Numerically optimized implementations, mitigation and simulations of polarisation mode dispersion in real-time transmission systems

The aim of this thesis is to present numerical investigations of the polarisation mode dispersion (PMD) effect. Outstanding issues on the side of the numerical implementations of PMD are resolved and the proposed methods are further optimized for computational efficiency and physical accuracy. Methods for the mitigation of the PMD effect are taken into account and simulations of transmission system with added PMD are presented. The basic outline of the work focusing on PMD can be divided as follows. At first the widely-used coarse-step method for simulating the PMD phenomenon as well as a method derived from the Manakov-PMD equation are implemented and investigated separately through the distribution of a state of polarisation on the Poincaré sphere, and the evolution of the dispersion of a signal. Next these two methods are statistically examined and compared to well-known analytical models of the probability distribution function (PDF) and the autocorrelation function (ACF) of the PMD phenomenon. Important optimisations are achieved, for each of the aforementioned implementations in the computational level. In addition the ACF of the coarse-step method is considered separately, based on the result which indicates that the numerically produced ACF, exaggerates the value of the correlation between different frequencies. Moreover the mitigation of the PMD phenomenon is considered, in the form of numerically implementing Low-PMD spun fibres. Finally, all the above are combined in simulations that demonstrate the impact of the PMD on the quality factor (Q=factor) of different transmission systems. For this a numerical solver based on the coupled nonlinear Schrödinger equation is created which is otherwise tested against the most important transmission impairments in the early chapters of this thesis.

Reliability analysis for hazard and operability studies

Fault tree analysis is used as a tool within hazard and operability (Hazop) studies. The present study proposes a new methodology for obtaining the exact TOP event probability of coherent fault trees. The technique uses a top-down approach similar to that of FATRAM. This new Fault Tree Disjoint Reduction Algorithm resolves all the intermediate events in the tree except OR gates with basic event inputs so that a near minimal cut sets expression is obtained. Then Bennetts' disjoint technique is applied and remaining OR gates are resolved. The technique has been found to be appropriate as an alternative to Monte Carlo simulation methods when rare events are countered and exact results are needed. The algorithm has been developed in FORTRAN 77 on the Perq workstation as an addition to the Aston Hazop package. The Perq graphical environment enabled a friendly user interface to be created. The total package takes as its input cause and symptom equations using Lihou's form of coding and produces both drawings of fault trees and the Boolean sum of products expression into which reliability data can be substituted directly.

Remote sensing applied to land use and erosion hazard studies in Jamaica

The northern half of the parish of St. Catherine in Jamaica was selected as a test area to study, by means of remote sensing, the problems of soil erosion in a tropical environment. An initial study was carried out to determine whether eroded land within this environment could be successfully interpreted and mapped from the available 1: 25,000 scale aerial photographs. When satisfied that a sufficiently high percentage of the eroded land could be interpreted on the aerial photographs the main study was initiated. This involved interpreting the air photo cover of the study area for identifying and classifying land use and eroded land, and plotting the results on overlays on topographic base maps. These overlays were then composited with data on the soils and slopes of the study area. The areas of different soil type/slope/land use combinations were then measured, as was the area of eroded land for each of these combinations. This data was then analysed in two ways. The first way involved determining which of the combinations of soil type, slope and land use were most and least eroded and, on the basis of this, to draw up recommendations concerning future land use. The second analysis was aimed at determining which of the three factors, soil type, slope and land use, was most responsible for determining the rate of erosion. Although it was possible to show that slope was not very significant in determining the rate of erosion, it was much more difficult to separate the effects of land use and soil type. The results do, however, suggest that land use is more significant than soil type in determining the rate of erosion within the study area.

The formation and impact of hazard control policy:a study of the regulation of white lead paint in Britain

Government regulation of industrial hazards is examined in the context of the economic and technical processes of industrial development. Technical problems and costs of control are considered as factors in both the formation and impact of regulation. This thesis focuses on an historical case-study of the regulation of the hazard to painting workers from the use of lead pigments in paint. A regulatory strategy based on the prohibition of lead paints gained initial acceptance within the British state in 1911, but was subsequently rejected in favour of a strategy that allowed continued use of lead paint subject to hygiene precautions. The development of paint technology and its determinants, including concern about health hazards, are analysed, focusing on the innovation and diffusion into the paint industry of the major white pigments: white lead (PbC03 .PB(OH)2)and its substitutes. The process of regulatory development is examined, and the protracted and polarised regulatory d~bate contrasted to the prevailing 'consensual' methods of workplace regulation. The rejection of prohibition is analysed in terms of the different political and technical resources of those groups in conflict over this policy. This highlights the problems of consensus formation around such a strategy, and demonstrates certain constraints on state regulatory activity, particularly regarding industrial development. Member-states of the International Labour Organisation agreed to introduce partial prohibition of lead paint in 1921. Whether this was implemented is related to the economic importance of lead and non-lead metal and pigment industries to a nation. An analysis is made of the control of lead poisoning. The rate of control is related to the economic and technological trajectory of the regulated industry. Technical and organisational characteristics are considered as well as regulatory factors which range from voluntary compliance and informal pressures to direct legal requirements. The implications of this case-study for the analysis of the development and impacts of regulation are assessed.

