Titrimetric assay of lisinopril in aqueous and non-aqueous media

Four simple titrimetric procedures are described for the determination of lisinopril (LNP) in bulk and in pharmaceuticals based on the neutralization of basic-amino and acidic carboxylic acid groups present in LNP. Method A is based on the neutralization of basic amino groups using perchloric acid as titrant in anhydrous acetic acid medium. Method B, method C and method D are based on neutralization of carboxylic acid group using NaOH, sodium methoxide and methanolic KOH, as titrants, respectively. Method A is applicable over 2.0-20.0 mg range and the calculations are based in the molar ratio of 1:2 (LNP:HClO4). Method B, method C and method D are applicable over 2.0-20.0 mg, 1.0-10.0 mg and 5.0-15.0 mg range, respectively, and their respective molar ratios are 1:1 (LNP:NaOH), 1:2 (LNP:CH3ONa) and 1:1 (LNP:KOH). Intraday and inter day accuracy and precision of the methods were evaluated and the results showed intra- and inter-day precision less than 2.7% (RSD), and accuracy of < 2.5 % (RE). The developed methods were applied to determine LNP in tablets and the results were validated statistically by comparing the results with those of the reference method by applying the Student's t-test and F-test. The accuracy was further ascertained by recovery studies via standard addition technique. No interferences from common tablet exipients was observed.

Titrimetric and spectrophotometric assay of bupropion hydrochloride in pharmaceuticals using mercury(II) nitrate

Two simple, rapid and accurate methods for the determination of bupropion hydrochloride (BUP) in pure and in pharmaceutical preparations are described. Both methods are based on the measurement of the chloride of its hydrochloride. In the titrimetric method, the chloride content of bupropion hydrochloride is determined by titrating with mercury(II)nitrate using diphenylcarbazone-bromophenol blue as indicator. Titrimetric method is applicable over a range 2-20 mg of BUP and the reaction stoichiometry is found to be 2:1 (BUP: Hg(NO3)2). The spectrophotometric method involves the addition of a measured excess of mercury(II) nitrate reagent in formate buffer to the drug, and after ensuring the reaction had gone to completion, the unreacted mercury(II) is treated with a fixed amount of diphenylcarbazone, and absorbance measured at 515 nm. The absorbance is found to decrease linearly with increasing concentration of BUP and the calibration curve is linear over 1.0-15.0 µg mL-1 BUP. The proposed methods were successfully applied to the determination of BUP in commercially available dosage forms with good accuracy and precision, and without detectable interference by excipients. The accuracy was further ascertained by placebo blank and synthetic mixture analyses and also by recovery experiments via standard-addition procedure.

Soluble tissue sugar content and leaf blast severity in response to the application of calcinated serpentinite as a silicon source in irrigated rice

A field experiment conducted with the irrigated rice cultivar BRS Formoso, to assess the efficiency of calcinated serpentinite as a silicon source on grain yield was utilized to study its effect on leaf blast severity and tissue sugar levels. The treatments consisted of five rates of calcinated serpentinite (0, 2, 4, 6, 8 Mg.ha-1) incorporated into the soil prior to planting. The leaf blast severity was reduced at the rate of 2.96% per ton of calcinated serpentinite. The total tissue sugar content decreased significantly as the rates of serpentinite applied increased (R² = 0.83). The relationship between the tissue sugar content and leaf blast severity was linear and positive (R² = 0.81). The decrease in leaf blast severity with increased rates of calcinated serpentinite was also linear (R²= 0.96) and can be ascribed to reduced sugar level.

Induction of plant defense responses by Ocimum gratissimum L. (Lamiaceae) leaf extracts

Aqueous extracts of the leaves of Ocimum gratissimum at 10, 25, 40 and 50% (w/v) concentrations induced the production of phytoalexins in soybean cotyledons and sorghum mesocotyls. The aqueous extracts also induced systemic resistance in cucumber to Colletotrichum lagenarium, reflected by reduction in disease incidence and an increase in chitinase production. Modes of action and the existence of possible elicitors of defense response in O. gratissimum leaf extracts are discussed.

