Resposta da batata cv. Cupido à fertilização organomineral

Potato crop cycle is relatively short and presents high yield per area; therefore, it is a very demanding culture for available nutrients in the soil solution. Despite its importance and the large number of studies about the crop, there is little research on plant nutrition regarding the use of organomineral fertilizer. This study evaluated potato, cv. Cupid, development and productivity as a function of fertilization with pelletized organomineral fertilizer. The experiment was done in Perdizes, Minas Gerais, in the rainy season of 2014/2015. The experimental design was a randomized blocks, with factorial arrangement of 4 x 2 (doses x management) and a control with mineral fertilizer, with 3 repetitions. Organomineral fertilizer doses were 25, 50, 75 and 100% of the conventional mineral dose, which was 600 kg ha-1 K2SO4, 850 kg ha-1 NH4H2PO4, and 300 kg ha-1 (NH4)2SO4 of topdressing 19 days after planting (DAP). Fertilization managements were with or without topdressing at 19 DAP, when the potato was hilled. Two plants per plot were sampled at 36, 50, 64 and 81 DAP and analyzed for leaf, stem and dry matter contents. DRIS - Diagnosis and Recommendation Integrated System was applied at 36 DAP and the potatoes were harvested 112 DAP and subjected to tuber classification. Throughout the cycle, stem, leaf and tuber dry mass showed no significant differences between the fertilization managements. The doses of organomineral fertilizer and topdressing management does not affect productivity, and the lower doses (25%) were similar the greater ones and the control, with an average of 16.8 t ha-1, demonstrating that it is viable to make a single application of organomineral fertilizer at planting due to operational efficiency. The low yields observed were due to high rainfall and temperature, creating favorable conditions for the incidence of pests and diseases. According to DRIS, the organomineral dose 75% for topdressing, presented the best nutritional balance.

Avaliação da soldagem GMAW mecanizada e automatizada para união de dutos utilizando fontes convencional e com controle de curto- circuito

Welding is one of the most employed process for joining steel pipes. Although, manual welding is still the most used one, mechanized version and even automatized one have increased its demand. Thus, this work deals with girth welding of API 5L X65 pipes with 8” of nominal diameter and 8.0 mm thickness, beveled with V-30º narrow gap. Torch is moved by a bug carrier (mechanized welding) and further the parameters are controlled as a function of angular position (automatized welding). Welding parameters are presented for filling the joint with two-passes (root and filling/capping passes). Parameters for the root pass were extracted from previous author´s work with weldments carried out in plates, but validated in this work for pipe welding. GMAW processes were assessed with short-circuit metal transfer in both conventional and derivative modes using different technologies (RMD, STT and CMT). After the parameter determination, mechanical testing was performed for welding qualification (uniaxial tension, face and root bending, nick break, Charpy V-notch impact, microhardness and macrograph). The initially obtained results for RMD and CMT were acceptable for all testing and, in a second moment, also for the STT. However, weld beads carried out by using the conventional process failed and revealed the existence of lack of fusion, which required further parametrization. Thus, a Parameter-Variation System for Girth Welding (SVP) was designed and built to allow varying the welding parameters as a function of angular position by using an inclinometer. The parameters were set for each of the three angular positions (flat, vertical downhill and overhead). By using such equipment and approach, the conventional process with parameter variation allowed reducing the welding time for joint accomplishment of the order of 38% for the root pass and 30% for the filling/capping pass.