Morphologic and molecular characterization of Myrciaria spp species

The jabuticaba tree is considered one of the most typical Brazilian fruit trees. However, few studies of this plant are found in the literature and even its botanical classification is very controversial. The present research reports some comparisons between jabuticaba species, using morphologic (organography) and molecular markers techniques. The morphologic characteristics of the plant used as markers were compared with specimens of the herbaria from São Paulo and Minas Gerais States and with the descriptions reported in the literature. Molecular differences between the species were identified by the use of RAPD markers. The experiment was made in Piracicaba, Jaboticabal and Ituverava municipal districts in São Paulo State, Brazil. Morphologic and molecular differences between the studied plants were identified and four groups of species were defined: Myrciaria cauliflora (Mart.) O. Berg, M. coronata Mattos, M. jaboticaba (Vell.) O. Berg. and Myrciaria phytrantha (Kiaersk.) Mattos. Both molecular and morphologic markers techniques showed to be important tools for the identification of jabuticaba tree species.

Agronomic and molecular traits of the 'Italia Muscat' clone in Sao Francisco River Valley

The objective of this study was to evaluate agronomic and molecular traits of the 'Italia Muscat' clone and compare it with the cv. 'Italia', providing information to support the cultivation of 'Italia Muscat' this cultivar in the São Francisco River Valley. Agronomic characteristics of both clones were evaluated for two seasons in 2004. The characteristics were phenology, bud break (%), bud fertility (%), yield (kg) mass of bunches (g), length and width of bunches (cm), mass of berries (g), length and diameter of berries (mm), TSS (ºBrix), ATT (% titratable acidity) and TSS/TTA. Molecular analysis of seven SSR markers were carried out. The clone 'Italia Muscat' showed larger berries, mass of bunches and better TSS/TA ratio than 'Italia'. The molecular analysis resulted in the same allelic profile in both clones, highlighting the need to use a larger number of microsatellite markers or other molecular technique to allow their discrimination. Based on their morpho-agronomic characteristics, 'Italia Muscat' seems to be a good table grape cultivar alternative for grape growers of São Francisco River Valley.

Molecular characterization of papaya genotypes using AFLP markers

Due to the low genetic variability reported in the commercial plantations of papaya (Carica papaya L.), the objective of this study was analyze the genetic diversity of 32 genotypes including cultivars, landraces, inbred lines, and improved germplasm using the AFLP technique (Amplified Fragment Length Polymorphism). The genetic distance matrix was obtained using the Nei and Li genetic distance and clustering was performed using the unweighted pair-method with arithmetic mean (UPGMA). Using 11 combinations of EcoRI/MseI primers, 383 polymorphic bands were obtained. On average, 34.8 polymorphic bands were obtained per primer combination. Five clusters were formed. The traditional cultivar 'Sunrise' and the inbred line CMF-L30-08 were the closest genotypes, and the improved germplasm (CMF041) and landrace (CMF233) the most distant. The main papaya cultivars commercially grown in Brazil, as well as four inbred lines and three improved germplasm, were clustered together, however, were not grouped in the same branch. The genetic distance between the Sunrise and Golden cultivars was 0.329, and even arising from mutation and selection within the Sunrise variety, the Golden stores considerable genetic variability. Additional variability was observed in the inbred lines derived from papaya breeding program at Embrapa Cassava and Fruits.

Combined experimental powder X-ray diffraction and DFT data to obtain the lowest energy molecular conformation of friedelin

Friedelin molecular conformers were obtained by Density Functional Theory (DFT) and by ab initio structure determination from powder X-ray diffraction. Their conformers with the five rings in chair-chair-chair-boat-boat, and with all rings in chair, are energy degenerated in gas-phase according to DFT results. The powder diffraction data reveals that rings A, B and C of friedelin are in chair, and rings D and E in boat-boat, conformation. The high correlation values among powder diffraction data, DFT and reported single-crystal data indicate that the use of conventional X-ray diffractometer can be applied in routine laboratory analysis in the absence of a single-crystal diffractometer.

