As vogais médias tônicas: um estudo contrastivo da metafonia com base em corpus

This research analyzes the average previous stressed vowels [ε] and [e] and later [ɔ] and [o] in nominal and verbal forms in the 1st person singular and 3rd person singular and plural in the present tense, specifically the umlaut process of mid vowels /e/ and /o/, which assimilate in /ε/ and /ᴐ/ in stressed position. The general objective of this research is to describe and quantify the occurrence of umlaut and subsequently analyze in which words there is regularity or not. As specific objectives we have: i) to compile and to label an oral, spontaneous, synchronic and regional corpus, from radio programs produced in the city of Ituiutaba, Minas Gerais; ii) to describe the characteristics of the corpus to be compiled; iii) to investigate the alternating timbre of mid vowels in stressed position; iv) to identify instances of nominal and verbal umlaut of the middle vowels in stressed position; v) to describe the identified cases of nominal and verbal umlaut; vi) to analyze the probable causes for the variation of the middle vowels. To perform the proposed analysis, we have adopted as a theoretical-methodological basis multi-representational models: Phonology of Use (BYBEE, 2001) and Exemplar Theory (PIERREHUMBERT, 2001) combined with the precepts of Corpus Linguistics (BEBER SARDINHA, 2004). The corpus consisted of 16 radio programs – eight political and eight religious – from the city of Ituiutaba-MG, with recordings of about 20 to 40 minutes. We note, by means of the results generated by WordSmith Tools® software, version 6.0 (SCOTT, 2012), that the analyzed forms show little variation, which shows that the umlaut is a process already lexicalized in participants of the radio programs analyzed. We conclude that the results converge with the proposal of the Phonology of Use (BYBEE, 2001; PHILLIPS, 1984) that less frequent words that have no phonetic environment conducive to change, are changed first.

Avaliação tribológica de novas modificações superficiais para cilindros de laminação a frio

The present work analyzed the tribological behavior of coatings/surface modifications traditionally used in cold rolling mill rolls and new coatings/surface modificationswith potential to replace the carcinogenic hard chrome. The study started with identification of wear mechanisms occurring in real coldrollingmill rolls. Due the high cost and dimensions of the rolls, thereplication technique was used. Replicas were obtained from 4 different rolling millBrazilian companies before and after a normal rolling campaign. Initial sliding tests were conducted using spherical and cylindrical counter bodies in order to verifywhichtribological conditions allowed to reproduce the wear mechanisms found in the replicas. These tests indicated the use of reciprocating sliding tests with cylindrical counter bodies (line contact), normal load of 100 N, and test times of and 1 h and 5 h. Different surface modifications were carried out on samples produced from a fragment of a rolling mill roll. The specimens were heat treated and ground on both sides. After, some specimens were surface textured by electrical discharge texturing (EDT). For both groups (ground and EDT), subsequent treatments of chromium plating, electroless NiP coating and plasma nitriding were carried out. The results of the reciprocating tests showed that specimens with electroless NiP coating presented the lowest friction coefficients, while plasma nitrided specimens showed the highest. In general, previous surface texturing before the coating/surface modification increased the wear of the counter bodies. Oneexceptionwas for EDT with subsequent electroless NiP coating, which presented the lowest counter bodies wear rate. The samples withelectroless NiP coating promoted a tribolayer consisting of Nickel, Phosphorus and Oxygen on both the specimens andthecounter bodies, which was apparently responsible for the reduction of friction coefficient and wear rate. The increase of the test time reduced the wear rate of the samples, apparently due the stability of the tribolayers formed, except for the nitrided samples. For the textured specimens, NiP coating showed the best performance in maintaining the surface topography of the specimens after the sliding tests.