Alzheimer's disease: Are cellular neurofibrillary tangles linked to beta/A4 formation at the projection sites?

The density of senile plaques (SP) and cellular neurofibrillary tabgles (NFT) revealed by the Glees and Gallyas stains; and beta/A4 deposits revealed by immunocytochemical staining, was estimated in the hippocampus and adjacent gyri in Alzheimer's disease (AD). Stepwise multiple regression was used to detemine whether the density of cellular NFT was related to the density of SP or beta/A4 deposits totalled over the projection sites. Cellular NFT density was only weakly correlated with the density of Glees SP and beta/A4 deposits at some of the projection sites. However, beta/A4 deposit density in a tissue was strongly correlated with the density of beta/A4 deposits at the projection sites suggesting that the lesions could spread through the brain. Hence, although there is a strong correlation between the density of beta/A4 deposits in different parts of the hippocampal formation there is little association between SP or beta/A4 and cellular NFT. These results do not provide strong evidence that beta/A4 protein is the cause of the neuritc changes in AD.

Radial growth of Rhizocarpon section Rhizocarpon lichen thalli over six years at snoqualmie pass in the Cascade Range, Washington State

This article describes a 6-yr study of the radial growth rates (RGR, mm yr-1) of Rhizocarpon section Rhizocarpon thalli on a talus slope at Snoqualmie Pass in the Cascade Range, Washington State, United States (47°27'N; 121°26'W). At the end of the growth period, 32 of a total of 39 thalli had exhibited a positive RGR, and 7 of a total of 39 thalli showed no measurable growth. Mean RGR of all thalli was 0.07 mm yr-1 (range, 0-0.19 mm, SD = 0.06). Analysis of variance suggested no significant variation in RGR in successive growth periods, but significant differences were present both within and between thalli. The slope of a boulder facet did not influence RGR, but growth was affected by aspect, the least growth being observed on north-northwest facets. A plot of RGR against thallus diameter revealed a wide scatter of data points with little evidence for a significant change in growth with thallus size. Hence, the study showed that the RGR of Rhizocarpon thalli at Snoqualmie is extremely slow and highly variable and significantly less than estimates based on lichenometry. To determine the growth curve of a yellow-green Rhizocarpon by direct measurement at such a site would require a large sample of thalli and careful standardization of the species studied, the aspect conditions under which the thalli were measured, and the initial hypothallus width of the thalli. © 2005 Regents of the University of Colorado.

Soredial dispersal from individual soralia in the lichen Hypogymnia physodes (L.) Nyl.

Soredial dispersal from individual soralia of Hypogymnia physodes (L.) Nyl. was studied in the field under natural conditions and by exposing the soralia to an electric fan. Individual soralia were placed on the adhesive surface of dust particle collectors which were pinned to vertical boards in the field. The majority of soredia that were deposited on the adhesive strips during the experiments were found within 1 cm of the source soralium. Deposition was studied over 6 successive days under natural conditions. Significantly fewer soredia were deposited from soralia after removal of mature accumulations and from soralia taken from moist thalli compared with soralia from air dry thalli. In addition, there was a decline in soredial deposition over the 6 days. The influence of wind speed and initial thallus moisture content on soredial deposition over short intervals of time was studied using an electric fan. More soredia and larger soredial clusters were deposited from air dry than moist soralia at all wind speeds. Variation in wind speed between 4 and 9 m/sec had little effect on soredial deposition. Deposition of soredia was also studied using the fan over successive 5-min intervals. Large numbers of soredia were deposited during the first 5-min period. Deposition then declined but recovered after about four 5-min periods. In all experiments there were differences between individual soralia in total numbers of soredia deposited and in the pattern of deposition over time. These results suggest (1) soredia accumulate on soralia and these deposits may be gradually or rapidly depleted in the field, (2) that after the release of soredial accumulations some newly exposed soredia may be rapidly dispersed, (3) a high initial thallus moisture content inhibits soredial release and (4) variation in wind speed is less important than moisture in influencing soredial deposition. The results may help to explain the intermittent pattern of soredial deposition and the poor correlations between deposition and climatic factors observed previously in the field. © 1992.

The slope of the psychometric function and non-stationarity of thresholds in spatiotemporal contrast vision

The slope of the two-interval, forced-choice psychometric function (e.g. the Weibull parameter, ß) provides valuable information about the relationship between contrast sensitivity and signal strength. However, little is known about how or whether ß varies with stimulus parameters such as spatiotemporal frequency and stimulus size and shape. A second unresolved issue concerns the best way to estimate the slope of the psychometric function. For example, if an observer is non-stationary (e.g. their threshold drifts between experimental sessions), ß will be underestimated if curve fitting is performed after collapsing the data across experimental sessions. We measured psychometric functions for 2 experienced observers for 14 different spatiotemporal configurations of pulsed or flickering grating patches and bars on each of 8 days. We found ß ˜ 3 to be fairly constant across almost all conditions, consistent with a fixed nonlinear contrast transducer and/or a constant level of intrinsic stimulus uncertainty (e.g. a square law transducer and a low level of intrinsic uncertainty). Our analysis showed that estimating a single ß from results averaged over several experimental sessions was slightly more accurate than averaging multiple estimates from several experimental sessions. However, the small levels of non-stationarity (SD ˜ 0.8 dB) meant that the difference between the estimates was, in practice, negligible.