Molecular characterization of Brazilian Dicyma pulvinata isolates

Forty-nine Brazilian Dicyma pulvinata isolates were examined by morphological traits and RFLP, RAPD and AFLP analyses. This fungus is a mycoparasite of Microcyclus ulei, the causal agent of the most devastating rubber (Hevea brasiliensis) disease, known as "South American Leaf Blight" (SALB). These isolates were compared with an Indian isolate from Cercosporidium sp., and a French isolate from Cladosporium fulvum. They were also compared with Dicyma ampullifera from Papua New Guinea. The morphological parameters analyzed confirmed the identification of the Brazilian isolates. The graphic representations of the distance matrices of each molecular marker showed similar results. Dicyma pulvinata isolates from M. ulei were closely related, whereas the reference isolates examined were dispersed. Among the D. pulvinata isolates obtained from M. ulei, a significant pairwise distance was obtained, for all the molecular markers, between the isolates from the areas favorable to the occurrence of SALB (North and Northeast of Brazil) and the region of escape for the disease (Mato Grosso State).

Molecular characterization of Brazilian strains of Xanthomonas campestris pv. viticola by rep-PCR fingerprinting

Bacterial canker of grapevine (Vitis vinifera), caused by Xanthomonas campestris pv. viticola was first detected in Brazil in 1998, affecting grapevines in the São Francisco river basin, state of Pernambuco. The disease was also reported in Juazeiro, Bahia and later in Piauí and Ceará. Due to its limited geographical distribution and relatively recent detection in Brazil, very little is known about the pathogen's biology and diversity. Repetitive DNA based-PCR (rep-PCR) profiles were generated from purified bacterial DNA of 40 field strains of X. campestris pv. viticola, collected between 1998 and 2001 in the states of Pernambuco, Bahia and Piauí. Combined analysis of the PCR patterns obtained with primers REP, ERIC and BOX, showed a high degree of similarity among Brazilian strains and the Indian type strain NCPPB 2475. Similar genomic patterns with several diagnostic bands, present in all strains, could be detected. Fingerprints were distinct from those of strains representing other pathovars and from a yellow non-pathogenic isolate from grape leaves. The polymorphism observed among the Brazilian strains allowed their separation into five subgroups, although with no correlation with cultivar of origin, geographic location or year collected.

Biological and molecular characterization of an isolate of Tobacco streak virus obtained from soybeans in Brazil

A virus was isolated from soybean (Glycine max) plants with symptoms of dwarfing and bud blight in Wenceslau Braz County, Paraná, Brazil. The host range and properties resembled those of Tobacco streak virus (TSV). The purified virus showed three peaks in a frozen sucrose gradient. Antiserum was produced and the virus was serologically related to TSV. Electron microscopy detected 28 nm spherical particles. Coat protein (CP) had a Mr of 29.880 Da. A fragment of 1028 nt was amplified, cloned and sequenced. One open reading frame with 717 nt was identified and associated to the CP. The CP gene shared 83% identity with the sequence of TSV CP from white clover (Trifolium repens) (GenBank CAA25133). This is the first report of the biological and molecular characterization of TSV isolated from soybeans. It is proposed that this isolate be considered a strain of TSV named TSV-BR.

Design of an adsorbent employing activated carbon fiber to remove lead

Zorflex® activated carbon fibers (ACF), reference FM100 198B, are used before and after an oxidizing procedure with H3PO4 to study the adsorption of Pb2+. The point of zero charge was determined for the modified and unmodified fiber giving values of 2.3 and 4.3, respectively. After oxidizing the ACF, the fiber showed to have a greater Pb2+ adsorption capacity in comparison with the unmodified fiber, which is related with the acid sites increase, where lead was mainly adsorbed. Determination of the BET area was carried out by nitrogen physisorption at 77K. ACFs presented superficial areas between 1000 and 1500 m²/g showing mostly, a microporous structure. The preliminary design of an adsorbent using the modified fiber is presented where the fiber superior physicochemical properties over the unmodified one are observed.

Viscometric investigations and molecular interactions of some derivatives of 5-substituted indole dihydropyrimidines in mixed organic solvents

Colloid chemical behavior of indole dihydropyrimidines in non-aqueous solvent mixture benzene-methanol of varying composition has been investigated by viscometric measurements at 303K± 0.1. The viscosity of the system increases with the increase in concentration. The Trend Change Point (TCP) values have been determined by intersection of two straight lines, which are found to be dependent on the composition of solvent mixtures. The study confirms that the nature of synthesized compounds agglomerate formed below and above 50% benzene concentration is quite different. The viscometric data have been analyzed in terms of Einstein, Vand, Moulik and Jones-Dole equations. These well known equations have been successfully applied to explain the results of viscosity measurements and the viscometric parameters show that the behavior of compound changes in the proximity of 50% benzene concentration.

