobre novos métodos analíticos aplicados à documentoscopia, balística e drogas de abuso

In this review recent methods developed and applied to solve criminal occurences related to documentoscopy, ballistic and drugs of abuse are discussed. In documentoscopy, aging of ink writings, the sequence of line crossings and counterfeiting of documents are aspects to be solved with reproducible, fast and non-destructive methods. In ballistic, the industries are currently producing ''lead-free'' or ''nontoxic'' handgun ammunitions, so new methods of gunshot residues characterization are being presented. For drugs analysis, easy ambient sonic-spray ionization mass spectrometry (EASI-MS) is shown to provide a relatively simple and selective screening tool to distinguish m-CPP and amphetamines (MDMA) tablets, cocaine and LSD.

Desenvolvimento e uso do compósito de Nb2O5|Cu como revestimento aplicado por aspersão térmica sobre o aço AISI 1020 para proteção contra a corrosão pelo solo em estruturas enterradas

An Nb2O|Cu corrosion-resistant coating was developed and applied onto AISI 1020 steel substrate by Powder Flame Spray. A galvanostatic electrochemical technique was employed, with and without ohmic drop, in four different soils (two corrosively aggressive and two less aggressive). Behavior of coatings in different soils was compared using a cathodic hydrogen reduction reaction (equilibrium potential, overvoltage and exchange current density) focusing on the effect of ohmic drop. Results allow recommendation of Nb2O5|Cu composite for use in buried structure protection.