Structural quality of soils cultivated with coffee and pasture in an environmental protection area

Studies of soils in Environmental Protection Areas (EPAs) are of great importance, because they are an essential component of ecosystems, directly interfering in environmental sustainability. The objective of this study was to evaluate the structural quality of soil cultivated with coffee and used as pasture in the Capituva's River microbasin, which is located in the Environmental Protection Area in Coqueiral, south of the state of Minas Gerais. Uniaxial compression test (preconsolidation test) and soil resistance to penetration were used. Undisturbed samples were taken from the surface layer (0-5 cm) of the soils in the area: a typic dystrophic Red Latosol (LVd - Oxisol), a typic eutrophic Red Argisol (PVe - Ultisol), and a typic dystrophic Haplic Cambisol (CXbd - Inceptisol). A significant linear positive correlation was observed between the results of the preconsolidation test and soil resistance to penetration. Load bearing capacity of soil could be estimated accordingly by means of penetration resistance for LVd, PVe, and CXbd. Cambisol - CXbd showed lower loading support capacity and resistance to penetration than LVd and PVe, due to the better crop management in this soil that resulted in higher physical quality which accounts for higher production and environmental sustainability.

Environmental and genetic variation of isoflavone content of soybean seeds grown in Brazil

The objective of this work was to evaluate isoflavone concentrations in seeds of different Brazilian soybean cultivars grown in a range of locations and environmental conditions in Brazil. Seeds of 233 cultivars grown in Ponta Grossa, PR, Brazil, during the 2001/2002 soybean season, and of 22 cultivars sown in different locations of Brazilian Northeast, Southeast on South regions were analyzed for total isoflavones, including daidzin, glycitin, genistin and acetylgenistin. The total isoflavones ranged from 12 mg 100 g-1 (cv. Embrapa 48) to 461 mg 100 g-1 (cv. CS 305) among the 233 cultivars grown in Ponta Grossa, and the differences among them are due to genetic effects since all cultivars were grown and collected at the same locatation and year. This is an indication of the possibility of breeding for isoflavone content. Differences in isoflavone content observed in the cultivars grown in different locations permit the selection of locations for optimum isoflavone content (low or high), depending on the uses of soybean. In the Northeast region (5-8°S), higher concentrations of total isoflavones were observed at São Raimundo das Mangabeiras (232 mg 100 g-1) and Tasso Fragoso (284 mg 100 g-1) municipalities, and in the South (23-30°S), isoflavones were higher in Guarapuava, Canoinhas, Vacaria and Campos Novos municipalities, ranging from 130 to 409 mg 100 g-1.

Limestone particle sizes and lighting regimens on egg and bone quality of laying hens

Abstract:The objective of this work was to evaluate the effect of limestone particle sizes in the diet and of lighting regimes on the egg and bone quality and on the performance of commercial laying hens. Three hundred Hissex White layers, at 18 weeks of age, were distributed in a completely randomized design, in a 5×2 factorial arrangement (coarse limestone in the diet at 0, 25, 50, 75, and 100%; with or without artificial light), with five replicates of six birds. No significant interaction was observed between particle sizes and lighting regime for the evaluated parameters. There was no significant effect of coarse limestone level in the diet on the performance and egg quality of hens; however, bone deformity (3.23 to 4.01 mm), strength (5.19 to 6.70 kgf cm-2), and mineral matter (51.09 to 59.61%) improved as the proportion of coarse limestone increased. For lighting regime, the treatment with artificial light yielded higher Haugh unit values (87.17 vs. 85.54) than that with natural light only. Greater limestone particles improve bone quality of laying hens, and the use of artificial light can benefit the albumen quality of the eggs.

Sorption kinetics and intrapaticulate diffusivity of As(III) bioremediation from aqueous solution, using modified and unmodified coconut fiber

The pollution and toxicity problems posed by arsenic in the environment have long been established. Hence, the removal and recovery remedies have been sought, bearing in mind the efficiency, cost effectiveness and environmental friendliness of the methods employed. The sorption kinetics and intraparticulate diffusivity of As (III) bioremediation from aqueous solution using modified and unmodified coconut fiber was investigated. The amount adsorbed increased as time increased, reaching equilibrium at about 60 minutes. The kinetic studies showed that the sorption rates could be described by both pseudo-first order and pseudo-second order process with the later showing a better fit with a value of rate constant of 1.16 x 10-4 min-1 for the three adsorbent types. The mechanism of sorption was found to be particle diffusion controlled. The diffusion and boundary layer effects were also investigation. Therefore, the results show that coconut fiber, both modified and unmodified is an efficient sorbent for the removal of As (III) from industrial effluents with particle diffusion as the predominant mechanism.