Leaf blight and defoliation of Eugenia spp. caused by Cylindrocladium candelabrum and C. spathiphylli in Brazil

Leaf blight and defoliation of Eugenia stipitata Mc Vaugh and Eugenia patrisii Vahl, caused respectively by Cylindrocladium candelabrum (Calonectria scoparia) and C. spathiphylli (Calonectria spathiphylli) are reported in the state of Pará, Brazil. On both host species, the disease is characterized by dark brown lesions of different sizes and shapes. A whitish bright sporulation, resembling Cylindrocladium is observed on the necrotic lesions by using a stereomycroscope or a pocket lense (10-20 X). Under favorable conditions and depending on the level of infection, intense premature tree defoliation may also be found.Although the conidial germination and mycelial growth were higher at 25ºC for both species, C. candelabrum was more sensitive to the variation of temperature (10, 20, 30 and 40 ºC) than C. spathiphylli. This is the first report of C. candelabrum and C. spathiphylli on Eugenia stipitata (araçá-boi) and on Eugenia patrisii (ubaia-da-amazônia), respectively in Brazil.

Weather based warning systems for bean angular-leaf-spot and anthracnose

Data available in the literature were used to develop a warning system for bean angular leaf spot and anthracnose, caused by Phaeoisariopsis griseola and Colletotrichum lindemuthianum, respectively. The model is based on favorable environmental conditions for the infectious process such as continuous leaf wetness duration and mean air temperature during this subphase of the pathogen-host relationship cycle. Equations published by DALLA PRIA (1977) showing the interactions of those two factors on the disease severity were used. Excell spreadsheet was used to calculate the leaf wetness period needed to cause different infection probabilities at different temperature ranges. These data were employed to elaborate critical period tables used to program a computerized electronic device that records leaf wetness duration and mean temperature and automatically shows the daily disease severity value (DDSV) for each disease. The model should be validated in field experiments under natural infection for which the daily disease severity sum (DDSS) should be identified as a criterion to indicate the beginning and the interval of fungicide applications to control both diseases.

In vivo sensitivity reduction of Puccinia triticina races, causal agent of wheat leaf rust, to DMI and QoI fungicides

Experiments were carried out to determine in vivo the IC50 and the IC90 for demethylation-inhibitor fungicides (DMIs, triazoles) and quinone outside inhibitors (QoIs, strobilurins) to the five most frequent races of Puccinia triticina in 2007 growing season in Southern Brazil. The tests were done in a greenhouse with wheat seedlings. DMI fungicides were tested at the concentrations, in mg/L, 0.0; 0.02; 0.2; 2.0; 20.0; 100.0 and 200.0, and QoIs at the concentrations 0.0; 0.0001; 0.001; 0.01; 0.1; 1 and 10.0 mg of active ingredient/L water. Fungicides were preventively applied at 24 hours before the inoculation of seedlings with the fungal spores. The effect of treatments was assessed based on the number of uredia/cm². The lowest IC50 (inhibitory concentration) for DMI fungicides determined for MCG-MN, sensitive race, ranged from 0.33 to 0.91 mg/L, while the highest values for MDP-MR, MDT-MR, MDK-MR, MFH-HT races, varied from 9.63 to 85.64 mg/L (suspected insensitivity). QoI fungicide presented an IC50 varying from 0.0018 to 0.14 mg/L. The sensitivity reduction factor for DMIs varied from 8.8 to 238.8, and for QoIs from 0.3 to 1.5 mg/L. Sensitivity reduction was confirmed for the races MDP-MR, MDT-MR, MDK-MR, MFH-HT to DMIs, as well as their sensitivity to QoI fungicides.

