Electronic dispersion compensation using full optical-field reconstruction in 10Gbit/s OOK based systems

We investigate the design of electronic dispersion compensation (EDC) using full optical-field reconstruction in 10Gbit/s on-off keyed transmission systems limited by optical signal-to-noise ratio (OSNR). By effectively suppressing the impairment due to low- frequency component amplification in phase reconstruction, properly designing the transmission system configuration to combat fiber nonlinearity, and successfully reducing the vulnerability to thermal noise, a 4.8dB OSNR margin can be achieved for 2160km single-mode fiber transmission without any optical dispersion compensation. We also investigate the performance sensitivity of the scheme to various system parameters, and propose a novel method to greatly enhance the tolerance to differential phase misalignment of the asymmetric Mach-Zehnder interferometer. This numerical study provides important design guidelines which will enable full optical-field EDC to become a cost-effective dispersion compensation solution for future transparent optical networks.

Chromatic dispersion compensation using full-field maximum-likelihood sequence estimation

We investigate full-field detection-based maximum-likelihood sequence estimation (MLSE) for chromatic dispersion compensation in 10 Gbit/s OOK optical communication systems. Important design criteria are identified to optimize the system performance. It is confirmed that approximately 50% improvement in transmission reach can be achieved compared to conventional direct-detection MLSE at both 4 and 16 states. It is also shown that full-field MLSE is more robust to the noise and the associated noise amplifications in full-field reconstruction, and consequently exhibits better tolerance to nonoptimized system parameters than full-field feedforward equalizer. Experiments over 124 km spans of field-installed single-mode fiber without optical dispersion compensation using full-field MLSE verify the theoretically predicted performance benefits.

Full-field electronic dispersion compensation of a 10 Gbit/s OOK signal over 4 x 124 km field-installed single-mode fibre

We experimentally demonstrate the use of full-field electronic dispersion compensation (EDC) to achieve a bit error rate of 5 x 10(-5) at 22.3 dB optical signal-to-noise ratio for single-channel 10 Gbit/s on-off keyed signal after transmission over 496 km field-installed single-mode fibre with an amplifier spacing of 124 km. This performance is achieved by designing the EDC so as to avoid electronic amplification of the noise content of the signal during full-field reconstruction. We also investigate the tolerance of the system to key signal processing parameters, and numerically demonstrate that single-channel 2160 km single mode fibre transmission without in-line optical dispersion compensation can be achieved using this technique with 80 km amplifier spacing and optimized system parameters.

Analysis of organisational climate to improve the adequacy of primary health care in the State of Kuwait

This study covers two areas of contribution to the knowledge, firstly it tried to investigate rigourously the relationships of a number of factors believed that they may affect the climate perception, classified into three types to arrive to prove a hypothesis of the important role that qualification and personal factors play in shaping the climate perception, this is in contrast with situational factors. Secondly, the study tries to recluster the items of a wide-range applied scale for the measurement of climate named HAY in order to overcome the cross-cultural differences between the Kuwaiti and the American society, and to achieve a modified dimensions of climate for a civil service organisation in Kuwait. Furthermore, the study attempts to carry out a diagnostic test for the climate of the Ministry of Public Health in Kuwait, aiming to diagnose the perceived characteristics of the MoPH organisation, and suggests a number of areas to be given attention if an improvement is to be introduced. The study used extensively the statistical and the computer facilities to make the analysis more representing the field data, on the other hand this study is characterised by the very highly responsive rate of the main survey which would affect the findings reliability. Three main field studies are included, the first one was to conduct the main questionnaire where the second was to measure the "should be" climate by the experts of MoPH using the DELPHI technique, and the third was to conduct an extensive meeting with the very top management team in MoPH. Results of the first stage were subject to CLUSTER analysis for the reconstruction of the HAY tool, whereas comparative analysis was carried on between the results of the second and third stages on one side, the first from the other.

A procedure for the reconstruction of a stochastic stationary temperature field

An iterative procedure is proposed for the reconstruction of a temperature field from a linear stationary heat equation with stochastic coefficients, and stochastic Cauchy data given on a part of the boundary of a bounded domain. In each step, a series of mixed well-posed boundary-value problems are solved for the stochastic heat operator and its adjoint. Well-posedness of these problems is shown to hold and convergence in the mean of the procedure is proved. A discretized version of this procedure, based on a Monte Carlo Galerkin finite-element method, suitable for numerical implementation is discussed. It is demonstrated that the solution to the discretized problem converges to the continuous as the mesh size tends to zero.

