Pole tip recession in linear tape systems

The tribology of linear tape storage system including Linear Tape Open (LTO) and Travan5 was investigated by combining X-ray Photoelectron Spectroscopy (XPS), Auger Electron Spectroscopy (AES), Optical Microscopy and Atomic Force Microscopy (AFM) technologies. The purpose of this study was to understand the tribology mechanism of linear tape systems then projected recording densities may be achieved in future systems. Water vapour pressure or Normalized Water Content (NWC) rather than the Relative Humidity (RH) values (as are used almost universally in this field) determined the extent of PTR and stain (if produced) in linear heads. Approximately linear dependencies were found for saturated PTR increasing with normalized water content increasing over the range studied using the same tape. Fe Stain (if produced) preferentially formed on the head surfaces at the lower water contents. The stain formation mechanism had been identified. Adhesive bond formation is a chemical process that is governed by temperature. Thus the higher the contact pressure, the higher the contact temperature in the interface of head and tape, was produced higher the probability of adhesive bond formation and the greater the amount of transferred material (stain). Water molecules at the interface saturate the surface bonds and makes adhesive junctions less likely. Tape polymeric binder formulation also has a significant role in stain formation, with the latest generation binders producing less transfer of material. This is almost certainly due to higher cohesive bonds within the body of the magnetic layer. TiC in the two-phase ceramic tape-bearing surface (AlTiC) was found to oxidise to form TiO2.The oxidation rate of TiC increased with water content increasing. The oxide was less dense than the underlying carbide; hence the interface between TiO2 oxide and TiC was stressed. Removals of the oxide phase results in the formation of three-body abrasive particles that were swept across the tape head, and gave rise to three-body abrasive wear, particularly in the pole regions. Hence, PTR and subsequent which signal loss and error growth. The lower contact pressure of the LTO system comparing with the Travan5 system ensures that fewer and smaller three-body abrasive particles were swept across the poles and insulator regions. Hence, lower contact pressure, as well as reducing stain in the same time significantly reduces PTR in the LTO system.

Does radial growth of the lichen Parmelia conspersa depend exclusively on growth processes at the lobe tip?

The objective of this study was to test the hypothesis that the radial growth of lobes of the lichen Parmelia conspersa depends largely on growth processes which occur at the lobe tip. First, individual lobes were removed from thalli and portions of the lobe removed to within various distances from the tip. Radial growth of the lobe was unaffected until less than 2 mm of the lobe tip remained. Second, the surfaces of individual lobes were painted with acrylic paint leaving different portions of the lobe exposed. Painting lobes to within 0.5 mm and 1 mm of the tip substantially reduced radial growth. Third, the levels of ribitol, arabitol and mannitol were measured in different regions behind the lobe tip on four occasions during 1994. The concentration of the three carbohydrates was greatest at the lobe tip and the levels declined linearly with distance from the tip. Fourth, painting one vertical half of the lobe tip did not affect radial growth but artificially bisecting the lobe tip with a scalpel reduced radial growth. Although transport of carbohydrate from other regions of the lobe cannot be ruled out, the results support the hypothesis that radial growth in P. conspersa depends largely on processes within a region approximately 2 mm behind the lobe tip.

Flt1 acts as a negative regulator of tip cell formation and branching morphogenesis in the zebrafish embryo

Endothelial tip cells guide angiogenic sprouts by exploring the local environment for guidance cues such as vascular endothelial growth factor (VegfA). Here we present Flt1 (Vegf receptor 1) loss- and gain-of-function data in zebrafish showing that Flt1 regulates tip cell formation and arterial branching morphogenesis. Zebrafish embryos expressed soluble Flt1 (sFlt1) and membrane-bound Flt1 (mFlt1). In Tg(flt1(BAC):yfp) × Tg(kdrl:ras-cherry)(s916) embryos, flt1:yfp was expressed in tip, stalk and base cells of segmental artery sprouts and overlapped with kdrl:cherry expression in these domains. flt1 morphants showed increased tip cell numbers, enhanced angiogenic behavior and hyperbranching of segmental artery sprouts. The additional arterial branches developed into functional vessels carrying blood flow. In support of a functional role for the extracellular VEGF-binding domain of Flt1, overexpression of sflt1 or mflt1 rescued aberrant branching in flt1 morphants, and overexpression of sflt1 or mflt1 in controls resulted in short arterial sprouts with reduced numbers of filopodia. flt1 morphants showed reduced expression of Notch receptors and of the Notch downstream target efnb2a, and ectopic expression of flt4 in arteries, consistent with loss of Notch signaling. Conditional overexpression of the notch1a intracellular cleaved domain in flt1 morphants restored segmental artery patterning. The developing nervous system of the trunk contributed to the distribution of Flt1, and the loss of flt1 affected neurons. Thus, Flt1 acts in a Notch-dependent manner as a negative regulator of tip cell differentiation and branching. Flt1 distribution may be fine-tuned, involving interactions with the developing nervous system.

Exploring image databases at the tip of your fingers

Visual information is becoming increasingly important and tools to manage repositories of media collections are highly sought after. In this paper, we focus on image databases and on how to effectively and efficiently access these. In particular, we present effective image browsing systems that are operated on a large multi-touch environment for truly interactive exploration. Not only do image browsers pose a useful alternative to retrieval-based systems, they also provide a visualisation of the whole image collection and let users explore particular parts of the collection. Our systems are based on the idea that visually similar images are located close to each other in the visualisation, that image thumbnails are arranged on a regular lattice (either a regular grid projected on a sphere or a hexagonal lattice), and that large image datasets can be accessed through a hierarchical tree structure. © 2014 International Information Institute.