An investigation of thin amorphous carbon-based sputtered coatings for MEMS and micro-engineering applications

The work presented in this thesis describes an investigation into the production and properties of thin amorphous C films, with and without Cr doping, as a low wear / friction coating applicable to MEMS and other micro- and nano-engineering applications. Firstly, an assessment was made of the available testing techniques. Secondly, the optimised test methods were applied to a series of sputtered films of thickness 10 - 2000 nm in order to: (i) investigate the effect of thickness on the properties of coatingslcoating process (ii) investigate fundamental tribology at the nano-scale and (iii) provide a starting point for nanotribological coating optimisation at ultra low thickness. The use of XPS was investigated for the determination of Sp3/Sp2 carbon bonding. Under C 1s peak analysis, significant errors were identified and this was attributed to the absence of sufficient instrument resolution to guide the component peak structure (even with a high resolution instrument). A simple peak width analysis and correlation work with C KLL D value confirmed the errors. The use of XPS for Sp3/Sp2 was therefore limited to initial tentative estimations. Nanoindentation was shown to provide consistent hardness and reduced modulus results with depth (to < 7nm) when replicate data was suitably statistically processed. No significant pile-up or cracking of the films was identified under nanoindentation. Nanowear experimentation by multiple nanoscratching provided some useful information, however the conditions of test were very different to those expect for MEMS and micro- / nano-engineering systems. A novel 'sample oscillated nanoindentation' system was developed for testing nanowear under more relevant conditions. The films were produced in an industrial production coating line. In order to maximise the available information and to take account of uncontrolled process variation a statistical design of experiment procedure was used to investigate the effect of four key process control parameters. Cr doping was the most significant control parameter at all thicknesses tested and produced a softening effect and thus increased nanowear. Substrate bias voltage was also a significant parameter and produced hardening and a wear reducing effect at all thicknesses tested. The use of a Cr adhesion layer produced beneficial results at 150 nm thickness, but was ineffective at 50 nm. Argon flow to the coating chamber produced a complex effect. All effects reduced significantly with reducing film thickness. Classic fretting wear was produced at low amplitude under nanowear testing. Reciprocating sliding was produced at higher amplitude which generated three body abrasive wear and this was generally consistent with the Archard model. Specific wear rates were very low (typically 10-16 - 10-18 m3N-1m-1). Wear rates reduced exponentially with reduced film thickness and below (approx.) 20 nm, thickness was identified as the most important control of wear.

International risk management:systems, internal control and corporate governance

This book is very practical in its international usefulness (because current risk practice and understanding is not equal across international boundaries). For example, an accountant in Belgium would want to know what the governance regulations are in that country and what the risk issues are that he/she needs to be aware of. This book covers the international aspect of risk management systems, risk and governance, and risk and accounting. In doing so the book covers topics such as: internal control and corporate governance; risk management systems; integrating risk into performance management systems; risk and audit; governance structures; risk management of pensions; pension scheme risks e.g. hedging derivatives, longevity bonds etc; risk reporting; and the role of the accountant in risk management. There are the case studies through out the book which illustrate by way of concrete practical examples the major themes contained in the book. The book includes highly topical areas such as the Sarbanes Oxley Act and pension risk management.

PCIM:a project control and inhibiting‐factors management model

In construction projects, the aim of project control is to ensure projects finish on time, within budget, and achieve other project objectives. During the last few decades, numerous project control methods have been developed and adopted by project managers in practice. However, many existing methods focus on describing what the processes and tasks of project control are; not on how these tasks should be conducted. There is also a potential gap between principles that underly these methods and project control practice. As a result, time and cost overruns are still common in construction projects, partly attributable to deficiencies of existing project control methods and difficulties in implementing them. This paper describes a new project cost and time control model, the project control and inhibiting factors management (PCIM) model, developed through a study involving extensive interaction with construction practitioners in the UK, which better reflects the real needs of project managers. A set of good practice checklist is also developed to facilitate implementation of the model. © 2013 American Society of Civil Engineers.

The impact of the language barrier on the management of multinational companies : a case study and survey, based exploration of the impact of the language barrier on the strategies, policies and systems by which multinational companies manage their subsidaries

The thesis begins with a conceptual model of the way that language diversity affects the strategies, organisation and subsidiary control policies of multinational companies. The model is based solely on the researcher'’ personal experience of working in a variety of international management roles, but in Chapter 2 a wide-ranging review of related academic literature finds evidence to support the key ideas. The model is developed as a series of propositions which are tested in a comparative case study, refined and then re-tested in a global survey of multinational subsidiaries. The principal findings of the empirical phases of the thesis endorse the main tenets of the model: - That language difference between parent and subsidiary will impair communication, create mistrust and impede relationship development. - That subsequently the feelings of uncertainty, suspicion and mistrust will influence the decisions taken by the parent company. - They will have heightened sensitivity to language issues and will implement policies to manage language differences. - They will adopt low-risk strategies in host countries where they are concerned about language difference. - They will use organisational and manpower strategies to minimise the consequences and risks of the communications problems with the subsidiary. - As a consequence the level of integration and knowledge flow between parent and subsidiary will be curtailed. - They will adopt styles of control that depend least on their ability to communicate with their subsidiary. Although there is adequate support for all of the above conclusions, on some key points the evidence of the Case Studies and Survey is contradictory. The thesis, therefore, closes with an agenda for further research that would address these inconsistencies.

