Adhesivos tipo poliuretano obtenidos a partir de aceite de ricino y almidón químicamente modificados

This study reports the preparation of polyurethane adhesives using polyols obtained from castor oil modified by a transesterification reaction with pentaerythritol and starch modified by glycosylation. The physical properties of the polyols such as hydroxyl value were determined and the infrared spectroscopic analysis of the polyols reported. The effect of varying the hydroxyl value in the polyols on physical properties of polyurethane coatings on wood and steel panels was determined. The characterization of polyurethane coatings carried out by IR spectroscopic analysis, scratch hardness resistance, impact resistance, lap shear strength, T-peel strength measurements, solvent resistance and chemical resistant determination were reported.

Obtenção de biodiesel por transesterificação em dois estágios e sua caracterização por cromatografia gasosa: óleos e gorduras em laboratório de química orgânica

Methanolic transesterification of oils and fats was carried out in a two steps procedure, under basic and acidic catalysis. Palm, soybean, canola, corn, rice, grapeseed, sunflower, peanut, pequi and olive oils, besides tallow and lard were used as feedstock. Specific gravity, relative viscosity, thin layer chromatography and gas chromatography were used to characterize the biodiesel. Biodiesel was obtained in high yield and purity. Results were used to discuss the following key-concepts: 1 - triglycerides, composition and properties; 2 - nucleophilic acyl substitution under basic and acid conditions, 3 - thin layer chromatography, 4 - gas chromatography and its quantitative methods.

Use of heterogeneous catalysts in methylic biodiesel production induced by microwave irradiation

The effect of different heterogeneous catalysts on the microwave-assisted transesterification of sunflower oil for the production of methylic biodiesel in a monomode microwave reactor is described. The experiments were carried out at 70 ºC with a 16:1 methanolsunflower oil molar ratio and different heterogeneous basic and acidic catalysts. The results showed that the microwave-heated reactions occur up to four times faster than those carried out with conventional heating. The reactions were performed with 24 catalysts; pure calcium oxide (CaO) and potassium carbonate, either pure or supported by alumina (K2CO3/Al2O3), were the most efficient catalysts.

Catálise básica usando sílica mesoporosa estabilizada por acrilatos encapsulados

The synthesis of new type of silicas, with structures akin to that of MCM-41, containing polyacrylate-encapsulated micelles in their mesopores is reported. Initially, the monomers were inserted in the aqueous micelles of cetyltrimethylammonium cations. MCM-41 was then prepared in this microemulsion. Finally, the polymerization of the acrylates was initiated by UVC radiation. The presence of monomers and polymers in the interior of micelles in aqueous media were characterized by IR spectroscopy and small-angle Xray scattering. The presence of this polymer increased the stability of these new materials in catalytic transesterification.

Poliuretanos obtenidos a partir de aceite de higuerilla modificado y poli-isocianatos de lisina: síntesis, propiedades mecánicas y térmicas y degradación in vitro

Biodegradable polyurethanes (PUR) were prepared from polyols derived from castor oil by transesterification of pentaerythritol-modified castor oil and lysine polyisocyanates (LDI and LTI). The polyurethanes obtained were characterized by Fourier transform infrared spectroscopy, thermogravimetric analysis (TGA), and dynamic mechanical thermal analysis (DMTA). The mechanical behavior of the polyurethanes was measured by Shore A hardness and tensile testing (stress-strain curves). The biodegradable nature of the material was determined by contact angle, water absorption tests, and in vitro degradation in PBS solution. This study aims to examine the effect of the structure and functionality of diisocyanate on the mechanical properties and in vitro degradation of the material. The results were compared with homologous materials obtained from isophorone diisocyanate (IPDI) used in previous works. The objective was to evaluate candidate materials that can be potentially used in tissue engineering.

ESTERIFICAÇÃO E TRANSESTERIFICAÇÃO SIMULTÂNEAS DE ÓLEOS ÁCIDOS UTILIZANDO CARBOXILATOS LAMELARES DE ZINCO COMO CATALISADORES BIFUNCIONAIS

Palm oil containing 40% fatty acids was converted to methyl esters using zinc carboxylates as the esterification/transesterification catalyst. The reaction was optimized using a factorial design in which the effects of the alcohol:fatty acids molar ratio (MRAG) and the catalyst concentration (CAT) were assessed. The best conversion was achieved with CAT at 4 wt% and MRAG at 4:1. However, the solid catalyst presented significant structural changes after use. For instance, laurate anions were replaced by carboxylates of higher molecular mass, leading to the formation of a new catalytically active layered structure. Also, the glycerin obtained as a co-product contained 86 wt% glycerol.

CARACTERIZAÇÃO E ATIVIDADE CATALÍTICA DE K2CO3/AL2O3 NA TRANSESTERIFICAÇÃO DO ÓLEO DE GIRASSOL COM AQUECIMENTO CONVENCIONAL E MICRO-ONDAS

Commercial and synthetic mesoporous aluminas impregnated with potassium carbonate were characterized by X-ray diffraction (XRD), nitrogen physisorption, infrared spectroscopy and 27Al MAS NMR. The activities in the transesterification reaction of sunflower oil with methanol for biodiesel production were evaluated. 27Al MAS NMR spectra evidenced the presence of AlIV and AlVI in the samples, and also of AlV sites in the mesoporous synthesized alumina, which disappeared after impregnation with potassium salt followed by calcination. All aluminas containing potassium were active for biodiesel production from sunflower seed oil, with high conversions by both conventional heating and microwave irradiation.

