Degradação e estabilização do diclofenaco em nanocápsulas poliméricas

The parameters which affect the degradation and stabilization of diclofenac in suspensions of nanocapsules and of the corresponding spray-dried powders were investigated. Formulations were subjected to 14 months of storage at room temperature. In addition, a study of the degradation of diclofenac was carried out by exposing the formulations or mixtures (drug and adjuvants) to UVC wavelengths. The presence of Epikuron 170® in a concentration higher than 3.06 mg/mL stabilizes the drug, avoiding its reduction or degradation. The degradation products were isolated, analyzed by gas chromatography-mass spectrometry, and identified as 2-(2',6'-dichlorophenyl)aminobenzyl alcohol and N-(2',6'-dichlorophenyl)anthranilylaldehyde.

Estabilização de solo contaminado com zinco usando zeólitas sintetizadas a partir de cinzas de carvão

The effect of synthetic zeolites on stabilizing Zn-contaminated soil using 0.01 mol L-1 CaCl2 leaching solution in batch experiments was investigated. The zeolites were synthesized from coal ash by hydrothermal treatment with alkaline solution. The additive enhanced the sorption capacity of the soil and reduced leaching. Zinc leaching was reduced by more than 80% using a minimum of 10% additive. The higher cation exchange capacity of the zeolite/soil mixtures and higher pH were responsible for stabilizing Zn in soil. The poly(2-aminobenzenesulfonic acid)-coated mercury thin-film electrode was used for the determination of zinc.

Efecto de solvente sobre la descomposición térmica de trans-3,6-dimetil-3,6-difenil-1,2,4,5-tetraoxaciclohexano en solución

The thermal decomposition reaction of trans-3,6-dimethyl-3,6-diphenyl-1,2,4,5-tetraoxacyclohexane (acetophenone cyclic diperoxide, DPAF), in different solvents (methanol, 1,4-dioxane, acetonitrile and 2-propanol/benzene mixtures) in the initial concentration and temperature ranges of (4.2-10.5) x 10-3 M and 140.0 to 185.0 ºC, respectively, follows a pseudo first order kinetic law up to at least 70% DPAF conversion. An important solvent effect on the rate constant values, activation parameters (DH# and DS#) and reaction products obtained in different solvents is detected, showing that the reaction is accelerated in alcohols.

Validation and statistical analysis of two high performance liquid chromatography methods for the determination of indinavir sulfate raw material and capsules

Two high performance liquid chromatography (HPLC) methods for the quantitative determination of indinavir sulfate were tested, validated and statistically compared. Assays were carried out using as mobile phases mixtures of dibutylammonium phosphate buffer pH 6.5 and acetonitrile (55:45) at 1 mL/min or citrate buffer pH 5 and acetonitrile (60:40) at 1 mL/min, an octylsilane column (RP-8) and a UV spectrophotometric detector at 260 nm. Both methods showed good sensitivity, linearity, precision and accuracy. The statistical analysis using the t-student test for the determination of indinavir sulfate raw material and capsules indicated no statistically significant difference between the two methods.

Análise sistemática de reagentes e resíduos sem identificação

This work presents a detailed routine applied to the identification of unknown chemicals and wastes. 786 specimens were analyzed during 20 months. Unknown materials fell into three basic classes: (i) commercial chemicals without labels or illegible ones; (ii) laboratory synthesis products; (iii) used solvents (including mixtures). Uranium and thorium were recovered form their wastes. Unknown chemicals were mainly inorganic compounds, many of which had never been opened. Alkaline salts were dominant, but also precious metal compounds were identified. Laboratory synthesis products were organic compounds. The final destination depended on the nature of the chemical. Most organic compounds were sent to incineration; inorganic salts were distributed among several public organizations, including secondary and technical schools. The work described in this paper greatly reduced the amount of wastes that had to be sent to disposal.

Resina de Protium heptaphyllum: isolamento, caracterização estrutural e avaliação das propriedades térmicas

Three mixtures of triterpenes (maniladiol and breine; alpha and beta-amyrin; lupenone, alpha and beta-amyrinone) were isolated from Protium heptaphyllum March resin. The structural identification was based on NMR and mass spectrometry data. Lupenone, and alpha and beta-amyrinone were not reported before as constituents of this resin. The resin was submitted to methylation and acetylation reactions. The pure and derivatized resins and the mixtures (maniladiol and breine; alpha and beta-amyrin) were analyzed by TG and DSC. The TG curves revealed that the derivatization decreases the thermal stability of the resin. The DSC curves showed peaks that can be assigned to evaporation and phase transitions processes.

A destilação simulada na indústria do petróleo

One of the most widely used physico-chemical characterizations of hydrocarbon mixtures is the determination of their boiling point distribution. Knowledge of the boiling range of crude oils and petroleum products is essential to ensure the correct specification of final products and to control refinery processes. Simulated distillation, a GC based process, has been playing this role for the past decades in the petroleum industry. The main purpose of this work is to show the fundamentals of this technique as well as its present trends.

