The influence of composition, temperature and strain rate on the deformation of F.C.C. metals and alloys

DUE TO COPYRIGHT RESTRICTIONS ONLY AVAILABLE FOR CONSULTATION AT ASTON UNIVERSITY LIBRARY AND INFORMATION SERVICES WITH PRIOR ARRANGEMENT

The influence of die temperature and hardness on the wear of no. 5 die steel under hot forging conditions

DUE TO COPYRIGHT RESTRICTIONS ONLY AVAILABLE FOR CONSULTATION AT ASTON UNIVERSITY LIBRARY AND INFORMATION SERVICES WITH PRIOR ARRANGEMENT

The influence of the frequency of wetting and drying on the radial growth of three saxicolous lichens in the field

Three lichen species were wetted with distilled water at different frequencies during August 1973 to July 1974. The radial growth rates of Parmelia glabratula ssp. fuliginosa and Physcia orbicularis thalli declined with increased wetting while the radial growth rate of Parmelia conspersa thalli increased with wetting frequency until ten experimental wettings per month but at fifteen wettings per month fell to a value near to the control. In the summer months, wetting resulted in a decline in the radial growth of P. glabratula ssp fuliginosa compared with the control but had little influence on the growth of P. conspersa and Physcia orbicularis. In the winter months, wetting had no significant influence on the radial growth of Parmelia glabratula ssp. fuliginosa, while the radial growth of P. conspersa increased and Physcia orbicularis declined compared with controls. These results are interpreted physiologically and in relation to the aspect distribution of the three lichens on rock surfaces.

The influence of the chemical nature of dispersed phase on stability in oil-in-water emulsions

Some of the problems arising from the inherent instability of emulsions are discussed. Aspects of emulsion stability are described and particular attention is given to the influence of the chemical nature of the dispersed phase on adsorbed film structure and stability, Emulsion stability has been measured by a photomicrographic technique. Electrophoresis, interfacial tension and droplet rest-time data were also obtained. Emulsions were prepared using a range of oils, including aliphatic and aromatic hydrocarbons, dispersed In a solution of sodium dodecyl sulphate. In some cases a small amount of alkane or alkanol was incorporated into the oil phase. In general the findings agree with the classical view that the stability of oil-in-water emulsions is favoured by a closely packed interfacial film and appreciable electric charge on the droplets. The inclusion of non-ionic alcohol leads to enhanced stability, presumably owing to the formation of a "mixed" interfacial film which is more closely packed and probably more coherent than that of the anionic surfactant alone. In some instances differences in stability cannot he accounted for simply by differences in interfacial adsorption or droplet charge. Alternative explanations are discussed and it is postulated that the coarsening of emulsions may occur not only hy coalescence but also through the migration of oil from small droplets to larger ones by molecular diffusion. The viability of using the coalescence rates of droplets at a plane interface as a guide to emulsion stability has been researched. The construction of a suitable apparatus and the development of a standard testing procedure are described. Coalescence-time distributions may be correlated by equations similar to those presented by other workers, or by an analysis based upon the log-normal function. Stability parameters for a range of oils are discussed in terms of differences in film drainage and the natl1re of the interfacial film. Despite some broad correlations there is generally poor agreement between droplet and emulsion stabilities. It is concluded that hydrodynamic factors largely determine droplet stability in the systems studied. Consequently droplet rest-time measurements do not provide a sensible indication of emulsion stability,

The influence of the socio-educational reading environment in an Arab University upon English reading performance

Research into FL/EFL macro-reading (the effect of the broader context of reading) has been little explored in spite of its importance in the FL/EFL reading programmes. This study was designed to build on previous work by explaining in more depth the influence of the socio-educational reading environment in an Arab university (Al-Fateh University in Tripoli, Libya) - as reported by students, upon these students' reading ability in English and Arabic (particularly the former). Certain aspects of the lecturers' reading habits and attitudes and classroom operation were also investigated. Written cloze tests in English and Arabic and self-administered questionnaires were given to 125 preliminary-year undergraduates in three faculties of Al-Fateh University on the basis of their use of English as a medium of instruction (one representing the Arts' stream and two representing the Science stream). Twenty two lecturers were interviewed and observed by an inventory technique along with twenty other preliminary-year students. Factor analysis and standard multiple regression technique were among the statistical methods used to analyse the main data. The findings demonstrate a significant relationship between reading ability in English and the reading individual and environmental variables - as defined in the study. A combination of common and different series of such predictors were found accountable for the variation (43% for the first year English specialist; 48% for the combined Medicine student sample) in the English reading tests. Also found was a significant, though not very large, relationship between reading ability in Arabic and the reading environment. Non-statistical but objective analyses, based on the present data, also revealed an overall association between English reading performance and an important number of reading environmental variables - where many `poor' users of the reading environment (particularly the academic one) obtained low scores in the English cloze tests. Accepting the limitations of a single study, it is nevertheless clear that the reading environment at the University is in need of improvement and that students' use of it also requires better guidance and training in how to use it effectively. Suggestions are made for appropriate educational changes.

