The role of insulin and the insulin-like growth factors in the proliferation of the rat thymic lymphocyte

Concanavalin A, provoked a 35-fold increase in the rate of proliferation of rat thymocytes. Insulin (10-6M), and insulin-like growth factor I (10-10M) approximately doubled the rate of DNA synthesis. Both of these structurally related molecules acted through the type I insulin-like growth factor receptor. The sequential addition of Concanavalin A and insulin, promoted a much greater proliferative response than to either of the two agonists alone. Insulin also increased the uptake of glucose and amino acids by the cells. Glucose uptake was enhanced at insulin concentrations of 10-6M and 10-10M. Amino acid uptake was more strongly affected at the higher concentration. Insulin-like growth factor I (10-11M) also enhanced amino acid uptake. The effects of insulin on metabolism were mediated by both insulin and type I insulin-like growth factor receptors. These effects were greatly enhanced after a pre-treatment with Concanavalin A. Concanavalin A provided a primary mitogenic signal to the cells. Amongst the responses was an increased expression of insulin and/or type I insulin-like growth factor receptors. The consequent enhanced cellular sensitivity to these agonists, enabled them to facilitate the passage of the cells through the cell cycle by: i) providing a secondary mitogenic signal, and ii) promoting the uptake of raw materials and energy substrates. The initiation of DNA synthesis and passage through the cell cycle was thus punctuated by the sequential expression of various cell surface receptors. This regulated cellular sensitivity, enabling them to react in a precisely orchestrated fashion to hormones and other molecules in their environment. The intracellular mechanism of insulin action remains an enigma. Although the presence of extracellular calcium was essential for insulin stimulation of amino acid uptake and DNA synthesis, the cation did not subserve a direct mediator function. Insulin promoted an increase in intracellular pH, which was mediated by the Na+/H+ antiport. Other mechanisms were probably also involved in mediating the full cellular response to insulin.

The study of ultra-low energy deposition of hydrogenated amorphous carbon thin films

This thesis is dedicated to the production and analysis of thin hydrogenated amorphous carbon films. A cascaded arc plasma source was used to produce a high density plasma of hydrocarbon radicals that deposited on a substrate at ultra low energies. The work was intended to create a better understanding of the mechanisms responsible for the film formation, by an extensive analysis on the properties of the films in correlation with the conditions used in the plasma cell. Two different precursors were used: methane and acetylene. They revealed a very different picture for the mechanism of film formation and properties. Methane was less successful, and the films formed were soft, with poor adhesion to the substrate and decomposing with time. Acetylene was the better option, and the films formed in this case were harder, with better adhesion to the substrate and stable over time. The plasma parameters could be varied to change the character of films, from polymer-like to diamond-like carbon. Films deposited from methane were grown at low deposition rates, which increased with the increase in process pressure and source power and decreased with the increase in substrate temperature and in hydrogen fraction in the carrier gas. The films had similar hydrogen content, sp3 fractions, average roughness (Ra) and low hardness. Above a deposition temperature of 350°C graphitization occurred - an increase in the sp2 fraction. A deposition mechanism was proposed, based upon the reaction product of the dissociative recombination of CH4+. There were small differences between the chemistries in the plasma at low and high precursor flow rates and low and high substrate temperatures; all experimental conditions led to formation of films that were either polymer-like, soft amorphous hydrogenated carbon or graphitic-like in structure. Films deposited from acetylene were grown at much higher deposition rates on different substrates (silicon, glass and plastics). The film quality increased noticeably with the increase of relative acetylene to argon flow rate, up to a certain value, where saturation occurred. With the increase in substrate temperature and the lowering of the acetylene injection ring position further improvements in film quality were achieved. The deposition process was scaled up to large area (5 x 5 cm) substrates in the later stages of the project. A deposition mechanism was proposed, based upon the reaction products of the dissociative recombination of C2H2 +. There were large differences between the chemistry in the plasma at low and medium/high precursor flow rates. This corresponded to large differences in film properties from low to medium flow rates, when films changed their character from polymer-like to diamond-like, whereas the differences between films deposited at medium and high precursor flow rates were small. Modelling of the film growth on silicon substrates was initiated and it explained the formation of sp2 and sp3 bonds at these very low energies. However, further improvements to the model are needed.