Emissões de motor agrícola com o uso de diferentes tipos de diesel e concentrações de biodiesel na mistura combustível

Resumo: O objetivo deste trabalho foi quantificar o efeito do tipo de diesel e da concentração de biodiesel na mistura combustível sobre as emissões de gases por motor agrícola submetido a diferentes cargas. Foram testados dois tipos de diesel: S10, com baixo teor de enxofre; e S500, com alto teor de enxofre; bem como suas misturas com 5, 10, 15, 20, 50 e 100% de biodiesel. O motor, de quatro cilindros, turboalimentado e com 105 cv de potência máxima, foi submetido a oito modos de operação, sob diferentes rotações e torques. O ensaio seguiu a metodologia prevista na norma NBR ISSO 8174-4:2012, tendo-se analisado as emissões de O2, CO2, NO2, NO, CO e de hidrocarbonetos (HC). Somente as emissões de HC foram influenciadas pelo tipo de diesel utilizado. As emissões de NO2 e O2 aumentaram com o aumento da concentração de biodiesel na mistura, enquanto as emissões de CO2, NO, CO e HC diminuíram. A carga aplicada ao motor esteve diretamente relacionada às emissões, exceto para O2. O combustível S10, com 20% de biodiesel, reduz as emissões, em comparação ao diesel comercial (S500), sem perda no desempenho do motor.

Biodiesel de babaçu (Orbignya sp.) obtido por via etanólica

Biodiesel was obtained by transesterification of babassu oil in anhydrous ethanol and methanol, employing NaOH as catalyst. The products obtained were characterized by physico-chemical and thermogravimetric analysis. It could be concluded that the properties of the two types of biodiesel (ethanolic and methanolic) are very similar when compared with diesel oil.

Biodiesel de soja: reação de transesterificação para aulas práticas de química orgânica

The transesterification procedure of triacylglycerides from soybean oil (in natura and waste oil) to give biodiesel was adapted to semi-micro laboratory scale as an additional experimental technique of nucleophilic acyl substitution for undergraduate courses in Chemistry and related areas.

Síntese de biodiesel: uma proposta contextualizada de experimento para laboratório de química geral

The contextualized understanding of concepts in Chemistry by students from other areas is a challenging task. In this experiment, the synthesis of biodiesel is done by base catalyzed transesterification of refined soy oil with methanol at room temperature and common glassware found in any chemistry laboratory. The proposal permits introducing several concepts, such as that of emulsion, viscosity and catalysis to illustrate an activity based on an actual problem. In this didactic approach, some common problems of biodiesel production, such as soap formation and phase separation, are introduced into the procedure in order to raise questions and motivate the students to participate in the experimental work and stimulate reflections about critical aspects of biodiesel production. This experiment was carried out in the first semester of 2006, in experimental general chemistry taken by physics and agricultural, civil and chemical engineering students of UNICAMP.

Desenvolvimento e validação de metodologia de análise de misturas biodiesel: diesel utilizando cromatografia gasosa-espectrometria de massas

The aim of this work was to develop and validate a method of analysis of biodiesel:diesel blends using HRGC-MS in SIM mode. The proposed method is applicable to biodiesel from linoleic oils, such as soybean oil. The following results were obtained: linearity over the methyl linoleate concentration range of 250-2500 mg L-1 (R² > 0.999); limits of detection and quantification of 2 and 5 mg L-1, respectively; recovery from 82 to 96% of biodiesel in diesel and repeatability < 2% (RSD). Comparison between two operators showed that it is not necessary the same operator to do the analysis.

Transesterificação de óleos vegetais: caracterização por cromatografia em camada delgada e densidade

We studied the transesterification of two vegetable oils: soybean and waste frying oil. The main problem of transesterification is related to the measurement of the ethyl ester content. In this work we used a quick analytical method for assessing the ethyl ester fraction of the purified fuel-grade transesterification products by applying a simple correlation with density. If the ester content is higher than 85% by weight the correlation allows the determination by a single density measurement. This method is suitable for control and determines the ethyl ester quickly and simply.

Síntese de padrões cromatográficos e estabelecimento de método para dosagem da composição de ésteres de ácidos graxos presentes no biodiesel a partir do óleo de babaçu

Several alkyl esters were synthesized, purified, characterized by ¹H NMR and employed as standards for establishing chromatographic methods to monitor their formation in the synthesis of biodiesel. The efficiency of the chromatographic methods was confirmed with the products of enzymatic transesterification of babassu oil with different alcohols (C2 to C4), using Lipozyme as catalyst.

