Effects of the rate of formant-frequency variation on the grouping of formants in speech perception

How speech is separated perceptually from other speech remains poorly understood. Recent research suggests that the ability of an extraneous formant to impair intelligibility depends on the modulation of its frequency, but not its amplitude, contour. This study further examined the effect of formant-frequency variation on intelligibility by manipulating the rate of formant-frequency change. Target sentences were synthetic three-formant (F1?+?F2?+?F3) analogues of natural utterances. Perceptual organization was probed by presenting stimuli dichotically (F1?+?F2C?+?F3C; F2?+?F3), where F2C?+?F3C constitute a competitor for F2 and F3 that listeners must reject to optimize recognition. Competitors were derived using formant-frequency contours extracted from extended passages spoken by the same talker and processed to alter the rate of formant-frequency variation, such that rate scale factors relative to the target sentences were 0, 0.25, 0.5, 1, 2, and 4 (0?=?constant frequencies). Competitor amplitude contours were either constant, or time-reversed and rate-adjusted in parallel with the frequency contour. Adding a competitor typically reduced intelligibility; this reduction increased with competitor rate until the rate was at least twice that of the target sentences. Similarity in the results for the two amplitude conditions confirmed that formant amplitude contours do not influence across-formant grouping. The findings indicate that competitor efficacy is not tuned to the rate of the target sentences; most probably, it depends primarily on the overall rate of frequency variation in the competitor formants. This suggests that, when segregating the speech of concurrent talkers, differences in speech rate may not be a significant cue for across-frequency grouping of formants.

The environmental impacts of technical change

The thesis is concerned with relationships between profit, technology and environmental change. Existing work has concentrated on only a few questions, treated at either micro or macro levels of analysis. And there has been something of an impasse since the neoclassical and neomarxist approaches are either in direct conflict (macro level), or hardly interact (micro level). The aim of the thesis was to bypass this impasse by starting to develop a meso level of analysis that focusses on issues largely ignored in the traditional approaches - on questions about distribution. The first questions looked at were descriptive - what were the patterns of distribution over time of the variability in types and rates of environmental change, and in particular, was there any evidence of periodization? Two case studies were used to examine these issues. The first looked at environmental change in the iron and steel industry since 1700, and the second studied pollution in five industries in the basic processing sector. It was established that environmental change has been markedly periodized, with an apparently fairly regular `cycle length' of about fifty years. The second questions considered were explanatory - whether and how this periodization could be accounted for by reference to variations in aspects of profitability and technical change. In the iron and steel industry, it was found that diffusion rates and the rate of nature of innovation were periodized on the same pattern as was environmental change. And the same sort of variation was also present in the realm of profits, as evidenced by cyclical changes in output growth. Simple theoretical accounts could be given for all the empirically demonstrable links, and it was suggested that the most useful models at this meso level of analysis are provided by structural change models of economic development.

Distributed temperature change sensor, based on Rayleigh backscattering in an optical fibre

A frequency-modulated continuous-wave technique is used to detect the presence of frequency shifts in the Rayleigh-backscattered light in a single-mode optical fiber as a result of a changing temperature. The system is able to detect a rate of temperature change of 0.014 K/s, when a 20-cm length of fiber is heated. The system is also able to demonstrate a spatial resolution of better than 15 cm.

