The influence of aspect on the pattern of saesonal growth in the lichen Parmelia glabratula ssp. fuliginosa (Fr. ex Duby) Laund

The radial growth of samples of thalli of Parmelia glabratula ssp. fuliginosa were measured in situ on a south-facing and a northwest-facing rock surface each month from August 1973 to July 1974. In the periods August to October 1973 and March to July 1974 the radial growth of thalli in the northwest population was greater than in the south population. In the period November 1973 to February 1974 the radial growth of thalli in the south population was greater than in the northwest population. A physiological basis for the differences in seasonal growth in the two populations was suggested. The mean annual radial growth rate (in units of mm/year) was not significantly different in the two populations. However, the variability in radial growth rate between thalli was signifiacntly larger in the northwest than in the south population. These results may be explained by genetic difference between the populations and environmental differences between the rock surfaces.

Integrated optimisation of surface roughness and tool performance when face milling 416 SS

Tool life is an important factor to be considered during the optimisation of a machining process since cutting parameters can be adjusted to optimise tool changing, reducing cost and time of production. Also the performance of a tool is directly linked to the generated surface roughness and this is important in cases where there are strict surface quality requirements. The prediction of tool life and the resulting surface roughness in milling operations has attracted considerable research efforts. The research reported herein is focused on defining the influence of milling cutting parameters such as cutting speed, feed rate and axial depth of cut, on three major tool performance parameters namely, tool life, material removal and surface roughness. The research is seeking to define methods that will allow the selection of optimal parameters for best tool performance when face milling 416 stainless steel bars. For this study the Taguchi method was applied in a special design of an orthogonal array that allows studying the entire parameter space with only a number of experiments representing savings in cost and time of experiments. The findings were that the cutting speed has the most influence on tool life and surface roughness and very limited influence on material removal. By last tool life can be judged either from tool life or volume of material removal.

Empirical expression of tool wear when face milling 416 SS

During a machining process, cutting parameters must be taken into account, since depending on them the cutting edge starts to wear out to the point that tool can fail and needs to be change, which increases the cost and time of production. Since wear is a negative phenomenon on the cutting tool, due to the fact that tool life is reduced, it is important to optimize the cutting variables to be used during the machining process, in order to increase tool life. This research is focused on the influence of cutting parameters such as cutting speed, feed per tooth and axial depth of cut on tool wear during a face milling operation. The Taguchi method is applied in this study, since it uses a special design of orthogonal array to study the entire parameters space, with only few numbers of experiments. Also a relationship between tool wear and the cutting parameters is presented. For the studies, a martensitic 416 stainless steel was selected, due to the importance of this material in the machining of valve parts and pump shafts. Copyright © 2009 by ASME.