Influência das condições de resfriamento sobre as propriedades superficiais e eletroquímicas de anodos dimensionalmente estáveis

Surface and electrochemical properties of the dimensionally stable anode Ti/(Ru0.3Ti0.7)O2 were studied as a function of the annealing temperature using different conditions in order to perform the cooling process of the oxide films (conventional thermal shock and the slow cooling processes). It was found that surface and electrochemical properties for the oxygen evolution reaction are both affected through the cooling process, being the electrode prepared at 400 ºC using the slow cooling process the less susceptible to wear. The Tafel slope obtained in the high overpotential domain was analysed in light of the apparent charge transfer coefficient.

Preparação de copolímeros à base de 2-vinilpiridina com propriedades bactericidas

We report the development of two copolymers based on 2-vinylpyridine, styrene and divinylbenzene (2Vpy-Sty-DVB) with different porosity degrees. The copolymers were subsequently quaternized with methyl iodide. To prepare charge transfer complexes, the unmodified copolymers and their derivatives quaternized with methyl iodine were impregnated with iodine. The antibacterial properties of the polymers were evaluated in dilutions ranging from 10² to 10(7) cells/mL of the auxotrophic OHd5-K12 Escherichia coli strain. It was possible to obtain materials with complete antibacterial activity even in the highest cell concentrations tested.

Validação computacional de métodos compostos no estudo de propriedades moleculares

Composite methods using ONIOM and different basis sets have been used to calculate proton and electron affinities for a set of alcohols at QCISD(T)/6-311++G(2df,p) level of theory. The study was carried out considering HF, MP2 and DFT (25 exchange correlation functional) methods. The calculation performed at ONIOM2(QCISD(T)/6-311++G(2df,p):HF/6-31G(d))//ONIOM2(O3LYP/6-31G(d):HF/6-31G(d)) resulted in the smallest average absolute deviation for AP and AE, 4,75 kJ/mol e 0,43 eV, respectively.

Efeito da adição de serragem de couro tratada quimicamente nas propriedades do cimento Portland

The sheave leather was subjected to chemical treatment in an attempt to immobilize chromium ion in a matrix of cement. Cementitious pastes were obtained by adding different proportions of waste treated solutions (5 and 10% compared to the cement mass) and the pH and setting time (hardening) were measured. Aiming to check the leather influence in Portland cement pastes, the phases formation were observed by X-ray diffraction (XRD). The results showed that the pretreatment was effective for the waste dissolution and the pH of treated waste chemical solutions did not influence significantly the characteristics of cement paste, with a slight increase in setting time results.

Interação de átomos leves com clusters de metais de transição

Density Functional Theory (DFT) calculations on the interactions of small atoms (H, C, O, and S) on first-row transition metal clusters were performed. The results show that the adsorption site may vary between the metal surface and the edge of the cluster. The adsorption energies, adatom-nearest neighbor and adatom-metal plane distances were also determined. Finally, the authors present a discussion about the performance of these metals as anodes on solid oxide fuel cells. The results obtained agree with empirical data, indicating that the theoretical model used is adequate

Sulfetos volatilizáveis por acidificação e metais extraídos simultaneamente na avaliação de sedimentos de água doce

This paper discusses the historical and methodological fundaments of the dynamics and quantification of acid volatile sulfides (AVS) and simultaneously extracted metals (SEM) in aquatic sediments. It also discusses the SEM/AVS relationship, which involves several controversial aspects such as sulfide stability, sulfide-organic matter interaction, and the inability to predict the toxicity of organic compounds in the environment. This relationship is an important tool for the inference of metal bioavailability. The use of ecotoxicological tests with target organisms regulated by international standards is also a relevant aspect.

Efeitos da história térmica nas propriedades do polímero pet: um experimento para ensino de análise térmica

Polyethilenetherephtalate (PET) is commonly used in manufacturing of beverage bottles representing a didactic appeal in thermal analysis education due to its presence in the student's day life. Additionally such polymer presents well defined thermal analytical curves and a well known thermal behavior. TGA curve is used to present the thermal stability. The thermal history effects in the thermal properties of a PET sample from a soft drink bottle are used to demonstrate the effect of different heating/cooling conditions on glass transition, melting, crystallization and crystalline degree using DSC curves.

Chumbo e zinco em águas e sedimentos de área de mineração e metalurgia de metais

Lead metallurgy at Adrianópolis is the largest environmental problem of Paraná, Brazil. The objective of this study was to determine Pb and Zn levels in water and sediment in two catchments by different extraction methods. The high levels of lead in water in most of samples do not allow the human use. Total Pb concentration as high as 795.3 µg L-1 was observed in Ribeira River bank, in a pluvial water stream flowering from a abandoned factory. Due to the high Pb levels in sediments from some sites (maximum of 24,300 mg kg-1) is recommended to avoid the water turbulence.

