Effects of the rate of formant-frequency variation on the grouping of formants in speech perception

How speech is separated perceptually from other speech remains poorly understood. Recent research suggests that the ability of an extraneous formant to impair intelligibility depends on the modulation of its frequency, but not its amplitude, contour. This study further examined the effect of formant-frequency variation on intelligibility by manipulating the rate of formant-frequency change. Target sentences were synthetic three-formant (F1?+?F2?+?F3) analogues of natural utterances. Perceptual organization was probed by presenting stimuli dichotically (F1?+?F2C?+?F3C; F2?+?F3), where F2C?+?F3C constitute a competitor for F2 and F3 that listeners must reject to optimize recognition. Competitors were derived using formant-frequency contours extracted from extended passages spoken by the same talker and processed to alter the rate of formant-frequency variation, such that rate scale factors relative to the target sentences were 0, 0.25, 0.5, 1, 2, and 4 (0?=?constant frequencies). Competitor amplitude contours were either constant, or time-reversed and rate-adjusted in parallel with the frequency contour. Adding a competitor typically reduced intelligibility; this reduction increased with competitor rate until the rate was at least twice that of the target sentences. Similarity in the results for the two amplitude conditions confirmed that formant amplitude contours do not influence across-formant grouping. The findings indicate that competitor efficacy is not tuned to the rate of the target sentences; most probably, it depends primarily on the overall rate of frequency variation in the competitor formants. This suggests that, when segregating the speech of concurrent talkers, differences in speech rate may not be a significant cue for across-frequency grouping of formants.

Remote sensing applied to land use and erosion hazard studies in Jamaica

The northern half of the parish of St. Catherine in Jamaica was selected as a test area to study, by means of remote sensing, the problems of soil erosion in a tropical environment. An initial study was carried out to determine whether eroded land within this environment could be successfully interpreted and mapped from the available 1: 25,000 scale aerial photographs. When satisfied that a sufficiently high percentage of the eroded land could be interpreted on the aerial photographs the main study was initiated. This involved interpreting the air photo cover of the study area for identifying and classifying land use and eroded land, and plotting the results on overlays on topographic base maps. These overlays were then composited with data on the soils and slopes of the study area. The areas of different soil type/slope/land use combinations were then measured, as was the area of eroded land for each of these combinations. This data was then analysed in two ways. The first way involved determining which of the combinations of soil type, slope and land use were most and least eroded and, on the basis of this, to draw up recommendations concerning future land use. The second analysis was aimed at determining which of the three factors, soil type, slope and land use, was most responsible for determining the rate of erosion. Although it was possible to show that slope was not very significant in determining the rate of erosion, it was much more difficult to separate the effects of land use and soil type. The results do, however, suggest that land use is more significant than soil type in determining the rate of erosion within the study area.

The formation and impact of hazard control policy:a study of the regulation of white lead paint in Britain

Government regulation of industrial hazards is examined in the context of the economic and technical processes of industrial development. Technical problems and costs of control are considered as factors in both the formation and impact of regulation. This thesis focuses on an historical case-study of the regulation of the hazard to painting workers from the use of lead pigments in paint. A regulatory strategy based on the prohibition of lead paints gained initial acceptance within the British state in 1911, but was subsequently rejected in favour of a strategy that allowed continued use of lead paint subject to hygiene precautions. The development of paint technology and its determinants, including concern about health hazards, are analysed, focusing on the innovation and diffusion into the paint industry of the major white pigments: white lead (PbC03 .PB(OH)2)and its substitutes. The process of regulatory development is examined, and the protracted and polarised regulatory d~bate contrasted to the prevailing 'consensual' methods of workplace regulation. The rejection of prohibition is analysed in terms of the different political and technical resources of those groups in conflict over this policy. This highlights the problems of consensus formation around such a strategy, and demonstrates certain constraints on state regulatory activity, particularly regarding industrial development. Member-states of the International Labour Organisation agreed to introduce partial prohibition of lead paint in 1921. Whether this was implemented is related to the economic importance of lead and non-lead metal and pigment industries to a nation. An analysis is made of the control of lead poisoning. The rate of control is related to the economic and technological trajectory of the regulated industry. Technical and organisational characteristics are considered as well as regulatory factors which range from voluntary compliance and informal pressures to direct legal requirements. The implications of this case-study for the analysis of the development and impacts of regulation are assessed.