Soredial dispersal from individual soralia in the lichen Hypogymnia physodes (L.) Nyl.

Soredial dispersal from individual soralia of Hypogymnia physodes (L.) Nyl. was studied in the field under natural conditions and by exposing the soralia to an electric fan. Individual soralia were placed on the adhesive surface of dust particle collectors which were pinned to vertical boards in the field. The majority of soredia that were deposited on the adhesive strips during the experiments were found within 1 cm of the source soralium. Deposition was studied over 6 successive days under natural conditions. Significantly fewer soredia were deposited from soralia after removal of mature accumulations and from soralia taken from moist thalli compared with soralia from air dry thalli. In addition, there was a decline in soredial deposition over the 6 days. The influence of wind speed and initial thallus moisture content on soredial deposition over short intervals of time was studied using an electric fan. More soredia and larger soredial clusters were deposited from air dry than moist soralia at all wind speeds. Variation in wind speed between 4 and 9 m/sec had little effect on soredial deposition. Deposition of soredia was also studied using the fan over successive 5-min intervals. Large numbers of soredia were deposited during the first 5-min period. Deposition then declined but recovered after about four 5-min periods. In all experiments there were differences between individual soralia in total numbers of soredia deposited and in the pattern of deposition over time. These results suggest (1) soredia accumulate on soralia and these deposits may be gradually or rapidly depleted in the field, (2) that after the release of soredial accumulations some newly exposed soredia may be rapidly dispersed, (3) a high initial thallus moisture content inhibits soredial release and (4) variation in wind speed is less important than moisture in influencing soredial deposition. The results may help to explain the intermittent pattern of soredial deposition and the poor correlations between deposition and climatic factors observed previously in the field. © 1992.

Field experiments on the dispersal, establishment and colonization of lichens on a slate rock surface

A sample of run-off water from a vertical, slate rock surface in Wales, U.K. contained abundant fragments of the lichen Parmelia glabratula ssp. fuliginosa from about 0.6 to 8.0 mm in diameter, a few fragments of Parmelia conspersa from 0.6 to 4.0 mm in diameter and a large number of unidentified propagules from 0.2 to 0.5 mm in diameter. The colonization of permanent plots on the rock surface was studied over six years. At the end of the experiment relatively few thalli of Parmelia conspersa, Parmelia glabratula ssp. fuliginosa and Buellia aethalea had established in plots on undisturbed and newly-exposed slate. Fragments (2 mm in diameter) of Parmelia conspersa placed on horizontal pieces of slate survived up to 120 days in cracks, 20 days on a thin smear of bird droppings but only 2-3 days on smooth slate, against small joints in the rock or in small holes. Isidia of Parmelia conspersa placed on horizontal pieces of slate established equally in plots on smooth undisturbed slate and in plots on the surface exposed after the removal of large Parmelia conspersa thalli, but less well on newly-exposed slate. These results suggest that lichen propagules are abundant in run-off water but establishment is a hazardous process. This may be attributable to a shortage of suitable sites on the substratum for attachment of propagules.

Passive nonlinear pulse shaping in normally dispersive fiber

We propose a simple method for passive nonlinear optical pulse shaping that utilizes pulse prechirping and nonlinear propagation in a normally dispersive nonlinear fiber to generate various temporal waveforms of practical interest from conventional laser pulses.

Dispersal in a population of the lichen Hypogymnia physodes

Dispersal of a Hypogymnia physodes (L.) Nyl. population was studied on an isolated Prunus blireiana L. tree at a site in North Seattle, U.S.A. Lichen propagules were trapped on adhesive strips pinned to four sites on the tree for 7 successive days. Soredia of H. physodes were frequently deposited on the strips but thallus fragments were rare. More soredia were deposited on the upper and lower branches than on the trunk, few soredia were deposited on the underside of the branches. The total daily deposition of soredia on the tree was positively correlated with average daily wind speed. Dispersal downwind from the tree was studied with squares of adhesive contact paper pinned to boards and located at intervals up to 25 m from the tree. Soredia and a few thallus fragments were recorded 25 m and 10 m, respectively, downwind on a day when average wind speed was 10.3 m/sec. The dispersal of soredia by wind from four individual thalli was studied over 10 successive days. Soredia were deposited from each thallus on each day mostly within 2 cm of the source. Higher wind speeds were necessary to dispersae soredia on days when the relative humidity was high. Soredia and thallus fragments were also dispersed by splash dispersal. More soredia were splashed furthest at a splash height of 90 cm. These results suggest that initial colonization of the tree by H. physodes may have occurred by wind-dispersed soredia. Subsequent spread probably occurred from established thalli mainly by the dispersal of soredia by wind and rain splash.