A preliminary investigation into the effects of ocular lubricants on higher order aberrations in normal and dry eye subjects

Purpose: To study the effects of ocular lubricants on higher order aberrations in normal and self-diagnosed dry eyes. Methods: Unpreserved hypromellose drops, Tears Again™ liposome spray and a combination of both were administered to the right eye of 24 normal and 24 dry eye subjects following classification according to a 5 point questionnaire. Total ocular higher order aberrations, coma, spherical aberration and Strehl ratios for higher order aberrations were measured using the Nidek OPD-Scan III (Nidek Technologies, Gamagori, Japan) at baseline, immediately after application and after 60. min. The aberration data were analyzed over a 5. mm natural pupil using Zernike polynomials. Each intervention was assessed on a separate day and comfort levels were recorded before and after application. Corneal staining was assessed and product preference recorded after the final measurement for each intervention. Results: Hypromellose drops caused an increase in total higher order aberrations (p= <0.01 in normal and dry eyes) and a reduction in Strehl ratio (normal eyes: p= <0.01, dry eyes p= 0.01) immediately after instillation. There were no significant differences between normal and self-diagnosed dry eyes for response to intervention and no improvement in visual quality or reduction in higher order aberrations after 60. min. Differences in comfort levels failed to reach statistical significance. Conclusion: Combining treatments does not offer any benefit over individual treatments in self-diagnosed dry eyes and no individual intervention reached statistical significance. Symptomatic subjects with dry eye and no corneal staining reported an improvement in comfort after using lubricants. © 2013 British Contact Lens Association.

Functionalised particles using dry powder coating in pharmaceutical drug delivery:promises and challenges

Introduction: Production of functionalised particles using dry powder coating is a one-step, environmentally friendly process that paves the way for the development of particles with targeted properties and diverse functionalities. Areas covered: Applying the first principles in physical science for powders, fine guest particles can be homogeneously dispersed over the surface of larger host particles to develop functionalised particles. Multiple functionalities can be modified including: flowability, dispersibility, fluidisation, homogeneity, content uniformity and dissolution profile. The current publication seeks to understand the fundamental underpinning principles and science governing dry coating process, evaluate key technologies developed to produce functionalised particles along with outlining their advantages, limitations and applications and discusses in detail the resultant functionalities and their applications. Expert opinion: Dry particle coating is a promising solvent-free manufacturing technology to produce particles with targeted functionalities. Progress within this area requires the development of continuous processing devices that can overcome challenges encountered with current technologies such as heat generation and particle attrition. Growth within this field requires extensive research to further understand the impact of process design and material properties on resultant functionalities.

Fourth-root summation of contrast over area:no end in sight when spatially inhomogeneous sensitivity is compensated by a witch's hat

Measurements of area summation for luminance-modulated stimuli are typically confounded by variations in sensitivity across the retina. Recently we conducted a detailed analysis of sensitivity across the visual field (Baldwin et al, 2012) and found it to be well-described by a bilinear “witch’s hat” function: sensitivity declines rapidly over the first 8 cycles or so, more gently thereafter. Here we multiplied luminance-modulated stimuli (4 c/deg gratings and “Swiss cheeses”) by the inverse of the witch’s hat function to compensate for the inhomogeneity. This revealed summation functions that were straight lines (on double log axes) with a slope of -1/4 extending to ≥33 cycles, demonstrating fourth-root summation of contrast over a wider area than has previously been reported for the central retina. Fourth-root summation is typically attributed to probability summation, but recent studies have rejected that interpretation in favour of a noisy energy model that performs local square-law transduction of the signal, adds noise at each location of the target and then sums over signal area. Modelling shows our results to be consistent with a wide field application of such a contrast integrator. We reject a probability summation model, a quadratic model and a matched template model of our results under the assumptions of signal detection theory. We also reject the high threshold theory of contrast detection under the assumption of probability summation over area.

The future of engineering - Do primary school engineering education interventions leave a lasting impression?

This positional paper proposes a conceptual framework and methodological approach for use in a PhD study investigating the longer term educational and social impact of 'active' engineering focused interventions for children age 8-10 in the UK. The study will critically analyse how a child's participation in an engineering education activity contributes to the Engineering Capital that the child possesses; focusing on how the child's awareness and perceptions about engineering are affected. To achieve this aim it is proposed that Grounded Theory methodology be used to enable an in-depth analysis of participation from the perspective of the child participant. The study proposed will be longitudinal, taking place over three formative years for the education and career aspirations of the child, from age 8-10 to 11-13. Although the research is in its infancy, this paper will provide the opportunity to develop theory in an underdeveloped area of engineering education research.