The nitrate to ammonia and ceramic (NAC) process for the denitration and immobilization of low-level radioactive liquid waste (LLW)

Hazardous radioactive liquid waste is the legacy of more than 50 years of plutonium production associated with the United States' nuclear weapons program. It is estimated that more than 245,000 tons of nitrate wastes are stored at facilities such as the single-shell tanks (SST) at the Hanford Site in the state of Washington, and the Melton Valley storage tanks at Oak Ridge National Laboratory (ORNL) in Tennessee. In order to develop an innovative, new technology for the destruction and immobilization of nitrate-based radioactive liquid waste, the United State Department of Energy (DOE) initiated the research project which resulted in the technology known as the Nitrate to Ammonia and Ceramic (NAC) process. However, inasmuch as the nitrate anion is highly mobile and difficult to immobilize, especially in relatively porous cement-based grout which has been used to date as a method for the immobilization of liquid waste, it presents a major obstacle to environmental clean-up initiatives. Thus, in an effort to contribute to the existing body of knowledge and enhance the efficacy of the NAC process, this research involved the experimental measurement of the rheological and heat transfer behaviors of the NAC product slurry and the determination of the optimal operating parameters for the continuous NAC chemical reaction process. Test results indicate that the NAC product slurry exhibits a typical non-Newtonian flow behavior. Correlation equations for the slurry's rheological properties and heat transfer rate in a pipe flow have been developed; these should prove valuable in the design of a full-scale NAC processing plant. The 20-percent slurry exhibited a typical dilatant (shear thickening) behavior and was in the turbulent flow regime due to its lower viscosity. The 40-percent slurry exhibited a typical pseudoplastic (shear thinning) behavior and remained in the laminar flow regime throughout its experimental range. The reactions were found to be more efficient in the lower temperature range investigated. With respect to leachability, the experimental final NAC ceramic waste form is comparable to the final product of vitrification, the technology chosen by DOE to treat these wastes. As the NAC process has the potential of reducing the volume of nitrate-based radioactive liquid waste by as much as 70 percent, it not only promises to enhance environmental remediation efforts but also effect substantial cost savings. ^

Large-Scale Testing to Study the Effects of Critical Parameters on the Aerodynamic Behavior of Long Span Bridges

Long-span bridges are flexible and therefore are sensitive to wind induced effects. One way to improve the stability of long span bridges against flutter is to use cross-sections that involve twin side-by-side decks. However, this can amplify responses due to vortex induced oscillations. Wind tunnel testing is a well-established practice to evaluate the stability of bridges against wind loads. In order to study the response of the prototype in laboratory, dynamic similarity requirements should be satisfied. One of the parameters that is normally violated in wind tunnel testing is Reynolds number. In this dissertation, the effects of Reynolds number on the aerodynamics of a double deck bridge were evaluated by measuring fluctuating forces on a motionless sectional model of a bridge at different wind speeds representing different Reynolds regimes. Also, the efficacy of vortex mitigation devices was evaluated at different Reynolds number regimes. One other parameter that is frequently ignored in wind tunnel studies is the correct simulation of turbulence characteristics. Due to the difficulties in simulating flow with large turbulence length scale on a sectional model, wind tunnel tests are often performed in smooth flow as a conservative approach. The validity of simplifying assumptions in calculation of buffeting loads, as the direct impact of turbulence, needs to be verified for twin deck bridges. The effects of turbulence characteristics were investigated by testing sectional models of a twin deck bridge under two different turbulent flow conditions. Not only the flow properties play an important role on the aerodynamic response of the bridge, but also the geometry of the cross section shape is expected to have significant effects. In this dissertation, the effects of deck details, such as width of the gap between the twin decks, and traffic barriers on the aerodynamic characteristics of a twin deck bridge were investigated, particularly on the vortex shedding forces with the aim of clarifying how these shape details can alter the wind induced responses. Finally, a summary of the issues that are involved in designing a dynamic test rig for high Reynolds number tests is given, using the studied cross section as an example.

