Avaliação de biocombustível derivado do bio-óleo obtido por pirólise rápida de biomassa lignocelulósica como aditivo para gasolina

A biofuel was prepared from acid aqueous fraction (pH = 2) of bio-oil produced by fast pyrolysis (Bioware Technology) of lignocellulosic biomass (sugar cane residue) and tested in blends (2, 5, 10 e 20% v/v) with gasoline type C (common) marketed in Brazil. The specification tests made in the Refinery President Getúlio Vargas (PETROBRAS) showed increasing in the octane number (MON) and antiknock index (AKI) with reduction in the residue generation during the combustion. The physicochemical characteristics of the biofuel were similar that combustible alcohol allowing its use as gasoline additive.

Influência do armazenamento de folhas secas no óleo essencial de patchouli (Pogostemon cablin Benth.)

The aim of this work was to evaluate the influence of five storage times of dry leaves of two patchouli genotypes on its essential oil content and chemical composition. Harvest was realized four months after planting. Storage influenced essential oil content of genotype POG-002. Patchoulol was the majority compound. Storage of dry leaves increased significatively the content of the compounds α-bulnesene and germacrene A of genotype POG-021 and longicanfenilone, pogostol and patchoulol of POG-002. However, storage reduced significatively the content of the compounds cicloseichelene, β-cariofilene, α-guaiene, acifilene and α-bulnesene of the essential oil of genotype POG-002.

Desenvolvimento de conjunto membrana-eletrodos para célula a combustível de metanol direto passiva

Direct methanol fuel cells (DMFCs) without external pumps or other ancillary devices for fuel and oxidant supply are known as passive DMFCs and are potential candidates to replace lithium-ion batteries in powering portable electronic devices. This paper presents the results obtained from a membrane electrode assembly (MEA) specifically designed for passive DMFCs. Appropriated electrocatalysts were prepared and the effect of their loadings was investigated. Two types of gas diffusion layers (GDL) were also tested. The influence of the methanol concentration was analyzed in each case. The best MEA performance presented a maximum power density of 11.94 mW cm-2.

Constituintes químicos e efeito ecotoxicológico do óleo volátil de folhas de Eucalyptus urograndis (Mirtaceae)

The volatile oil from the leaves of E. urograndis was analyzed by GC and GC-MS. It was identified 10 compounds in which, orto-cimene (41.4%) and 1,8-cineol (25.8%) were the main constituents. The induction of deleterious effect to aquatic organisms due to the presence of volatile oil lixiviated from E. urograndis leaves was studied using Daphnia laevis and D. similis as bioindicators. Through the results of toxicological tests it was possible to show that the litterbag of E. urograndis represents a risk factor for the aquatic ecosystem of lakes and rivers that are in the surrounding area of large scale Eucalyptus plantations. The method can be used for monitor the quality of these types of aquatic environments.

Desenvolvimento de processo de produção de conjuntos eletrodo-membrana-eletrodo para células a combustível baseadas no uso de membrana polimérica condutora de prótons (PEMFC) por impressão a tela

Proton exchange membrane fuel cell (PEMFC) requires membrane electrode assemblies (MEA) to generate electrical energy from hydrogen and oxygen. In this study a MEA production process by sieve printing and an ink composition were developed to produce catalyst layers of MEAs. The deposition of the exact catalyst content was possible on cathodes and anodes with only one print step. The optimal ink developed shown viscosity of 2.75 Pa s, density 1.27 g cm-3, total solid content of 33.76 % and tack of 92 U.T. The electrodes prepared in only one printing step showed higher performance than those prepared in several steps.

Identificação de adulteração de biocombustível por adição de óleo residual ao diesel por espectrofluorimetria total 3D e análise das componentes principais

Total spectrofluorimetry associated to Principal Components Analysis (PCA) were used to classify into different groups the samples of diesel oil, biodiesel, vegetal oil and residual oil, as well as, to identify addition of non-transesterified residual vegetable oil, instead of biodiesel, to the diesel oil. Using this method, the samples of diesel oil, mixtures of biodiesel in diesel and mixtures of residual oil in diesel were separated into well-defined groups.

Estudos de biodegradação de óleo diesel por consórcio microbiano coletado em Porto Velho - RO, amazônia

The goal of this research was to evaluate the biodegradation of diesel by a microbial consortium collected in a region close to distributors of fuel. The experiments were monitored by SPME-GC-FID and SPME-GC-MS. The consortium showed a high potential for production of biosurfactants, presenting an emulsification index of 53%. The consortium degraded completely n-alkanes, while dimethylnaphtalene, hepthyl-cyclohexane and 2,6,10-trimethyl-undecane were partially degraded and pristane was not degraded. From this consortium five strains were isolated and identified as Acinetobacter baumannii. Based on this initial investigation this consortium appears to be effective for bioremediation in Porto Velho - RO region.

