Larval development of Physocephala (Diptera, Conopidae) in the bumble bee Bombus morio (Hymenoptera, Apidae)

Larval development of Physocephala (Diptera, Conopidae) in the bumble bee Bombus morio (Hymenoptera, Apidae). In the summer of 2012, a high incidence of conopid larvae was observed in a sample of female B. morio collected in remaining fragments of semidecidual forest and Cerrado, in the municipality of Sorocaba, state of São Paulo, Brazil. The larval development of conopid flies was studied, beginning at the larval instars (LO to L3) and PUP, until the emergence of the imago under laboratory conditions and inside the host. At the first instar, or LO, the microtype larvae measured less than 1 mm in length. During the transition from L1 to L3, the larvae grew in length. At L3, the larvae doubled their length (4 mm) and then started to develop both in length and width, reaching the PUP stage with 10 mm in length and 7 mm in width. The main characteristic that differentiates L3 from the early instars is the larger body size and the beginning of posterior spiracle development. The development from PUP to puparium took less than 24h. The bees died ten days after the fly oviposition, or just before full PUP development. The early development stages (egg-LO to L1) were critical for larva survival. The pupa was visible between the intersegmental sternites and, 32 days after pupation, a female imago of Physocephala sp. emerged from one bee. The puparium and the fly measured approximately 10 mm in length. In a single day of collection, up to 45% of the bumble bees collected were parasitized by conopid flies.

Bee assemblage in habitats associated with Brassica napus L.

ABSTRACTAssessments in agricultural crops indicate that alterations in the landscape adjacent to the crops can result in reduced productivity due to loss or low abundance of pollinating agents. In the canola crop, production is partially dependent on insect pollination. Therefore, knowledge of the faunal diversity within and near crop fields is key for the management of these insects and consequently for the increase in productivity. This study aimed to determine and compare the diversity of bees in habitats associated with canola fields in southern Brazil. Bees were captured in four agricultural areas using pan traps in three habitat classes: (1) flowering canola crop, (2) forest remnant, and (3) grassland vegetation. The highest abundance of bees was observed in the grassland vegetation (50%) and in the flowering canola field (47%). Eight species common to the three habitat classes were recorded, four of which are represented by native social bees. In addition, a single or a few individuals represented species that were exclusive to a specific habitat class; eight species were collected exclusively in the interior of the canola field, 51 in the grassland vegetation, and six in the forest remnant. The majority of the rare species recorded exhibits subsocial or solitary behaviour and inhabit open places. The composition of bee groups differed between the habitats showing the importance of maintaining habitat mosaics with friendly areas for pollinators, which promote the pollination service for canola flowers.

New species of the stingless bee genus Schwarziana (Hymenoptera, Apidae)

ABSTRACT Two new species of the stingless bee genus Schwarziana from Brazil are described and illustrated. Schwarziana bocainensis sp. nov. is described from Serra da Bocaina, in São Paulo, and S. chapadensis sp. nov. is described from Chapada dos Veadeiros, in Goiás. An identification key to workers of the known species of Schwarziana is provided.

Evaluation of sample preparation methods and optimization of nickel determination in vegetable tissues

Nickel, although essential to plants, may be toxic to plants and animals. It is mainly assimilated by food ingestion. However, information about the average levels of elements (including Ni) in edible vegetables from different regions is still scarce in Brazil. The objectives of this study were to: (a) evaluate and optimize a method for preparation of vegetable tissue samples for Ni determination; (b) optimize the analytical procedures for determination by Flame Atomic Absorption Spectrometry (FAAS) and by Electrothermal Atomic Absorption (ETAAS) in vegetable samples and (c) determine the Ni concentration in vegetables consumed in the cities of Lorena and Taubaté in the Vale do Paraíba, State of São Paulo, Brazil. By means of the analytical technique for determination by ETAAS or FAAS, the results were validated by the test of analyte addition and recovery. The most viable method tested for quantification of this element was HClO4-HNO3 wet digestion. All samples but carrot tissue collected in Lorena contained Ni levels above the permitted by the Brazilian Ministry of Health. The most disturbing results, requiring more detailed studies, were the Ni concentrations measured in carrot samples from Taubaté, where levels were five times higher than permitted by Brazilian regulations.

