Uptake and transport of orally-deliverable drugs across caco-2 cell monolayers:the effect of lipid formulations

The aim of this thesis is to investigate the physicochemical parameters which can influence drug loading within liposomes and to characterise the effect such formulations have on drug uptake and transport across in vitro epithelial barrier models. Liposomes composed of phosphatidylcholine (PC) or distearoyl phosphatidylcholine (DSPC) and cholesterol (0, 4, 8, 16 µM) were prepared and optimised in terms of drug loading using the hand-shaking method (Bangham et al., 1965). Subsequently, liposomes composed of 16 µM PC or DSPC and cholesterol (4 µM) were used to monitor hydroxybenzoate release and transport from Iiposomes. The MIT (3[4,5-Dimethylthiazol-2-yl]-2,5-diphenyl tetrazolium bromide) and crystal violet assays were employed to determine toxicity of the Iiposome. formulations towards the Caco-2 cell line, employed to model the epithelial barrier in vitro. Uptake and transport of mannitol, propranolol, glutamine and digoxin was measured in the presence and absence of Iiposome formulations to establish changes in absorption resulting from the presence of lipid formulations. Incorporation of the four hydroxybenzoates was shown to be influenced by a number of factors, including liposome composition and drug conformation. Methyl hydroxybenzo.ate (MP) was incorporated into the bilayer most effectively with percentage incorporation of 68% compared to 45% for butyl hydroxybenzoate (BP), despite its increased Iipophilicity. This was attributed to the decreased packing ability of BP within the hydrocarbon core of the lipid bilayer compared to MP. Release studies also suggested that the smaller MP was more strongly incorporated within the lipid bilayer with only 8% of the incorporated solute being released after 48-hours compared to 17% in the case of BP. Model transport studies were seen to reflect drug release profiles from the liposome bilayers with significantly (p < 0.01) higher amounts of BP partitioning from the liposome compared to MP, Caco-2 cell viability was maintained above 86% in the presence of all Iiposome formulations tested indicating the liposome formulations are non-toxic towards Caco-2 cells. Paracellular (apical-to-basolateral) transport of mannitol was significantly increased in the presence of DSPC, PC / DSPC:Cholesterol (16:4 µM; 1000 µg). Glutamine uptake and transport via the carrier-mediated route was Significantly (p < 0.01) increased in the presence of PC I DSPC:Cholesterol (16:0; 16:4 µM). Digoxin apical-to-basolateral transport was significantly increased (p < 0,01) in the presence of PC / DSPC:Cholesterol (16:0; 16:4 µM); thus reducing digoxin efflux via P-glycoprotein. In contrast, PC:ChoJesterol (16:0; 16:4 µM) significantly (p < 0.01) decreased propranolol uptake via the passive transcellular route. Bi-directional transport of propranolol was significantly (p < 0,01) decreased in the presence of PC/DSPC:Cholesterol (16:0; 16:4 µM). The structure of a solute is an important determinant for the incorporation and release of a solute from liposome formulations. PC, DSPC and cholesterol liposome formulations are nontoxic towards Caco-2 cell monolayers and improved uptake and transport of mannitol, glutamine. and digoxin across Caco-2 cell monolayers; thus providing a potential alternative delivery vehicle.

Interactions between oligoamines and superoxide anion

1- Oligoamines and EDTA inhibited the reduction of cytochrome-C and nitrobule tetrazolium (NBT) induced by the hypoxanthine/xanthine oxidase superoxide anion generating system in the following order of effectiveness: putrescine > diaminopropane > spermidine > EDTA > spermine > cadaverine. 2- Oligoamines and EDTA did not affect the rate of urate formation from the hypoxanthine/xanthine oxidase system. 3- Oligoamines and EDTA inhibited the reduction of cytochrome-C induced by stimulated PMNL's in the same order of effectiveness as mentioned before. 4- Oligoamines and EDTA inhibited luminol dependent stimulated PMNL's chemiluminescence. 5- Oligoamines and EDTA inhibited the aerobic photoreduction of NBT. 6- Oligoamines-copper sulphate complexes inhibited the reduction of cytochrome-C induced by the hypoxanthine/xanthine oxidase system more effectively than oligoamines or copper sulphate individually. 7- Superoxide anion, hydrogen peroxide and hydroxyl radical induced breakdown of isolated intact guinea pig liver lysosomes. 8- Oligoamines and EDTA protected isolated intact guinea pig liver lysosomes from the lytic effect of superoxide anion generated either by the hypoxanthine/xanthine oxidase system or by stimulated PMNL's. 9- Oligoamines and EDTA have no stabilizing effect on isolated intact guinea pig liver lysosomes. 10- The uptake of oligoamines by lysosomes was in the following order: putrescine > spermidine > spermine. 11- Oligoamines were metabolised into aldehyde compounds either by the hypoxanthine/xanthine oxidase system or stimulated PMNL's. 12- Oligoamines and EDTA have no effect on the activities of free lysosomal enzymes (acid phosphatase and -glucosaminidase). 13- Oligoamines and EDTA inhibited lipid peroxidation in guinea pig liver lysosomes induced either by the hypoxanthine/xanthine oxidase or ascorbic acid-ferrous sulphate. 14- Oligoamines and EDTA have no effect on the release of PGE_2 from stimulated peritoneal guinea pig PMNL's. 15- Oligoamines increased the uptake of (^3H)thymidine and (^3H)leucine by stimulated peritoneal guinea pig macrophages in the following order of effectiveness: spermine > spermidine > putrescine > cadaverine. 16- PGE_2, dibutyryl Cyclic AMP, and theophylline inhibited luminol dependent stimulated peritoneal guinea pig PMNL's chemiluminescence.