Thin film bearings with phase change of lubricant

The possible evaporation of lubricant in fluid film bearings has been investigated theoretically and by experiment using a radial flow hydrostatic bearing supplied with liquid refrigerant R114. Good correlation between measured and theoretical values was obtained using a bespoke computational fluid dynamic model in which the flow was assumed to be laminar and adiabatic. The effects of viscous dissipation and vapour generation within the fluid film are fully accounted for by applying a fourth order Runge-Kutta routine to satisfy the radial and filmwise transverse constraints of momentum, energy and mass conservation. The results indicate that the radial velocity profile remains parabolic while the flow remains in the liquid phase and that the radial rate of enthalpy generation is then constant across the film at a given radius. The results also show that evaporation will commence at a radial location determined by geometry and flow conditions and in fluid layers adjacent to the solid boundaries. Evaporation is shown to progress in the radial direction and the load carrying capacity of such a bearing is reduced significantly. Expressions for the viscosity of the liquid/vapour mixture found in the literature survey have not been tested against experimental data. A new formulation is proposed in which the suitable choice of a characteristic constant yields close representation to any of these expressions. Operating constraints imposed by the design of the experimental apparatus limited the extent of the surface over which evaporation could be obtained, and prevented clear identification of the most suitable relationship for the viscosity of the liquid/vapour mixture. The theoretical model was extended to examine the development of two phase flow in a rotating shaft face seal of uniform thickness. Previous theoretical analyses have been based on the assumption that the radial velocity profile of the flow is always parabolic, and that the tangential component of velocity varies linearly from the value at the rotating surface, to zero at the stationary surface. The computational fluid dynamic analysis shows that viscous shear and dissipation in the fluid adjacent to the rotating surface leads to developing evaporation with a consequent reduction in tangential shear forces. The tangential velocity profile is predicted to decay rapidly through the film, exhibiting a profile entirely different to that assumed by previous investigators. Progressive evaporation takes place close to the moving wall and does not occur completely at a single radial location, as has been claimed in earlier work.

Intern pharmacists as change agents to improve the practice of nonprescription medication supply: provision of salbutamol to patients with asthma

BACKGROUND: Earlier work established an evidence practice gap during provision of nonprescription salbutamol (albuterol). Pharmacist interns are hypothesized to be in a position to improve professional practice in the community pharmacy setting. OBJECTIVE: To explore the potential of intern pharmacists to improve the professional practice of community pharmacy staff in the provision of nonprescription salbutamol. METHODS: Intern pharmacists (n = 157) delivered an asthma intervention in 136 pharmacies consisting of an educational activity to pharmacy staff and a health promotion campaign to consumers. Post-intervention, simulated patients presented to 100 intervention and 100 control community pharmacies with a request for salbutamol. The appropriate outcome was medical referral for poor asthma control and correction of poor inhaler technique. Incidence and quantity of patient assessment and counseling provided during the visit were also assessed. Logistic regression was used to determine the predictors of medical referral. RESULTS: A doubling in the rate of medical referral was seen in the intervention group (19% vs 40%; p = 0.001). Assessment of reliever use frequency was the main predictor of medical referral (OR = 22.7; 95% CI 9.06 to 56.9). Correction of poor inhaler technique did not improve; however, a reduction in salbutamol supplied without patient assessment (23% vs 8%; p = 0.009) or counseling (75% vs 48%; p < 0.001) was noted. CONCLUSIONS: A doubling in the rate of medical referral showed a clear improvement in professional practice during the provision of nonprescription salbutamol. The improved patient outcome in the intervention group was due to increased assessment of reliever use frequency. Identification of poor inhaler technique remained near zero in both groups, which suggests that intern pharmacists were able to improve the current practice of community pharmacies yet were unable to establish a new practice behavior. This study provides evidence that intern pharmacists can act as change agents to improve pharmacy practice.

Purchasing power parity and structural instability in the US/UK exchange rate

The aim of this study is to determine if nonlinearities have affected purchasing power parity (PPP) since 1885. Also using recent advances in the econometrics of structural change we segment the sample space according to the identified breaks and look at whether the PPP condition holds in each sub-sample and whether this involves linear or non-linear adjustment. Our results suggest that during some sub-periods, PPP holds, although whether it holds or not and whether the adjustment is linear or non-linear, depends primarily on the type of exchange rate regime in operation at any point in time.

