Extração no ponto nuvem de compostos orgânicos homólogos e isômeros

In this work, the feasibility of employing micelle-mediated extraction for selective separation of homologous or isomeric organic compounds is demonstrated. Firstly, the main parameters controlling extraction performances, such as surfactant concentration and temperature were varied. A Scheffé-type experimental design was demonstrated as a novel and useful method to characterize the various experimental factors. At each point selected in the two-phase domain and for a given solute, extraction percentage (E%), concentration ratio, phase volume ratio, and equilibrium partition coefficient (K C) were determined. The values of E% and K C decrease in the following order: phenol > 1-phenylethanol ~ 2-phenylethanol > benzyl alcohol.

Comparação da eficiência do processo de ozonização e ozonização catalítica (Mn II e Cu II) na degradação de fenol

This paper discusses the results obtained with homogeneous catalytic ozonation [Mn (II) and Cu (II)] in phenol degradation. The reduction of total phenols and total organic carbon (TOC) and the ozone consumption were evaluated. The efficiency in phenol degradation (total phenol removal) at pH 3, with the catalytic process (Mn (II)), increased from 37% to 55% while the TOC removal increased from 4 to 63% in a seven-minute treatment. The ozonation process efficiency at pH 10 was 43% and 39% for phenol and TOC removal, respectively. The presence of both metallic ions (Mn2+ and Cu+2) in the ozonation process resulted in a positive effect.

Imobilização de TiO2 em concreto: fotodegradação de clorofórmio e fenol

TiO2 immobilization on concrete was studied using mixtures with cement, varnish and resin. The UV radiation sources were a germicide UV lamp and solar light. Aqueous solutions of chloroform (CHCl3) and of phenol were prepared and recirculated over the TiO2 immobilized surfaces. The immobilized TiO2 surfaces showed better photocatalytic efficiency for phenol degradation compared to the control. For CHCl3, the presence or absence of the catalyst did not cause any significant difference to its degradation efficiency. The micrographic results showed a more homogeneous surface for TiO2 immobilized in resin and varnish.

Avaliação da fotodegradação de poliolefinas através de exposição natural e artificial

Samples of polypropylene (PP) and low-density polyethylene (LDPE) were submitted to ultraviolet radiation, in the natural environment and also in the laboratory. Chemical modifications were quantified by the carbonyl index (CI), mechanical properties and melt flow index. The degradation in the laboratory was comparatively faster than in the environment for both types of polymers. The accelerating factor was determined for the various properties investigated. This parameter, however, showed a large variation with the degradation criteria and the type of polymer. The existence of a "universal accelerating factor", therefore, was not observed in the current study.

Adsorção de fenol sobre carvão ativado em meio alcalino

The present study describes phenol adsorption on commercial active carbon (CAF) under alkaline conditions in the concentration range of 0.01 to 2.08 mmol L-1. Surface characterization has been performed by means of surface area measurements, IR spectroscopy and Boehm titration. The effect of temperature on the adsorption equilibrium isotherm was investigated at 23, 30, 40, 50 and 60 °C. The results showed that adsorption capacity decreased with increasing temperature. The adsorption kinetics and the role of surface characteristics on the adsorption of phenol also discussed.

Constituintes químicos da casca do caule de Amburana cearensis A.C. Smith

The phytochemical analysis of the ethanol extract trunk bark of Amburana cearensis allowed the isolation and identification of twelve constituents: coumarin, sucrose, two phenol acids (vanillic acid and protocatechuic acid), five flavonoids (afrormosin, isokaempferide, kaempferol, quercetin and 4'-methoxy-fisetin), a phenol glucoside (amburoside A) and a mixture of glucosilated b-sitosterol and stigmasterol. Their structures were elucidated by spectroscopic methods such as IR, MS, ¹H and 13C NMR, including uni and bidimensional techniques, in addition to comparison with literature data.

Constituintes químicos de Philodendron imbe Schott

The chemical composition of the ethanolic extract of the leaves and roots from Philodendron imbe Schott was investigated. The main constituents isolated the leaves were beta-sitosterol one polyprenoid hexaprenol, and 6beta-hydroxy-stigmast-4-en-3-one, a steroid, not yet reported in the Philodendron gender. A mixture of constituents, namely, ethyl myristoleate, alpha-bisabolol, ethyl isopalmitate, 3-octadecenyl-phenol and the major component ethyl palmitate, were isolated from the roots. Structure elucidation of these secondary metabolites was accomplished by spectrometric analysis, including 1D and 2D NMR experiments such as ¹H, ¹H and ¹H,13C-COSY.

Efeito do intemperismo artificial em quatro madeiras tropicais monitorado por espectroscopia de infravermelho (DRIFT)

Four tropical woods, were investigated to compare their performance and natural resistances to artificial weathering using the diffuse reflectance infrared Fourier transform spectroscopy (DRIFT). The species were garapeira (Apuleia leiocarpa), itaúba (Mezilaurus itauba) and tauari (Couratari sp.), woods traditionally indicated for exterior uses, and marupá (Simarouba amara), that served as reference. The samples were submitted to cycles of UV radiation (350 nm) and water until 2,000 h. The photodegradation processes of woods surfaces were accomplished monitoring the changes in the intensities associated to lignin (1508 cm-1) and carbonyl group (1736 cm-1) absorptions. The results have shown that lignin was the first component to be photodegradated, resulting in surfaces mainly composed by cellulose, after 2,000 h of UV irradiation. The processes of formation and lixiviation of carbonyl compounds were different for each species. The experimental conditions used in this work were too severe to evaluate the wood density and extractives content influences during the treatment.

