Foraging behavior and ruminal fermentation of dairy cows grazing ryegrass pasture alone or with white clover

The objective of this work was to evaluate the influence of pasture composition and regrowth age on the relationship between feeding behavior and ruminal fermentation in dairy cows grazing perennial ryegrass with or without white clover. The experiment was carried out in a 2x2 factorial arrangement, with two sward types and two ages of regrowth. Swards of perennial ryegrass sown alone (PRG) and of perennial ryegrass mixed with white clover (GC) were evaluated. Twelve late-lactation Holstein cows, fistulated at the rumen, were distributed in a 4x4 latin square experimental design with four 12-day periods. Daily distribution of grazing was similar in the PRG and the GC swards, but the concentration of rumen volatile fatty acids (VFA) was higher and the proportion of propionate was lower on mixed swards during the day. Daily distribution of grazing was similar in pastures of different ages. However, in the oldest swards, rumen fluid pH increased and VFA concentration decreased after evening milking. Time spent grazing does not influence ruminal fermentation, which depends on the changes that occur as different sward layers are grazed.

Optimization of heterologous microsatellites in Piracanjuba

Abstract: The objective of this work was to evaluate 41 microsatellite markers for heterologous amplifications in piracanjuba (Brycon orbignyanus). Some markers were tested for the first time. Loci were optimized for PCR conditions and applied to a sample of 49 individuals. Thirty-one loci resulted in PCR product formation, whereas ten loci yielded intelligible polymorphic patterns in the evaluated sample and can be used for amplifications in this species. From the evaluated markers, four loci (BoM1, BoM13, Bh6, and Bh16) are valid to be applied in the study of piracanjuba.

Optimization of a protocol for the micropropagation of pineapple

The present work aimed at maximizing the number of plantlets obtained by the micropropagation of pineapple (Ananas comosus (L.) Merrill) cv. Pérola. Changes in benzylaminopurine (BAP) concentration, type of medium (liquid or solidified) and the type of explant in the proliferation phase were evaluated. Slips were used as the explant source, which consisted of axillary buds obtained after careful excision of the leaves. A Sterilization was done in the hood with ethanol (70%), for three minutes, followed by calcium hypochlorite (2%), for fifteen minutes, and three washes in sterile water. The explants were introduced in MS medium supplemented with 2mg L-1 BAP and maintained in a growth room at a 16h photoperiod (40 mmol.m-2.s-1), 27 ± 2ºC. After eight weeks, cultures were subcultured for multiplication in MS medium. The following treatments were tested: liquid x solidified medium with different BAP concentrations (0.0, 1.5 or 3.0 mg L-1), and the longitudinal cut, or not, of the shoot bud used as explant. The results showed that liquid medium supplemented with BAP at 1.5 mg L-1, associated with the longitudinal sectioning of the shoot bud used as explant presented the best results, maximizing shoot proliferation. On average, the best treatment would allow for an estimated production of 161,080 plantlets by the micropropagation of the axillary buds of one plant with eight slips and ten buds/slips, within a period of eight months.

Optimization of OSEM parameters in myocardial perfusion imaging reconstruction as a function of body mass index: a clinical approach

AbstractObjective:The present study is aimed at contributing to identify the most appropriate OSEM parameters to generate myocardial perfusion imaging reconstructions with the best diagnostic quality, correlating them with patients' body mass index.Materials and Methods:The present study included 28 adult patients submitted to myocardial perfusion imaging in a public hospital. The OSEM method was utilized in the images reconstruction with six different combinations of iterations and subsets numbers. The images were analyzed by nuclear cardiology specialists taking their diagnostic value into consideration and indicating the most appropriate images in terms of diagnostic quality.Results:An overall scoring analysis demonstrated that the combination of four iterations and four subsets has generated the most appropriate images in terms of diagnostic quality for all the classes of body mass index; however, the role played by the combination of six iterations and four subsets is highlighted in relation to the higher body mass index classes.Conclusion:The use of optimized parameters seems to play a relevant role in the generation of images with better diagnostic quality, ensuring the diagnosis and consequential appropriate and effective treatment for the patient.