COMPOSIÇÃO QUÍMICA E TEMPERATURA DE CRISTALIZAÇÃO DE ÉSTERES OBTIDOS DE QUATRO ÓLEOS VEGETAIS EXTRAÍDOS DE SEMENTES DE PLANTAS DO CERRADO

The seed oils from four plants (Scheelea phalerata, Butia capitata, Syagrus romanzoffiana, Terminalia cattapa) found in Mato Grosso do Sul were extracted at good yields. Alkaline transesterification of these seed oils to esters using methanol and ethanol was studied and also produced good yields. Oleic acid (30.5/32.3%), lauric acid (30.7/32.9%) methyl and ethyl esters, were the main components of transesterification of the oils from Scheelea phalerata and Syagrus romanzoffiana. Lauric acid (42.2%), capric acid (15.9%) and caprylic acid (14.6%) methyl and ethyl esters were the main ester components of transesterification of the oil from Butia capitata. Oleic acid (37.8%), palmitic acid (33.5%) and linoleic acid (22.6%) methyl and ethyl esters were the main components of transesterification of oil from Terminalia catappa. Based on differential scanning calorimetry (DSC) studies, the first crystallization peak temperature of esters was observed. Esters derived from oils of the family Arecaceae (Scheelea phalerata, Butia capitata, Syagrus romanzoffiana) showed the lowest points of crystallization, despite having high levels of saturated fat. Esters of Terminalia cattapa oil, rich in unsaturated fat, showed the highest crystallization temperature. This difference in behavior is probably related to the high concentration of esters derived from lauric acid and palmitic acid.

GLICEROFOSFOLIPÍDIOS SINTÉTICOS PARA USO COMO ADITIVO BIOCIDA EM TINTAS ANTI‑INCRUSTANTE

AbstractThis paper presents a technological innovation that uses a subclass of glycerophospholipids as a booster biocide in antifouling paint. These glycerophospholipid PAF-analogs are economically and environmentally viable compounds because they are synthesized from a metal-free raw material source-soybean lecithin. The synthesis, which involves transesterification followed by an alkylation reaction, produced a mixture of glycerophospholipids that were characterized by mass spectrometry. Evaluation of the antifouling performance with field tests showed that the replacement of ordinary halogenated booster biocide with the synthesized product gave a better efficiency and an exceptional antifouling activity with a significant reduction in the coverage of the fouling macro-organisms.

OTIMIZAÇÃO DO PROCESSO DE TRANSESTERIFICAÇÃO EM DUAS ETAPAS PARA PRODUÇÃO DE BIODIESEL ATRAVÉS DO PLANEJAMENTO EXPERIMENTAL DOEHLERT

In this work, Doehlert experimental design was used to optimize the Transesterification Double Step Process (TDSP) method of methyl soybean oil biodiesel production which starts with a basic catalysis followed by an acidic catalysis. The conversion values were calculated from NMR spectra. Response surface was used to show the results of the interactions between the variables. This experimental design evaluated variables like catalyst and alcohol amount for the basic catalysis and time and temperature for the acidic catalysis. According to results obtained after Doehlert design application the alcohol amount was the main factor that influenced on the basic catalysis but for the acidic catalysis both time and temperature are important and their effects are opposite. It resulted on excellent conversions for both steps obtaining for the basic catalysis about 100% when was used like optimal conditions catalyst amount equal to 0.40 g and volume of methanol equal to 60 mL and for the acidic catalysis about 99% when was used like optimal conditions temperature of 65 °C and 90 minutes for reaction time.

SÍNTESE E PROPRIEDADES DE SÍLICAS HÍBRIDAS CONTENDO SURFACTANTES CETILTRIALQUILAMÔNIO

This work presents the synthesis of silicas containing cetyltrialkylammoniun surfactants in their mesopores. Initially, the aqueous dispersions of these surfactants were characterized by small-angle X-ray scattering (SAXS). The hybrid silicas obtained from these dispersions were evaluated by X-ray diffractometry (XRD) and nitrogen physisorption. The XRD showed that, increasing the head size, there is a shift of the peak corresponding to the (100) diffraction plane to smaller 2θ angles, which indicates an increase in the silicas porous diameter. The increasing of the silicas porous diameter was confirmed by nitrogen physisorption. The base catalytic properties of these hybrid silicas were evaluated in the transesterification reaction showing that those containing the cations C16Et3+ and C16Pr3+ showed better performance.

Production of biodiesel from babassu oil using methanol-ethanol blends

Maranhão state in Brazil presents a big potential for the cultivation of several oleaginous species, such as babassu, soybean, castor oil plant, etc... These vegetable oils can be transformed into biodiesel by the transesterification reaction in an alkaline medium, using methanol or ethanol. The biodiesel production from a blend of these alcohols is a way of adding the technical and economical advantages of methanol to the environmental advantages of ethanol. The optimized alcohol blend was observed to be a methanol/ethanol volume ratio of 80 % MeOH: 20 % EtOH. The ester content was of 98.70 %, a value higher than the target of the ANP, 96.5 % (m/m), and the biodiesel mass yield was of 95.32 %. This biodiesel fulfills the specifications of moisture, specific gravity, kinematic viscosity and percentages of free alcohols (methanol plus ethanol) and free glycerin.