Microvariation at the human D1S80 locus

Microvariant allelic polymorphisms have been known since 1966 when Harris, Hubby and Lewontin described the huge store of genetic variation detectable at the polypeptide level. Later Jeffreys used MVR (minisatellite variant repeat) analysis to describe the variation hidden within minisatellite VNTRs and to propose a mutational mechanism.^ The questions I have asked follow these traditions: (1) How much microvariant polymorphism exists at the discrete allele minisatellite D1S80 locus? (2) Do alleles or groups of alleles associate randomly with the flanking markers to form haplotypes? (3) What mechanisms might explain mutations at this locus? What are the phylogenetic relationships among the alleles?^ The minisatellite locus D1S80 (1p35-36), GenBank sequence (Accession # D28507), is a highly polymorphic Variable Number of Tandem Repeat (VNTR) based on a 16 base core. D1S80 alleles are electrophoretically separable into discontinuous sets of equivalent length alleles. Sequence variation or minor length variation within these classes was expected: I have sought to determine the nature of this microvariant heterogeneity by sequencing nominal and variant alleles.^ Alleles were analyzed by Single-Strand Conformation Polymorphism (SSCP) analysis. Sequences were determined to ascertain whether sequence variation or size variation is the major cause of altered electrophoretic migration of microvariant D1S80 alleles. Twenty three alleles from 14 previously typed individuals were sequenced. The individuals were from African American, Caucasian, or Hispanic databases.^ A Tsp509 I restriction site, previously reported as a Hinf I flanking polymorphism, and a 3$\sp\prime$ flanking region BsoF I restriction site polymorphism were identified. There appears to be a strong association of the 5$\sp\prime$ flanking region Hinf I(+) and Tsp509 I(-) site and the 3$\sp\prime$ flanking region BsoF I(-) site with the 18 allele, while the 24 tends to be associated with the Hinf I(-), Tsp509 I(+) and BsoF I(+) sites.^ The general conclusion for this locus is clearly the closer you look, the more you find. D1S80 allelic polymorphisms are primarily due to variation in the number of repeat units and to sequence variation among repeats. The sequenced based gene tree depicts two major classes of alleles which conform to the two most common alleles, reflecting either equivalent age or population size bottlenecks. ^

Mitochondrial inheritance during a parasexual cycle in {\it Fusarium oxysporum\/} forma specialis {\it cubense\/}

Fusarium oxysporum is a diverse, asexual fungal species composed of both saprophytic and pathogenic members. The destructive phytopathogens are classified into formae speciales based on the host species and into vegetative compatibility groups (VCGs) based on the ability of two individuals to form heterokaryons. Parasexuality, a non-sexual mode of genetic exchange unique to some fungi has been demonstrated in the laboratory in Fusarium oxysporum f. sp. cubense (FOC). The goals of this dissertation were threefold: to ascertain whether mitochondrial (mt) markers can distinguish race differences in FOC; to determine genetic relatedness of VCGs in FOC based on a mt marker; and to discover the mode of mt inheritance during a parasexual cycle.^ Band patterns produced by electrophoresis of Hae III digested genomic DNA indicated that VCG differences, not race, could be discerned by mtDNA analysis. Primers were designed to amplify a mt intergenic locus which served as a molecular marker to screen 55 strains of FOC in 16 VCGs using both single strand conformational polymorphism and DNA sequencing. Based on homogeneity of the locus, strains were assigned to seven mitotypes, a classification unit which I introduced and found informative for grouping related VCGs.^ To determine the mode of mt inheritance during a parasexual cycle, strains in different mitotypes were paired. Mitochondrial inheritance in all hybrid progeny was found to be uniparental. I speculated that if a parasexual cycle occurs in nature there would be greater variation in the nuclear genome than the mt. This could produce multiple VCGs within a mitotype, a phenomenon observed in FOC. Based on these data, I concluded that parasexuality in nature may contribute to the diversity observed in Fusarium oxysporum. ^

The isolation, characterization, and application of WRKY genes as useful molecular markers in tropical trees