Powder flow criteria for design of vertical silo walls

For design of vertical silos walls involving the storage of bulk solids to be safe and reliable, it is important knowing the largest possible number of variables such as: flow properties, silo geometry and pattern of flow desired. In order to validate the theories of flow prediction and design of conical hoppers, the flow properties of two bulk solids were determined, the theories of Jenike's flowability and Enstad and Walker for hopper design were analyzed and the results were compared with those experimentally obtained in a reduced model of a semicircular-section silo. Results show that Enstad theory for the hopper design is adequate to occur mass flow inside the silo, and for the sizing of the discharge outlet, the Walker's theory was closer to the appropriate than Jenike's theory, which was higher around 100% than the experimental hopper outlet.

Molecular characterization of group A bovine rotavirus in southeastern and central-western Brazil, 2009-2010

Rotavirus is an important cause of neonatal diarrhea in humans and several animal species, including calves. A study was conducted to examine 792 fecal samples collected from calves among 65 dairy and beef herds distributed in two of Brazil's major livestock producing regions, aiming to detect the occurrence of rotavirus and perform a molecular characterization of the rotavirus according to G and P genotypes in these regions. A total of 40 (5.05%) samples tested positive for rotavirus by the polyacrylamide gel electrophoresis (PAGE) technique. The molecular characterization was performed by multiplex semi-nested RT-PCR reactions, which indicated that the associations of genotypes circulating in herds in Brazil's southeastern region were G6P[11], G10P[11], G[-]P[5] + [11], G[-]P[6] in the state of São Paulo and G6P[11], G8P[5], G11P[11], G10P[11] in the state of Minas Gerais. In the central-western region, the genotypes G6P[5] + [11], G6P[5], G8P[-], G6P[11], G [-] P[1], G[-] P[11], and G[-] P[5] were detected in the state of Goiás, while the genotypes G6P[5], G8[P11], G6[P11], G8[P1], G8[P5], G6[P1] were circulating in herds in the state of Mato Grosso do Sul. The genotypic diversity of bovine rotavirus found in each region under study underlines the importance of characterizing the circulating samples in order to devise the most effective prophylactic measures.

Pythium insidiosum: morphological and molecular identification of Brazilian isolates

Pythium insidiosum is an oomycete belonging to the kingdom Stramenipila and it is the etiologic agent of pythiosis. Pythiosis is a life-threatening infectious disease characterized by the development of chronic lesions on cutaneous and subcutaneous, intestinal, and bone tissues in humans and many species of animals. The identification of P. insidiosum is important in order to implement a rapid and definitive diagnosis and an effective treatment. This study reports the identification of 54 isolates of P. insidiosum of horses, dogs and sheep that presented suspicious clinical lesions of pythiosis from different regions in Brazil, by using morphological and molecular assays. Throughout the PCR it was possible to confirm the identity of all Brazilian isolates as being P. insidiosum.

Molecular characterization of virulence factors in Aeromonas hydrophila obtained from fish

Multiple factors can be involved in the virulence processes of Aeromonas hydrophila. The objective of the present paper was to verify the presence of aerolysin, hidrolipase, elastase and lipase virulence genes through the polymerase chain reaction (PCR) in A. hydrophila isolates obtained from fish of the São Francisco River Valley, and to evaluate virulence according to the presence of these genes in Nile tilapia fingerlings. One hundred and fourteen isolates from the bacteria were used. DNA was heat extracted and PCR undertaken using specific primers described in the literature. For in vivo tests Nile tilapia fingerlings were used. From the PCR tests, negative isolates for all genes tested were selected, positive isolates for two genes (aerolysin and elastase) and positive for the four genes tested. These were inoculated at a concentration of 10(8) UFC/ml into the tilapias, considered as treatments; another group of animals was used as control (with inoculation of saline solution). In all, 12 distinct standards regarding the presence of virulence factors in isolates from A. hydrophila, were observed. Of the 114 isolates analyzed, 100 (87.72%) presented at least one of the virulence factors under study. The virulence factors were widely distributed among the A. hydrophila isolates. Aerolysin was the most frequent virulence factor present in the isolates analyzed. A. hydrophila led to the mortality of the Nile tilapia fingerlings, regardless of the absence or quantity of virulence genes tested.