Dispersal of soredia from individual soralia of the lichen Hypogymnia physodes (L.) Nyl. in a simple wind tunnel

Dispersal of soredia from individual soralia of the lichen Hypogymnia physodes (L.) Nyl. was studied using a simple wind tunnel constructed in the field. Individual lobes with terminal soralia were placed in the wind tunnel on the adhesive surface of dust particle collectors. Air currents produced by a fan were directed over the surface of the lobes. The majority of soredia were deposited within 5 cm of the source soralium but some soredia were dispersed to at least 80 cm at a wind speed of 6 m s-1. Variation in wind speed had no statistically significant effect on the total number of soredial clusters deposited averaged over soralia but the mean size of cluster and the distance dispersed were greater at higher wind speeds. The number of soredia deposited was dependent on the orientation of the soralium to the air currents. More soredia were deposited with the soralium facing the fan at a wind speed of 9 m s-1. Moisture in the form of a fine mist reduced substantially the number of soredia deposited at a wind speed of 6 m s-1 but had no effect on the mean number of soredia per cluster or on the mean distance dispersed. The data suggest: (1) that wind dispersal from an individual soralium is influenced by wind speed, the location of the soralium on the thallus and the level of moisture and (2) that air currents directed over the surfaces of thalli located on the upper branches of trees would effectively disperse soredia of H. physodes vertically and horizontally within a tree canopy. © 1994.

The influence of climate on the dispersal of lichen soredia

The relationship between the daily deposition of soredia of Hypogymnia physodes (L.) Nyl. and local climatic records was studied in the field during three periods at a site in Seattle, WA, U.S.A: (1) 11 August – 16 September 1986 (Study A); (2) 16 December – 11 January 1987 (Study B) and (3) 8 July 1988 – 30 January 1989 (Study C). The soredia were trapped on adhesive strips placed at various locations on a Prunus blireiana L. tree for 24 hr periods. A correlation matrix of the data from all three studies revealed a negative correlation between soredial deposition and relative humidity; and a positive correlation with rainfall and temperature. A multiple regression and forward stepwise regression analysis selected relative humidity as the most significant climatic variable, i.e. more soredia tended to be deposited when relative humidity was low. Analysis of individual studies by multiple regression revealed: (1) no significant relationships between soredial deposition and climate in Study A; (2) positive relationships with temperature and wind speed in Study B and (3) positive relationships with wind speed and rainfall in the summer/autumn months of Study C; in the winter months no relationships with climate were found because few soredia were deposited. The data suggest that in the field seasonal photoperiod differences combined with moderately high temperatures and high relative humidity may promote soredial formation and accumulation on thalli prior to soredia dispersal. In addition, low relative humidity may promote soredial release while wind and raindrops may be possible agents of dispersal.

Dispersal, establishment and survival of soredia and fragments of the lichen, Hypogymnia physodes (L.) Nyl.

Dispersal, establishment and survival were studied in a population of Hypogymnia physodes (L.) Nyl. growing on an isolated tree (Prunus blireiana L.) at a site in North Seattle, U.S.A. Lichen propagules were trapped daily on adhesive strips pinned to various sites on the tree over a period of 36 days. Both soredia and fragments were deposited on the strips, particularly on the upper branches of the tree, with soredia being considerably more numerous than fragments. Daily variation in total soredia deposited did not correlate with 10 climatic variables including wind speed, relative humidity and average temperature. Establishment and survival of propagules were studied by introducing soredia and fragments into various sites on the bark and by observing the distribution of small thalli in different microsites. Microtopography of bark significantly influenced establishment and survival. Survival was poor on smooth bark compared with survival on algal or lichen crusts and on rough bark. Survival of soredia did not vary significantly at different locations on the tree. It is likely that colonization of the tree by H. physodes occurs largely by soredia. Colonization appears to be limited more by the range of dispersal over the tree than by differential survival over different parts of the tree.

Passive nonlinear pulse shaping in normally dispersive fiber systems

We propose a novel approach to characterize the parabolically-shaped pulses that can be generated from more conventional pulses via nonlinear propagation in cascaded sections of commercially available normally dispersive (ND) fibers. The impact of the initial pulse chirp on the passive pulse reshaping is examined. We furthermore demonstrate that the combination of pulse pre-chirping and propagation in a single ND fiber yields a simple, passive method for generating various temporal waveforms of practical interest.

Do ‘passive’ medical titanium surfaces deteriorate in service in the absence of wear?

