Desenvolvimento de tecnologia para confecção de eletrodos e conjuntos eletrodo-membrana-eletrodo (MEA) por impressão à tela para aplicação em módulos de potência de células PEMFC

Significant functions in the Proton Exchange Membrane Fuel Cells (PEMFCs) rely on Gas Diffusion Layers (GDLs), such as control the water balance in the membrane electrode assembly (MEA), allow suitable gas permeability and porosity, etc. Aware of the GDL importance in the cell performance and its great demand in scale-up projects, the fuel cell research group at Instituto de Pesquisas Energéticas e Nucleares (IPEN) has developed a Sieve Printing method (innovative in Brazil) as a strategic solution for producing GDL and electrodes used in high power PEMFC stacks. The method has shown to be adequate to fabricate low cost electrodes, GDLs of different dimensions and to produce any amount of MEAs for power stacks.

Extração de ácido trans-trans mucônico urinário com polímeros de impressão molecular e análise por cromatografia gasosa: espectrometria de massas

This paper describes selective molecularly imprinted solid-phase extraction of ttMA from urine samples followed by derivatization and analysis by gas chromatography/mass spectrometry (GC/MS). The analytical calibration curve ranged from 0.3 to 7.0 mg L-1 (r = 0.999) and the limit of quantitation (LOQ) was 0.3 mg L-1. The method was applied for the determination of ttMA in urine samples from smokers and concentrations detected ranged from < LOQ to 1.64 mg L-1. Thus, the proposed method proved adequate for the determination of urinary ttMA in the biomonitoring of occupational exposure to low levels of benzene.

Processamento de placas de circuito impresso de equipamentos eletroeletrônicos de pequeno porte

A hydrometallurgical process applicable to printed circuit boards of small electrical and electronic devices was developed. This involved three leaching steps (60 ºC, 2 h): 6 mol L-1 NaOH, 6 mol L-1 HCl and aqua regia. NaOH removed the resin and flame retardant that covered the circuit boards. HCl dissolved the most electropositive metals and a small amount of copper (~0.3 wt%). Aqua regia dissolved the noble metals. Silver precipitated as AgCl. Gold and platinum were quantitatively extracted with pure methyl-isobutylketone and Alamine 336 (10 % vol. in kerosene), respectively. Slow evaporation of the raffinate crystallized CuCl2.4H2O (89% yield).

Análise voltamétrica do corante têxtil do tipo antraquinona empregando eletrodos de carbono impresso

O corante reativo Reactive Blue (RB4), que possui como grupo cromóforo uma antraquinona e um grupo diclorotriazina como grupo reativo, foi determinado em níveis de micromol utilizando eletrodos de carbono impresso empregando a técnica de voltametria de pulso diferencial. Foram obtidas respostas lineares entre a corrente de pico e a concentração do corante entre 3,4 x 10-6 e 3,0 x 10-4 mol L-1 em solução de KCl pH 1,0. Empregando as condições otimizadas para a analise do corante, foi estudada a influência da temperatura de aquecimento na hidrólise do grupo reativo, monitorando um pico de redução em -1,1 V (vs. carbono impresso).

Gerenciamento de resíduos químicos em um laboratório de ensino e pesquisa: a experiência do Laboratório de Limnologia da UFRJ

This work describes the waste management system developed at the Laboratory of Limnology of Federal University of Rio de Janeiro. The initial challenge was to identify and treat a great variety of wastes generated in the analytical procedures performed in the laboratory. Since many of the students and researchers are not chemists, an intensive training was performed during the establishment of the management system. After three years, there was a deep change of attitude of the professionals involved. The present experience may be useful for other laboratories with a profile similar to the one under study.