5 resultados para Lower Tagus Valley basin
em Aston University Research Archive
Resumo:
The Andean forearc of northern Chile comprises four morphotectonic units, which include from east to west: 1) The Cordillera de la Costa: composed of Jurassic granites and andesites, thought to represent a volcanic arc, the Mejillones terrane, an accreted allochthonous terrane, and the Lower Cretaceous Coloso basin, which formed through forearc extension along the suture between the Mejillones terrane and the Jurassic arc. Palaeomagnetic studies of the above units have identified approximately 29+/-11 degrees of clockwise rotation. Rotation is due to extension (caused by subduction roll back and slab pull), at an angle to the direction of absolute motion of the South American Plate. 2) The Central Depression: a large arid basin containing isolated fault-bounded blocks of pre-Mesozoic metamorphosed igneous rocks, Triassic sediments and volcanics, and Jurassic carbonates, deposited in a. back-arc basin setting. The isolated blocks formed through extension along previous thrust faults, these originated through compression of the back-arc basin due to accretion of the Jurassic volcanic arc. 3) The Precordillera.: composed of Permian-Triassic rift-related sediments and volcanics, Jurassic continental sediments synchronous with back-arc basin sedimentation, and Cretaceous and Oligo-Miocene continental sediments deposited in foreland basins. Palaeomagnetism has identified clockwise rotation in rocks ranging in age from Jurassic-Miocene. Rotation in the Precordillera. affected larger structural blocks than in the Cordillera de la Costa. 4) The Salar Depression: a. series of arid continental basins developed on continental crust. These basins nay have originated in the Triassic, when rifting of the South American craton is thought to have taken place. In conclusion, palaeomagnetic and geological evidence is consistent with the view that the north Chilean forearc was largely under an extensional stress regime. However, the presence of extensive compressional structures in Palaeocene and older rocks in the forearc together with the currently active foreland thrust belt of Argentina. indicate that throughout the evolution of the Andean Orogen, a delicate balance between compressional and extensional tectonic regimes has existed.
Resumo:
This thesis describes the geology of a Lower Palaeozoic terrain, situated west of the town of Fishguard, SW Dyfed, Wales. The area is dominated by the Fishguard Volcanic Complex (Upper Llanvirn), and sediments that range in age from the Middle Cambrian to the Lower Llandeilo. The successions represent an insight into sedimentation and volcanism for c. 100 Ma. along the south-western margin of the Lower Palaeozoic Welsh Basin. The stratigraphy of the sedimentary sequence has been completely revised and the existing volcanostratigraphy modified. The observed complexity of the stratigraphy is primarily the consequence of Caldedonide deformation which resulted in large scale repetition. Fold-thrust tectonics dominates the structural style of the area. Caledonide trending (NE-SW) cross-faults complicate preexisting structures. Middle Cambrian (?) sedimentation is documented by shallow marine clastics and red shales deposited within tidal - subtidal environments. Upper Cambrian sedimentation was dominated by shallow marine `storm' and `fair weather' sedimentation within a muddy shelf environment. Shallow marine conglomerates and heterolithic intertidal siliciclastics mark the onset of Ordovician sedimentation during the lower Arenig transgression. Mid-Arenig sediments reflect deposits influenced by storm, fair-weather and wave related processes in various shallow marine environments, including; shoreface, inner shelf, shoaling bar, and deltaic. Graptolitic marine shales were deposited from the upper mid-Arenig through to the lower Llandeilo; during which time sediments accumulated by pelagic processes and fine grained turbidites. The varied nature of sedimentation reflects both localised change within the depositional system and the influence of larger regional eustatic events. Ordovician subaqueous volcanic activity produced thick accumulations of lavas, pyroclastics, hydroclastics, and hyaloclastics. The majority of volcanism was effusive in nature, erupted below the Pressure Compensation Level. Basaltic volcanism was characterised by pillowed lavas and tube networks, whilst sheet-flow lavas, pillow breccias and minor hyaloclastites developed locally. Silicic volcanism was dominated by rhyolitic clastics of various affinities, although coherent silicic obsidian lavas, sheet-flow lavas and pyroclastics developed. Hypabyssal intrusives of variable composition and habit occur throughout the volcanic successions. Low-grade regional metamorphism has variably affected the area, conditions of the prehnite-pumpellyite and greenschist facies having been attained. Numerous secondary phases developed in response to the conditions imposed, which collectively indicate that P-T conditions were of low-pressure facies series in the range P= 1.2-2.0 kbars and T= 230-350oC, under an elevated geothermal gradient of 40-45oC km-1. Polymineralic cataclastites associated with Caledonide deformation indicate that tectonism and metamorphism were in part contemporaneous.