Pragmatic development of service based real-time change data capture

This thesis makes a contribution to the Change Data Capture (CDC) field by providing an empirical evaluation on the performance of CDC architectures in the context of realtime data warehousing. CDC is a mechanism for providing data warehouse architectures with fresh data from Online Transaction Processing (OLTP) databases. There are two types of CDC architectures, pull architectures and push architectures. There is exiguous data on the performance of CDC architectures in a real-time environment. Performance data is required to determine the real-time viability of the two architectures. We propose that push CDC architectures are optimal for real-time CDC. However, push CDC architectures are seldom implemented because they are highly intrusive towards existing systems and arduous to maintain. As part of our contribution, we pragmatically develop a service based push CDC solution, which addresses the issues of intrusiveness and maintainability. Our solution uses Data Access Services (DAS) to decouple CDC logic from the applications. A requirement for the DAS is to place minimal overhead on a transaction in an OLTP environment. We synthesize DAS literature and pragmatically develop DAS that eciently execute transactions in an OLTP environment. Essentially we develop effeicient RESTful DAS, which expose Transactions As A Resource (TAAR). We evaluate the TAAR solution and three pull CDC mechanisms in a real-time environment, using the industry recognised TPC-C benchmark. The optimal CDC mechanism in a real-time environment, will capture change data with minimal latency and will have a negligible affect on the database's transactional throughput. Capture latency is the time it takes a CDC mechanism to capture a data change that has been applied to an OLTP database. A standard definition for capture latency and how to measure it does not exist in the field. We create this definition and extend the TPC-C benchmark to make the capture latency measurement. The results from our evaluation show that pull CDC is capable of real-time CDC at low levels of user concurrency. However, as the level of user concurrency scales upwards, pull CDC has a significant impact on the database's transaction rate, which affirms the theory that pull CDC architectures are not viable in a real-time architecture. TAAR CDC on the other hand is capable of real-time CDC, and places a minimal overhead on the transaction rate, although this performance is at the expense of CPU resources.

High rate growth of nanocrystalline diamond films using high microwave power and pure nitrogen/methane/hydrogen plasma

In this work, we investigate the impact of minute amounts of pure nitrogen addition into conventional methane/hydrogen mixtures on the growth characteristics of nanocrystalline diamond (NCD) films by microwave plasma assisted chemical vapour deposition (MPCVD), under high power conditions. The NCD films were produced from a gas mixture of 4% CH4/H2 with two different concentrations of N2 additive and microwave power ranging from 3.0 kW to 4.0 kW, while keeping all the other operating parameters constant. The morphology, grain size, microstructure and texture of the resulting NCD films were characterized by using scanning electron microscope (SEM), micro-Raman spectroscopy and X-ray diffraction (XRD) techniques. N2 addition was found to be the main parameter responsible for the formation and for the key change in the growth characteristics of NCD films under the employed conditions. Growth rates ranging from 5.4 μm/h up to 9.6 μm/h were achieved for the NCD films, much higher than those usually reported in the literature. The enhancing factor of nitrogen addition on NCD growth rate was obtained by comparing with the growth rate of large-grained microcrystalline diamond films grown without nitrogen and discussed by comparing with that of single crystal diamond through theoretical work in the literature. This achievement on NCD growth rate makes the technology interesting for industrial applications where fast coating of large substrates is highly desirable.

Distributed temperature change sensor, based on Rayleigh backscattering in an optical fibre

A frequency-modulated continuous-wave technique is used to detect the presence of frequency shifts in the Rayleigh-backscattered light in a single-mode optical fiber as a result of a changing temperature. The system is able to detect a rate of temperature change of 0.014 K/s, when a 20-cm length of fiber is heated. The system is also able to demonstrate a spatial resolution of better than 15 cm.

Hydrodynamic phenomena in the downcomer during flow rate transients in the primary circuit of a PWR

Mixing phenomena observed when the flow rate in a single loop of the primary circuit is changed can influence the operation of pressurized water reactor (PWR) by inducing local gradients of boron concentration or coolant temperature. Analysis of one-dimensional Laser Doppler Anemometry (LDA) measurements during the start-up and shutdown of pump on a single loop of the ROCOM test facility has been performed. The effect of a step change and a ramped change in the flow rate on the axial and azimuthal velocities was examined. Numerical simulations were also performed for the step change in the flow rate that gave quantitative agreement with the axial velocities. Phenomenological agreement was made on the turbulent kinetic energy; however, observed values were a factor of 2.5 less than the turbulent kinetic energy derived from the measurements. © 2007.