O efeito da desativação térmica nas propriedades oxirredutoras e na atividade catalítica de catalisadores CZ e Pd-CZ

Automotive catalyst, using in Brazil since 1992, is a essential technology for vehicular emissions control. Noble metals are the active phase of these catalysts, and cerium zirconium mixed oxides (CZ), responsibles for the oxygen storage capacity (OSC), one of the most important aspect for the operational performance of the catalyst. In this context, the oxireduction properties analysis of CZ and Pd/CZ (palladium supported in CZ) system are the objective of this study, as well as, the impact of the thermal aging in the OSC. Aging consisted of treatments at 900 or 1200 °C, for 12 or 36 h, in oxidizing condition.

Modelagem termodinâmica por extração por solvente de metais divalentes em meio sulfato usando D2EHPA

The extraction of divalent metals (Mn2+, Ni2+, Co2+ and Cu2+) in the system MSO4 - H2SO4 - H2O - D2EHPA in isoparaffin (17/21) was studied by a thermodynamic model based on chemical equilibria with mass and charge balance equations. The activity coefficients of all solutes in the aqueous phase were calculated by Davies equation. By applying this model, the equilibrium concentrations of solutes were calculated from de concentration of divalent metals and pH. The predicted distribution coefficients for the divalents metals were in good agreement with experimental results.

Uso do bivalve límnico Anodontites tenebricosus (LEA, 1834) no biomonitoramento de metais do Rio Ribeira de Iguape

This study investigated the contamination of the Ribeira de Iguape River - RIR by Cd, Zn, Cr and Pb, using the bivalve Anodontites tenebricosus as a biomonitor. Metal concentrations in tissue samples were measured by HR-ICPMS. Bivalve tissues exhibited mean levels of 1.00 µg/g Cd; 152.89 µg/g Zn; 14.79 µg/g Cr and 4.40 µg/g Pb. Lead concentrations were comparable to those reported for moderately contaminated sites. The results showed that Pb is bioavailable to the bivalves, exhibiting high concentrations and exceeding both natural and reference values for human consumption. The freshwater bivalve Anodontites tenebricosus is a suitable biomonitor of contamination by metals.

Propriedades físicas de filmes biodegradáveis à base de amido de mandioca, álcool polivinílico e montmorilonita

The objective of this work was to manufacture biodegradable films based on cassava starch, polyvinyl alcohol (PVA) and sodium montmorillonite (Na-MMT), using glycerol as a plasticizer. These films were characterized according to their microstructure, optical, mechanical, and barrier properties. The combination of starch-PVA-MMT resulted in films with a more homogeneous surface than starch films. The introduction of PVA into the starch matrix led to the formation of films with lower water vapor permeability (WVP), higher tensile strength and greater elongation. MMT was exfoliated in the films, resulting in greater stability for different relative humidities, lower WVP, higher resistance and lower flexibility.

Desenhos de estruturas químicas correlacionam-se com propriedades biológicas: MIA-QSAR

Descriptors in multivariate image analysis applied to quantitative structure-activity relationship (MIA-QSAR) are pixels of bidimensional images of chemical structures (drawings), which were used to model the trichomonicidal activities of a series of benzimidazole derivatives. The MIA-QSAR model showed good predictive ability, with r², q² and r val. ext.² of 0.853, 0.519 and 0.778, respectively, which are comparable to the best values obtained by CoMFA e CoMSIA for the same series. A MIA-based analysis was also performed by using images of alphabetic letters with the corresponding numeric ordering as dependent variables, but no correlation was found, supporting that MIA-QSAR is not arbitrary.

Coeficientes de difusão de metais em materiais não convencionais (agarose e acetato de celulose) usados na técnica de difusão em filmes finos por gradientes de concentração

The DGT technique allows one to measure quantitatively free and labile metal species in aquatic systems. Nevertheless, for this approach, knowledge is required of the diffusion coefficients of the analytes in a diffusive layer. In this study, the diffusion coefficients of Hg(II), As(III), Mn(II), Mg(II), Cu(II), Cd(II) were determined in agarose gel and those of Ba(II), Cd(II), Cu(II), Mg(II), Mn(II) e Zn(II) in cellulose acetate membranes. These materials presented good performance and the reported results can be used as a data base for further DGT studies.

Avaliação das propriedades de compósitos de polipropileno reforçados com casca de aveia

The preparation of oat-reinforced polypropylene nanocomposites with different fiber contents by means of melt-processing was investigated. Composite properties were evaluated by Scanning Electron Microscopy (SEM), Flexural Modulus, Dynamic Mechanical Analysis (DMA), Differential Scanning Calorimetry (DSC) and Thermogravimetric Analysis (TGA). Findings confirmed that the oat composite properties were affected by fiber type and content. Improvements in mechanical properties were obtained using fiber contents < 20% w.t.