Effect of the temperature on the composition of lignin pyrolysis products

The temperature dependence of the pyrolysis products of two types of lignin (Alcell lignin and Asian lignin) was investigated using pyrolysis-gas chromatography-mass spectrometry (PyGC-MS). About 50 compounds were identified and quantified for each type of lignin over a temperature range of 400-800C. The maximum yield of phenolic compounds was obtained at 600C for both lignins, which was 17.2% for Alcell lignin and 15.5% for Asian lignin. Most of the phenolic compounds had an individual yield of less than 1%; however, for Alcell lignin, 5-hydroxyvanillin was the highest yield at 4.29 wt%on dry ash-free lignin, and for Asian lignin, 2-methoxy-4-vinylphenol was the highest yield at 4.15 wt % on dry ash-free lignin.

Getting marketing back into the boardroom:the influence of the marketing department in companies today

What influence do marketing departments have in companies today? Which factors determine this influence? These are the issues discussed in the present article. Empirical evidence based on data from companies in the Netherlands demonstrates that accountability, innovativeness and customer connections are the three major drivers of influence. The need for a strong marketing department within companies is also discussed, supported by empirical data.

Subject identification via ECG fiducial-based systems:influence of the type of QT interval correction

Electrocardiography (ECG) has been recently proposed as biometric trait for identification purposes. Intra-individual variations of ECG might affect identification performance. These variations are mainly due to Heart Rate Variability (HRV). In particular, HRV causes changes in the QT intervals along the ECG waveforms. This work is aimed at analysing the influence of seven QT interval correction methods (based on population models) on the performance of ECG-fiducial-based identification systems. In addition, we have also considered the influence of training set size, classifier, classifier ensemble as well as the number of consecutive heartbeats in a majority voting scheme. The ECG signals used in this study were collected from thirty-nine subjects within the Physionet open access database. Public domain software was used for fiducial points detection. Results suggested that QT correction is indeed required to improve the performance. However, there is no clear choice among the seven explored approaches for QT correction (identification rate between 0.97 and 0.99). MultiLayer Perceptron and Support Vector Machine seemed to have better generalization capabilities, in terms of classification performance, with respect to Decision Tree-based classifiers. No such strong influence of the training-set size and the number of consecutive heartbeats has been observed on the majority voting scheme.

Influence of the generated power, measurement bandwidth, and noise level on intensity statistics of a quasi-CW Raman fiber laser

In the present paper we numerically study instrumental impact on statistical properties of quasi-CW Raman fiber laser using a simple model of multimode laser radiation. Effects, that have the most influence, are limited electrical bandwidth of measurement equipment and noise. To check this influence, we developed a simple model of the multimode quasi- CW generation with exponential statistics (i.e. uncorrelated modes). We found that the area near zero intensity in probability density function (PDF) is strongly affected by both factors, for example both lead to formation of a negative wing of intensity distribution. But far wing slope of PDF is not affected by noise and, for moderate mismatch between optical and electrical bandwidth, is only slightly affected by bandwidth limitation. The generation spectrum often becomes broader at higher power in experiments, so the spectral/electrical bandwidth mismatch factor increases over the power that can lead to artificial dependence of the PDF slope over the power. It was also found that both effects influence the ACF background level: noise impact decreases it, while limited bandwidth leads to its increase. © (2014) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.

Psychological influence of the media on patients commencing oral anticoagulation in atrial fibrillation:a qualitative analysis

Background: Oral anticoagulation (OAC) reduces stroke risk in patients with atrial fibrillation (AF); however it is still underutilized and sometimes refused by patients. Two inter-related studies were undertaken to understand the experiences and what influences this un- derutilisation of warfarin treatment in AF patients. These studies explored physician and patient experiences of AF and OAC treatment. The paper focuses on specific sub-themes from the study that explored patients’ experiences will be discussed. Aim: The study in question aimed to explore the experiences which influence patients’ decisions to accept, decline or discontinue OAC. Methods: Semi-structured individual interviews with patients were con- ducted. Three sub-groups of patients (n = 11) diagnosed with AF were interviewed; those who accepted, refused, and who discontinued war- farin. Interpretative phenomenological analysis (IPA) was used to examine the data. IPA is a qualitative method that focuses on how participants make sense of an experiences phenomenon Results: Three over-arching themes comprised patients’ experiences: (i)the initial consultation, (ii) life after the consultation, and (iii) patients’reflections. In the last theme, patients reflected on their perceptions ofaspirin and warfarin. Aspirin was perceived as a natural wonder-drugwhile warfarin was perceived as a dangerous drug usually given to peo-ple at the end of their life. Interestingly they perceive both drugs as‘old’. However, for aspirin it had a positive association, old meaningtried and tested. While for warfarin, old meant ‘has been around fortoo long’.Conclusion: Media had an important role in how patients’ perceptionsof these two drugs were influenced. Literature shows that framingtechniques, i.e. using certain words or phrases such as ‘rat poison’, areprocesses adopted by media to alter medical knowledge into lay per-son’s language. Patients in turn form negative cognitive schemas,between the word ‘poison’ and warfarin, leading to the negative per-ception of warfarin which could influence non-adherence to treatment.This qualitative research highlighted the potential influences of themedia on AF patient perceptions commencing OAC treatment. Theassociation between media stimuli and patient perceptions on OACshould be further explored. The influential power of lay-media couldalso be instrumental in disseminating appropriate educational materialto the public

