Determination of anaerobic threshold in rats using the lactate minimum test

The break point of the curve of blood lactate vs exercise load has been called anaerobic threshold (AT) and is considered to be an important indicator of endurance exercise capacity in human subjects. There are few studies of AT determination in animals. We describe a protocol for AT determination by the "lactate minimum test" in rats during swimming exercise. The test is based on the premise that during an incremental exercise test, and after a bout of maximal exercise, blood lactate decreases to a minimum and then increases again. This minimum value indicates the intensity of the AT. Adult male (90 days) Wistar rats adapted to swimming for 2 weeks were used. The initial state of lactic acidosis was obtained by making the animals jump into the water and swim while carrying a load equivalent to 50% of body weight for 6 min (30-s exercise interrupted by a 30-s rest). After a 9-min rest, blood was collected and the incremental swimming test was started. The test consisted of swimming while supporting loads of 4.5, 5.0, 5.5, 6.0 and 7.0% of body weight. Each exercise load lasted 5 min and was followed by a 30-s rest during which blood samples were taken. The blood lactate minimum was determined from a zero-gradient tangent to a spline function fitting the blood lactate vs workload curve. AT was estimated to be 4.95 ± 0.10% of body weight while interpolated blood lactate was 7.17 ± 0.16 mmol/l. These results suggest the application of AT determination in animal studies concerning metabolism during exercise.

Matching salt intake to physiological need in rats using foraging protocols

Several studies of the quantitative relationship between sodium need and sodium intake in rats are reviewed. Using acute diuretic treatment 24 h beforehand, intake matches need fairly accurately when intake is spread out in time by using a hypotonic solution of NaCl. In contrast, using a hypertonic solution, intake is typically double the need. Using the same diuretic treatment, although the natriuresis occurs within ~1 h, the appetite appears only slowly over 24 h. Increased plasma levels of aldosterone parallel the increased intake; however, treatment with metyrapone blocks the rise in aldosterone but has no effect on appetite. Satiation of sodium appetite was studied in rats using sodium loss induced by chronic diuretic treatment and daily salt consumption sessions. When a simulated foraging cost was imposed on NaCl access in the form of a progressive ratio lever press task, rats showed satiation for NaCl (break point) after consuming an amount close to their estimated deficit. The chronic diuretic regimen produced hypovolemia and large increases in plasma aldosterone concentration and renin activity. These parameters were reversed to or toward non-depleted control values at the time of behavioral satiation in the progressive ratio protocol. Satiation mechanisms for sodium appetite thus do appear to exist. However, they do not operate quantitatively when concentrated salt is available at no effort, but instead allow overconsumption. There are reasons to believe that such a bias toward overconsumption may have been beneficial over evolutionary time, but such biasing for salt and other commodities is maladaptive in a resource-rich environment.

Genetic analysis of the ELOVL6 gene polymorphism associated with type 2 diabetes mellitus

Recent animal studies have indicated that overexpression of the elongation of long-chain fatty acids family member 6 (Elovl6) gene can cause insulin resistance and β-cell dysfunction. These are the major factors involved in the development of type 2 diabetes mellitus (T2DM). To identify the relationship between single nucleotide polymorphisms (SNP) ofELOVL6 and T2DM pathogenesis, we conducted a case-control study of 610 Han Chinese individuals (328 newly diagnosed T2DM and 282 healthy subjects). Insulin resistance and islet first-phase secretion function were evaluated by assessment of insulin resistance in a homeostasis model (HOMA-IR) and an arginine stimulation test. Three SNPs of the ELOVL6 gene were genotyped with polymerase chain reaction-restriction fragment length polymorphism, with DNA sequencing used to confirm the results. Only genotypes TT and CT of the ELOVL6 SNP rs12504538 were detected in the samples. Genotype CC was not observed. The T2DM group had a higher frequency of the C allele and the CT genotype than the control group. Subjects with the CT genotype had higher HOMA-IR values than those with the TT genotype. In addition, no statistical significance was observed between the genotype and allele frequencies of the control and T2DM groups for SNPs rs17041272 and rs6824447. The study indicated that the ELOVL6 gene polymorphism rs12504538 is associated with an increased risk of T2DM, because it causes an increase in insulin resistance.

Calcium bioavailability of raw and extruded amaranth grains

Calcium bioavailability of raw and extruded amaranth grains was assessed in a biological assay in rats. Rats were fed for 28 days on diets in which raw or extruded amaranth was the only calcium source, compared to a control diet with calcium carbonate. Calcium and phosphorous levels were determined in the rats' serum during the experimental period and in the bones at the end of the experiment. Amaranth extrusion increased its calcium bioavailability, assessed by tibia and femur weights and calcium and phosphorous content of the bones. Apparent calcium absorption index, the force needed to break the bones and bone densitometry of both extruded and raw amaranth were the same, though different from the control group. The results show that amaranth can be a complementary source of dietary calcium the bioavailability of which is favorably modified by the extrusion process.