The improvement of tropical tree crops using conventional breeding methods faces challenges due to the length of time involved. Thus, like most crops, there is an effort to utilize molecular genetic markers in breeding programs to select for desirable agronomic traits. Known as marker assisted breeding or marker assisted selection, genetic markers associated with a phenotype of interest are used to screen and select material reducing the time necessary to evaluate candidates. As the focus of this research was improving disease resistance in tropical trees, the usefulness of the WRKY gene superfamily was investigated as candidates for generating useful molecular genetic markers. WRKY genes encode plant-specific transcriptional factors associated with regulating plants' responses to both biotic and abiotic stress. ^ One pair of degenerate primers amplified 48 WRKY gene fragments from three taxonomically distinct, economically important, tropical tree crop species: 18 from Theobroma cacao L., 21 from Cocos nucifera L. and 9 from Persea americana Mill. Several loci from each species were polymorphic because of single nucleotide substitutions present within a putative non-coding region of the loci. Capillary array electrophoresis-single strand conformational polymorphism (CAE-SSCP) mapped four WRKY loci onto a genetic linkage map of a T. cacao F2 population segregating for resistance to witches' broom disease. Additionally, PCR primers specific for four T. cacao loci successfully amplified WRKY loci from 15 members of the Byttneriae tribe. A method was devised to allow the reliable discrimination of alleles by CAE-SSCP using only the mobility assigned to the sample peaks. Once this method was validated, the diversity of three WRKY loci was evaluated in a germplasm collection of T. cacao . One locus displayed high diversity in the collection, with at least 18 alleles detected from mobility differences of the product peaks. The number of WRKY loci available within the genome, ease of isolation by degenerate PCR, codominant segregation demonstrated in the F2 population, and usefulness for screening germplasm collections and closely related wild species demonstrates that the WRKY superfamily of genes are excellent candidates for developing a number of genetic molecular markers for breeding purposes in tropical trees. ^

Dynamic modeling and analysis of single-stage boost inverters under normal and abnormal conditions

Inverters play key roles in connecting sustainable energy (SE) sources to the local loads and the ac grid. Although there has been a rapid expansion in the use of renewable sources in recent years, fundamental research, on the design of inverters that are specialized for use in these systems, is still needed. Recent advances in power electronics have led to proposing new topologies and switching patterns for single-stage power conversion, which are appropriate for SE sources and energy storage devices. The current source inverter (CSI) topology, along with a newly proposed switching pattern, is capable of converting the low dc voltage to the line ac in only one stage. Simple implementation and high reliability, together with the potential advantages of higher efficiency and lower cost, turns the so-called, single-stage boost inverter (SSBI), into a viable competitor to the existing SE-based power conversion technologies.^ The dynamic model is one of the most essential requirements for performance analysis and control design of any engineering system. Thus, in order to have satisfactory operation, it is necessary to derive a dynamic model for the SSBI system. However, because of the switching behavior and nonlinear elements involved, analysis of the SSBI is a complicated task.^ This research applies the state-space averaging technique to the SSBI to develop the state-space-averaged model of the SSBI under stand-alone and grid-connected modes of operation. Then, a small-signal model is derived by means of the perturbation and linearization method. An experimental hardware set-up, including a laboratory-scaled prototype SSBI, is built and the validity of the obtained models is verified through simulation and experiments. Finally, an eigenvalue sensitivity analysis is performed to investigate the stability and dynamic behavior of the SSBI system over a typical range of operation. ^

Switching patterns and steady-state analysis of grid-connected and stand-alone single-stage boost-inverters for PV applications

Renewable or sustainable energy (SE) sources have attracted the attention of many countries because the power generated is environmentally friendly, and the sources are not subject to the instability of price and availability. This dissertation presents new trends in the DC-AC converters (inverters) used in renewable energy sources, particularly for photovoltaic (PV) energy systems. A review of the existing technologies is performed for both single-phase and three-phase systems, and the pros and cons of the best candidates are investigated. In many modern energy conversion systems, a DC voltage, which is provided from a SE source or energy storage device, must be boosted and converted to an AC voltage with a fixed amplitude and frequency. A novel switching pattern based on the concept of the conventional space-vector pulse-width-modulated (SVPWM) technique is developed for single-stage, boost-inverters using the topology of current source inverters (CSI). The six main switching states, and two zeros, with three switches conducting at any given instant in conventional SVPWM techniques are modified herein into three charging states and six discharging states with only two switches conducting at any given instant. The charging states are necessary in order to boost the DC input voltage. It is demonstrated that the CSI topology in conjunction with the developed switching pattern is capable of providing the required residential AC voltage from a low DC voltage of one PV panel at its rated power for both linear and nonlinear loads. In a micro-grid, the active and reactive power control and consequently voltage regulation is one of the main requirements. Therefore, the capability of the single-stage boost-inverter in controlling the active power and providing the reactive power is investigated. It is demonstrated that the injected active and reactive power can be independently controlled through two modulation indices introduced in the proposed switching algorithm. The system is capable of injecting a desirable level of reactive power, while the maximum power point tracking (MPPT) dictates the desirable active power. The developed switching pattern is experimentally verified through a laboratory scaled three-phase 200W boost-inverter for both grid-connected and stand-alone cases and the results are presented.