Uso de amêndoas de baru (Dypterix alata) para remoção de Ni(ii) em etanol combustível

The present work describes the sorption potential of Dypterix alata (baru) for removal of Ni(II) in hydrous ethanol. Infrared spectroscopy was used for elucidating possible functional groups responsible for uptaking Ni(II). Sorption studies using Ni(II) standard solutions were carried out in batch experiments as functions of extraction time and pH solution. The Ni(II) was quantified before and after the removal experiments using Flame Atomic Absorption Spectrometry. Furthermore, based on adsorption studies and adsorption isotherms applied to the Langmuir and Freundlich models, it was possible to verify that D. alata presents a high adsorption capacity. The results show that D. alata can be used for removing Ni(II) in ethanol solutions.

Efeito da temperatura do ar de secagem sobre o teor e a composição química do óleo essencial de Pectis brevipedunculata

Leaves and flower heads of P. brevipedunculata were submitted to four drying-air temperatures (room temperature, 40, 50 and 60 ºC). Room temperature (approximately 30 ºC) and higher temperature drying (50 and 60 ºC) had a deleterious effect on the essential oil content. The recommended drying-air temperature for the species is 40 ºC for it results in the same amount of essential oil observed in fresh cut plants. Overall, 13 components accounting for more than 92% of the total composition were identified. Citral was the major component, followed by α-pinene and limonene. The essential oil showed high toxicity against Artemia salina larvae.

Avaliação da eficiência das técnicas ESI-MS e ATR/FTIR na determinação de adulteração de BX com querosene e óleo residual

Direct infusion electrospray ionization mass spectrometry in the negative ion mode, ESI(-)-MS and Fourier transform infrared spectroscopy (FTIR) were used together with partial least squares (PLS) as a tool to determine B3 adulteration (B3 - mixture of 3% v/v of biodiesel in diesel) with kerosene and residual oil.

Avaliação de metodologia eletroquímica no monitoramento da conversão de óleo de girassol em biodiesel

The development of analytical procedures to evaluate transesterification process is still a challenge in biodiesel production. Then, this paper shows an electroanalytical methodology to transesterification process assessment, proposing the application of nanostructured TiO2 electrodes. The results showed, for sunflower oil - methanol reaction catalyzed by KOH, a reduction peak in - 1050 mV and the gradual appearance of a second peak at - 1160 mV. This peak was observed as originated by the transesterification process and is probably related to intermediates. By measuring the intensity of this peak a kinetic profile was determined, showing that the conversion is almost finished in 2 h.

Avaliação da natureza da atividade catalítica de compostos de bismuto em reações de metanólise do óleo de soja

Sodium bismuthate dihydrate and two species derived from its thermal treatment were investigated as catalysts for soybean oil methanolysis and, regardless of the type of solid used, ester yields always above 76 wt% were obtained. After a single reaction course, both liquid and solid phases were characterized using several analytical methods such as X-ray diffraction and thermogravimetric analysis. As a result, the catalytic phenomenon was shown to be solely due to the leaching of alkalinecatalytic species from the solid materials.

Composição química e avaliação da atividade antimicrobiana do óleo essencial das folhas de Piper malacophyllum (C. Presl.) C. DC.

This work reports the chemical composition as well as the antibacterial, antifungal and antiparasitic activities of the leaf essential oil from Piper malacophyllum. The oil was extracted by hydrodistillation and analyzed by GC-FID, GC-MS and polarimetry. Among the 28 compounds identified, (+)-camphor was the major constituent. The essential oil showed activity against most of the microorganisms tested, especially antifungal action, with a MIC of 500 µg mL-1 against Trichophyton mentagrophytes and Cryptococcus neoformans. This is the first study reporting the composition and biological properties of leaf essential oil from P. malacophyllum.

Biomassa em aula prática de Química Orgânica Verde: cravo-da-índia como fonte simultânea de óleo essencial e de furfural

This work presents an optimized integrated experiment for isolation of clove bud essential oil, rich in eugenol, and subsequent utilization of the solid residue for furfural synthesis. The operationally simple laboratory protocols and utilization of water as a solvent in both operations, plus the use of biomass as the starting material for preparation of versatile intermediates in organic synthesis, make the experiments attractive for undergraduate experimental organic chemistry courses in the context of green chemistry. In addition, this is the first description of the use of biomass (clove bud) in the simultaneous preparation of two chemical feedstocks, eugenol and furfural, on experimental organic chemistry courses.

Craqueamento termo-catalítico da mistura óleo de fritura usado-lodo de estamparia têxtil para a produção de óleo com baixo índice de acidez

In this work, cracking experiments were performed to carry out the thermal conversion of the mixture of used frying oil and textile stamping sludge in continuous reactor. The textile stamping sludge was used to catalyze the reaction of thermal cracking. The physical and chemical properties of the oil produced were analyzed. Among the results of this analysis the level of acidity in the range of 12 mg KOH/g stands out. Low levels of acidity as this particular mean better quality oil. In this regard it is important that further researches on processes of conversion of residual oil occur.