Globally, more than 1000 tonnes of titanium (Ti) is implanted into patients in the form of biomedical devices on an annual basis. Ti is perceived to be ‘biocompatible’ owing to the presence of a robust passive oxide film (approx. 4 nm thick) at the metal surface. However, surface deterioration can lead to the release of Ti ions, and particles can arise as the result of wear and/or corrosion processes. This surface deterioration can result in peri-implant inflammation, leading to the premature loss of the implanted device or the requirement for surgical revision. Soft tissues surrounding commercially pure cranial anchorage devices (bone-anchored hearing aid) were investigated using synchrotron X-ray micro-fluorescence spectroscopy and X-ray absorption near edge structure. Here, we present the first experimental evidence that minimal load-bearing Ti implants, which are not subjected to macroscopic wear processes, can release Ti debris into the surrounding soft tissue. As such debris has been shown to be pro-inflammatory, we propose that such distributions of Ti are likely to effect to the service life of the device.

Passive mode-locked lasing by injecting a carbon nanotube-solution in the core of an optical fiber

In this paper, we propose a saturable absorber (SA) device consisting on an in-fiber micro-slot inscribed by femtosecond laser micro fabrication, filled by a dispersion of Carbon Nanotubes (CNT). Due to the flexibility of the fabrication method, efficient and simple integration of the mode-locking device directly into the optical fiber is achieved. Furthermore, the fabrication process offers a high level of control over the dimensions and location of the micro-slots. We apply this fabrication flexibility to extend the interaction length between the CNT and the propagating optical field along the optical fiber, hence enhancing the nonlinearity of the device. Furthermore, the method allows the fabrication of devices that operate by either a direct field interaction (when the central peak of the propagating optical mode passes through the nonlinear media) or an evanescent field interaction (only a fraction of the optical mode interacts with the CNT). In this paper, several devices with different interaction lengths and interaction regimes are investigated. Self-starting passively modelocked laser operation with an enhanced nonlinear interaction is observed using CNT-based SAs in both interaction regimes. This method constitutes a simple and suitable approach to integrate the CNT into the optical system as well as enhancing the optical nonlinearity of CNT-based photonic devices.

In-fiber microchannel device filled with a carbon nanotube dispersion for passive mode-lock lasing

Fueled by their high third-order nonlinearity and nonlinear saturable absorption, carbon nanotubes (CNT) are expected to become an integral part of next-generation photonic devices such as all-optical switches and passive mode-locked lasers. However, in order to fulfill this expectation it is necessary to identify a suitable platform that allows the efficient use of the optical properties of CNT. In this paper, we propose and implement a novel device consisting of an optofluidic device filled with a dispersion of CNT. By fabricating a microchannel through the core of a conventional fiber and filling it with a homogeneous solution of CNTs on Dimethylformamide (DMF), a compact, all-fiber saturable absorber is realized. The fabrication of the micro-fluidic channel is a two-step process that involves femtosecond laser micro-fabrication and chemical etching of the laser-modified regions. All-fiber high-energy, passive mode-locked lasing is demonstrated with an output power of 13.5 dBm. The key characteristics of the device are compactness and robustness against optical, mechanical and thermal damage.

All-optical passive 2R regeneration of dispersion-managed RZ data at 40 and 80 Gbit/s using in-line NOLMs

We demonstrate that the use of in-line nonlinear optical loop mirrors (NOLMs) in dispersion-managed (DM) transmission systems dominated by amplitude noise can achieve passive 2R regeneration of a 40 and 80 Gbit/s RZ data stream. This is an indication that the use of this approach could obviate the need for full-regeneration in high data rate, strong DM systems, when intra-channel four-wave mixing poses serious problems.

Study of the operating regime for all-optical passive 2R regeneration of dispersion-managed RZ data at 40 Gb/s using in-line NOLMs

In this letter, we numerically demonstrate that the use of inline nonlinear optical loop mirrors in strongly dispersion-managed transmission systems dominated by pulse distortion and amplitude noise can achieve all-optical passive 2R regeneration of a 40-Gb/s return-to-zero data stream. We define the tolerance limits of this result to the parameters of the input pulses.

All-optical passive 2R regeneration for N×40 Gbit/s WDM transmission using NOLM and novel filtering technique

We propose an all-optical passive 2R regeneration method for WDM (N×40 Gbit/s) dispersion-managed RZ transmission based on specially designed WDM guiding filters and in-line nonlinear optical loop mirrors. By system optimisation, the feasibility of 150 GHz-spaced × l6 channel transmission over 25,000 km of standard fibre is numerically demonstrated.

All-optical passive quasi-regeneration in transoceanic 40 Gbit/s return-to-zero transmission systems with strong dispersion management

A method of all-optical passive quasi-regeneration in transoceanic 40 Gbit/s return-to-zero transmission systems with strong dispersion management was described. The use of in-line nonlinear optical loop mirrors (NOLM) by the method was demonstrated. The quasi-regeneration of signals performed by NOLMs was found to improve the systems's performance.