The human factors of automatic speech recognition in control room systems

This thesis addresses the viability of automatic speech recognition for control room systems; with careful system design, automatic speech recognition (ASR) devices can be useful means for human computer interaction in specific types of task. These tasks can be defined as complex verbal activities, such as command and control, and can be paired with spatial tasks, such as monitoring, without detriment. It is suggested that ASR use be confined to routine plant operation, as opposed the critical incidents, due to possible problems of stress on the operators' speech.  It is proposed that using ASR will require operators to adapt a commonly used skill to cater for a novel use of speech. Before using the ASR device, new operators will require some form of training. It is shown that a demonstration by an experienced user of the device can lead to superior performance than instructions. Thus, a relatively cheap and very efficient form of operator training can be supplied by demonstration by experienced ASR operators. From a series of studies into speech based interaction with computers, it is concluded that the interaction be designed to capitalise upon the tendency of operators to use short, succinct, task specific styles of speech. From studies comparing different types of feedback, it is concluded that operators be given screen based feedback, rather than auditory feedback, for control room operation. Feedback will take two forms: the use of the ASR device will require recognition feedback, which will be best supplied using text; the performance of a process control task will require task feedback integrated into the mimic display. This latter feedback can be either textual or symbolic, but it is suggested that symbolic feedback will be more beneficial. Related to both interaction style and feedback is the issue of handling recognition errors. These should be corrected by simple command repetition practices, rather than use error handling dialogues. This method of error correction is held to be non intrusive to primary command and control operations. This thesis also addresses some of the problems of user error in ASR use, and provides a number of recommendations for its reduction.

The choice of the model in inventory control and the cost of sophistication

This thesis is concerned with the inventory control of items that can be considered independent of one another. The decisions when to order and in what quantity, are the controllable or independent variables in cost expressions which are minimised. The four systems considered are referred to as (Q, R), (nQ,R,T), (M,T) and (M,R,T). Wiith ((Q,R) a fixed quantity Q is ordered each time the order cover (i.e. stock in hand plus on order ) equals or falls below R, the re-order level. With the other three systems reviews are made only at intervals of T. With (nQ,R,T) an order for nQ is placed if on review the inventory cover is less than or equal to R, where n, which is an integer, is chosen at the time so that the new order cover just exceeds R. In (M, T) each order increases the order cover to M. Fnally in (M, R, T) when on review, order cover does not exceed R, enough is ordered to increase it to M. The (Q, R) system is examined at several levels of complexity, so that the theoretical savings in inventory costs obtained with more exact models could be compared with the increases in computational costs. Since the exact model was preferable for the (Q,R) system only exact models were derived for theoretical systems for the other three. Several methods of optimization were tried, but most were found inappropriate for the exact models because of non-convergence. However one method did work for each of the exact models. Demand is considered continuous, and with one exception, the distribution assumed is the normal distribution truncated so that demand is never less than zero. Shortages are assumed to result in backorders, not lost sales. However, the shortage cost is a function of three items, one of which, the backorder cost, may be either a linear, quadratic or an exponential function of the length of time of a backorder, with or without period of grace. Lead times are assumed constant or gamma distributed. Lastly, the actual supply quantity is allowed to be distributed. All the sets of equations were programmed for a KDF 9 computer and the computed performances of the four inventory control procedures are compared under each assurnption.

Fish farm effluent control and the development of an expert system

In recent years, freshwater fish farmers have come under increasing pressure from the Water Authorities to control the quality of their farm effluents. This project aimed to investigate methods of treating aquacultural effluent in an efficient and cost-effective manner, and to incorporate the knowledge gained into an Expert System which could then be used in an advice service to farmers. From the results of this research it was established that sedimentation and the use of low pollution diets are the only cost effective methods of controlling the quality of fish farm effluents. Settlement has been extensively investigated and it was found that the removal of suspended solids in a settlement pond is only likely to be effective if the inlet solids concentration is in excess of 8 mg/litre. The probability of good settlement can be enhanced by keeping the ratio of length/retention time (a form of mean fluid velocity) below 4.0 metres/minute. The removal of BOD requires inlet solids concentrations in excess of 20 mg/litre to be effective, and this is seldom attained on commercial fish farms. Settlement, generally, does not remove appreciable quantities of ammonia from effluents, but algae can absorb ammonia by nutrient uptake under certain conditions. The use of low pollution, high performance diets gives pollutant yields which are low when compared with published figures obtained by many previous workers. Two Expert Systems were constructed, both of which diagnose possible causes of poor effluent quality on fish farms and suggest solutions. The first system uses knowledge gained from a literature review and the second employs the knowledge obtained from this project's experimental work. Consent details for over 100 fish farms were obtained from the public registers kept by the Water Authorities. Large variations in policy from one Authority to the next were found. These data have been compiled in a computer file for ease of comparison.

