Clinical evaluation of the Oculus Keratograph

AIM: To determine the validity and reliability of the measurement of corneal curvature and non-invasive tear break-up time (NITBUT) measures using the Oculus Keratograph. METHOD: One hundred eyes of 100 patients had their corneal curvature assessed with the Keratograph and the Nidek ARKT TonorefII. NITBUT was then measured objectively with the Keratograph with Tear Film Scan software and subjectively with the Keeler Tearscope. The Keratograph measurements of corneal curvature and NITBUT were repeated to test reliability. The ocular sensitivity disease index questionnaire was completed to quantify ocular comfort. RESULTS: The Keratograph consistently measured significantly flatter corneal curvatures than the ARKT (MSE difference: +1.83±0.44D), but was repeatable (p>0.05). Keratograph NITBUT measurements were significantly lower than observation using the Tearscope (by 12.35±7.45s; pp < 0.001) and decreased on subsequent measurement (by -1.64 ± 6.03s; p < 0.01). The Keratograph measures the first time the tears break up anywhere on the cornea with 63% of subjects having NI-TBUT's <5s and a further 22% having readings between 5 and 10s. The Tearscope results were found to correlate better with the patients symptoms (r = -0.32) compared to the Keratograph (r = -0.19). Conclusions: The Keratograph requires a calibration off-set to be comparable to other keratometry devices. Its current software detects very early tear film changes, recording significantly lower NITBUT values than conventional subjective assessment. Adjustments to instrumentation software have the potential to enhance the value of Keratograph objective measures in clinical practice.

Placebo expectancy effect of consuming psychoactive beverages on cognition and mood

Energy drinks have become very popular over the past few years with over half the student population in colleges and universities consuming them at least once a month (Malinauskas et al., 2007). It has been reported that the most common reasons why students consume energy drinks are to maintain alertness, reduce symptoms of hangover, increase energy, to help with driving and to prevent sleepiness (Attila and Cakir, 2011; Malinauskas et al., 2007). Previous research has suggested that energy drinks enhance sensorimotor speed, behaviour, and reduce levels of fatigue (Alford et al., 2001; Horne and Reyner, 2001; Howard and Marczinski, 2010; Kennedy and Scholey, 2004; Smit et al., 2004). The two key ingredients found in energy drinks are caffeine and glucose which have been examined together and alone, which have indicated enhanced reaction times, improvement in both verbal memory and sustained attention and more recently there is evidence to show that expectancy may play a key role in predicting intentions of future consumption (Adan and serra-Grabulosa, 2010). According to Kirsch (1997) people have specific expectations when they consume psychoactive substances that trigger physiological and psychological reactions, which tend to be independent of the psychoactive substance ingested. The concept of expectancy effects can be unambiguous especially when the information provided to the participants prior to the experimental study is specific to a possible outcome response. This thesis investigated the extent of expectancy effect on cognition and mood when psychoactive drinks containing caffeine and glucose were consumed in comparison to non-psychoactive drinks. The investigation commenced with examining the independent effects of caffeine and glucose, followed by the combination of caffeine and glucose as an energy drink on mood and cognition. The investigation advanced by comparing drink presentation effects (i.e., consuming the experimental drink from a branded bottle versus from a glass) irrespective of drink content on mood and cognition. Finally, the investigation lead to exploring what factors may predict expectancy effects when participants’ consumed psychoactive drinks among healthy adults. This was done by applying the Theory of Planned Behaviour model (TPB) (Azjen, 1991) to explore the contribution of specific attitudes, subjective norms and perceived behavioural control to the extent of expectancy effects as well as to behavioural intention, with additional variables including; beliefs, habits, past-behaviour, selfidentity. Self-identity representing someone who drinks energy drinks regularly. The level of internal consistency for Cronbach’s alpha was conducted for each variable within the TPB model and for the additional variables included for test reliability. This thesis consisted of four studies, which found that consumption of caffeine and glucose independently and also in combination resulted in psychoactive effects on mood and cognition. Experiment 2 was the only study, which indicated an expectancy effect for immediate verbal recall task and the mood subscale tension. Conversely, for experiment 4 there was a reverse effect found for the immediate verbal recall task. However, there were significant expectancy and psychoactive effects found for mood subscales throughout the four studies. It was also found that the TPB model had two significant variables past-behaviour and self-identity predicted intentions suggesting that participants who regularly consume psychoactive beverages have salient beliefs about consuming psychoactive drinks and the TPB model can be utilised to predict their intentions. Furthermore, the Theory of planned behaviour model found that habit and self-identity significantly predicted participants’ expectancy effects on the vigour. Indicating consumers of energy drinks are familiar with expected outcome response. This model was unsuccessful in predicting expectancy response for cognitive performance. Thus, overall the findings from the four studies indicated that caffeine and glucose have cognitive enhancing properties, which also positively improve mood. However, expectancy effects have been identified for mood only, whereas the overall findings within this thesis were unable to identify significant predictors of expectancy effect and response.

