Inter-relação entre lesão cervical não cariosa e comprometimento periodontal: diagnóstico, tratamento e previsibilidade - estudo clínico prospectivo e laboratorial

The coexistence of gingival recession (GR) with root coverage indication and non-carious cervical lesions (LCNC) generates the need for a protocol that respects and promotes health of dental and periodontal tissues and allows treatment predictability. The main objectives of this theses were: (1) verify, through clinical evaluations, the connective tissue graft for root coverage on direct and indirect restorations made of ceramic resin; (2) analyze the influence of the battery level of the LED curing unit in the composite resin characteristics; (3) assess the influence of restorative materials, composite resin and ceramics, on the viability of gingival fibroblasts from primary culture. Nine patients with good oral hygiene and occlusal stability diagnosed with LCNCs the anterior teeth including premolars associated with gingival recession (class I and II of Miller) and only gingival recession were selected. After initial clinical examination, occlusal adjustment was performed and the patients had their teeth randomized allocated on direct composite resin restoration of LCNC, polishing and GR treatment with connective tissue graft and advanced coronally flap CR group (n = 15); and indirect ceramic restoration of the LCNC's and GR treatment (CTG+CAF) Group C (n = 15). The GR presented teeth with no clinically formed LCNCs cavity were treated using (CTG+CAF) being the control group (n = 15). Sorption and solubility tests, analysis of the degree of conversion and diametral tensile strength were performed in composite resin samples (n = 10) photoactivated by 100, 50 and 10% battery charge LED unit. The viability of fibroblasts on composite resin, ceramics and dentin disks (n = 3) was examined. Clinical follow-up was performed for three months. The data obtained at different stages were tabulated and subjected to analysis for detection of normal distribution and homogeneity. The results showed that: the LED unit with 10% battery affects the characteristics of the composite resin; restorative materials present biocompatibility with gingival fibroblasts; and the association of surgical and restorative treatment of teeth affected by NCCL and GR presents successful results at 3-month follow-up.

Biometria de frutos e sementes, crescimento e produção de mudas de Campomanesia adamantium Blume e Campomanesia pubescens O. Berg

Campomanesia adamantium and Campomanesia pubescens are morphologically similar, occur in the same regions of the Cerrado, are difficult to differentiate and exhibit naturally slow growth and development. The objectives of this study were to analyze fruit and seed biometric data, emergence capacity and seedling growth characteristics. Fruit from both species was collected and used to measure biometric data of the fruit and seeds and to set up two emergence and two seedling growth experiments. C. adamantium fruit is round and has wider, pale yellow seeds while C. pubescens fruit is ellipsoidal to pyriform with yellow gold seeds. C. adamantium’s greater fresh fruit mass and biometric variability favors selection of promising material for commercialization. Seed drying reduced the speed and rate of seedling emergence of C. adamantium, but had no effect on C. pubescens. Leaf number, height, shoot dry weight and the ratio of shoot dry weight to root dry weight were greater in C. adamantium than in the slower growing C. pubescens. Increases in substrate volume favor seedling development. Slow-release fertilizer application at 1g per 115 cm3 substrate increased leaf formation, plant height and shoot dry weight of seedlings of both species and lateral budding in C. adamantium. Until 120 days after transplant, lateral budding was not observed in C. pubescens seedlings. For all traits evaluated in this experiment, C. adamantium seedling growth was greater than that of C. pubescens.