A comparison of the impact of avoidance cues in hazard avoidance during evaluation of text entry

The research presented in this paper is part of an ongoing investigation into how best to support meaningful lab-based evaluations of mobile technologies. In our previous work, we developed a hazard avoidance system for use during lab evaluations [1]; in the work reported here, we further assess the impact of this system, specifically in terms of the effect of avoidance cue type on speech-based text entry tasks.

Rayleigh noise mitigation in DWDM LR-PONs using carrier suppressed subcarrier-amplitude modulated phase shift keying

We demonstrate a novel Rayleigh interferometric noise mitigation scheme for applications in carrier-distributed dense wavelength division multiplexed (DWDM) passive optical networks at 10 Gbit/s using carrier suppressed subcarrier-amplitude modulated phase shift keying modulation. The required optical signal to Rayleigh noise ratio is reduced by 12 dB, while achieving excellent tolerance to dispersion, subcarrier frequency and drive amplitude variations.

Various nonlinearity mitigation techniques employing optical and electronic approaches

In this letter, we directly compare digital back-propagation (DBP) with spectral inversion (SI) both with and without symmetry correction via dispersive chirping, and numerically demonstrate that predispersed SI outperforms traditional SI, and approaches the performance of computationally exhaustive ideal DBP. Furthermore, we propose for the first time a novel practical scheme employing predispersed SI to compensate the bulk of channel nonlinearities, and DBP to accommodate the residual penalties due to varying SI location, with predispersed SI ubiquitously employed along the transmission link with <;0.5-dB penalty. Our results also show that predispersed SI enables partial compensation of cross-phase modulation effects, increasing the transmission reach by ×2.

Mitigation of pattern sensitivity in full-field electronic dispersion compensation

We investigate the pattern-dependent decoding failures in full-field electronic dispersion compensation (EDC) by offline processing of experimental signals, and find that the performance of such an EDC receiver may be degraded by an isolated "1" bit surrounded by long strings of consecutive "0s". By reducing the probability of occurrence of this kind of isolated "1" and using a novel adaptive threshold decoding method, we greatly improve the compensation performance to achieve 10-Gb/s on-off keyed signal transmission over 496-km field-installed single-mode fiber without optical dispersion compensation.

Mitigation of patterning effects at 40 Gbits/s by skewed channel pre-encoding

Through direct modeling, a reduction of pattern-dependent errors in a standard fiber-based transmission link at 40 Gbits/s rate is demonstrated by application of a skewed data pre-encoding. The trade-off between the improvement of the bit error rate and the loss in the data rate is examined.

Mitigation of patterning effects at 40 Gb/s by skewed channel pre-encoding

Through modelling of direct error computation, a reduction of pattern- dependent errors in a standard fiber-based transmission link at 40 Gb/s rate is demonstrated by application of a skewed data pre-encoding. The trade-off between the bit-error rate improvement and the data rate loss is examined.

A comparison of the impact of avoidance cues in hazard avoidance during evaluation of text entry

The research presented in this paper is part of an ongoing investigation into how best to support meaningful lab-based evaluations of mobile technologies. In our previous work, we developed a hazard avoidance system for use during lab evaluations [1]; in the work reported here, we further assess the impact of this system, specifically in terms of the effect of avoidance cue type on speech-based text entry tasks.

Mitigation of patterning effects at 40 Gbits/s by skewed channel pre-encoding

Through direct modeling, a reduction of pattern-dependent errors in a standard fiber-based transmission link at 40 Gbits/s rate is demonstrated by application of a skewed data pre-encoding. The trade-off between the improvement of the bit error rate and the loss in the data rate is examined. © 2007 Optical Society of America.

Mitigation of patterning effects at 40 Gb/s by skewed channel pre-encoding

Through modelling of direct error computation, a reduction of pattern- dependent errors in a standard fiber-based transmission link at 40 Gb/s rate is demonstrated by application of a skewed data pre-encoding. The trade-off between the bit-error rate improvement and the data rate loss is examined.

Study of EEPN mitigation using modified RF pilot and Viterbi-Viterbi based phase noise compensation

We propose - as a modification of the optical (RF) pilot scheme -a balanced phase modulation between two polarizations of the optical signal in order to generate correlated equalization enhanced phase noise (EEPN) contributions in the two polarizations. The method is applicable for n-level PSK system. The EEPN can be compensated, the carrier phase extracted and the nPSK signal regenerated by complex conjugation and multiplication in the receiver. The method is tested by system simulations in a single channel QPSK system at 56 Gb/s system rate. It is found that the conjugation and multiplication scheme in the Rx can mitigate the EEPN to within 1/2 orders of magnitude. Results are compared to using the Viterbi-Viterbi algorithm to mitigate the EEPN. The latter method improves the sensitivity more than two orders of magnitude. Important novel insight into the statistical properties of EEPN is identified and discussed in the paper. © 2013 Optical Society of America.

Self-phase modulation dependent dispersion mitigation in high power SSB and DSB + dispersion compensated modulated radio-over-fiber links

The joint effect of fiber chromatic dispersion and fiber nonlinearity onto single-sideband and double-sideband modulated radio-over-fiber links is investigated. Experimental and simulated results show that modulation suppression caused by the chromatic dispersion in radio-over-fiber links can be successfully eliminated in both schemes only when the system is in the linear regime. Under nonlinear transmission the received microwave carrier power depends on the optical incident power.