Reconstruction of an acoustically sound-soft obstacle from one incident field and the far field pattern

The problem considered is that of determining the shape of a plane acoustically sound-soft obstacle from the knowledge of the far-field pattern for one time-harmonic incident field. An iterative procedure is proposed based on two boundary integrals representing the incident field and the far-field pattern, respectively. Numerical examples are included which show that the procedure gives accurate numerical approximations in relatively few iterations.

The influence of climate on the dispersal of lichen soredia

The relationship between the daily deposition of soredia of Hypogymnia physodes (L.) Nyl. and local climatic records was studied in the field during three periods at a site in Seattle, WA, U.S.A: (1) 11 August – 16 September 1986 (Study A); (2) 16 December – 11 January 1987 (Study B) and (3) 8 July 1988 – 30 January 1989 (Study C). The soredia were trapped on adhesive strips placed at various locations on a Prunus blireiana L. tree for 24 hr periods. A correlation matrix of the data from all three studies revealed a negative correlation between soredial deposition and relative humidity; and a positive correlation with rainfall and temperature. A multiple regression and forward stepwise regression analysis selected relative humidity as the most significant climatic variable, i.e. more soredia tended to be deposited when relative humidity was low. Analysis of individual studies by multiple regression revealed: (1) no significant relationships between soredial deposition and climate in Study A; (2) positive relationships with temperature and wind speed in Study B and (3) positive relationships with wind speed and rainfall in the summer/autumn months of Study C; in the winter months no relationships with climate were found because few soredia were deposited. The data suggest that in the field seasonal photoperiod differences combined with moderately high temperatures and high relative humidity may promote soredial formation and accumulation on thalli prior to soredia dispersal. In addition, low relative humidity may promote soredial release while wind and raindrops may be possible agents of dispersal.

3D reconstruction of complex dielectric function of the glass during the femtosecond micro-fabrication

We measure complex amplitude of scattered wave in the far field, and justify theoretically and numerically solution of the inverse scattering problem. This allows single-shot reconstructing of dielectric function distribution during direct femtosecond laser micro-fabrication.

3D Reconstruction of the complex dielectric function of glass during femtosecond laser micro-fabrication

We report on a new technique to reconstruct the 3D dielectric function change in transparent dielectric materials and the application of the technique for on-line monitoring of refractive index modification in BK7 glass during direct femtosecond laser microfabrication. The complex optical field scattered from the modified region is measured using two-beam, single-shot interferogram and the distribution of the modified refractive index is reconstructed by numerically solving the inverse scattering problem in Born approximation. The optical configuration suggested is further development of digital holographic microscopy (DHM). It takes advantage of high spatial resolution and almost the same optical paths for both interfering beams, and allows ultrafast time resolution.

3D reconstruction of complex dielectric function of the glass during the femtosecond micro-fabrication

We measure complex amplitude of scattered wave in the far field, and justify theoretically and numerically solution of the inverse scattering problem. This allows single-shot reconstructing of dielectric function distribution during direct femtosecond laser micro-fabrication.

3D reconstruction of the complex dielectric function of glass during femtosecond laser micro-fabrication

We report on a new technique to reconstruct the 3D dielectric function change in transparent dielectric materials and the application of the technique for on-line monitoring of refractive index modification in BK7 glass during direct femtosecond laser microfabrication. The complex optical field scattered from the modified region is measured using two-beam, single-shot interferogram and the distribution of the modified refractive index is reconstructed by numerically solving the inverse scattering problem in Born approximation. The optical configuration suggested is further development of digital holographic microscopy. It takes advantage of high spatial resolution and almost the same optical paths for both interfering beams, and allows ultrafast time resolution. © Springer Science+Business Media, LLC. 2011.

A procedure for the temperature reconstruction in corner domains from Cauchy data

An iterative procedure is proposed for the reconstruction of a stationary temperature field from Cauchy data given on a part of the boundary of a bounded plane domain where the boundary is smooth except for a finite number of corner points. In each step, a series of mixed well-posed boundary value problems are solved for the heat operator and its adjoint. Convergence is proved in a weighted L2-space. Numerical results are included which show that the procedure gives accurate and stable approximations in relatively few iterations.

Nonlinear integral equation methods for the reconstruction of an acoustically sound-soft obstacle

The problem considered is that of determining the shape of a planar acoustically sound-soft obstacle from knowledge of the far-field pattern for one time-harmonic incident field. Two methods, which are based on the solution of a pair of integral equations representing the incoming wave and the far-field pattern, respectively, are proposed and investigated for finding the unknown boundary. Numerical resultsare included which show that the methods give accurate numerical approximations in relatively few iterations.