Optimization of the sampling scheme for maps of physical and chemical properties estimated by kriging

The sampling scheme is essential in the investigation of the spatial variability of soil properties in Soil Science studies. The high costs of sampling schemes optimized with additional sampling points for each physical and chemical soil property, prevent their use in precision agriculture. The purpose of this study was to obtain an optimal sampling scheme for physical and chemical property sets and investigate its effect on the quality of soil sampling. Soil was sampled on a 42-ha area, with 206 geo-referenced points arranged in a regular grid spaced 50 m from each other, in a depth range of 0.00-0.20 m. In order to obtain an optimal sampling scheme for every physical and chemical property, a sample grid, a medium-scale variogram and the extended Spatial Simulated Annealing (SSA) method were used to minimize kriging variance. The optimization procedure was validated by constructing maps of relative improvement comparing the sample configuration before and after the process. A greater concentration of recommended points in specific areas (NW-SE direction) was observed, which also reflects a greater estimate variance at these locations. The addition of optimal samples, for specific regions, increased the accuracy up to 2 % for chemical and 1 % for physical properties. The use of a sample grid and medium-scale variogram, as previous information for the conception of additional sampling schemes, was very promising to determine the locations of these additional points for all physical and chemical soil properties, enhancing the accuracy of kriging estimates of the physical-chemical properties.

Pollination efficiency of the stingless bee Melipona subnitida on greenhouse sweet pepper

The present study was carried out in Northeastern Region of Brazil, in order to investigate the use of stingless bee Melipona subnitida Ducke in the pollination of greenhouse sweet pepper (Capsicum annuum L.). Treatments of hand cross-pollination, hand self-pollination, pollination by bees and restricted pollination were performed. Results showed that despite sweet pepper flowers are considered autogamous, this crop benefits from pollination by M. subnitida, producing fruits significantly heavier and wider, containing a greater number of seeds and of better quality (lower percentage of malformed fruits) than self-pollinated sweet pepper. Thus, M. subnitida can be considered an efficient pollinator of greenhouse sweet pepper.

Optimization of particle bombardment parameters for the genetic transformation of Brazilian maize inbred lines

The objective of this work was to develop a genetic transformation system for tropical maize genotypes via particle bombardment of immature zygotic embryos. Particle bombardment was carried out using a genetic construct with bar and uidA genes under control of CaMV35S promoter. The best conditions to transform maize tropical inbred lines L3 and L1345 were obtained when immature embryos were cultivated, prior to the bombardment, in higher osmolarity during 4 hours and bombarded at an acceleration helium gas pressure of 1,100 psi, two shots per plate, and a microcarrier flying distance of 6.6 cm. Transformation frequencies obtained using these conditions ranged from 0.9 to 2.31%. Integration of foreign genes into the genome of maize plants was confirmed by Southern blot analysis as well as bar and uidA gene expressions. The maize genetic transformation protocol developed in this work will possibly improve the efficiency to produce new transgenic tropical maize lines expressing desirable agronomic characteristics.

Selection of bee species for environmental risk assessment of GM cotton in the Brazilian Cerrado

The objective of this work was to list potential candidate bee species for environmental risk assessment (ERA) of genetically modified (GM) cotton and to identify the most suited bee species for this task, according to their abundance and geographical distribution. Field inventories of bee on cotton flowers were performed in the states of Bahia and Mato Grosso, and in Distrito Federal, Brazil. During a 344 hour sampling, 3,470 bees from 74 species were recovered, at eight sites. Apis mellifera dominated the bee assemblages at all sites. Sampling at two sites that received no insecticide application was sufficient to identify the three most common and geographically widespread wild species: Paratrigona lineata, Melissoptila cnecomola, and Trigona spinipes, which could be useful indicators of pollination services in the ERA. Indirect ordination of common wild species revealed that insecticides reduced the number of native bee species and that interannual variation in bee assemblages may be low. Accumulation curves of rare bee species did not saturate, as expected in tropical and megadiverse regions. Species-based approaches are limited to analyze negative impacts of GM cotton on pollinator biological diversity. The accumulation rate of rare bee species, however, may be useful for evaluating possible negative effects of GM cotton on bee diversity.

Optimization of heterologous microsatellites in Piracanjuba

Abstract: The objective of this work was to evaluate 41 microsatellite markers for heterologous amplifications in piracanjuba (Brycon orbignyanus). Some markers were tested for the first time. Loci were optimized for PCR conditions and applied to a sample of 49 individuals. Thirty-one loci resulted in PCR product formation, whereas ten loci yielded intelligible polymorphic patterns in the evaluated sample and can be used for amplifications in this species. From the evaluated markers, four loci (BoM1, BoM13, Bh6, and Bh16) are valid to be applied in the study of piracanjuba.

