Caracterización del proceso de adsorción de 3-cloro fenol desde solución acuosa sobre carbon activado por calorimetria de inmersión

The immersion enthalpy of activated carbon in 3-chlorophenol solutions, of 100 mg L-1, is determined at different pH values between 3 and 11 with results between 37.6 and 21.2 J g-1. The 3-chlorophenol adsorbed quantities on the activated carbon during the calorimetric experience, are between 1.13 and 2.19 mg g-1, for different pH values of the solution. The 3-chlorophenol adsorbed quantity and the immersion enthalpy decrease by increasing of the pH solution, while increasing the adsorbed quantity increases the immersion enthalpy value.

Remoção de chumbo(II) em sistemas contínuos por carvão ativado com vapor

Fixed-bed column studies were undertaken to evaluate the performance of a commercial Brazilian activated carbon in removing Pb(II) from aqueous environment. Breakthrough points were found out for the metal adsorption by varying different operating parameters like feed concentrations (10 and 20 mg L-1) and bed heights (0.5, 1.5 and 2.8 cm). A good agreement was observed between the experimental data and the values predicted by the bed depth service time (BDST) model. Regeneration of the exhausted columns was possible with HCl, and the adsorption capacity was maintained after three adsorption-desorption cycles.

Remoção de íons Zn2+, Cd2+ e Pb2+ de soluções aquosas usando compósito magnético de zeólita de cinzas de carvão

For this study, magnetic composite of zeolite-magnetite was prepared by mixing magnetite nanoparticles suspension with synthetic zeolite. The nanoparticles in suspension were synthesized by precipitating iron ions in a NaOH solution. The zeolite was synthesized from coal fly ash by alkaline hydrothermal treatment. The magnetic composite was characterized by XDR, SEM, magnetization measurements, IR, and BET surface area. Batch tests were carried out to investigate the adsorption of metal ions of Zn2+, Cd2+ and Pb2+ from aqueous solution onto magnetic composite. Adsorption isotherms were analyzed using Freundlich and Langmuir equations. The adsorption equilibrium data fitted well to the Langmuir equation with maximum adsorption capacities in the range of 28.5-127 mg g-1.

Rejeito de mineração de carvão como adsorvente para remoção da acidez, Fe (III), Al (III) e Mn (II) em drenagem ácida

This study aimed the use of coal mining waste as a new adsorbent for H3O+ and removal of Al (III), Fe (III) and Mn (II) from acid mine drainage. Data from kinetic and equilibrium of the adsorption of H3O+ followed the pseudo second-order and Langmuir isotherm models. The maximum adsorption capacity of H3O+ was 316 mmol kg-1. The adsorbent removed 100% of Al (III), 100% of Fe (III) and 89% of Mn (II), suggesting its use as an alternative for the treatment of acid mine drainage.

Relación entre la entalpía de inmersión de monolitos de carbon activado y parametros texturales

In this study, Disc and honeycomb-shaped activated carbon monoliths were obtained using as a precursor coconut shell, without the use of any binder. Textural characterization was performed by adsorption of N2 at 77 K and immersion calorimetry into benzene. The experimental results showed that the activation with zinc chloride produces a wide development of micropores, yielding micropore volumes between 0,38 and 0,79 cm³ g-1, apparent BET surface area between 725 and 1523 m² g-1 and immersion enthalpy between 73,5 and 164,2 J g-1.Were made comparisons between textural parameters and energy characteristics.

Remoção dos corantes azul brilhante, amarelo crepúsculo e amarelo tartrazina de soluções aquosas utilizando carvão ativado, terra ativada, terra diatomácea, quitina e quitosana: estudos de equilíbrio e termodinâmica

This work compared activated carbon, activated earth, diatomaceous earth, chitin and chitosan to removal acid blue 9, food yellow 3 and FD&C yellow nº 5 dyes from aqueous solutions with different pH values (2-10). In the best process condition for each dye, equilibrium studies were carried out at different temperatures (from 298 to 328 K) and Langmuir, Freundlich, Redlich-Peterson, Temkin and Dubinin-Radushkevich models were fitted with experimental data. In addition, entropy change, Gibbs free energy change and enthalpy change were obtained in order to verify the thermodynamic adsorption behavior.