Biodegradação de fenol por uma nova linhagem de A spergillus sp. isolada de um solo contaminado do sul do Brasil

The main goal of this work was to study the biodegradation of phenol in batch mode by a filamentous fungus isolated from a contaminated site in Southern Brazil. A better performance was obtained by previous adaptation of the microorganism to the toxic chemical. A 2³ experimental design was proposed and it could be observed total phenol degradation in 72 h using 500 mg L-1 glucose, inoculum of 20% and agitation of 200 rpm, resulting a biodegradation rate of 3.76 mg L-1 h-1. In relation to phenol tolerance, Aspergillus sp. LEBM2 was able to consume up to 989 ± 15 mg L-1.

Caracterización del proceso de adsorción de 3-cloro fenol desde solución acuosa sobre carbon activado por calorimetria de inmersión

The immersion enthalpy of activated carbon in 3-chlorophenol solutions, of 100 mg L-1, is determined at different pH values between 3 and 11 with results between 37.6 and 21.2 J g-1. The 3-chlorophenol adsorbed quantities on the activated carbon during the calorimetric experience, are between 1.13 and 2.19 mg g-1, for different pH values of the solution. The 3-chlorophenol adsorbed quantity and the immersion enthalpy decrease by increasing of the pH solution, while increasing the adsorbed quantity increases the immersion enthalpy value.

Preparação e utilização de uma argila esmectítica organofílica como adsorvente de fenol

The main goal of this research was the preparation and use of a organophilic smectitic clay able to promoting the adsorption of phenol. In this work was used a natural clay called Chocolate, from Campina Grande - PB (Brazil). The natural clay was treated with a solution of sodium carbonate. After this the sodium clay was treated with quaternary ammonium salt. The adsorptive study was conducted by different values of pH and temperature. The results showed a better performance in adsorptive at pH 7 and temperature 30 ºC, with removal of more than 80% of phenol.

Degradação de benzeno, tolueno e xilenos em águas contaminadas por gasolina, utilizando-se processos foto-Fenton

In this work the potentiality of photo-Fenton processes were investigated toward the degradation of aromatic hydrocarbons (BTXs) from water contaminated with gasoline. The main results demonstrated that BTXs can be quickly degraded by photo-Fenton process assisted by solar or artificial UV-A radiation, degradation that leads to generation of characteristic phenolic transient species (ie. phenol, hydroquinone and catechol). In the treatment of contaminated water by photo-Fenton processes assisted by solar light, complete BTXs removal was observed in reaction times of about 5 min. Mineralization of about 90% was also observed by applying a multiple H2O2 addition system.

Nanoestruturas em fotocatálise: uma revisão sobre estratégias de síntese de fotocatalisadores em escala nanométrica

Advanced oxidative processes (AOPs) are based on chemical processes that can generate free radicals, such as hydroxyl radicals (.OH) which are strong, non-selective oxidant species that react with the vast majority of organic compounds. Nanostructured semiconductors, especially titanium dioxide (TiO2) in the anatase phase, are well-established photocatalysts for this process, which have proved to be useful in the degradation of dyes, pesticides and other contaminants. Research in different strategies for the synthesis of nanostructured semiconductors, with particular characteristic is currently a topic of interest in many studies. Thus, this paper presents a review about various synthesis strategies of nanostructured photocatalysts.

Nanocompósitos semicondutores ZnO/TiO2: testes fotocatalíticos

Titanium dioxide is an efficient photocatalist, being possible to improve its efficiency with better charge separation which occurs when it is coupled with other semiconductors. Nanometric particles of ZnO were used to impregnate TiO2 P25 in order to optimize its photocatalytic properties. ZnO/TiO2 composites were obtained at different proportions and were characterized by X-ray diffraction (XRD), micro-Raman and diffuse reflectance spectroscopies, measurement of surface area (BET) and scanning electron microscopy (SEM). Raman spectroscopy data revealed a change on the TiO2 surface due the presence of ZnO which was observed by an enlargement of TiO2 peaks and a change on the relation rate between anatase and rutile phases of the composites. The photodegradation of azo-dye Drimaren red revealed better efficiency for ZnO/TiO2 3% nanocomposite and for ZnO pure.

Blainvillea rhomboidea: constituintes químicos e atividade citotóxica

The phytochemical investigation of the ethanol extract from the aerial parts of Blainvillea rhomboidea (Asteraceae) resulted in the isolation and characterization of 8β-tigloyloxy-grazielia acid, together with the flavonoids derrone, acacetin, luteolin and luteolin 7-methyl ether, and p-(1-methyl-ethan-1-ol)-phenol. The structures of all compounds were determined by spectroscopic methods (¹H and 13C NMR and HREIMS) and comparison with published spectral data. The flavonoids luteolin and 7-O-metyl-luteolin, isolated from the active dichloromethane fraction, showed moderate cytotoxic activity.