Privatisation, corporate control and employment growth:evidence from a panel of large Polish firms, 1996-2002

Using data on Polish firms this paper examines the relationship between corporate control structures, sales growth and the determinants of employment change. Privatised and de novo firms are the main drivers of employment growth; in the case of de novo firms, it is foreign ownership which underpins the result. Being privatised has a positive impact on employment but this is concentrated within a range of 3–6 years after privatisation. There are no systematic differences in employment response to negative sales growth across the ownership categories. Employment in state firms is less responsive to positive sales growth. From these results we infer that the behaviour of state firms is affected by both insider rent sharing and binding budget constraints.

A probabilistic indirect adaptive control for systems with input-dependent noise

A probabilistic indirect adaptive controller is proposed for the general nonlinear multivariate class of discrete time system. The proposed probabilistic framework incorporates input–dependent noise prediction parameters in the derivation of the optimal control law. Moreover, because noise can be nonstationary in practice, the proposed adaptive control algorithm provides an elegant method for estimating and tracking the noise. For illustration purposes, the developed method is applied to the affine class of nonlinear multivariate discrete time systems and the desired result is obtained: the optimal control law is determined by solving a cubic equation and the distribution of the tracking error is shown to be Gaussian with zero mean. The efficiency of the proposed scheme is demonstrated numerically through the simulation of an affine nonlinear system.

A Bayesian formulation of search, control and the exploration/exploitation trade-off

A new approach to optimisation is introduced based on a precise probabilistic statement of what is ideally required of an optimisation method. It is convenient to express the formalism in terms of the control of a stationary environment. This leads to an objective function for the controller which unifies the objectives of exploration and exploitation, thereby providing a quantitative principle for managing this trade-off. This is demonstrated using a variant of the multi-armed bandit problem. This approach opens new possibilities for optimisation algorithms, particularly by using neural network or other adaptive methods for the adaptive controller. It also opens possibilities for deepening understanding of existing methods. The realisation of these possibilities requires research into practical approximations of the exact formalism.

Social control and knowledge in democratic societies

In this article we introduce the notions of knowledge policy and the politics of knowledge. These have to be distinguished from the older, well-known terms of research policy, or science and technology policy. While the latter aim to foster the development of innovations in knowledge and its applications, the former is aware of side effects of new knowledge and tries to address them. While research policy takes the aims of innovations as largely unproblematic (insofar as they help improving national competitiveness), knowledge policy tries to govern (regulate, control, restrict, or even forbid) the production of knowledge.

"Well did you feel jealous?" Control and ideology in police interviews with rape complainants

The methods used by the UK Police to investigate complaints of rape have unsurprisingly come under much scrutiny in recent times, with a 2007 joint report on behalf of HM Crown Prosecution Service Inspectorate and HM Inspectorate of Constabulary concluding that there were many areas where improvements should be made. The research reported here forms part of a larger project which draws on various discourse analytical tools to identify the processes at work during police interviews with women reporting rape. Drawing on a corpus of video recorded police interviews with women reporting rape, this study applies a two pronged analysis to reveal the presence of these ideologies. Firstly, an analysis of the discourse markers ‘well’ and ‘so’ demonstrates the control exerted on the interaction by interviewing officers, as they attach importance to certain facts while omitting much of the information provided by the victim. Secondly, the interpretative repertoires relied upon by officers to ‘make sense’ of victim’s accounts are subject to scrutiny. As well as providing micro-level analyses which demonstrate processes of interactional control at the local level, the findings of these analyses can be shown to relate to a wider context – specifically prevailing ideologies about sexual violence in society as a whole.

The role of leader-member exchanges in mediating the relationship between locus of control and work reactions

The relationship between locus of control, the quality of exchanges between subordinates and leaders (LMX), and a variety of work-related reactions (intrinsic/extrinsic job satisfaction, work-related well-being, and organizational commitment) are examined. It was predicted that people with an internal locus of control develop better quality relations with their manager and this, in turn, results in more favourable work-related reactions. Results from two different samples (N=404, and N=51) supported this prediction, and also showed that LMX either fully, or partially, mediated the relationship between locus of control and all the work-related reactions.