Caracterização e avaliação da atividade fotocatalítica de catalisadores baseados no TiO2, sintetizados mediante hidrólise em uma mistura de solventes

This study involved the synthesis of photocatalysts based on titanium dioxide (TiO2). The photocatalysts were synthesized by the sol-gel method using three different proportions of acetone (25%, 50% and 75% v/v) in water/acetone mixtures, in order to control the hydrolysis of the precursor of titanium (titanium tetraisopropoxide). Aiming to investigate the structural, morphological and electronic changes provoked by the use of the solvent mixtures, different methodologies were used to characterize the oxides, such as X-ray diffraction (XRD), RAMAN spectroscopy, UV-Vis diffuse reflectance spectroscopy, and measurements of specific surface area (BET). XRD combined to RAMAN analyses revealed that the products are two-phase highly crystalline oxides involving anatase as main phase and brookite. Besides, the refined XRD using the method of Rietveld demonstrated that the presence of acetone during the synthesis influenced in the composition of the crystalline phases, increasing the proportion of the brookite phase between 13 and 22%. The band gap energy of these oxides practically did not suffer changes as function of the synthesis conditions. As shown by the isotherm, these photocatalysts are mesoporous materials with mean diameter of pores of 7 nm and approximately 20% of porosity. The surface area of the oxides prepared by hydrolysis in presence of acetone was 12% higher compared to the bare oxide. After characterized, these oxides had their photocatalytic activities evaluated by photodegradation of the azo dyes Ponceau 4R (P4R), Tartrazine (TTZ) and Reactive Red 120 (RR120), and also by the ability to mediate the photocatalytic production of hydrogen. Using the most efficient photocatalyst, the mineralization achieved for the dyes P4R, RR120 and TTZ was of respectively 83%, 79% and 56% in 120 minutes of reaction, while the discoloration of P4R e RR120 reached 100% and 94% for TTZ. In addition, the same photocatalyst in the presence of 0.5% w/w of Platinum and suspended in a 5:1 v/v water/methanol mixture, produced 56 mmol of gaseous hydrogen in five hours of experiment, corresponding to a specific rate of hydrogen production of 139.5 mmol h-1 g-1.

Determinação voltamétrica de zinco empregando eletrodos quimicamente modificados com bismuto

This dissertation presents the development of voltammetric methods to zinc determination in multivitamin commercial samples, talc, and art materials for painting (soft pastel) combining an alkaline extraction with 1.0 mol L-1 NaOH aqueous solution and bismuth modified electrodes. Two electrodes were used to zinc quantification in the samples, bismuth film electrode (BiFE) plated in situ onto glassy carbon and carbon paste electrode chemically modified with strongly acidic ion exchange resin Amberlite® IR 120 and bismuth nanostructures (EPCAmbBi). It was verified that the best concentration of Bi3+ for Bi film deposition onto glassy carbon was 4.0 μmol L-1 using an 0.1 mol L-1 acetate buffer aqueous solution (pH = 4.5) as supporting electrolyte. The best condition to formation of Bi nanostructures in the EPC modified with 10 % Amberlite® IR 120 was the use of 30 s to pre-concentration (open circuit) in 0.5 mmol L-1 Bi3+ aqueous solution (pH 5.5) prepared with supporting electrolyte solution. The obtained analytical curve for Zn2+ using BiFE presented linear range from 0.5 to 5.0 μmol L-1, the limit of detection (LD) was 41 nmol L-1. For EPCAmbBi only one linear range was observed for the analytical curve varying the Zn2+ concentration from 0.05 to 8.2 μmol L-1, LD obtained in this curve it was equal to 10 nmol L-1. The EPCAmbBi presented the most intense and sharp anodic stripping peaks for Zn2+ presenting, therefore, a better voltammetric profile, with sensitivity higher than obtained with the BiFE. Moreover, the EPCAmbBi presented a LD lower than that obtained with the BiFE. Alkaline extraction was an efficient sample pretreatment to extract Zn2+ from solid samples, besides that, this procedure was less susceptible to interferences from Cu2+, since it remains at extracting vessel as insoluble Cu(OH)2. The combination of alkaline extraction with the EPCAmbBi is a simple, fast, efficient and low cost for the zinc determination in pharmaceutical formulations and art materials for painting (soft pastel) samples, which can be employed as a low-cost alternative method to the atomic absorption spectroscopy.

Estudo das alterações hematológicas e urinárias em cães em diferentes estágios de disfunção renal e avaliação do biomarcador cistatina C

Chapter 2 - Cystatin C is a cationic protein is not glycosylated, produced a steady state for all nucleated and present in biological fluids cells being freely filtered by the glomeruli and almost completely catabolized in the proximal tubule, it is a promising early renal dysfunction marker. This study aimed to determine and compare the serum concentration of cystatin C biomarker in 86 dogs. The animals were divided into four groups according to serum creatinine levels: G1 - up. 1.4 mg / dL (23 animals), G2 - 1.5-2.0 mg / dL (16 animals), G3 - 2.1 to 5.0 mg / dL (24 animals) and G4 - above 5.1 mg / dL (23 animals). There was the measurement of the parameters used in the clinical routine of small animals such as urea, urinary gamma glutamyl transferase, proteinuria, alkaline phosphatase, sodium, potassium, chloride, calcium, phosphorus, calcium/phosphorus ratio and cystatin C. There was no statistical difference for urea, proteinuria, phosphorus, calcium/phosphorus, potassium and cystatin C, however, the other showed no statistical difference. Based on the results we can infer that cystatin C was not a good early indicator of kidney disease in dogs. Chapter 3 - This study aimed to determine the hematological and urinalysis elements such as density, proteinuria, cylinders and pH in 86 dogs The animals were divided into four stages according to serum creatinine levels: I - up to 1.4 mg/dL (23 animals), II - 1.5-2.0 mg/dL (16 animals), III from 2.1 to 5.0 mg/dL (24 animals) and IV - above 5.1 mg/dL (23 animals). In stage III, IV there was anemia normocytic normochromic type. Stage II had a leukocytosis frame by neutrophilia with a regenerative left shift and stage III and IV detour degenerative left. The density remained within the reference values all stages. Proteinuria showed statistical significance for the classification 2+ (1.0 g/L), between stage I and II, II and IV. Only the cylinder granular statistical difference in the classification 2+ between stage II and III, and 3+ between stage I and III. The prevailing pH was acid. The haematological values compared to serum creatinine stages showed the changes in hemoglobin and packed cell volume erythrocytes become more pronounced as serum creatinine values rise , this is also the behavior of neutrophils rods and proteinuria.