Optimization of Cooling Protocols for Hearts Destined for Transplantation

Design and analysis of conceptually different cooling systems for the human heart preservation are numerically investigated. A heart cooling container with required connections was designed for a normal size human heart. A three-dimensional, high resolution human heart geometric model obtained from CT-angio data was used for simulations. Nine different cooling designs are introduced in this research. The first cooling design (Case 1) used a cooling gelatin only outside of the heart. In the second cooling design (Case 2), the internal parts of the heart were cooled via pumping a cooling liquid inside both the heart’s pulmonary and systemic circulation systems. An unsteady conjugate heat transfer analysis is performed to simulate the temperature field variations within the heart during the cooling process. Case 3 simulated the currently used cooling method in which the coolant is stagnant. Case 4 was a combination of Case 1 and Case 2. A linear thermoelasticity analysis was performed to assess the stresses applied on the heart during the cooling process. In Cases 5 through 9, the coolant solution was used for both internal and external cooling. For external circulation in Case 5 and Case 6, two inlets and two outlets were designed on the walls of the cooling container. Case 5 used laminar flows for coolant circulations inside and outside of the heart. Effects of turbulent flow on cooling of the heart were studied in Case 6. In Case 7, an additional inlet was designed on the cooling container wall to create a jet impinging the hot region of the heart’s wall. Unsteady periodic inlet velocities were applied in Case 8 and Case 9. The average temperature of the heart in Case 5 was +5.0oC after 1500 s of cooling. Multi-objective constrained optimization was performed for Case 5. Inlet velocities for two internal and one external coolant circulations were the three design variables for optimization. Minimizing the average temperature of the heart, wall shear stress and total volumetric flow rates were the three objectives. The only constraint was to keep von Mises stress below the ultimate tensile stress of the heart’s tissue.

Relationship between Changes in Cash Flow and Investments in Publicy Traded Restaurant Firms in the United States

This research investigated the relationship between investments in fixed assets and free cash flows of U.S. restaurant firms while controlling for future investment opportunities and financial constraints. It also investigated investment and cash-flow sensitivity in the context of economic conditions. Results suggested that investments in small firms (with higher financial constraints) had relatively weaker sensitivity to cash flows than investments in large firms (with higher sensitivity). Controlling for economic conditions did not significantly change results. While the debate over sensitivity of investments to cash flows remains unresolved, it has not been explored widely in industry contexts, especially in services such as the restaurant industry. In addition to its contribution to this literature, this paper provides implications for cash-flow management in publicly traded restaurant companies.

No Free Lunch: Displaced Marsh Consumers Regulate a Prey Subsidy to an Estuarine Consumer

Pulse subsidies account for a substantial proportion of resource availability in many systems, having persistent and cascading effects on consumer population dynamics, and energy flow within and across ecosystem boundaries. Although the importance of pulsed resource subsidies is well-established, the mechanisms that regulate resource fluxes across ecosystem boundaries are not well understood. The aim of our study was to determine the extent that marsh consumers regulated a marsh prey subsidy to estuarine consumers in the oligohaline reaches of an Everglades estuary. We characterized a marsh pulsed subsidy of cyprinodontoid, invertebrate and sunfish prey that move into the upper estuary from adjacent drying marshes. In response to the prey pulse, we examined the numerical, fitness and dietary responses of three focal consumers in the upper estuary; two marsh species (largemouth bass and bowfin) that accompanied the subsidy as a result of marsh drying, and one estuarine consumer (snook). At the onset of marsh drying and the prey subsidy, estuarine consumers switched diets to consume the larger marsh prey (sunfishes), while bass and bowfin maintained similar diets (cyprinodontoids and invertebrates respectively) than pre and post subsidy. From the consumption of this subsidy, bass (marsh species) and snook (estuarine species) exhibited fitness gains while bowfin did not. Although both marsh and estuarine consumers benefitted from the subsidy, we found evidence that freshwater consumers shunted some of the subsidy away from snook. Of the prey sampled in consumer stomachs, 41% of marsh prey biomass was eaten by marsh consumers, while 59% was consumed by the estuarine consumer. We conclude that the amount of the marsh prey available to estuarine consumers may be greater in the absence of marsh consumers, thus the magnitude of the prey subsidy could depend on the dynamics of the marsh consumers from donor communities.