An experimental/numerical study of the turbulent boundary layer development along a surface with a sudden change in roughness

A theory for the description of turbulent boundary layer flows over surfaces with a sudden change in roughness is considered. The theory resorts to the concept of displacement in origin to specify a wall function boundary condition for a kappa-epsilon model. An approximate algebraic expression for the displacement in origin is obtained from the experimental data by using the chart method of Perry and Joubert(J.F.M., vol. 17, pp. 193-122, 1963). This expression is subsequently included in the near wall logarithmic velocity profile, which is then adopted as a boundary condition for a kappa-epsilon modelling of the external flow. The results are compared with the lower atmospheric observations made by Bradley(Q. J. Roy. Meteo. Soc., vol. 94, pp. 361-379, 1968) as well as with velocity profiles extracted from a set of wind tunnel experiments carried out by Avelino et al.( 7th ENCIT, 1998). The measurements are found to be in good agreement with the theoretical computations. The skin-friction coefficient was calculated according to the chart method of Perry and Joubert(J.F.M., vol. 17, pp. 193-122, 1963) and to a balance of the integral momentum equation. In particular, the growth of the internal boundary layer thickness obtained from the numerical simulation is compared with predictions of the experimental data calculated by two methods, the "knee" point method and the "merge" point method.

Turbulent heat transfer and pressure drop in pinned annular regions

Experiments were performed to determine average heat transfer coefficients and friction factors for turbulent flow through annular ducts with pin fins. The measurements were carried out by means of a double-pipe heat exchanger. The total number of pins attached to the inner wall of the annular region was 560. The working fluids were air, flowing in the annular channel, and water through the inner circular tube. The average heat transfer coefficients of the pinned air-side were obtained from the experimental determination of the overall heat transfer coefficients of the heat exchanger and from the knowledge of the average heat transfer coefficients of the circular pipe (water-side), which could be found in the pertinent literature. To attain fully developed conditions, the heat exchanger was built with additional lengths before and after the test section. The inner circular duct of the heat exchanger and the pin fins were made of brass. Due to the high thermal conductivity of the brass, the small tube thickness and water temperature variation, the surface of the internal tube was practically isothermal. The external tube was made of an industrial plastic which was insulated from the environment by means of a glass wool batt. In this manner, the outer surface of the annular channel can be considered adiabatic. The results are presented in dimensionless forms, in terms of average Nusselt numbers and friction factors as functions of the flow Reynolds number, ranging from 13,000 to 80,000. The pin fin efficiency, which depends on the heat transfer coefficient, is also determined as a function of dimensionless parameters. A comparison of the present results with those for smooth sections (without pins) is also presented. The purpose of such a comparison is to study the influence of the presence of the pins on the pressure drop and heat transfer rate.

Is there correlation between the turbulent eddies size and mechanical hemolysis ?

Hemolytic profile of an artificial device chronically implanted in the cardiovascular system may represent the difference between the success and failure in its long-term performance. Last decades have witnessed efforts on the development of methods capable of predicting red blood cell damage in artificial organs. However, all of them have had limited success to predict hemolysis. The primary cause of this problem is that such models do not take into consideration structures of turbulent flow. The present paper demonstrates that microscopic measurable occurrences of the turbulent flow may be linked to red blood cell trauma. This study suggests that if the smallest turbulent eddies dimension is under 10 m m hemolysis is not dependent on the exposure time and the red blood cells damage depends only on the dissipation of the turbulent energy in the erythrocyte membrane. The analysis reported here opens the possibility of mapping the flow field in artificial assist devices based on the smallest eddy length scales. This is a promising new trend and should be considered in the designing requirements of the next generations of artificial organs.

Rice seedling and plant development as affected by increasing rates of penoxsulam under controlled environments

Rice is a major staple in many countries. Weed control is one of the factors limiting higher rice yield. ALS (acetolactate synthase)-inhibiting herbicides are desirable weed control herbicides because of their high efficacy, low toxicity to mammalians, and low rates used. An important herbicide characteristic is high selectivity to the crop, since it facilitates fast crop establishment and greater crop advantage over the weeds. The objectives of this work were to study the effects of increasing rates of the ALS-inhibiting herbicide penoxsulam on seed integrity and germination, and seedling and plant development of rice cv. BRS Pelota under controlled laboratory and greenhouse conditions. The results showed that penoxsulam affected rice germination and seedling and plant growth at rates above 54 g a.i. ha-1, and that penoxsulam is safe for rice seedling development at the currently recommended rates.