Esterificação de ácidos graxos utilizando zircônia sulfatada e compósitos carvão ativado/zircônia sulfatada como catalisadores

In this work sulfated zirconia (SZr) and activated carbon/SZr composites produced by impregnation method with or without heating treatment step (CABC/SZr-I and CABC/SZr-I SC) and by the method of synthesis of SZr on the carbon (CABC/SZr-S) was used as catalysts in the esterification reactions of fatty acids. The SZr presented very active, conversions higher than 90% were obtained after 2 h of reaction. The activity of the composite CABC/SZr-I20%SC was up to 92%, however, this was directly related to time and temperature reactions. CABC/SZr-I and CABC/SZr-S were less active in esterification reactions, what could be attributed to its low acidity

Caracterização cromatográfica de compostos orgânicos presentes nos resíduos sólidos provenientes de indústria de reciclagem de papel e sua aplicação na produção de briquetes de carvão vegetal

Recycling of paper in industrial scale has become an established practice worldwide. In this work, organic compositions of three different kinds of sludge generated in recycle paper industry were studied, and the incorporation of one of those sludge in briket was also investigated. The characterization of organic compounds in sludge samples and briket was performed using Gas Chromatography coupled with Mass Spectrometry after a Soxhlet extraction. Different chemical classes were identified in each type of sludge, but just the sludge composed by cellulose residue did not presented polyaromatic hydrocarbons. Four formulations of sludge incorporated with charcoal for briket production were evaluated.

Oxidação de glicerol sobre nanopartículas de ouro suportadas em carvão ativado: monitoramento quimiométrico da reação por ESI-MS e MIR

A study on the monitoring of glycerol oxidation catalyzed by gold nanoparticles supported on activated carbon under mild conditions by chemometric methods is presented. The reaction was monitored by mass spectrometry-electrospray ionization (ESI-MS) and comparatively by mid infrared spectroscopy (MIR). Concentration profiles of reagent and products were determined by chemometric tools such as Principal Component Analysis (PCA), Evolving Factor Analysis (EFA) and Multivariate Curve Resolution (MCR). The gold nanoparticle catalyst was relatively active in glycerol oxidation, favoring formation of high added value products. It was found that the reaction stabilization was reached at four hours, with approximately 70% glycerol conversion and high selectivity for glycerate.

Caracterização detalhada de material de referência certificado de carvão brasileiro

The use and characterization of the first Certified Reference Material (CRM) of Brazilian coal for analytical quality control are presented. All results were determined within the limits of repeatability and reproducibility allowed under the standards. Notable among the characterization parameters was the mineral matter content (45.39%) obtained by an alternative procedure showing a low relative error (-2.1%) compared to the standard technique (low ashing temperature). The possible expanded application of this CRM application in national laboratories, beyond the certificated and reference parameters, has advantages such as lower cost and easy availability, but round robin tests must be performed.

Remoção de compostos fenólicos de soluções aquosas utilizando carvão ativado preparado a partir do aguapé (Eichhornia crassipes): estudo cinético e de equilíbrio termodinâmico

Activated carbon was produced from the water hyacinth (CAA) by impregnation with ZnCl2 (1:2), followed by pyrolysis at 700 ºC, under N2. CAA was used for the adsorption of phenol, m-cresol and o-cresol from aqueous solutions, using batch adsorption. The effects of contact time, pH, temperature and concentration on sorption were investigated. Adsorption capacity, calculated using the Langmuir model proved to be dependent on temperature, reaching values of 163.7, 130.2 and 142.3 mg g-1 for phenol, m-cresol and o-cresol, respectively, at 45 ºC. Thermodynamic data at the solid-liquid interface suggests an endothermic, spontaneous and environmentally-friendly process.

