Depression with postpartum onset: a prospective cohort study in women undergoing elective cesarean section in Brasilia, Brazil

PURPOSE: It was to determine the prevalence of depressive symptoms in a sample of puerperal women from Brasília, Brazil, distinguishing cases with onset after delivery from those already present during pregnancy. METHODS: A prospective cohort study with convenience sampling of patients submitted to elective cesarean section at two private hospitals. As an instrument for assessing depressive symptoms, the Edinburgh Postnatal Depression Scale with cutoff >13 was applied shortly before delivery and four to eight weeks after childbirth. RESULTS: Among the 107 women who completed the study, 11 (10.3%) had significant depressive symptoms during pregnancy and 12 (11.2%) during the postpartum period. Among the 12 patients with postpartum symptoms, 6 had symptoms during pregnancy, so that 5.6% of the sample had postpartum onset of depression. The higher overall frequency of depression was significantly among single women than among married women (p=0.04), a fact mainly due to a higher frequency of single women experiencing persistent depressive symptoms both before and after delivery (p=0.002). The risk of depression was not influenced by age, parity or educational level. CONCLUSION: Women with depression identified during the postpartum period comprise a heterogeneous group, in which symptoms may have started before pregnancy, during pregnancy or after childbirth. In this sample, half of the postpartum depression cases already presented symptoms during late pregnancy. Since depression can arise before and after childbirth, it may have different etiologies and, therefore, a different response to treatment, a possibility that should be considered by clinicians and researchers.

Model for subchannel friction factors and flow redistribution in wire-wrapped rod bundles

The fuel element of LMFBR consists of a bundle of rods wrapped with an helical wire as spacer, surrounded by an hexagonal duct. In the present work, a semi-empirical model is developed to calculate bundle average and subchannel based friction factors and flow redistribution. The obtained results were compared to experimental data and they were considered satisfactory for wide range of geometrical parameters.

Parameter optimization of AC rectangular wave outputs for aluminum cold wire GTAW

The objective of this work was to optimize the parameter setup for GTAW of aluminum using an AC rectangular wave output and continuous feeding. A series of welds was carried-out in an industrial joint, with variation of the negative and positive current amplitude, the negative and positive duration time, the travel speed and the feeding speed. Another series was carried out to investigate the isolate effect of the negative duration time and travel speed. Bead geometry aspects were assessed, such as reinforcement, penetration, incomplete fusion and joint wall bridging. The results showed that currents at both polarities are remarkably more significant than the respective duration times. It was also shown that there is a straight relationship between welding speed and feeding speed and this relationship must be followed for obtaining sound beads. A very short positive duration time is enough for arc stability achievement and when the negative duration time is longer than 5 ms its effect on geometry appears. The possibility of optimizing the parameter selection, despite the high inter-correlation amongst them, was demonstrate through a computer program. An approach to reduce the number of variables in this process is also presented.

The pulsed wire anemometer: review and further developments

The purpose of the present paper is to review work that has been done on the pulsed wire anemometer technique and also suggest further developments that could be made in its range of application. The aper discusses the three types of probes that have been used in pulsed wire anemometry: the crossed wire velocity probe, the parallel wire wall shear stress probe and the parallel wire velocity probe. The work shows that the crossed wire and the parallel wire techniques can be used to make velocity, turbulence and wall shear stress measurements in highly turbulent flows without any upper restriction on turbulence level. Comments are also made on the potential of a parallel wire probe for use in highly turbulent flows that would enable higher order velocity cross-product terms to be measured.

Why are the rates of cesarean section in Brazil higher in more developed cities than in less developed ones?

The objective of the present study was to investigate factors associated with cesarean sections in two cities located in different regions of Brazil and to determine factors that explain the higher cesarean section rate in the more developed city, Ribeirão Preto, compared to the less developed one, São Luís. Data from two cohort studies comprising 2846 women in Ribeirão Preto in 1994, and 2443 women in São Luís in 1997/1998 were used. Adjusted and non-adjusted risk estimates were calculated using a Poisson regression model. The cesarean section rate was 33.7% in São Luís and 50.8% in Ribeirão Preto. Adjusted analysis in a joint sequential model revealed a 51% higher risk of cesarean section in Ribeirão Preto compared to São Luís (prevalence rate ratio (PRR) = 1.51). Adjustment for category of hospital admission reduced the PRR to 1.09, i.e., this variable explained 82% of the difference in the cesarean section rate between the two cities. Adjustment for the variable "the same physician for prenatal care and delivery" reduced the PRR to 1.07, with the "physician" factor explaining 86% of the difference between rates. When simultaneously adjusted for the two variables, the PRR decreased to 1.05, with these two variables explaining 90% of the difference in the cesarean section rate between the two cities, and the difference was no longer significant. The difference in the cesarean section rate between the two Brazilian cities, one more and one less developed, was mainly explained by the physician factor and, to a lesser extent, by the category of hospital admission.

The effect of epidural and general anesthesia on newborn rectal temperature at elective cesarean section

Both epidural and general anesthesia can impair thermoregulatory mechanisms during surgery. However, there is lack of information about the effects of different methods of anesthesia on newborn temperature. The purpose of this study was to determine whether there are differences in newborn rectal temperature related to type of anesthesia. Sixty-three pregnant women were randomly assigned to receive general or epidural anesthesia. Maternal core temperature was measured three times with a rectal probe just before anesthesia, at the beginning of surgery and at delivery. In addition, umbilical vein blood was sampled for pH. The rectal temperatures of the babies were recorded immediately after delivery, and Apgar scores were determined 1, 5, and 10 min after birth. The duration of anesthesia and the volume of intravenous fluid given during the procedure (833 ± 144 vs 420 ± 215 mL) were significantly higher in the epidural group than in the general anesthesia group (P < 0.0001). Maternal rectal temperatures were not different in both groups at all measurements. In contrast, newborn rectal temperatures were lower in the epidural anesthesia group than in the general anesthesia group (37.4 ± 0.3 vs 37.6 ± 0.3°C; P < 0.05) immediately after birth. Furthermore, the umbilical vein pH value (7.31 ± 0.05 vs 7.33 ± 0.01; P < 0.05) and Apgar scores at the 1st-min measurement (8.0 ± 0.9 vs 8.5 ± 0.7; P < 0.05) were lower in the epidural anesthesia group than in the general anesthesia group. Since epidural anesthesia requires more iv fluid infusion and a longer time for cesarean section, it involves a risk of a mild temperature reduction for the baby which, however, did not reach the limits of hypothermia.