Production of fungal protein by solid substrate fermentation of cactus Cereus peruvianus and Opuntia ficus indica

Agricultural wastes from cactus Cereus peruvianus and Opuntia ficus indica were investigated for protein production by solid substrate fermentation. Firstly, the polyelectrolytes were extracted and used in water cleaning as auxiliary of flocculation and coagulation. The remaining fibrous material and peels were used as substrate for fermentation with Aspergillus niger. Glucoamylase and cellulase were the main enzymes produced. Amino acids were determined by HPLC and protein by Lowry's method. After 120 hours of fermentation the protein increased by 12.8%. Aspartic acid (1.27%), threonine (0.97%), glutamic acid (0.88%), valine (0.70%), serine (0.68%), arginine (0.82%), and phenylalanine (0.51%) were the principal amino acids produced.

The chemistry involved in the steam treatment of lignocellulosic materials

Pretreatment of lignocellulosic materials is essential for bioconversion because of the various physical and chemical barriers that greatly inhibit their susceptibility to bioprocesses such as hydrolysis and fermentation. The aim of this article is to review some of the most important pretreatment methods developed to date to enhance the conversion of lignocellulosics. Steam explosion, which precludes the treatment of biomass with high-pressure steam under optimal conditions, is presented as the pretreatment method of choice and its mode of action on lignocellulosics is discussed. The optimal pretreatment conditions for a given plant biomass are defined as those in which the best substrate for hydrolysis is obtained with the least amount of soluble sugars lost to side reactions such as dehydration. Therefore, pretreatment optimization results from a compromise between two opposite trends because hemicellulose recovery in acid hydrolysates can only be maximized at lower pretreatment severities, whereas the development of substrate accessibility requires more drastic pretreatment conditions in which sugar losses are inevitable. To account for this heterogeneity, the importance of several process-oriented parameters is discussed in detail, such as the pretreatment temperature, residence time into the steam reactor, use of an acid catalyst, susceptibility of the pretreated biomass to bioconversion, and process design.

Optimization of methodology to analyze ascorbic and dehydroascorbic acid in vegetables

In this study, different solutions to extract vitamin C were tested. High-performance liquid chromatography was chosen and the conditions were based on isocratic elution in reverse phase column. Dehydroascorbic acid was determined indirectly after its reduction using dithiothreitol. The use of metaphosphoric acid to stabilize the vitamin C was shown to be required and it was necessary to neutralize the pH of the extract to apply dithiothreitol. The average recovery was 90% in collard and tomato samples. The presence of oil did not interfere in extraction and the methodology can be used to analyze stir fried vegetables.

Optimization of the carrot leaf dehydration aiming at the preservation of omega-3 fatty acids

The carrot leaf dehydration conditions in air circulation oven were optimized through response surface methodology (RSM) for minimizing the degradation of polyunsaturated fatty acids, particularly alpha-linolenic (LNA, 18:3n-3). The optimized leaf drying time and temperature were 43 h and 70 ºC, respectively. The fatty acids (FA) were investigated using gas chromatography equipped with a flame ionization detector and fused silica capillary column; FA were identified with standards and based on equivalent-chain-length. LNA and other FA were quantified against C21:0 internal standard. After dehydration, the amount of LNA, quantified in mg/100 g dry matter of dehydrated carrot leaves, were 984 mg.

Optimization of the use of carbon paste electrodes (CPE) for electrochemical study of the chalcopyrite

The use of carbon paste electrodes (CPE) of mineral sulfides can be useful for electrochemical studies to overcome problems by using massive ones. Using CPE-chalcopyrite some variables were electrochemically evaluated. These variables were: (i) the atmosphere of preparation (air or argon) of CPE and elapsed time till its use; (ii) scan rate for voltammetric measurements and (iii) chalcopyrite concentration in the CPE. Based on cyclic voltammetry, open-circuit potential and electrochemical impedance results the recommendations are: oxygen-free atmosphere to prepare and kept the CPE until around two ours, scan rates from 10 to 40 mV s-1, and chalcopyrite concentrations > 20%.