Fungicide baseline for mycelial sensitivity of Exserohilum turcicum, causal agent of northern corn leaf blight

Northern corn leaf blight, caused by Exserohilum turcicum(Et), is one of the major corn diseases which can reduce grain yield and quality. The aim of this study was to determine the mycelial sensitivity of ten Etisolates, five from Argentina and five from Brazil, to six fungicides (carbendazim, captan, fludioxinil, metalaxyl, iprodione and thiram) used in seed treatment. The inhibitory concentration (IC50) was determined by using seven concentrations of the fungicides supplemented to the agar medium. The mycelial colony diameter was measured with a digital caliper. Experimental design was completely randomized with four replicates. Data on the percent mycelial growth inhibition were analyzed by logarithmic regression and the IC50 was calculated. The fungicide iprodione was the most potent, with IC50 < 0.01 mg/L, followed by fludioxonil, IC50 0.31 mg/L, and thiram, 1.37 mg/L. Carbendazim, metalaxyl and captan were classified as non-fungitoxic, showing IC50 > 50 mg/L for all isolates. Although iprodione is the most potent fungicide, it is not used for corn seed treatment. The IC50s obtained in this study can be used as baseline for future monitoring studies of Etsensitivity to fungicides.

Quantification of incubation, latent and infection periods of Phakopsora pachyrhizi in soybean, according to chronological time and degree-days

ABSTRACT In experiments conducted in a growth chamber, the chronological time and the accumulated degree-days were determined for the duration of incubation, latent and infectious periods of Phakopsora pachyrhizi cultivars BRSGO 7560 and BRS 246 RR. Detached soybean leaflets were placed in gerbox-type acrylic boxes and inoculated with 20 x 103 uredospores/mL. The study was conducted at 12-h photoperiod and temperatures of 10ºC, 15ºC, 22ºC, 25ºC and 30°C for 30 days. Lesions and uredia/cm2were evaluated and the number of uredia per lesion was quantified after the beginning of sporulation. The sporulation potential was also quantified for cultivars BRSGO 7560 and BRS 246 RR. The steps of the infection process can be quantified based on both the chronological time and the accumulated heat. The cultivar BRSGO 7560 produced 4,012.8 spores/cm2 and BRS 246 RR, 7,348.4 uredospores/cm2. The largest number of uredia was produced at 25ºC in both cultivars; however, BRS 246 RR presented 372.7 uredia/cm2 and BRSGO 7560, 231.6 uredia/cm2. At 10ºC and 30°C, leaf infection did not occur in both cultivars.

Influence of temperature and leaf wetness duration in the severity of Cercospora leaf spot of beet

ABSTRACT In the present study, the influence of temperature (15, 20, 25, 30 and 35°C) and leaf wetness period (6, 12, 24 and 48 hours) on the severity of Cercospora leaf spot of beet, caused by Cercospora beticola, was studied under controlled conditions. Lesion density was influenced by temperature and leaf wetness duration (P<0.05). Data were subjected to nonlinear regression analysis. The generalized beta function was used for fitting the disease severity and temperature data, while a logistic function was chosen to represent the effect of leaf wetness on the severity of Cercospora leaf spot. The response surface resultant of the product of the two functions was expressed as ES = 0.0001105 * (((x-8)2.294387) * ((36-x)0.955017)) * (0.39219/(1+25.93072 * exp (-0.16704*y))), where: ES represents the estimated severity value (0.1); x, the temperature (ºC) and y, the leaf wetness duration (hours). This model should be validated under field conditions to assess its use as a computational forecast system for Cercospora leaf spot of beet.

Development of a weather-based model for Botrytis leaf blight of onion

ABSTRACT In the present study, onion plants were tested under controlled conditions for the development of a climate model based on the influence of temperature (10, 15, 20 and 25°C) and leaf wetness duration (6, 12, 24 and 48 hours) on the severity of Botrytis leaf blight of onion caused by Botrytis squamosa. The relative lesion density was influenced by temperature and leaf wetness duration (P <0.05). The disease was most severe at 20°C. Data were subjected to nonlinear regression analysis. Beta generalized function was used to adjust severity and temperature data, while a logistic function was chosen to represent the effect of leaf wetness on the severity of Botrytis leaf blight. The response surface obtained by the product of two functions was expressed as ES = 0.008192 * (((x-5)1.01089) * ((30-x)1.19052)) * (0.33859/(1+3.77989 * exp (-0.10923*y))), where ES represents the estimated severity value (0.1); x, the temperature (°C); and y, the leaf wetness (in hours). This climate model should be validated under field conditions to verify its use as a computational system for the forecasting of Botrytis leaf blight in onion.