The relationship between socioeconomic status, course delivery method, and student success at a state college: A single institution analysis

In an effort to improve instruction and better accommodate the needs of students, community colleges are offering courses delivered in a variety of delivery formats that require students to have some level of technology fluency to be successful in the course. This study was conducted to investigate the relationship between student socioeconomic status (SES), course delivery method, and course type on enrollment, final course grades, course completion status, and course passing status at a state college. ^ A dataset for 20,456 students of low and not low SES enrolled in science, technology, engineering, and mathematics (STEM) course types delivered using traditional, online, blended, and web enhanced course delivery formats at Miami Dade College, a large open access 4-year state college located in Miami-Dade County, Florida, was analyzed. A factorial ANOVA using course type, course delivery method, and student SES found no significant differences in final course grades when used to determine if course delivery methods were equally effective for students of low and not low SES taking STEM course types. Additionally, three chi-square goodness-of-fit tests were used to investigate for differences in enrollment, course completion and course passing status by SES, course type, and course delivery method. The findings of the chi-square tests indicated that: (a) there were significant differences in enrollment by SES and course delivery methods for the Engineering/Technology, Math, and overall course types but not for the Natural Science course type and (b) there were no significant differences in course completion status and course passing status by SES and course types overall and SES and course delivery methods overall. However, there were statistically significant but weak relationships between course passing status, SES and the math course type as well as between course passing status, SES, and online and traditional course delivery methods. ^ The mixed findings in the study indicate that strides have been made in closing the theoretical gap in education and technology skills that may exist for students of different SES levels. MDC's course delivery and student support models may assist other institutions address student success in courses that necessitate students having some level of technology fluency. ^

Switching Patterns and Steady-State Analysis of Grid-Connected and Stand-Alone Single-Stage Boost-Inverters for PV Applications

Renewable or sustainable energy (SE) sources have attracted the attention of many countries because the power generated is environmentally friendly, and the sources are not subject to the instability of price and availability. This dissertation presents new trends in the DC-AC converters (inverters) used in renewable energy sources, particularly for photovoltaic (PV) energy systems. A review of the existing technologies is performed for both single-phase and three-phase systems, and the pros and cons of the best candidates are investigated. In many modern energy conversion systems, a DC voltage, which is provided from a SE source or energy storage device, must be boosted and converted to an AC voltage with a fixed amplitude and frequency. A novel switching pattern based on the concept of the conventional space-vector pulse-width-modulated (SVPWM) technique is developed for single-stage, boost-inverters using the topology of current source inverters (CSI). The six main switching states, and two zeros, with three switches conducting at any given instant in conventional SVPWM techniques are modified herein into three charging states and six discharging states with only two switches conducting at any given instant. The charging states are necessary in order to boost the DC input voltage. It is demonstrated that the CSI topology in conjunction with the developed switching pattern is capable of providing the required residential AC voltage from a low DC voltage of one PV panel at its rated power for both linear and nonlinear loads. In a micro-grid, the active and reactive power control and consequently voltage regulation is one of the main requirements. Therefore, the capability of the single-stage boost-inverter in controlling the active power and providing the reactive power is investigated. It is demonstrated that the injected active and reactive power can be independently controlled through two modulation indices introduced in the proposed switching algorithm. The system is capable of injecting a desirable level of reactive power, while the maximum power point tracking (MPPT) dictates the desirable active power. The developed switching pattern is experimentally verified through a laboratory scaled three-phase 200W boost-inverter for both grid-connected and stand-alone cases and the results are presented.