VEGETATIVE RESCUE AND CUTTINGS PROPAGATION OF Araucaria angustifolia (Bertol.) Kuntze

Brazilian pine or araucaria (Araucaria angustifolia) is a coniferous tree with great economic, social and environmental importance in southern Brazil, being exploited for both wood production and for its edible pine nuts. However, no efficient cloning techniques are available and, therefore, the purpose of this study was to evaluate the effectiveness of vegetative rescue methods for cuttings propagation of the species. Shoots/cuttings were generated in two ways: 26 years old trees underwent coppicing and 20 years old trees had the primary branches on the upper third of crown pruned at 2, 20 and 50 cm from the main trunk. Orthotropic shoots were rooted after application of indole-3-butyric acid (IBA) at 0, 2, 4 and 6 g.L-1. Coppicing produced 47 cuttings per plant with 90% orthotropic shoots, while pruning resulted in 182 cuttings per plant with 44% orthotropic shoots. Rooting success indexes were low with no influence of IBA, although they are slightly superior to the ones available in the literature for the species, ranging from 12 to 30% for the coppice shoots and from 0 to 28% for the branches shoots. We conclude that both vegetative rescue techniques are viable and have potentially important applications. Coppicing is recommended for the propagation aiming the production of wood, while shoots derived from the side branches of the crown are more appropriate for seeds orchards formation.

Atrazine persistence applied as commercial and xerogel formulations in oxisol

The intensive use of pesticides have contaminated the soil and groundwater. The application of herbicides as controlled release formulations may reduce the environmental damage related to their use because it may optimize the efficiency of the active ingredient and reducing thus the recommended dose. The objective of this study was to evaluate the persistence of the herbicide atrazine applied as commercial formulation (COM) and as controlled release formulation (xerogel - XER) in Oxisol. The experimental design used was split-plot randomized-blocks with four replications, in a (2 x 6) + 1 arrangement. The two formulations (COM and XER) were assigned to main plots and different atrazine concentrations (0, 3.200, 3.600, 4.200, 5.400 and 8.000 g atrazine ha-1) were assigned to sub-plots. Persistence was determined by means of dissipation kinetics and bioavailability tests. The methodology of bioassays to assess the atrazine availability is efficient and enables to distinguish the tested formulations. The availability of atrazine XER is higher than the commercial in two different periods: up to 5 days after herbicide application and at the 35th day after application. The XER formulation tends to be more persistent in relation to COM formulation.

Effects of straw decomposition degree on leaching and weed control efficacy of tebuthiuron and hexazinone in green sugarcane harvesting

Green sugarcane harvesting may promote great changes in the dynamics of herbicides in the environment. Our goal was to evaluate the influence of straw decomposition degree on leaching and weed (Ipomoea grandifolia) control efficacy by (14C) tebuthiuron and hexazinone. The presence of straw on the soil surface affected leaching, mainly for hexazinone (leaching reduced from 37 to 5% of the applied amount in the presence of straw). Overall, tebuthiuron showed more efficient control of Ipomoea than hexazinone. The straw decomposition degree affected only hexazinone efficacy that was lowest for the least decomposed straw. Further studies are needed to evaluate the effects of sugarcane straw on herbicides dissipation, particularly on volatilization and photolysis, to better predict their efficacy and environmental fate.

A fast and efficient method for the study of caffeine levels in energy drinks using micellar electrokinetic chromatography (MEKC)

Energy drinks are becoming popular in Brazil and in the world due to their stimulant properties. Caffeine is present in energy drinks with the aim of stimulating the central nervous system and intensifying brain activity. On the other hand, the ingestion of high doses of caffeine can cause undesirable symptoms such as anxiety and tachycardia. Therefore, it is necessary to monitor the caffeine content added to energy drinks to guarantee that the levels in the final product are in accordance with the labeling and within the legislation limits. The goal of this work was to validate a fast, efficient, and low-cost method for the determination of caffeine in energy drinks by micellar electrokinetic chromatography (MEKC). A total of seven brands were analyzed, each in three lots. The electrolyte was prepared with 50 mmol.L-1 of sodium dodecyl sulfate (SDS) and 10 mmol.L-1 of sodium carbonate (pH 11.0). The mean concentration of caffeine ranged from 122.8 to 318.6 mg.L-1. None of the brands had caffeine levels above the maximum limit. Considering the interval of confidence (95%), 72% of the samples had less caffeine than the amount informed on the product label.