The macular mapping test:a reliability study

Background: Age-related macular degeneration (ARMD) is the leading cause of visual disability in people over 60 years of age in the developed world. The success of treatment deteriorates with increased latency of diagnosis. The purpose of this study was to determine the reliability of the macular mapping test (MMT), and to investigate its potential as a screening tool. Methods: The study population comprised of 31 healthy eyes of 31 participants. To assess reliability, four macular mapping test (MMT) measurements were taken in two sessions separated by one hour by two practitioners, with reversal of order in the second session. MMT readings were also taken from 17 age-related maculopathy (ARM), and 12 AMD affected eyes. Results: For the normal cohort, average MMT scores ranged from 85.5 to 100.0 MMT points. Scores ranged from 79.0 to 99.0 for the ARM group and from 9.0 to 92.0 for the AMD group. MMT scores were reliable to within ± 7.0 points. The difference between AMD affected eyes and controls (z = 3.761, p = < 0.001) was significant. The difference between ARM affected eyes and controls was not significant (z = -0.216, p = 0.829). Conclusion: The reliability data shows that a change of 14 points or more is required to indicate a clinically significant change. This value is required for use of the MMT as an outcome measure in clinical trials. Although there was no difference between MMT scores from ARM affected eyes and controls, the MMT has the advantage over the Amsler grid in that it uses a letter target, has a peripheral fixation aid, and it provides a numerical score. This score could be beneficial in office and home monitoring of AMD progression, as well as an outcome measure in clinical research. © 2005 Bartlett et al; licensee BioMed Central Ltd.

Reliability, normative data, and the effect of age-related macular disease on the Eger Macular Stressometer photostress recovery time

Purpose: To assess repeatability and reproducibility, to determine normative data, and to investigate the effect of age-related macular disease, compared with normals, on photostress recovery time measured using the Eger Macular Stressometer (EMS). Method: The study population comprised 49 healthy eyes of 49 participants. Four EMS measurements were taken in two sessions separated by 1 h by two practitioners, with reversal of order in the second session. EMS readings were also taken from 17 age-related maculopathy (ARM), and 12 age-related macular degeneration (AMD), affected eyes. Results: EMS readings are repeatable to within ± 7 s. There is a statistically significant difference between controls and ARM affected eyes (t = 2.169, p = 0.045), and AMD affected eyes (t = 2.817, p = 0.016). The EMS is highly specific, and demonstrates sensitivity of 29% for ARM, and 50% for AMD. Conclusions: The EMS may be a useful screening test for ARM, however, direct illumination of the macula of greater intensity and longer duration may yield less variable results. © 2004 The College of Optometrists.

Probing three-way interactions in moderated multiple regression:Development and application of a slope difference test

Researchers often use 3-way interactions in moderated multiple regression analysis to test the joint effect of 3 independent variables on a dependent variable. However, further probing of significant interaction terms varies considerably and is sometimes error prone. The authors developed a significance test for slope differences in 3-way interactions and illustrate its importance for testing psychological hypotheses. Monte Carlo simulations revealed that sample size, magnitude of the slope difference, and data reliability affected test power. Application of the test to published data yielded detection of some slope differences that were undetected by alternative probing techniques and led to changes of results and conclusions. The authors conclude by discussing the test's applicability for psychological research. Copyright 2006 by the American Psychological Association.

The Team Climate Inventory (TCI): a psychometric test on a Taiwanese sample of work groups

Understanding the feasibility of applying the Team Climate Inventory (TCI) in non-Western cultures is essential for researchers attempting to understand the influence of culture on workers' perceived climate. This study describes the application of the TCI in such a setting using data from 203 administrators employed in a Taiwanese medical center. Reliability and factor analyses were performed to establish the feasibility and psychometric properties of the TCI Taiwan version. Reliabilities of both the four- and five-factor solutions exceeded .80. Factor analyses indicated a satisfactory four-factor structure, despite some variations in comparison with the U.K. version. The TCI Taiwan version is feasible and has acceptable psychometric properties. Further research is warranted regarding the degree to which disparities result from cultural differences and the specific nature of organizational systems in Chinese communities.