Resumo:
In weak argillaceous rocks the unweathered strength may be barely sufficient to meet civil engineering reguirements and any reductjon due to weathering will be critical. This study investigates the weathering of the Lower Lias clays with particular reference to their petrography and engineering properties. Investigations revealed the Midland Basin of deposition to contain reasonable thicknesses of clay, relatively uniform in nature with a well developed weathered zone, From the available exposures, the weathering zone of the Blockley Clay pit was selected and sampled for laboratory investigations of; Structure, Mineralogy and Chemistry and Engineering Properties. The nature and orientation of the fissures in the unweathered clay were analysed. A close relationship was found to exist between the major joint set and the ground surface, with stress release due to excavation being almost negligible. Thin sections of the clay, examined for structural data, suggested that there exist layers or areas that have been disturbed as a result of density differences. Shear planes were found in both the unweathered and weathered clay, in the latter case often associated with remoulding of the material. A direct measure of remoulding was obtained from the birefringence ratio. The fabric was examined in closer detail using the scanning electron microscope. Mineralogy, as revealed by X-ray and optical techniques indicated illite as the dominant clay mineral, with kaolinite subsidiary; quartz, calcite, pyrite, chlorite/vermiculite are present as accessory minerals. Weathering changes this relationship, calcite and pyrite being removed early in the process, with illite being degraded. The cementing action of calcite and iron oxides was investigated however, this was shown to be negligible. Quantitative measurements of both fixed (with minerals) and free (oxide coatings) iron were obtained by atomic absorption, with the Fe 3+/ Fe2+ ratio obtained by Mossbauer spectroscopy, Evidence indicates that free iron oxide coatings only become important as a result of weathering with the maximum concentration in the very highly weathered material. Engineering index properties and shear strength values were taken throughout the profile, Relationships between moisture content and strength, liquid limit and iron (Fe) were obtained and a correlation between the weathering zomes and the shear strength/depth curve has been established.
Resumo:
This thesis describes the stratigraphy, sedimentology and diagenesis of the Pendleside Limestone (Asbian age), a sequence of limestones, shales and dolostones in the Clitheroe area of N. W. England. Field study of 19 measured sections indicates that it was deposited in a rhythmically subsiding basin (Craven Basin) because of movements on the Mid-Craven Fault which was active in Dinantian times. The sequence is up to 190m thick and consists mostly of distal turbidite deposits which have been reworked at horizons when sediment accumulation built up to the wave base. The original depositional fabric and mineralogy of the Pendleside Limestone Group has been extensively modified by diagenetic processes including cementation, authigenesis, dolomitization and silicification. These processes have been studied using a wide variety of laboratory techniques. The carbonate cements of the PendIeside Limestone consist predominantly of ferroan calcite and non-ferroan calcite with microdolomite incIusions. The former is probably a stable replacement of original-high-magnesian calcite. Cementation was accompanied by the formation of authigenic albite and quartz. Much of the upper part of the Pendleside Limestone has been extensively dolomitized and chertified. Several distinct zones of dolomitization are found which increase in thickness and intensity towards the top of the Pendleside Limestone Group. The dolostone horizons correspond to coarser-grained lithologies deposited during periods of shallow water sedimentation. The composition of the dolomites changes from ferroan dolomite in the lower part of the Group to non-ferroan dolomite in the upper part. The low strontium and sodium content of the dolostones in association with the other evidence suggests that the dolomitization was brought about in an open system by the mixing of marine and fresh water in phreatic lens which were established at periodic intervals. The dolomitization was closely associated with chertification although this was initiated by the dissolution of siliceous spicules which provided the necessary source of silica.
Resumo:
The thesis provides a comparative study of both sedimentology and diagenesis of Lower Permian (Rotliegend) strata, onshore and offshore U.K. (Southern North Sea). Onshore formations studied include the Bridgnorth, Penrith and Hopeman Sandstone, and are dominated by aeolian facies, with lesser amounts of interbedded fluvial sediments. Aeolian and fluvial strata in onshore basins typically grade laterally into alluvial fan breccias at basin margins. Onshore basins represent proximal examples of Rotliegend desert sediments. The Leman Sandstone Formation of the Ravenspurn area in the Southern North Sea displays a variety of facies indicative of a distal sedimentological setting; Aeolian, fluvial, sabkha, and playa lake sediments all being present. "Sheet-like" geometry of stratigraphical units within the Leman Sandstone, and alternation of fluvial and aeolian deposition was climatically controlled. Major first order bounding surfaces are laterally extensive and were produced by lacustrine transgression and regression from the north-west. Diagenesis within Permian strata was studied using standard petrographic microscopy, scanning electron microscopy, cold cathodo-Iuminescence, X-ray diffraction clay analysis, X-ray fluorescence spectroscopy, fluid inclusion microthermometry, and K-Ar dating of illites. The diagenesis of Permian sediments within onshore basins is remarkably similar, and a paragenetic sequence of early haematite, illitic clays, feldspar, kaolinite, quartz and late calcite is observed. In the Leman Sandstone formation, authigenic mineralogy is complex and includes early quartz, sulphates and dolomite, chlorite, kaolinite, late quartz, illite and siderite. Primary lithological variation, facies type, and the interdigitation and location of facies within a basin are important initial controls upon diagenesis. Subsequently, burial history, structure, the timing of gas emplacement, and the nature of sediments within underlying formations may also exersize significant controls upon diagenesis within Rotliegend strata.