Metodologia analítica para quantificar o teor de biodiesel na mistura biodiesel: diesel utilizando espectroscopia na região do infravermelho

Considered the best substitute for diesel, biodiesel can be blended with diesel in any ratio, bringing lots of environmental, economic and social advantages. Brazilian law Nº 11097/2005, proposes the introduction of biodiesel in to the Brazilian energy matrix, mixed with diesel at a minimum percentage of 2%. For consumers and sellers to be sure that the commercialized mixture of biodiesel:diesel contains the correct percentage, it is necessary to develop analytical methodologies to quantify the amount of biodiesel added. This work presents a fast, low-cost and simple methodology to determine the biodiesel proportion in mixtures of biodiesel:diesel, based on infrared spectroscopy.

Análise por cromatografia gasosa de BTEX nas emissões de motor de combustão interna alimentado com diesel e mistura diesel-biodiesel (B10)

This paper describes the procedures for analysing pollutant gases emitted by engines, such as volatile organic compounds (benzene, toluene, ethylbenzene, o-xylene, m-xylene and p-xylene) by using high resolution gas chromatography (HRGC). For IC engine burning, in a broad sense, the use of the B10 mixture reduces drastically the emissions of aromatic compounds. Especially for benzene the reduction of concentrations occurs at the level of about 24.5%. Although a concentration value below 1 µg mL-1 has been obtained, this reduction is extremely significant since benzene is a carcinogenic compound.

Avaliação da estabilidade oxidativa de biodiesel de óleo de girassol com antioxidantes

Biodiesel can contain unsaturated fatty acids, which are susceptible to oxidation, being able to change into polymerized compounds. In this work biodiesel was characterized according to physical-chemistry parameters and the antioxidant activity of butylated hydroxyanisole (BHA), butylated hydroxytoluene (BHT) and tert-butylhydroquinone (TBHQ) added to biofuel was analyzed. Biodiesel was submitted to accelerate oxidation in the Schaal oven test, and peroxide value was analyzed.The absorptivity values at 232 nm and 270 nm and oxidative stability in Rancimat®were determined. It was observed that TBHQ presented superior antioxidant activity than BHT and BHA.

Gliceroquímica: novos produtos e processos a partir da glicerina de produção de biodiesel

Glycerol is a byproduct of biodiesel production through transesterification of oils and fat. This article discusses the chemical transformation of glycerol in ethers, acetals and esters of high technological applications, especially in the fuel sector. Glycerol hydrogenolysis, dehydration to acrolein and oxidation are discussed as well, to show the potential use of glycerol for production of plastic monomers. Finally, the article shows other transformations, such as syn gas production, epichloridrin and glycerin carbonate.

Biodiesel: visão crítica do status atual e perspectivas na academia e na indústria

This article presents a bibliographic review of research carried out on different alternative processes for biodiesel production. The supercritical and subcritical (non catalytic) reaction conditions, the use of solid basic, solid acid and other heterogeneous catalysts, including the use of immobilized enzymes and whole-cell catalysts are also critically compared with the traditional homogeneous alkaline or acid catalysts that are common on industrial applications. Advantages and limitations of all these processes for the transference from the laboratory to the industry are discussed. A correlation of the chemical composition with the quality parameters of the produced biodiesel is done with aim to stablish adequate procedures for the right selection of the raw-material. Castor bean oil is used as an example of inappropriate oil in order to produce a B100 that fulfill all the international physico-chemical quality standards. In this article are presented research results to adequate the values of viscosity, density and iodine number of the castor and soybean biodiesel to the international standard limits by means blending these both biodiesels at the right ratio.

Cadeia do biodiesel da bancada à indústria: uma visão geral com prospecção de tarefas e oportunidades para P&D&I

Contextualized overview of the Biodiesel Production Chain, from the lab bench to the industry, with critical evaluation of state-of-art and technological development through scientific articles and patents, focusing on feedstock, reaction/production, first and second generation processes, specification and quality, transport, storage, co-products (effluents and sub-products), and emissions. Challenges are identified and solutions are proposed based on the Brazilian feedstock, edaphoclimatic conditions, process monitoring in remote regions, state policy, and environment preservation, among others. Forecasts are made based on the technology assessment, identifying future trends and opportunities for R&D&I.

Biodiesel: parâmetros de qualidade e métodos analíticos

The establishment of quality standards for biodiesel was a key step to win the confidence of the market and the automotive industry, thus ensuring the success of the new fuel. In this review are presented standard methods and other analytical methods suggested for analysis of biodiesel. The methods of analysis were divided into groups according to information that may be provided on the contaminants from the raw material of the production process, the molecular structures of biodiesel and its degradation during storage.