Saponinas triterpênicas de Tocoyena brasiliensis Mart. (Rubiaceae)

The present communication reports the isolation and identification of four triterpenoid saponins from the chloroform extract of the leaves of Tocoyena brasiliensis: 3-O-beta-D-quinovopyranosyl quinovic acid, 3-O-beta-D-quinovopyranosyl cincholic acid, 3-O-beta-D-glucopyranosyl quinovic acid and the 28-O-beta-D-glucopyranosyl ester derivative of quinovic acid as binary mixtures, respectively. From the ethanol extract a flavonoid identified as ramnazin-3-O-rutinoside was obtained. The structures of these compounds were assigned by data analysis of 1D and 2D NMR spectrometry and comparison with data recorded in the literature for these compounds.

Constituintes químicos da raiz e do talo da folha do açaí (Euterpe precatoria Mart., Arecaceae)

Phytochemical investigation of the hexane, ethyl acetate and methanolic extracts of roots and leaf stalks of Euterpe precatoria Mart. ("açaí"), afforded stigmast-4-en-6beta-ol-3-one (3); p-hydroxy benzoic acid (4); 3beta-O-D-glucopyranosyl-sitosterol (5); beta-sitosterol palmitate (6); mixtures of beta-sitosterol and stigmasterol (1 and 2), alpha-, beta-amirin and lupeol (7, 8 and 9), friedelin-3-one and 28-hydroxy-friedelin-3-one (10 and 11) and alpha-, beta-D-glucose (12, 13). Except for 1, 2 and 4, the other isolated constituents are described in the genus for the first time. Compounds 3 and 5 gave good results in the brine shrimp bioassay, which detects compounds with potential uses as antitumor agents, pesticides, etc..

Cromatografia de troca-iônica aplicada ao isolamento da fração ácida do óleo de copaíba (Copaifera multijuga) e da sacaca (Croton cajucara)

Plant extracts are usually complex mixtures which contain several molecules of different sizes with varied functional groups. Such extracts are a challenge to the chemist of natural products. Ion exchange chromatography in non-aqueous medium, used for separation of basic or acidic fractions from plant extracts, is an important unit operation in preparative scale separations. Anionic macroporous resin in non-aqueous medium was used with success in this study for separation of the acid fraction of Copaifera multijuga (Copaiba oil), rich in labdanic diterpenes and for the methanolic extract of Croton cajucara (acetyl aleuritoric acid).

Montagem de câmara com lâmpada de ultravioleta de baixo custo

Thin layer chromatography is a quick, inexpensive and effective way of screening mixtures of non-volatile organic compounds and it is highly recommended for analytical studies. Inspection of plates under ultraviolet light for the detection of colourless compounds should be performed before any further chemical methods are applied. Construction of a low-cost UV-viewing cabinet with lamp employing parts easily found on the local market is described.

O modelamento estatístico de misturas: experimento tutorial usando voltametria de redissolução anódica

This work illustrates the modeling procedure for a solvent mixture using the simplex- centroid approach. The selected experiment was the optimization of the peak current observed in the direct determination of nickel by anodic stripping voltammetry (ASV) in a solvent mixture composed of N,N-dimethylformamide, ethanol and water. The text is presented in a tutorial way, showing in detail the several steps which must be followed in such a process. Since not all possible mixtures lead to a measurable instrumental response, pseudocomponents had to be used to rescale the experimental design. This also allows to show how to apply this tool, usually troublesome for non-specialists in mixture modeling procedures.

Uso de lodo de estação de tratamento de água centrifugado em matriz de concreto de cimento portland para reduzir o impacto ambiental

An alternative application of the humid sludge from the Passaúna WTP, located in Curitiba's metropolitan area, is proposed for concrete structures, partially replacing aggregates and cement. For the investigation, a reference concrete and four concrete mixtures with sludge were produced, and from these, two mixtures, containing 4% and 8% of sludge (m/m), were analyzed by different techniques: X ray fluorescence, X ray diffraction, thermo-gravimetric analysis, physicochemical analysis, compressive strength, etc. The properties were evaluated and the results indicate that the mixtures can be applied in different situations as cast structures for construction of concrete walls. Mixtures with more than 4% of sludge are restricted to applications where the workability of the concrete is not required, such as for residential pavements, sidewalks and stepping floors.

Imobilização de TiO2 em concreto: fotodegradação de clorofórmio e fenol

TiO2 immobilization on concrete was studied using mixtures with cement, varnish and resin. The UV radiation sources were a germicide UV lamp and solar light. Aqueous solutions of chloroform (CHCl3) and of phenol were prepared and recirculated over the TiO2 immobilized surfaces. The immobilized TiO2 surfaces showed better photocatalytic efficiency for phenol degradation compared to the control. For CHCl3, the presence or absence of the catalyst did not cause any significant difference to its degradation efficiency. The micrographic results showed a more homogeneous surface for TiO2 immobilized in resin and varnish.

Comportamento de cristalização de lipídios estruturados obtidos a partir de gordura de palmiste e óleo de peixe

The aim of this study is to evaluate the crystal structure of binary mixtures of palm kernel fat and fish oil, before and after chemical and enzymatic interesterification. The crystal structure was analyzed by polarized light microscopy. The addition of fish oil didn't change the palm kernel fat crystallization characteristics, spherullites of types A and B being observed. However, due to chemical and enzymatic interesterification, smaller crystals were obtained. There was no difference between chemical and enzymatic interesterification, probably as a function of acyl migration in discontinuous processes catalyzed by lipases.