The influence of environment on foliose lichen growth and its ecological significance

This chapter considers various aspects of the influence of the environment on the growth of foliose lichens and its significance in determining the ecology of individual species. Radial growth (RaG) and growth in mass of foliose lichens is influenced by climate and microclimate and also by substratum factors such as rock and bark texture, substrate chemistry, and nutrient enrichment. Seasonal fluctuations in growth, as measured by radial growth rate (RaGR) per month, often correlate best with average or total rainfall, the number of rain days, or rainfall in a specific season. Temperature has also been identified to be an important climatic factor influencing growth in some studies. Interactions between microclimatic factors and especially light intensity, temperature, and moisture status are important in determining differences in growth in relation to aspect and slope of the substratum. The physical and chemical nature of the substratum has a profound influence on the growth of foliose lichens. Hence, the effects of texture, porosity, rate of drying, and the physical changes of the substratum on growth are likely to influence lichen distributions. Bird droppings may influence growth and survival by smothering the thalli, altering the pH, or adding inhibitory and stimulatory compounds. Nitrogen and phosphate availability may also influence growth. Chemical factors also have an important influence on lichens of maritime rocks, the effect of salinity and calcium ions being of particular importance. Effects of environmental factors on growth influence the competitive ability of a lichen and ultimately its ecology and distribution.

An assessment of the performance of high density polyethylene copolymers for natural gas distribution pipes

The total thermoplastics pipe market in west Europe is estimated at 900,000 metric tonnes for 1977 and is projected to grow to some 1.3 million tonnes of predominantly PVC and polyolefins pipe by 1985. By that time, polyethylene for gas distribution pipe and fittings will represent some 30% of the total polyethylene pipe market. The performance characteristics of a high density polyethylene are significantly influenced by both molecular weight and type of comonomer; the major influences being in the long-term hoop stress resistance and the environmental stress cracking resistance. Minor amounts of hexene-1 are more effective than comonomers lower in the homologous series, although there is some sacrifice of density related properties. A synergistic improvement is obtained by combining molecular weight increase with copolymerisation. The Long-term design strength of polyethylene copolymers can be determined from hoop stress measurement at elevated temperatures and by means of a separation factor of approximate value 22, extrapolation can be made to room temperature performance for a water environment. A polyethylene of black composition has a sufficiently improved performance over yellow pigmented pipe to cast doubts on the validity of internationally specifying yellow coded pipe for gas distribution service. The chemical environment (condensate formation) that can exist in natural gas distribution networks has a deleterious effect on the pipe performance the reduction amounting to at least two decades in log time. Desorption of such condensate is very slow and the influence of the more aggressive aromatic components is to lead to premature stress cracking. For natural gas distribution purposes, the design stress rating should be 39 Kg/cm2 for polyethylenes in the molecular weight range of 150 - 200,000 and 55 Kg/cm2 for higher molecular weight materials.

Getting marketing back in the boardroom:understanding the drivers of marketing's influence within the firm

As many strategically important aspects of marketing are addressed by other functions in the organization, the decreased influence of the marketing department within companies is a topic of growing debate. In this study, the authors investigate this diminished influence and assess its determinants and consequences. They interviewed 25 marketing and finance executives from leading Dutch firms. They also conducted a large-scale Internet-based survey of several hundred marketing, finance, and general managers. Their results show that accountability and the innovativeness of the marketing department are the major drivers of the marketing department’s influence. They also demonstrate that a firm’s short-term orientation is negatively related to the influence of the marketing department. Marketing influence is positively related to market orientation, which is positively related to firm performance. Their results do not support prior findings of a direct positive link between marketing influence and firm performance, which might suggest that there is no need for a strong marketing department. The study suggests that an influential marketing department is relevant primarily when the firm is not market oriented. When firms are market oriented, a less influential marketing department does not lower their performance. Hence, it appears that they can choose to have an influential or noninfluential marketing department without any repercussions for their performance. Marketing activities could move to other functions. The authors suggest that marketing departments should aim to retain their influence. Dispersing marketing decision making among many functions can cause a lack of coordination; customers also lose their advocate within the firm. How can marketing departments regain their influence? The authors suggest two general solutions. First, marketing departments should become more accountable by linking marketing actions and policies with financial results. Marketers should become capable in analytics and finance. Second, they should become more innovative by increasing their share in new product or service concepts. They can do so by using their knowledge of the market and customers to contribute to new product or service development.