Effect of preparation practices and the cowpea cultivar Vigna unguiculata L.Walp on the quality and content of myo-inositol phosphate in akara (fried bean paste)

Akara is one of Brazil's national treasures prepared from cowpea (Vigna unguiculata L.Walp), grated onions and salt and deep-fried in crude palm oil. The results of this study on akara preparation methods showed that, in general, cowpeas were soaked for up 3 hours at room temperature, and the seed coats were then removed. The akara makers preferred the olho de pombo cultivar, because of its cream hue, or the macassar cultivar because it produces a crispier paste. The seeds purchased from street markets had lower ranges of InsP6, InsP5, and InsP4 (1.03-7.62 ∝mol.g- 1; 0.14-1.31 ∝mol.g- 1; and 0.0-0.10 ∝mol.g- 1, respectively) than both the paste and akara (6.72-19.24 ∝mol.g- 1; 1.29-4.57 ∝mol.g- 1; 0.0-0.76 ∝mol.g- 1; 3.31-13.71 ∝mol.g- 1; 0.0-4.48 ∝mol.g- 1; and 0.0-1.32 ∝mol.g- 1). These results suggest that other beans or cowpea varieties have been used in the preparation of akara and that the phytate levels do not affect its nutritional quality.

Effects of genotype and environment on grain yield and quality traits in bread wheat (T. aestivum L.)

Genotype (G), environment (E) and their interaction (GEI) play an important role in the final expression of grain yield and quality attributes. A multi-environment trial in wheat was conducted to evaluate the magnitude of G, E and GEI effects on grain yield and quality of wheat genotypes under the three rainfed locations (hereafter environment) of Central Anatolian Plateau of Turkey, during the 2012-2013 cropping season. Grain yield (GY) and analyses of test weight (TW), protein content (PC), wet gluten content (WGC), grain hardness (GH), thousand kernel weight (TKW) and Zeleny sedimentation volume (ZSV) were determined. Allelic variations of high and low molecular weight glutenin subunits (HMW-GS and LMW-GS) and 1B/1R translocation were determined in all genotypes evaluated. Both HMW-Glu-1, 17+18, 5+10 and LMW-Glu-3 b, b, b corresponded to genotypes possessing medium to good quality attributes. Large variability was found among most of the quality attributes evaluated; wider ranges of quality traits were observed in the environments than among the genotypes. The importance of the growing environment effects on grain quality was proved, suggesting that breeders' quality objectives should be adapted to the targeted environments.

Whole and crushed nutlets of chia (Salvia hispanica) from Mexico as a source of functional gums

The objective of this study was to characterize the chemical and functional properties of Mexican chia (Salvia hispanica) gums extracted from defatted whole and crushed nutlets using the Soxhlet and SFE-CO2 methods. Chia gums have interesting chemical and functional properties for the food industry. The oil and gum yields were in the range of 1.98-16.42% and 5.81-12.60%, respectively. The defatting procedure did not affect significantly the oil and gum extraction; the nutlet type (whole or crushed) was the only parameter influencing the yield. The proximate composition and the protein and fiber contents of chia gum were evaluated. Low contents of protein and fiber and high NFE levels were found in whole nutlet gums. The functional properties of chia gum extracted from whole and crushed nutlets with the Soxhlet and SFE-COs methods showed the following ranges of water absorption capacity of 62.64 to 143.66 g/g, water adsorption capacity of 0.69 to 1.35 g/g, and water and oil holding capacity of 100 to 149.28 g/g and19.5 to 40.4 g/g, respectively. The rheological behavior exhibited by the gums was pseudoplastic or shear thinning. From a functional perspective, chia gum is an important food component due its emulsifier and stabilizer potentials.

Drying peanut seed using air ambient temperature at low relative humidity

The moisture content of peanut kernel (Arachis hypogaea L.) at digging ranges from 30 to 50% on a wet basis (w.b.). The seed moisture content must be reduced to 10.5% or below before seeds can be graded and marketed. After digging, peanuts are cured on a window sill for two to five days then mechanically separated from the vine. Heated air is used to further dry the peanuts from approximately 18 to 10% moisture content w.b. Drying is required to maintain peanut seed and grain quality. Traditional dryers pass a high temperature and high humidity air stream through the seed mass. The drying time is long because the system is inefficient and the high temperature increases the risk of thermal damage to the kernels. New technology identified as heat pipe technology (HPT) is available and has the unique feature of removing the moisture from the air stream before it is heated and passed through the seed. A study was conducted to evaluate the performance of the HPT system in drying peanut seed. The seeds inside the shells were dried from 17.4 to 7.3% in 14 hours and 11 minutes, with a rate of moisture removal of 0.71% mc per hour. This drying process caused no reduction in seed quality as measured by the standard germination, accelerated ageing and field emergence tests. It was concluded that the HPT system is a promising technology for drying peanut seed when efficiency and maintenance of physiological quality are desired.

Indústria e crescimento econômico: evidências para países desenvolvidos e em desenvolvimento

The work develops an empirical investigation on the relevance of industry / GDP, manufacture / GDP and industrial employment / total employment on long run growth using panel data. The results indicate the existence of a direct and significant relation for industry (manufacture) share to GDP and industrial employment for long run growth. The annual impact on growth of a 10% increase, over a five year period, in the industry share to GDP (manufacture share to GDP) ranges from 0.19% to 0.32% (0.2% to 0.4%) and for the industrial employment / total employment it varies from 0.3% to 0.5%.