Mechanical and water vapor permeability properties of biodegradables films based on methylcellulose, glucomannan, pectin and gelatin

Mimic biological structures such as the cell wall of plant tissues may be an alternative to obtain biodegradable films with improved mechanical and water vapor barrier properties. This study aims to evaluate the mechanical properties and water vapor permeability (WVP) of films produced by using the solvent-casting technique from blended methylcellulose, glucomannan, pectin and gelatin. First, films from polysaccharides at pH 4 were produced. The film with the best mechanical performance (tensile strength = 72.63 MPa; elongation = 9.85%) was obtained from methylcellulose-glucomannan-pectin at ratio 1:4:1, respectively. Then, gelatin was added to this polysaccharide blend and the pH was adjusted to 4, 5 and 6. Results showed significant improvement in WVP when films were made at pH 5 and at polysaccharides/gelatin ratio of 90/10 and 10/90, reaching 0.094 and 0.118 g.mm/h.m².kPa as values, respectively. Films with the best mechanical properties were obtained from the blend of polysaccharides, whereas WVP was improved from the blend of polysaccharides and gelatin at pH 5.

Microencapsulation of babassu coconut milk

The objective of this study was to obtain babassu coconut milk powder microencapsulated by spray drying process using gum Arabic as wall material. Coconut milk was extracted by babassu peeling, grinding (with two parts of water), and vacuum filtration. The milk was pasteurized at 85 ºC for 15 minutes and homogenized to break up the fat globules, rendering the milk a uniform consistency. A central composite rotatable design with a range of independent variables was used: inlet air temperature in the dryer (170-220 ºC) and gum Arabic concentration (10-20%, w/w) on the responses: moisture content (0.52-2.39%), hygroscopicity (6.98-9.86 g adsorbed water/100g solids), water activity (0.14-0.58), lipid oxidation (0.012-0.064 meq peroxide/kg oil), and process yield (20.33-30.19%). All variables influenced significantly the responses evaluated. Microencapsulation was optimized for maximum process yield and minimal lipid oxidation. The coconut milk powder obtained at optimum conditions was characterized in terms of morphology, particle size distribution, bulk and absolute density, porosity, and wettability.

Development and characterization of orally-disintegrating films for propolis delivery

This study aimed at evaluating the effect of different concentrations of hydrolyzed collagen (HC) on the properties of an orally disintegrating film containing propolis ethanol extract (PEE) as an active component. The films were evaluated in terms of total phenols, mechanical properties, solubility, contact angle, disintegration time, and microstructure. The films were prepared by casting with 2 g of protein mass (gelatin and HC), 30 g of sorbitol/100 g of protein mass, and 100 g of PEE/100 g of protein mass. HC was incorporated at concentrations of 0, 10, 20, and 30 g/100 g of protein mass. It was found that increased concentrations of HC reduced tensile strength and increased elongation; however, all films showed plastic behavior. An increase in solubility at 25 ºC, a reduction in the contact angle, and disintegration time were also observed. Thus, higher concentrations of collagen led to more hydrophilic and more soluble polymeric matrices that showed shorter dissolution time, favoring the use of these materials as carriers for active compounds to be delivered in the oral cavity.

The effect of relative humidity on tensile strength and water vapor permeability in chitosan, fish gelatin and transglutaminase edible films

Abstract Composite films of chitosan, fish gelatin and microbial transglutaminase (MTgase) were developed. Films were produced by the casting method and dried at room temperature for 30 h, conditioned for 7 days at 30 °C at a relative humidity (RH) from 11 to 90%, and characterized. Chitosan:fish gelatin films in different proportions (100:0, 75:25, 50:50) with MTgase, were subjected to tensile properties and water vapor transmission (WVT) testing. The results showed that tensile strength decreased with an increase in RH and with an increase in gelatin content. Percent of elongation also increased with increasing RH and gelatin concentration. Water vapor transmission showed an increase proportional to an increase in RH with the presence of gelatin being unfavorable for reducing WVT. Results in this work allowed studying the effect of relative humidity on tensile and water vapor properties of chitosan and fish gelatin films.

The effect of different concentrations of pre-harvest gibberellic acid on the quality and durability of ‘Obilnaja’ and ‘Black Star’ plum varieties

Abstract The research work aimed at investigating the effect of pre-harvest gibberellic acid (GA3) treatment on the quality of ‘Obilnaja’ and ‘Black Star’ Japanese plum varieties. GA3 was sprayed onto the trees during the fruit color break at 0, 25, 50, 75, and 100 ppm concentrations. After pre-cooling, the plums were placed in modified atmosphere packages and exposed to the following conditions as follows: short storage-transportation (ST) [20 days at 2 °C and 90% relative humidity (RH)]; distribution center (DC) (5 days at 6 °C and 80% RH), and shelf life conditions (SL) (2 days at 20 °C and 70% RH). Pre-harvest GA3 treatments increased the fruit weight and size. Treatment of GA3 at 50, 75, and 100 ppm increased the fruit flesh firmness and total soluble substances (TSS) values in both the plum varieties during storage, transport, and marketing; it also limited the weight loss during the marketing process. Treatment of GA3 had no significant effects on the color, titratable acidity (TA), and the total phenolic and antioxidant activity values of plums. Pre-harvest GA3 treatment at 50 ppm GA3 can be thus recommended for both the plum varieties due to its effect on the fruit quality.