Folate metabolism in the female weanling rat

The metabolism of a mixture of [2-14C] and [3',5',7,9-3H] folic acid was studied in female weanling rats. Intact folates and folate catabolites were excreted in the urine. Folate polyglutamates were found in the tissues. Rats treated with the oestrogen diethylstilbestrol and 17 -ethynyloestradiol exhibited marked changes in the metabolic handling of folic acid and folate catabolism was greatly increased compared to controls. Allopurinol treatment gave greater label retention in the gut, with a substantial increase in catabolism compared to normals. A dose response relationship was illustrated between allopurinol dose and folate catabolism. After lead acetate dosing there was little radioactivity in the urine and tissues over 72h and more radioactivity was retained in the faeces compared to normals. Excretion of intact folates was depressed, especially 5MeTHF and 10CHOTHF. A tenfold increase in both lead and folic acid dosage resulted in an even further decrease of radioactivity in the tissues and urine over 72h. Excretion in the faeces was further elevated. Ferrous sulphate administration resulted in increased catabolism. The retention of radioactivity in the liver, kidney and gut was greatly reduced. A new method of folate analysis; Sephadex LH-20 was introduced. In vitro superoxide anion formation was illustrated using an allopurinol/xanthine oxidase system. Histological studies were employed to qualitatively and quantitatively illustrate the oxidative status in livers and brains of allopurinol and ferrous sulphate dosed rats. Increased dose related formazan deposition was observed when livers of pretreated animals were incubated with nitroblue tetrazolium. Formazan deposition was reduced in pretreated animals also treated with the anti-oxidants vitamin E, mannitol or 4-hydroxy-methyl-4,6-ditertiary-butylphenol. A possible route of folate catabolism is scission by a non-enzymic oxidation involving active oxygen species.

Characterisation of electrospun polystyrene scaffolds for three-dimensional in vitro biological studies

The purpose of this study was to produce a well-characterised electrospun polystyrene scaffold which could be used routinely for three-dimensional (3D) cell culture experimentation. A linear relationship (p<0.01p<0.01) between three principal process variables (applied voltage, working distance and polymer concentration) and fibre diameter was reliably established enabling a mathematical model to be developed to standardise the electrospinning process. Surface chemistry and bulk architecture were manipulated to increase wetting and handling characteristics, respectively. X-ray photoelectron spectroscopy (XPS) confirmed the presence of oxygen-containing groups after argon plasma treatment, resulting in a similar surface chemistry to treated tissue culture plastic. The bulk architecture of the scaffolds was characterised by scanning electron microscopy (SEM) to assess the alignment of both random and aligned electrospun fibres, which were calculated to be 0.15 and 0.66, respectively. This compared to 0.51 for collagen fibres associated with native tissue. Tensile strength and strain of approximately of 0.15 MPa and 2.5%, respectively, allowed the scaffolds to be routinely handled for tissue culture purposes. The efficiency of attachment of smooth muscle cells to electrospun scaffolds was assessed using a modified 3-[4,5-dimethyl(thiazol-2yl)-3,5-diphery] tetrazolium bromide assay and cell morphology was assessed by phalloidin-FITC staining of F-actin. Argon plasma treatment of electrospun polystyrene scaffold resulted in significantly increased cell attachment (p<0.05p<0.05). The alignment factors of the actin filaments were 0.19 and 0.74 for the random and aligned scaffold respectively, compared to 0.51 for the native tissue. The data suggests that electrospinning of polystyrene generates 3D scaffolds which complement polystyrene used in 2D cell culture systems.

Physical and biological properties of a novel siloxane adhesive for soft tissue applications

The aim of this study was to investigate the adhesive properties of an in-house amino-propyltrimethoxysilane-methylenebisacrylamide (APTMS-MBA) siloxane system and compare them with a commercially available adhesive, n-butyl cyanoacrylate (nBCA). The ability of the material to perform as a soft tissue adhesive was established by measuring the physical (bond strength, curing time) and biological (cytotoxicity) properties of the adhesives on cartilage. Complementary physical techniques, X-ray photoelectron spectroscopy, Raman and infrared imaging, enabled the mode of action of the adhesive to the cartilage surface to be determined. Adhesion strength to cartilage was measured using a simple butt joint test after storage in phosphate-buffered saline solution at 37°C for periods up to 1 month. The adhesives were also characterised using two in vitro biological techniques. A live/dead stain assay enabled a measure of the viability of chondrocytes attached to the two adhesives to be made. A water-soluble tetrazolium assay was carried out using two different cell types, human dermal fibroblasts and ovine meniscal chondrocytes, in order to measure material cytotoxicity as a function of both supernatant concentration and time. IR imaging of the surface of cartilage treated with APTMS-MBA siloxane adhesive indicated that the adhesive penetrated the tissue surface marginally compared to nBCA which showed a greater depth of penetration. The curing time and adhesion strength values for APTMS-MBA siloxane and nBCA adhesives were measured to be 60 s/0.23 MPa and 38 min/0.62 MPa, respectively. These materials were found to be significantly stronger than either commercially available fibrin (0.02 MPa) or gelatin resorcinol formaldehyde (GRF) adhesives (0.1 MPa) (P <0.01). Cell culture experiments revealed that APTMS-MBA siloxane adhesive induced 2% cell death compared to 95% for the nBCA adhesive, which extended to a depth of approximately 100-150 μm into the cartilage surface. The WST-1 assay demonstrated that APTMS-MBA siloxane was significantly less cytotoxic than nBCA adhesive as an undiluted conditioned supernatant (P <0.001). These results suggest that the APTMS-MBA siloxane may be a useful adhesive for medical applications. © VSP 2005.