Utilização de resíduos agroindustriais para a produção de proteases pelo termofílico Bacillus sp em fermentação submersa: otimização do meio de cultura usando a técnica de planejamento experimental

Thermophilic Bacillus sp. SMIA-2, produced protease when grown on apple pectic, whey protein and corn step liquor medium, whose concentration was varied from 3 to 10 gL-1, according to the central composite design 2³. The experiments were conducted in shaker, at 50 °C, 150 rpm and initial pH 6.5. The results revealed that the culture medium affected both, cell growth and enzyme production. After graphical and numerical optimization procedure, the enzyme production reached its maximum value at 30 h fermentation, reaching, approximately, 70 U protein mg-1, suggesting that this process was partially associated to the growth.

Terbinafine: optimization of a LC method for quantitative analysis in pharmaceutical formulations and its application for a tablet dissolution test

A simple liquid chromatographic method was optimized for the quantitative determination of terbinafine in pharmaceutical hydroalcoholic solutions and tablets, and was also employed for a tablet dissolution test. The analysis was carried out using a RP-C18 (250 mm × 4.6 mm, 5 μm) Vertical® column, UV-Vis detection at 254 nm, and a methanol-water (95:5, v/v) mobile phase at a flow-rate of 1.2 mL min-1. Method validation investigated parameters such as linearity, precision, accuracy, robustness and specificity, which gave results within the acceptable range. The tablets dissolution was quite fast: 80% of the drug was dissolved within 15 min.

Optimization of a HPLC procedure for simultaneous determination of cisplatin and the complex cis,cis,trans-diamminedichlorodihydroxoplatinum(IV) in aqueous solutions

A RP-HPLC procedure for the simultaneous determination of cisplatin and the complex cis,cis,trans-diamminedichlorodihydroxo-platinum(IV), was development. The developed procedure was validated in terms of linearity, accuracy, precision, limits of detection (LOD), limits of quantification (LOQ) and specificity. The limits of detection (LOD) were 0.47 x 10-4 and 0.53 x 10-4 mol L-1 and the limits of quantification (LOQ) were 1.57 x 10-4 and 1.75 x 10-4 mol L-1, for cisplatin and cis,cis,trans-diamminedichlorodihydroxopla-tinum(IV), respectively. The average recoveries of cisplatin and cis,cis,trans-diamminedichlorodihydroxoplatinum(IV) was 100.6% ± 1.4 and 101.2% ± 1.1, respectively. Intermediate (inter-day) precision, repeatability and specificity of the procedure for hydrolysis products of cisplatin were studied. The results of the study showed that the proposed RP-HPLC procedure is simple, rapid, precise, accurate and specific.

Optimization of wood flour acetylation by factorial design and partial least squares regression

Acetylation was performed to reduce the polarity of wood and increase its compatibility with polymer matrices for the production of composites. These reactions were performed first as a function of acetic acid and anhydride concentration in a mixture catalyzed by sulfuric acid. A concentration of 50%/50% (v/v) of acetic acid and anhydride was found to produced the highest conversion rate between the functional groups. After these reactions, the kinetics were investigated by varying times and temperatures using a 3² factorial design, and showed time was the most relevant parameter in determining the conversion of hydroxyl into carbonyl groups.

Optimization and practical implementation of ultrafast 2D NMR experiments

Ultrafast 2D NMR is a powerful methodology that allows recording of a 2D NMR spectrum in a fraction of second. However, due to the numerous non-conventional parameters involved in this methodology its implementation is no trivial task. Here, an optimized experimental protocol is carefully described to ensure efficient implementation of ultrafast NMR. The ultrafast spectra resulting from this implementation are presented based on the example of two widely used 2D NMR experiments, COSY and HSQC, obtained in 0.2 s and 41 s, respectively.

Xylitol from rice husks by acid hydrolysis and Candida yeast fermentation

An investigation was conducted into the production of xylose by acid hydrolysis of rice husks and its subsequent bioconversion to xylitol. The parameters were optimised using the response surface methodology. The fermentation stage took place with the aid of the yeast species Candida guilliermondii and Candida tropicalis. An evaluation of the influence of several biomass pre-treatments was also performed. The effects of the acid concentration and hydrolysate pH on xylitol global yield were also assessed, and the highest yield of xylitol was 64.0% (w/w). The main products, xylose and xylitol, were identified and quantified by means of liquid chromatography.