Estudo da liberação controlada do herbicida ametrina em compósitos à base de PVA: carvão ativado

Herbicides have great importance in agricultural productivity for weed control, given their competition with crops. However, inadequate application of herbicides may lead to environmental problems, which can be minimized through controlled release of the active compounds. This may be achieved by protecting the herbicide in a structure with adequate porosity, where the diffusional behavior can determine release. Thus, in this study we evaluated a novel structure, a composite based on activated carbon bonded by polyvinyl alcohol (PVA) as pellets, to deliver a triazine herbicide. The product obtained was shown to be adequate for its purpose, since it was possible to process regular pellets, where the PVA percentage determined the properties.

Remoção do ácido mefenâmico em água utilizando carvão ativado em pó, lama vermelha e oxidação com cloro

The use of activated carbon powder (ACP), red mud and oxidation with chlorine to remove mefenamic acid in water are described, aimed at their application as a complement to sewage treatment processes in Brazil. A study on the behavior of mefenamic acid in water was performed by evaluating its dissolution for different concentrations and times. Subsequently, the optimal conditions for removal of mefenamic acid were investigated using ACP adsorption at different pH and concentrations, and red mud adsorption using different pH. The utilization of different pH and times was also investigated to establish the ideal conditions for chemical oxidation of the drug. Among the different conditions studied, the best condition for drug removal by ACP and red mud were 100% and 96%, respectively, while the best condition for chemical oxidation occurred using solutions with pH 6 and 7 and reaction times of 30 and 60 minutes.

TRATAMENTO DA VINHAÇA POR ADSORÇÃO EM CARVÃO DE BAGAÇO DE CANA-DE-AÇÚCAR

The aim of this study was to develop an effective and economically viable technology for the treatment of vinasse, prior to its disposal in the soil for fertirrigation, aiming this way at reducing the environmental impacts generated by inadequately discarding this effluent. The primary treatment of vinasse by adsorption was evaluated. Adsorbents were prepared from sugar cane bagasse and their efficiency evaluated in relation to the treatment of vinasse. The process of preparation of activated carbon consisted of carbonizing bagasse at different temperatures followed by chemical activation with NaOH. The carbon samples obtained by solely carbonizing sugar cane bagasse were more efficient for removing turbidity of vinasse than samples activated with NaOH. The sample carbonized at 800 °C was the most efficient for removing turbidity of wastewater (83%). During a process of adsorption of vinasse in two stages, it was possible to obtain color removal, turbidity and COD of approximately 76, 85 and 69%, respectively. After the adsorption step of vinasse, the solid waste generated in the second stage of adsorption can be burned in the boilers of the power plant itself, affording an energy of 4606 cal g-1.

Avaliação do emprego dos adsorventes: carvão ativo, chromosorb W e membrana C18 na preparação de amostras de ar para a determinação de d-aletrina em ambientes fechados

Os piretróides sintéticos são inseticidas amplamente utilizados para o controle de agentes patogênicos, desde a produção agrícola até a proteção da saúde humana, porém, apesar de suas inúmeras vantagens podem causar intoxicações em indivíduos potencialmente expostos a suas diversas apresentações. Amostras de ar foram coletadas pela geração da atmosfera padrão, onde a d-aletrina foi adsorvida em cartuchos contendo Carvão Ativo, Chromosorb W e/ou Membrana C18. As determinações das concentrações da d-aletrina foram efetuadas empregando um sistema de cromatografia gasosa. Os adsorventes Carvão ativo, Chromosorb W e Membrana C18 apresentaram adsorções de 100,8., 104,1 e 100,5%, com um desvio padrão relativo de 4,1, 7,5 e 7,9%, respectivamente. Coletou-se amostras de ar para a determinação da concentração da d-aletrina em diferentes em ambientes fechados, em diferentes dias da semana, obtendo-se níveis de concentração de d-aletrina de 3,4., 8,5 e 12,7 mig.m³, respectivamente.