The MacDQoL individualized measure of the impact of macular degeneration on quality of life: reliability and responsiveness

PURPOSE: To investigate the MacDQoL test-retest reliability and sensitivity to change in vision over a period of one year in a sample of patients with age-related macular degeneration (AMD). DESIGN: A prospective, observational study. METHOD: Patients with AMD from an ophthalmologist's list (n = 135) completed the MacDQoL questionnaire by telephone interview and underwent a vision assessment on two occasions, one year apart. RESULTS: Among participants whose vision was stable over one year (n = 87), MacDQoL scores at baseline and follow-up were highly correlated (r = 0.95; P < .0001). Twelve of the 22 scale items had intraclass correlations of >.80; only two were correlated <.7. There was no difference between baseline and follow-up scores (P = .85), indicating excellent test-retest reliability. Poorer quality of life (QoL) at follow-up, measured by the MacDQoL present QoL overview item, was associated with deterioration in both the better eye and binocular distance visual acuity [VA] (r = 0.29; P = .001, r = 0.21; P = .016, respectively; n = 135). There was a positive correlation between deterioration in the Mac. DQoL average weighted impact score and deterioration in both binocular near VA and reading speed (r = 0.20; P = .019, r = 0.18; P = .041, respectively; n = 135). CONCLUSION: The MacDQoL has excellent test-retest reliability. Its sensitivity to change in vision status was demonstrated in correlational analyses. The measure indicates that the negative impact of AMD on QoL increases with increasing severity of visual impairment.

The design of environmental test rigs

Product reliability and its environmental performance have become critical elements within a product's specification and design. To obtain a high level of confidence in the reliability of the design it is customary to test the design under realistic conditions in a laboratory. The objective of the work is to examine the feasibility of designing mechanical test rigs which exhibit prescribed dynamical characteristics. The design is then attached to the rig and excitation is applied to the rig, which then transmits representative vibration levels into the product. The philosophical considerations made at the outset of the project are discussed as they form the basis for the resulting design methodologies. It is attempted to directly identify the parameters of a test rig from the spatial model derived during the system identification process. It is shown to be impossible to identify a feasible test rig design using this technique. A finite dimensional optimal design methodology is developed which identifies the parameters of a discrete spring/mass system which is dynamically similar to a point coordinate on a continuous structure. This design methodology is incorporated within another procedure which derives a structure comprising a continuous element and a discrete system. This methodology is used to obtain point coordinate similarity for two planes of motion, which is validated by experimental tests. A limitation of this approach is that it is impossible to achieve multi-coordinate similarity due to an interaction of the discrete system and the continuous element at points away from the coordinate of interest. During the work the importance of the continuous element is highlighted and a design methodology is developed for continuous structures. The design methodology is based upon distributed parameter optimal design techniques and allows an initial poor design estimate to be moved in a feasible direction towards an acceptable design solution. Cumulative damage theory is used to provide a quantitative method of assessing the quality of dynamic similarity. It is shown that the combination of modal analysis techniques and cumulative damage theory provides a feasible design synthesis methodology for representative test rigs.

Team effectiveness: a test of in-put process-output

This research addressed the question: "Which factors predict the effectiveness of healthcare teams?" It was addressed by assessing the psychometric properties of a new measure of team functioning with the use of data collected from 797 team members in 61 healthcare teams. This new measure is the Aston Team Performance Inventory (ATPI) developed by West, Markiewicz and Dawson (2005) and based on the IPO model. The ATPI was pilot tested in order to examine the reliability of this measure in the Jordanian cultural context. A sample of five teams comprising 3-6 members each was randomly selected from the Jordan Red Crescent health centers in Amman. Factors that predict team effectiveness were explored in a Jordanian sample (comprising 1622 members in 277 teams with 255 leaders from healthcare teams in hospitals in Amman) using self-report and Leader Ratings measures adapted from work by West, Borrill et al (2000) to determine team effectiveness and innovation from the leaders' point of view. The results demonstrate the validity and reliability of the measures for use in healthcare settings. Team effort and skills and leader managing had the strongest association with team processes in terms of team objectives, reflexivity, participation, task focus, creativity and innovation. Team inputs in terms of task design, team effort and skills, and organizational support were associated with team effectiveness and innovation whereas team resources were associated only with team innovation. Team objectives had the strongest mediated and direct association with team effectiveness whereas task focus had the strongest mediated and direct association with team innovation. Finally, among leadership variables, leader managing had the strongest association with team effectiveness and innovation. The theoretical and practical implications of this thesis are that: team effectiveness and innovation are influenced by multiple factors that must all be taken into account. The key factors managers need to ensure are in place for effective teams are team effort and skills, organizational support and team objectives. To conclude, the application of these findings to healthcare teams in Jordan will help improve their team effectiveness, and thus the healthcare services that they provide.