Planktonic diatoms in lotic and lentic environments in the Lago dos Tigres hydrologic system (Britânia, Goiás, Brazil): Coscinodiscophyceae and Fragilariophyceae

A floristic study of Coscinodiscophyceae and Fragilariophyceae in the Lago dos Tigres hydrologic system is presented. Phytoplankton samples were collected with a plankton net (25 µm mesh) at 11 sampling stations, three in lotic areas and eight in lacustrine zones. Eleven species of Coscinodiscophyceae and eight of Fragilariophyceae were identified; descriptions, comments, their geographic distributions for the midwestern region of Brazil, type of environment (lentic/lotic), and illustrations are provided. Among the taxa found, 13 were recorded for the first time in midwestern Brazil: Aulacoseira alpigena, A. distans, A. granulata var. angustissima, A. granulata var. valida, A. muzzanensis, Discostella stelligera var. stelligera, Fragilaria capucina var. fragilarioides, F. delicatissima var. delicatissima, F. javanica, Pleurosira laevis, Staurosira acutirostrata, Staurosirella crassa, and Ulnaria ulna.

Vitamin D3-induced calcemic and phosphatemic responses in the freshwater mud eel Amphipnous cuchia maintained in different calcium environments

Vitamin D3 (100 ng 100 g body weight-l day-l) was administered intraperitoneally (ip) to the freshwater mud eel Amphipnous cuchia kept in artificial freshwater, calcium-free freshwater, low-calcium freshwater (0.2 mmol/l CaCl2) or calcium-rich freshwater (13.4 mmol/l CaCl2) for 15 days. Analyses of serum calcium and phosphate levels were performed on days 1, 3, 5, 10 and 15 after the beginning of the experiment (six eels from each group at each interval). Administration of vitamin D3 elevated the serum calcium [maximum elevation occurred at day 10 in artificial freshwater (vehicle: 10.55 ± 0.298, vitamin D: 13.90 ± 0.324), low-calcium freshwater (vehicle: 11.17 ± 0.220, vitamin D: 12.98 ± 0.297) and calcium-rich freshwater (vehicle: 11.24 ± 0.373, vitamin D: 14.24 ± 0.208) whereas it occurred at day 5 (vehicle: 8.42 ± 0.253, vitamin D: 11.07 ± 0.328) in calcium-free freshwater] and phosphate levels [maximum elevation at day 15 in artificial freshwater (vehicle: 4.39 ± 0.105, vitamin D: 5.37 ± 0.121), calcium-free freshwater (vehicle: 4.25 ± 0.193, vitamin D: 5.12 ± 0.181), low-calcium freshwater (vehicle: 3.93 ± 0.199, vitamin D: 5.28 ± 0.164) and calcium-rich freshwater (vehicle: 3.77 ± 0.125, vitamin D: 5.46 ± 0.151)] of the fish maintained in the above mentioned environmental media, but the responses were more pronounced in the fish kept in calcium-rich media

Desiccation tolerance of Tapirira obtusa seeds collected from different environments

This study was aimed at evaluating the desiccation sensitivity in seeds of the tree Tapirira obtusa (Benth.) J. D. Mitchell collected from three different environments and subjected to two distinct drying speeds. Seeds were collected from a rocky area, in the "Cerrado", and in a riparian forest area, in the region of municipality of Lavras, State of Minas Gerais. The seeds were subjected to drying with magnesium chloride (slow drying) or silica gel (fast drying), into closed environment, until moisture contents of 40%, 30%, 20% and 10%, considering as control, the percentage of germination at the initial moisture content in each environment, which varied from 47% to 50%. Percentages of germination and normal seedlings as well as germination speed index were assessed. For the three environments studied, there was no effect of slow drying on seed germination. Seeds from area of Cerrado, however, have shown a slight reduction on germination when subjected to fast drying. Oppositely, seeds from rocky area had germination increased when subjected to fast drying. Seeds from riparian forest area had no reduction on germination percentage, independent of drying speed. Results suggest that seeds of T. obtusa are not sensitive to desiccation.