Optimization of a protocol for the micropropagation of pineapple

The present work aimed at maximizing the number of plantlets obtained by the micropropagation of pineapple (Ananas comosus (L.) Merrill) cv. Pérola. Changes in benzylaminopurine (BAP) concentration, type of medium (liquid or solidified) and the type of explant in the proliferation phase were evaluated. Slips were used as the explant source, which consisted of axillary buds obtained after careful excision of the leaves. A Sterilization was done in the hood with ethanol (70%), for three minutes, followed by calcium hypochlorite (2%), for fifteen minutes, and three washes in sterile water. The explants were introduced in MS medium supplemented with 2mg L-1 BAP and maintained in a growth room at a 16h photoperiod (40 mmol.m-2.s-1), 27 ± 2ºC. After eight weeks, cultures were subcultured for multiplication in MS medium. The following treatments were tested: liquid x solidified medium with different BAP concentrations (0.0, 1.5 or 3.0 mg L-1), and the longitudinal cut, or not, of the shoot bud used as explant. The results showed that liquid medium supplemented with BAP at 1.5 mg L-1, associated with the longitudinal sectioning of the shoot bud used as explant presented the best results, maximizing shoot proliferation. On average, the best treatment would allow for an estimated production of 161,080 plantlets by the micropropagation of the axillary buds of one plant with eight slips and ten buds/slips, within a period of eight months.

Optimization of OSEM parameters in myocardial perfusion imaging reconstruction as a function of body mass index: a clinical approach

AbstractObjective:The present study is aimed at contributing to identify the most appropriate OSEM parameters to generate myocardial perfusion imaging reconstructions with the best diagnostic quality, correlating them with patients' body mass index.Materials and Methods:The present study included 28 adult patients submitted to myocardial perfusion imaging in a public hospital. The OSEM method was utilized in the images reconstruction with six different combinations of iterations and subsets numbers. The images were analyzed by nuclear cardiology specialists taking their diagnostic value into consideration and indicating the most appropriate images in terms of diagnostic quality.Results:An overall scoring analysis demonstrated that the combination of four iterations and four subsets has generated the most appropriate images in terms of diagnostic quality for all the classes of body mass index; however, the role played by the combination of six iterations and four subsets is highlighted in relation to the higher body mass index classes.Conclusion:The use of optimized parameters seems to play a relevant role in the generation of images with better diagnostic quality, ensuring the diagnosis and consequential appropriate and effective treatment for the patient.

Optimization of methodology to analyze ascorbic and dehydroascorbic acid in vegetables

In this study, different solutions to extract vitamin C were tested. High-performance liquid chromatography was chosen and the conditions were based on isocratic elution in reverse phase column. Dehydroascorbic acid was determined indirectly after its reduction using dithiothreitol. The use of metaphosphoric acid to stabilize the vitamin C was shown to be required and it was necessary to neutralize the pH of the extract to apply dithiothreitol. The average recovery was 90% in collard and tomato samples. The presence of oil did not interfere in extraction and the methodology can be used to analyze stir fried vegetables.

Relationship between botanical origin and antioxidants vitamins of bee-collected pollen

This study quantified vitamin C, E and β-carotene in samples of fresh bee-collected pollen and correlating them with the botanical origin. Vitamin content varied between 13.5 and 42.5 µg/g for vitamin E; 56.3 and 198.9 µg/g for β-carotene and 273.9 and 560.3 µg/g for vitamin C. It was concluded that the botanical origin and collecting season influenced the vitamin contents. There is a relationship between the vitamins and its botanical origin: Raphanus sp and Macroptilium sp, Mimosa caesalpineafolia with β-carotene; Raphanus sp, Eucalyptus sp, Macroptilium sp, Mimosa caesalpineafolia with vitamin E and Anadenanthera sp, Arecaceae type and Philodendron sp with vitamin C.

Optimization of the carrot leaf dehydration aiming at the preservation of omega-3 fatty acids

The carrot leaf dehydration conditions in air circulation oven were optimized through response surface methodology (RSM) for minimizing the degradation of polyunsaturated fatty acids, particularly alpha-linolenic (LNA, 18:3n-3). The optimized leaf drying time and temperature were 43 h and 70 ºC, respectively. The fatty acids (FA) were investigated using gas chromatography equipped with a flame ionization detector and fused silica capillary column; FA were identified with standards and based on equivalent-chain-length. LNA and other FA were quantified against C21:0 internal standard. After dehydration, the amount of LNA, quantified in mg/100 g dry matter of dehydrated carrot leaves, were 984 mg.

Optimization of the use of carbon paste electrodes (CPE) for electrochemical study of the chalcopyrite

The use of carbon paste electrodes (CPE) of mineral sulfides can be useful for electrochemical studies to overcome problems by using massive ones. Using CPE-chalcopyrite some variables were electrochemically evaluated. These variables were: (i) the atmosphere of preparation (air or argon) of CPE and elapsed time till its use; (ii) scan rate for voltammetric measurements and (iii) chalcopyrite concentration in the CPE. Based on cyclic voltammetry, open-circuit potential and electrochemical impedance results the recommendations are: oxygen-free atmosphere to prepare and kept the CPE until around two ours, scan rates from 10 to 40 mV s-1, and chalcopyrite concentrations > 20%.